Having problems with your Pressure Washers ?

What oil to use for a troy bilt power washer model # 020207


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What oil to use for a troy bilt power washer model # 020207


... Pressure Washers

My Troy Bilt power washer (using Honda GCV160 engine) has no pressure coming from the pump. I checked the water flow, everything seems fine. I believe the pump needs oil added, however, I can't seem to firgure it out (how to add oil to the pump). I did notice that previously, I used to see drops of oil coming from under the pump. I I have a bad seal, can I add oil and test the pressure before I change the seal? Please advise.


I had a similar problem. Turns out I had left the hose disconnected and some sort of wasp built a paper type nest inside the washer tube that the hose connects to. I had to take the pump off and take apart and then cleaned it out with a screw driver. ... Honda Black Max 2600 PSI Pressure Washer

Troy Bilt power washer 020293- Oil in air filter


That is incorrect. if the oil has been over filled, it will saturate the filter element by way of the crankcase breather tube. it is the small plastic pipe that connects to the bottom of the filter housing. check the oil level. these machines take ve ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

What oil do I use for my Troy-Bilt 2350 psi power washer?


... Briggs & Stratton Pressure Washers

Troy-Bilt 2550 20293 pressure washer not producing pressure. Worked when last used 2 months ago. Pump pistons are moving up and down when engine is pulled through. Inlet water is flowing through pump but no pressure when engine is started. I have the same problem. Water flows thru the pump when not running, but no flow or goes in by-pass mode when I start the pump. The pump being Troy Bilt Model 020296-01. I replaced unloader valve even. Anything else I can do?


You replaced the unloaded valve. Are you positive you have the unloader screwed to pressure and not turned the opposite way? You will have no pressure if it is adjusted wrong. One other thing I have encountered is that the unloader has a ball bearing ... Pressure Washers

What of oil is used in pump of a simpson power washer model msv 3100 ,not the engine oil. the pump oil ,it's life time oil


... Pressure Washers

New honda pressure washer maybe had it 2 years and only has about 3 hours on it, I was using it yesterday and it started fine and after running for about 10 min it shut down like i turned the kill switch, it has oil and gas but seems to have lost compression. It is a Honda overhead cam GCV 160, pressure washer is a Troy Built model


... Pressure Washers

Oil for a troy bilt 2550 psi pressure washer pump


What fluid and how much is required in the Troy-Bilt 2550 power washer pump? ... Briggs & Stratton Pressure Washers

I have an electric power washer model PW181000AV with about 25 hours on it. Got home from my winter retreat and used the power washer about 1/2 hour on the driveway. Everything worked fine. Went to complete the job the next day, and the motor would not power on. No sounds at all, like it wasn't getting electricity. Did the standard trouble shooting with ground fault and on my own electrical system. Been using the same outlet for all the time I have owned the power washer, so distance is no


... Campbell Hausfeld Pressure Washers

Troy Bilt pressure washer model 020209 will not build pressure-have checked all screens and intake in pressure hose and garden hose from house to pump. water leaks at gun handle- took it apart and oiled piston- was ''grabby'' but now snappy but still leaks. Engine starts fine and runs fine. Please help.


A leaking gun will kill all the pressure. You may need to repair or replace the gun ... Briggs & Stratton Pressure Washers

Do I need to add oil to the gas for a Troy-Bilt 2500 power washer


This engine is 4-cycle. It does not require oil in the gas. Is the crankcase full of oil? Do you know how to check it? ... Karcher 2500 PSI Pressure Washer

My neighbor just gave me a Troy Bilt 020207 power washer. It is 2450 PSI and 2 GPM. He snapped the pull cord rope. I looked at the pull cord cover and it seems to have 3 rivets holding it to the main housing. How do you recommend to repair or replace the pull cord?


Sounds like a briggs engine, DONT remove the rivits, go down a little further and remove the 4 3/8 bolts that hold the blower housing on.Turn it upside down, prewinf the pulley in the direction that it turns when the rope is being pulled. When it sto ... Briggs & Stratton Pressure Washers

Oil for Troy built pressure washer model 020207


... Pressure Washers

Hi I have a Troy-Bilt Pressure washer 2200 psi model 20292. I've used it only 4 or 5 times. It ran great for an hour today then it lost pressure. Seems like the pump is not working. The engine runs fine but no pressure. The water runs through the nozzel and I blew air in the lines to make sure there is no blockage and found no blockage even in the pump lines. Any ideas. Tom


... Briggs & Stratton Gas Pressure Washer 20244

I have a washer model 1805 (1800 PSI). Everything works but there is always leaking of water (sprays) when I use it. The leak is not from where the water hose connects to the washer, but where the black piece attached to the hose is connected to the body of the washer. I can still do a decent job of power washing, but am wondering if the leaking of water is reducing the power of the washer.


Yes, leaking water will reduce the pressure. Sounds like you need to replace the O-Ring inside the connections on the pump. This is where the pressure hose connects to the pump. If you look carefully inside that connection you will see an O-Ring. Use ... Campbell Hausfeld PW1805 1800 PSI 15 GPM Pressure Washer

Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Troy Bilt Pressure Washer Model 01902 Leaking Gas from Air Filter


Try banging lightly on carberator with block of wood or something to free up float and valve!!!! ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

I have a Honda xr2600 power washer. When I tried using it, water was squirting from the top of the gun. I took it apart to find that there are o-rings on top of some kind of washer---looks like a lock washer but it's made of cardboard??? Two of these washers were broken. I can get the o-rings but I can't seem to find the washers. I tried getting the manual for this model on line with no luck. Any assistance will be greatly appreciated.


The washers that you describe are made of teflon and are split to facilitate installation and/or allow expansion as they wear. These washers are actually seals and at times are used together with orings to seal high pressure. You should ... Honda Pressure Washers

What can of oil to used in a chore master 1250 power washer


... Mi T M Mi-T-M CM-1250-0MEH NA Chore Master 1250 PSI Chore Master Pressure Washer CM-1250-0MEH

Troy-Bilt Power Washer Has No Pressure


... Pressure Washers

I have a troy build pressure washer model number 020337 Do I need to change the oil in the pump, and if yes how do I drain it and what kind of oil. I know how to change the engine oil


The pump requires no maintenance and no oil change. It is lubricated for life. ... Karcher 2500 PSI Pressure Washer

Rockworth Powertask Pressure Washer : model no AROW4P seems to rev flat out, hav to put choke in middle to use so not to fast revs. Im sure it used to rev higher and lower according to use of lance. could it be something to do with 3 valve things if so how could i tell if ok. put clean fuel in. oil level ok.another problem is when switched on water comes straight through lance,trigger makes no diffrence. please help


... Pressure Washers

I have a Whirlpool Gold Model GU2700XTSBO its only 4 years old. About two weeks ago i noticed that the green lights were flashing and it would not run, I unpluged it for an hour and pluged it back in and the lights went away and it worked ok for the last two weeks. Last night I went to use it and there is no power at all to the washer, I checked the power source to the outlet and there is power there, so I dont know if there is a reset button or some control panel problem?


... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

What type of oil is used in a simpson power washer,the pump not the engine


... Simpson Pressure Washers

Power washer not starting what type of oil to use dpd3100


10 w 30 for engine\015\012\015\01210 w 30 and specify for [PUMP OIL]\015\012\015\012ANY AUTO STORE\015\012\015\012THANKS AND PLEASE RATE JJ505 ... Dewalt DPD3100 Gas Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1543 seconds