Having problems with your Pressure Washers ?

Hose assembly 5140067-10

\015 Please let me know where I can buy this hose in the west rand\015

Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need the steps to change the hose assembly on my Whirlpool portable dishwasher. When I got it someone had cut the sink connections off so my son connected it to the water and drain with my washing machine which was in the kitchen. However, I have moved and want to use it as portable. I purchased the new hose assembly for the sink faucet, I just need instructions on how to take the dishwasher apart and connect the new hoses.....HELP PLEASE!


... Whirlpool 24 in. Portable Dishwasher Dishwasher

Assembly plans for karcher 2400 psi pressure i recently had a problem, with my pressure washer. i was cleaning out my hose and took the hose assembly and brass fitting off. run water threw it thought i had cleand it out, put it back together and now when i hooked my water hose back up the water comes out of the despencer instead of the pressure wand. does eny one no what i need to do to revurse this?


... Honda Karcher G2400HH-R Pressure Washer

Due to the my Indesit IDL 530 dishwasher not draining properly, I turned it onto it's left side, removed the base plate and pump and checked for blockages in the pump and associated hoses, which were all clear. However in re-assembling it I have forgotten which way round to connect the twin wire plug to the base plate. I cannot find a relevant wiring diagram online and therefore cannot tell which is the correct way around. I then guessed and re-assembled it anyway, and as you might have g


Hi.There is more than one wire going from control board to the tub. If the connector can be plugged either way without forcing it, then usually does not make any difference the way you plug this determined connector. It will be usef ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Removed rear toe-plate to detect leak. Leak caused by broken drain hose. Hose replaced. To do this the unit was tipped forward onto its front door to allow access to the base area. Water allowed to drain out the front base area. Unit re-assembled but now does not switch on. Water connected. Base-plate dry. No water was detected at upper-front control panel. Power is connected and reaching unit ( multi-meter test ). Tipping the unit forward seems to be the cause. Is there any fuse,


The micro switches are frequently replaced on the door handle and they don't need to ever get wet. A lot of amp draw burns those switches up while they are dry. If they were wet and power was applied then they got fried my friend. The good news is th ... Dishwashers

Frigidaire dishwasher (Electrolux FDB750RCB0) does not move water through the hose to the upper wash/spray bar. The lower wash/spray bar has pressure enough to turn. With the dish washer out from under the counter I can see the water rise very slowly up the translucent hose. If I remove the check ball under the stem assembly in the motor in the bottom of the tub, water flows, but I'm not sure if the top bar turns then (with the door open I see water coming down from the top, but never saw


... Dishwashers

Hose assembly 5140067-10


... Pressure Washers

Drain and fill hose assembly leaks at faucet on model # 665.17822000 dishwasher


... Kenmore Dishwashers

Kenmore dishwasher is leaking at drain and fill hose assembly


... Kenmore Dishwashers

How do I replace a coupler and hose assembly for Maytag Dishwasher DWC7302AAB?


... Dishwashers

I had a draining problem, clogged line, fixed. Does the small in line rubber valve under the dishwasher in the transition piece to the hose have any real need to go back? and which direction it is cupped slightly. Also are there any assembly instructions? I cant seem to get it back quite right, or a white washer has split. not sure which.


... Whirlpool 24" Built-In Dishwasher - Black-on-Black

I have a fridgidaire Gallery dishwasher model # FDB949GFS2. It was not spraying water while running, so I checked for clogged wash arms and hoses etc. So I replaced the motor assembly and now I hear the motor running, it fills with hot water but it is still not circulating water. Is there something else I need to check. Thanks Tom


Most likely the wash sump is blocked. Refer this diagram. You will have to open the sump (item 14) and loo ... Frigidaire FDB949GF Dishwasher

Coleman power washer PW0912201. Water is blowing out of the chemical pickup tube when water hose is turned on prior to starting. After starting the water realy blows out from there. Would the unloader be faulty? I tried to pull out the unloader stem assembly from the manifold but it appears to be pressed in. Do I need a new manifold kit? or am I looking at the wrong part to correct this?


... Coleman Pressure Washers

Bosch SHU 43C 05UC/22 Has a very loud Groaning noise at start up midway and at end of cycle. Have cleaned and changed the DW Hose to the DW drain assembly under sink. Drains better but, I suspect the drain motor has been overtaxed because it's a long way to the sink - about 8 ft. under the kitchen in crawl space and up to sink.


... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

Machine stopped before end of cycle and did not drain. Cleaned out water, took apart pump assembly, impeller, etc. and drain hose. No obvious problem. Put everything back but dishwasher won't star


... Whirlpool 24 in. DU920QWD Built-in Dishwasher

Where can a hose and wand assembly be found for Coleman Powermate Pressure Washer model PW0811505.02 serial HH0710494, 1500 psi.


... Pressure Washers

What is the difference between the 5835ED2002A blower assembly and the 5835ED2002D. The repair replaced the ''A'' with a ''D''. The ''D'' has a drain hose and ''A'' does not. Can this part still be used? Model # LDF6810BB. Thanks.


... LG Dishwashers

Dishwasher expelling water through air gap into sink We have disconnected the hoses to check for obstruction and have replaced air gap assembly


MY DISHWASHER AIR GAP IS SHOOTING WATER INTO THE KITCHEN SINK WHY ? ... Dishwashers

My GE Monogram ZBD4500 dishwasher does not drain completely at the end of the cycle. If I run a couple of manual cycles afterwards it eill eventually drain completely. Drain hose is clean, pump suction sump looks clean, drain pump impeller appears OK, discharge check valve assembly is easy to blow through in direction of drain. Do I have a sequence switch problem?


I bloody lostt you! are you still there? ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

I bought a new karcher model no. K3.690 Thurs. Apr. 8th 2010, I tried to start it today Sun. Apr. 11th, when connecting my high pressure hose, to the trigger assembly, it does not lock in, I followed the proper instructions as per the quick start.


... Alfred Karcher K 5.93 M Electric Pressure Washer

Bosch Dishwasher SGS43E02 Exxcel. Switches on at main switch (0 appears in the numerical display) but none of the right hand programme buttons seem to be working! Have checked filter on water supply hose and that doesn't look blocked.


Obviously a faulty connection. Lots of switching off and on and holding down the buttons eventually sorted it! ... Bosch 24 in. SGS43E02 Exxcel Built-In Dishwasher

I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.


Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers

How to remove/install drain hose - Bosch dishwasher SHX33A05UC/22


... Bosch Dishwashers

Pressure Washer - Psi 3000: We have a 2600 psi EXCELL Honda PW. The short hose...


... Honda Pressure Washer PSI 3000

I am replacing the drain hose on my LG Dishwasher LDS5811BB. The new hose they gave me has an additional piece connected onto the hose. I don't know what it is or what it is for. The original drain hose was composed soley of a gray hose with the to end connectectors. This new hose is similar with an additional white, hard plastic, U-shaped hose with a black hose extending off the end of the U-shaped end. Is this an air gap extension, and if so, what do I connect it to or can I cap it off?


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0307 seconds