Having problems with your Admiral 24 in. DDB1501AWW Free-Standing Dishwasher ?

When opening the door the door latch sticks. you have to push and tug several times for the door latch to release.


Answers :

Repair Help & Product Troubleshooting for Admiral 24 in. DDB1501AWW Free-Standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When opening the door the door latch sticks. you have to push and tug several times for the door latch to release.


... Admiral 24 in. DDB1501AWW Free-Standing Dishwasher

I have a Jenn Air JDB 4000 AWB that is seven years old. I have had several problems with this unit during that time. Yesterday when I tried to open the door the "push handle" stuck in the depressed position inside the front door panel and will not release. The front door is locked shut. I have not tried to force anything (yet). How can I get the door open?


... Jenn-Air Dishwashers

The release clasp on the front of the dishwasher seems to be broken. It does not click correctly when I attempt to open the door and seems "free". For a few times, it seemed like it was hard to open but no one used a lot of force, we just tried several times and then it would open. Can this be a part I can replace myself or do I need to call a repairman?


... Maytag Dishwashers

My dishwasher clean light keeps flashing ... turned the braker off, open and closed the door several times, as well as the soap holder, moved the latch where the door closes ... not sure what else to do ... what else can I try?


The reset sequence used was reported to be the following:1) Crack the door open.2) Within 3 seconds press the following sequence - Hi Temp Scrub, Energy Saver Dry, Hi Temp Scrub, Energy Saver Dry3) Close and latch the door4) P ... Whirlpool GU2400XTP Built-in Dishwasher

Detergent dispenser will not stay shut so the soap power falls out before washing starts. Last time use I opened the door by mistake part way through the cycle. Could this have messed up the latch release mechanism? Thanks, slice10sheep


Opening the door did not affect the latch on the dispenser. The catch does wear out and can be replaced. This involves disassembling the door and a small jigsaw puzzle of springs and levers. If you are attempting I would advise taking pictures to ref ... Kenmore Dishwashers

Have a Bosch shy56a05uc dishwasher that suddenly stopped working to a point. I believe it is related to the door latch switch, because I don't feel the door securely latch shut when I close it, and I also don't get any cycle lights or times registered on the LED readout. If I depress the on switch, the drain pump will start even with the door open, and, depending on how long I leave the switch on, water will start to fill in the dishwasher, open or not.


Does your dishwasher electronic control or mechanical timer? if mechanical timer, I encounter a similar problem n change the mechanical timer. that problem solved.\015\012\015\012Prince P ... Dishwashers

My soap cap remains in the closed position at all times. The clasp mechanism works fine, if I cycle through with the door open I can see and hear the catch release when it should. But the door remains closed at all times. I leave it open to run, and sometimes it's closed when the wash cycle finishes! Is there an easy way to take the cap off and clean it? Or do I need to WD-40 around it?


There is a little spring in there that flips the door open, just take the screws off of the side of the door, you'll see the broken spring by the door, make sure power is off to dishwasher ... GE Nautilus 24" Built-in Dishwasher

GE Nautilus My dishwasher is approx. 6 years old. It has recently started having this problem. On the second cycle (the one where the little door inside opens and release the soap) does not want to work right. The door will open, but it is like there is no water spraying to spread it out. The soap (I've tried both liquid and powder) sticks and drys, running down the door and in the bottom of the tray. I have to open the machine and add the soap to the bottom of the machine if I want to get my di


Smoking from GE (Model:gsd3725f00bb) dishwasherWe moved in an old house, the dishwasher had been installed. but today we found smoking from the dishwasher and smells burned plastic. Could you have any resolution for me? or this problem is popul ... GE Nautilus 24" Built-in Dishwasher

Door latch I have this model and the door latch is not working....have hard time opening it now. How do you remove the tope part of the door that contains that latch so I can put in back in place????


The latch is fairly simple to replace. There are several screws around the inside of the door that hold the inside panel in place. You then will be able to slide the panel out of the way (it is attached by wires).You will then be able to ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

Tecnik DW2677 Hi, my dishwasher regularly starts to bleep after starting a wash program. When the door is opened it stops bleeping and the right hand light flashes 7 times repeatedly in sequence. By holding down the start and program change buttons together for a few seconds, it will reset. If you then close the door all is well for a few seconds the pump sound like it expells some water and then it starts to bleep again. The above process can happen several times before it decides to do what it


Check your water intake- i had the same issue - a leaky fitting wasn't supplying enough water to the dishwasher. had exactly the same symptoms you describe. fixed the leak, reset the dishwasher & it's working fine.\015\012\015\012\015\012\0 ... Tecnik TDW2677 Built-in Dishwasher

Detergent dispenser door Whirlpool DU7400 won't open. I tested 300109 ACTUATOR resistance and it is closed. I ran washer and saw the actuator receives a current several times during the complete wash cycle. How else can I test? I notice the lever on the Acutator is quite floppy. Should it be stiff? Also the dispenser door does pop open if pushed from behind so that seems OK? Does anyone have the actual testing procedure for this problem? Thanks for anyone's help!


