Having problems with your Pressure Washers ?

No spark we had a gas leakand it ran down to the coil and flywheel. The engine quit and wouldn 't restart. no spark. I replaced the coil and still no spark. the insulation on the magnet appears to be good .I need help please.


Answers :

Here are a few pointers from a former pressure pump tech. Usually no spark is caused by the low oil safety system or spark plug wire shorted. This system will prevent the engine from starting if the oil is dirty or contaminated with gas. Try disconnecting the oil sensor and the kill wire from the coil. If no joy re-install the old coil and test without oil sensor connected. The spark coil can be tested with a growler used to test armatures. Sometimes a shorting sparkplug wire can be found by pulling the starter rope in a dark room and look for sparks jumping to metal. enjoy
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No spark we had a gas leakand it ran down to the coil and flywheel. The engine quit and wouldn 't restart. no spark. I replaced the coil and still no spark. the insulation on the magnet appears to be good .I need help please.


Here are a few pointers from a former pressure pump tech. Usually no spark is caused by the low oil safety system or spark plug wire shorted. This system will prevent the engine from starting if the oil is dirty or contaminated with gas. Try disconn ... Pressure Washers

KITCHEN AID STAINLESS DISHWASHER MODEL #kuds02frssWe just replaced both springs in the door and the latch mechanism and the soap dispenser that still does not work. Our door will not stay shut. MY HUSBAND NEEDS HELP.. PLEASE HELP. HE IS VERY GOOD AT REPAIRS AND IS STUMPED!!


Hi.Your husband must check wiring harness from electronic control to door lock solenoid.The solenoid should also be tested reading Ohms with a multimeter.Here parts and diagrams: ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

Honda GC190 no start. Unit has been sitting for 2 years. Drained old gas, cleaned the carb. No go. New plug gapped to 0.030in. Still nothing. spark seems good. Cleaned the fuel strainer and there IS a bit of vacuum at the fuel pump when cranking. Poured a dab of gas into combustion chamber.. Still won't "talk to me" AT ALL. Removed valve cover and checked the valves.. within specs and nothing sticking or hanging up. Timing belt and cam looks good. Took a peak at the coil.. air gap in specs. 1ohm


... Karcher 2500 PSI Pressure Washer

Good Morning, I don't need any help except to get rid of my lg dishwasher because it is the worst dishwasher I have ever had!!! I have had it fixed once(new motor ,new soap tray,new board) and it still does not work good and still smell like it is burning up. I have not been as unhappy with anything in my life. WISH I HAD NOT HEARD OF LG AND WASTED A LOT OF MONEY!!!!!!!!!


Hi,You might be interested in this.....http://www.contacthelp.com/directory/Shopping/Electronics/LG?ListingID=386heatman101 ... LG Dishwashers

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

I have a Miele G570 dishwasher and the spinners don't appear to be turning properly. I have removed and cleaned the incoming water strainer, but still no better. The water supply pressure is the same as always. The unit goes through it's complete cycle but the dishes are still not clean. Can you help please?


Run a nice long hot "Pots and Pans" cycle every now and then.Try calling the Miele Appliance Hotline 1-800-999-1360 when your in front of the machine. ... Miele Dishwashers

Door interlock appears faulty on my whirlpool awm 321 . It wont allow program start when door closes . Needs a lot of coaxing , banging with palm of hand , knee etc .Door itself appears fine , catch looks ok , finishes and runs ok once we finaly get it started .Hve tried pressing the interlock slider in with a pencil , but cannot succeed in pushing the contacts into place and starting the program . HELP PLEASE


Only solution is to replace the interlock - it is just held in by 2 screws ... Dishwashers

Our hot water supply to the kitchen sink became disconnected and flooded the kitchen. Since then it appears that we are not getting any water INTO the dishwaher (just makes a terrible grinding sound..solenoid stuck ?? ). I did put 3 or 4 quarts of water inand it drained alright. Also tried cancelling the cycles but that hasn't helped. We also discoonected the power for a day but still no luck. Please help Ron


... Bosch SHX55M02UC Built-in Dishwasher

The dishwasher is not cleaning the dishes at all, so far I have done the following: Checked both sprayer arms and they move freely and do not appear to be clogged (I ran stiff wire thru holes in each The float is not stuck and moves up/down easily The water leavel in bottom of tub does appear to be low - so I added water filiing tub to heating coil - however this did not help and the water did not spray on lower or upper racks - this is an older model Kenmore Ultra Wash WHAT DO I NEED TO CHECK N


Heating element may have burned out. Check water temp during wash--should read between 130 to 140 F.If not the heating element,you may have to replace pump-motor assembly or wash impeller.Hope this helps. ... Kenmore Dishwashers

We have a Whirlpool Quiet Partner II Dishwasher and the Start button continously flashes off and on and we are not able to locate our manual. It appears that we need to reset the unit in order to get it working again. Please help.


There sshould be a techsheet/trouble shooter behind the lower acess panel on the d/w itself, start button flashing sounds as if it wants to start and is waiting for you to close the door. although your physically closing its possibel the door swithc ... Dishwashers

Conia CDW0305W dishwasher. Gets stuck on the cycle and has be clicked along to finish. Doesn't appear to be heating as it first sticks at a point I'd expect hot water wash and dishes come out with grease residue and still wet. I live in the middle of nowhere, to a professional will cost me a fortune. Is this the metal element and can I fix it myself? Please help, I'm sick of hand washing!!


... Dishwashers

Our 8 year old integrated 2 draw dishwasher (top draw) has a problem on the rinse cycle and constantly beeps and water at the bottom of the draw remains. I have cleaned out all the grit and stuff residual water and tried to use again. But alas there appears to be a blockage still on the rinse cycle. Can you help or do I need to get a plumber? Thanks...Louise


Sorry i lost you my breaker tripped ... Dishwashers

Model #gld5800l15cc doesn't clean dishes. doesn't seem to fill enuff before the cycle. the pump starves. for the heck of it I poured water into it manually and it worked fine. all the sparayers then had good pressure. I cleaned the inlet screen at the solenoid and its still the same. Help please!!!!!


Replace the level sensor in the tub of the washer. ... GE Dishwashers

I have an Asko D1322, about 2 years old. All is good with the washing but the dishes when it finishes are still very wet. The fan appears to be running and I'm getting a small flow of air out the vent in the bottom left of the door. Does the fan need any maintenance? I was wondering if this might improve air flow and get rid of the condensation quicker.


... Asko D1876 Dishwasher

Hi, my dishwasher zanussi de4744 still works but has no hot water, need help please.


... Zanussi 18 in. DE4744 Free-standing Dishwasher

I have been running into alot of ge /hotpoint dishwasher with a little water near the pump screen the drain hose is tied up and the check valve in the bottom back appears to be good is that normal help please customers are saying they have never seen water in it before


Hi,This is a common problem. In most of the Hotpoint dishwashers, right at the back of the tube, there is a long screen. You need to take that off. You would see the piston and the nut -it's what is causing the problem.Tap the nibs to loo ... Dishwashers

The inside of the dishwasher used to sparkle & clean the dishes very good, now the dishes look dirty & inside looks dull with a white film. I have tried cleaning filters & taking arms offs to check for blockage, making sure the Jet Dry dispenser is properly filled, the hose going to the dishwasher does not appear to be kinked, how would I check inside the dishwasher to see if it's kinked there? Do you have any other suggestions? please help!!!!


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Bosch 23 in. SHU33A Built-In Dishwasher

I have a Kenmore dishwasher model # 665.16512202, The handle or latch is slack and it will not close. I've looked at diagrams and all the parts seem in tact but when I place the latch/handle assembly back together it still will not close. I need help please.


Have you checked the latch as well. Make sure the lever lines up with the latch and seats deep enough. No obstructions at the lower hinges as well. ... Dishwashers

Good morning, I have 01 Hobart dishwasher AM14, i need to be replace rinse sensor probe and temperature sensor for booster heater.But I can't to find Hobart part number Please help me.Thank you.


294692 for the rinse probe.\015\012"temperature sensor for booster heater"? Do you mean the thermostat? If so, part number is 274161.\015\012\015\012Parts breakdowns and part numbers are available at ... Hobart AM14C-155 Dishwasher

I have a Baldor 6000W generator with a gx340 11hp engine. I have drained the tank and carb and put new gas and sea foam in it. Also I have replaced the spark plug and fuel filter. The engine will start/run as long a I spray starting fluid in the carb. But it will not continue to run without it. Also I just checked the oil level and that is good. Please help!!!


It sounds like the engine is not getting enough fuel for it to run. First check that you have the fuel tap in the on position. If the fuel tap is on then the carby might be blocked or the needle & seat are not working properly. Turn the ... Honda 8 HP Engine

11 hp honda pressure washer engine won't start. No spark at the pkug, bought a new coil and still no spark. This sysem only has a coil off the fly wheel and the spark plug. I even changed spark plug. Use the unit the other day, shut it down and on restart it won't start. Also, I disconnected the kill switch and the il lvel sensor so nothing was going to ground.


If you replaced the coil,check the wire and boot,check with meter for continuity.could be loose connection to spark plug ... Honda Pressure Washer PSI 3000

Please help me, I need help urgent. I brought my F-22 Jet Tech in March 2008 for my restaurant. The machine was fine, but got electrical problem, which is very serious, ELECTRIC SHOCK. We cant use it,since we cant touch it. This just happen 3 days ago, I called the prof electrician, but he has no knowledge of the machine, so, he didn't want to even touch it. Please help. URGENT. Thanks Ellen Fiske ph. 347-835-8701 Honeys thai pavilion address : 3036 westchester ave, bronx, ny 10461 email


YOur best bet is still the electrician.\015\012\015\012However, I would get him to go through the electric diagrams contained in this website. Scroll down to the F-22 mode ... Jet Tech Systems 24 in. 737 Free-standing Dishwasher

I need help with trying to keep a roof over my head,so my landlord does not throw me into the street.I need legal advice. can anyone please help me


Different states have different laws on eviction. An eviction takes longer if you have children. Maybe you should tell the state you live and other pertient information. ... Dishwashers

Manual Needed can i get help? i need a manaul 4 swan swd001 please help


... Equator 20 in. CD 400 Compact Dishwasher

I have proplem start the engine i check the spark from the coil to sparkply and i find out no spark so i order the coil and i steal have a problem , the kill switch is working ok. Thanks for any help Demetrios


Have you put a new sparkplug in. Also check that the oil level is full. If still no go, check the spacing between the coil and flywheel. ... Honda 8 HP Engine
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1514 seconds