... Whirlpool 300109 ACTUATOR

Frigidaire dishwasher won't end cycle - will run on and on for hours. Sometimes it cycles through, usually it just endlessly washes and rinses. I have to CANCEL the cycle, which causes the dishwasher to empty and run a few RINSE ONLY cycles (which are consistent, cycle time wise) to rinse the soap off of the dishes. Also, the door for the soap seems to stick - how long into the cycle before the soap door should open? Also, does opening the washer during it's cycle (to add more dishes) change or


I would say the resettable thermostat has failed. There is a thermostat which senses the water temperature, and when it fails, it causes the dishwasher to run constant. Replace the thermostat underneath the dishwasher and that should cure problem. P ... Frigidaire 24 in. FDBB540 Built-in Dishwasher

Our Whirlpool dishwasher is two years old and using the same dishwasher and glass cleaning fluid since we installed the unit we are now getting soapy suds in the washer when we open the door. The installer told us to put cooking fluid in several times and run the machine on "rinse". We did this several time and we are still getting suds. Frank Hill 508-879-7425


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure ... Whirlpool Dishwashers

Detergent door latch sticks closed not releasing the detergent


... Danby 17 in. DDW1802W Designer Series Built-in Dishwasher

The control panel on my Maytag MDBH970AW is unresponsive, and the latch is stuck in the "open" position (the plastic piece stays pushed in to the handle and won't come down). I've checked that the unit is getting power from the house. Last time I had this exact problem (when it was under warranty), they had to replace the control panel, the latch, and it seemed like most of the door. What should I do?


... Maytag 24 in. MDBH970AWS Built-in Dishwasher

I purchased a new dishwasher on 2/22/07 at the Home Depot in Parksburg,Pa. I first had to have it repaired on 4/28/08 for wires stuck to inner door. They repaired two broken wires and added insulation so wires do not stick to the door. The second repair was a little more than two months later. On 7/18/08 they had to install a new motor because the motor locked up. Both times I waited several weeks due to not having money and appliance center being busy. I used J.B Zimmerman in Blue Ball,P


Hel1Dav2,\015\012\015\012I understand your frustration with having to deal with major repairs to a new applaince. However, I don't belive this is the correct forum that you need to use. I have found a helpful link that you may try in th ... Dishwashers

I have a Frigidaire FDB2410LDC3 Dishwasher. It was working great until my 5 year old fell on the door and it does not spring back up now. I tried looking with a flashlight in the sides and the springs may be OK. What is most mystifying about this is something has gone wrong with the part your hand uses to close and open it. The latch is limp so I wonder if there was some other spring in there that broke in the incident. Now after some time of forcing it to shut (due to that pesky latch that


Prhandle and latch.obably sprung the hinges. The reason it dont want to work right is the door latch is not latching properly and therefore it wont start. I would start by replacing the hinges and springs and the ... Dishwashers

Maytag 300 Quiet Series Dishwasher - release latch to open/close door is pushed up into "compartment" and stuck; dishwasher door will not open


Hi, I have the same exact Dishwasher, and I totally understand when you decribe the handle is stuck in the up position. When I opened mine and looked at the mechanism from the inside, there is a torsion spring that allows the lock to activate when th ... Maytag Dishwashers

No matter which cycle selection in pushed, the dishwasher only starts up in the "normal" 93 min cycle. If I try other cycle options, and persist, I get an ER message and the cycle stops prior to the soap powder door opening and never completes the cycle. Only with turning off power for several minutes and receiving the PF message, and resetting ONE TIME that message can I then select any cycle, at which time the machine "defaults" to the "normal" full cycle. If I do not disturb that cycle, it wi


Looks like you are having a good deal of problems with the dishwasher.\015\012\015\012It will be helpful if you provide the make and model no. of the dishwasher.\015\012\015\012At this stage I can speculate the controller (ass ... Dishwashers

PDW8100 Dishwasher went through cycle several times, but I am unable to open the door. Is there a way to get it open? Thanks, Barbara


Hi,\015\012\015\012\015\012\015\012\015\012When your dishwasher door has a problem, check these:Latch ... GE Dishwashers

Since purchasing my dishwasher last year I've constantly had intermittent problems regarding the detergent dispenser. It often does not open and therefore does not release the detergent into the wash...the detergent gets damp inside the dispenser and sticks....it often tumbles out when I open the dishwasher door at the end of the cycle.


I would replace the control board. Since the problem is intermittent this would indicate that the controller is not consistently sending voltage to the dispenser to open. ... Whirlpool GU2300XTSS Stainless Steel 24 in Builtin Dishwasher

Maytag built in dishwasher quiet series 200. Door closed and latch won't release to open door.


Insert flat head screwdriver in side of handle and pry out or use dinner knife(butter knife) ... Dishwashers

Kitchenaid dishwasher model kuds01fl door pops open - it appears the latch is not keeping it closed while the diswasher is operating. We push and hold it closed and it stays for a time and then pops open again - any ideas on how to fix it?? Thanks,


... KitchenAid Dishwashers

Kitchenaide dishwasher door won't open. Ran it 3 nights ago and it is holding my dishes captive. Can't open to get model # the latch is floppy and won't release. It's about 12 yrs. old. HELP!


Hello antpitypat.... When this happens, the only way to open it is to use a butter knife and gently move the latch as you pull on the latch. With a little patience and maneuvering of that floppy latch it will open. Once you do get it opened up use ... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1360 seconds