Having problems with your AEG 23 in. Favorit 44070Vi Built-in Dishwasher ?

I have a aeg 43070 vi dishwasher It keeps tripping the circit breaker on the house fuse box . I have reset the leak cutout by dipping the dishwasher back and stopped the warning sound,but went for about a minute and then trip the electrics again . any ideas whats wrong ?


Answers :

I assume you are refering to the earth leakage circuit breaker. This trips when a earth leak fault has occured. The normal cause for this could be
\015\012A) Water leaking via a pipe at the bottom comming in contact with one of the electric motors at the base of the washer.
\015\012B) A heating element has gone faulty with a electrical leak to earth.
\015\012You need to test this with a multimeter on the OHMS scale and rectify any short to earth that the meter would indicate.
Repair Help & Product Troubleshooting for AEG 23 in. Favorit 44070Vi Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a aeg 43070 vi dishwasher It keeps tripping the circit breaker on the house fuse box . I have reset the leak cutout by dipping the dishwasher back and stopped the warning sound,but went for about a minute and then trip the electrics again . any ideas whats wrong ?


I assume you are refering to the earth leakage circuit breaker. This trips when a earth leak fault has occured. The normal cause for this could be\015\012A) Water leaking via a pipe at the bottom comming in contact with one of the electric moto ... AEG 23 in. Favorit 44070Vi Built-in Dishwasher

My baumatic bfd62w dishwasher starts off ok then trips the fuses on the main electric circuit. Moving the cycle on it does the same thing after a couple of minutes, whats causing this please?


... Danby DDW497W 22 in. Countertop Dishwasher

I have a GE Quiet Power 3 dishwasher that was working fine last week. Over the weekend I ran it and we could hear a banging noise, so my boyfriend opened it three or four times in a row (during the cycle) to figure out what it was. The fourth time, it went dead. I checked and it had tripped the breaker. I reset the breaker and the dishwasher seemed to be working again, however the lights on the front were flashing (they hadn't previously), and now it will run for about 10 minutes but no water ru


Were you able to figure this out? We have the same problem here! ... Maytag Dishwasher

Does the KUDLO3FVSS2 dishwasher have a reset button? The electricity went off and then came back on in a minute. The dish washer does not work now. It's like its not getting any electricity. Its 1 year and 1 month old.


... KitchenAid Dishwashers

No Power Hi Timon90, I used the dishwasher like normal yesterday today I went to use it and there is no power at all. I have checked our electricity box and none of the switches are tripped. I have put the door in as hard as I can and have checked whether the electricity plug has been pulled out by accident. Can you suggest anything or should I call a serviceman. Thanks from Julie


Remove the door skin dont forget the two screws under the door in the middle,the control panel will lift off remove the power board(unclicks)remove the plastic case and see if its blown.But first also remove the lower kick plate at the front and chec ... Asko 24 in. D3350 Dishwasher

Bosch SHY66C My Bosch dishwasher won't fill with water.  All electrical connections are fine and I can hear it make a sound as if it is trying to start about every 2 minutes.  There was water in the bottom so I used a shop vac and pulled it all out but it still won't start and is doing the same thing.  I checked the solenoid with a multi-meter and it appears to be working.  My power went out last night for about two hours and that's all I can think of that might have affected it.  The dishwasher


I'm a novice on this question, but i agree with the above statement about check the stuck float switch or check for a bad safety switch or lockout switch of some sort. I would suspect something is definately faulty in that area. Will the dishwasher r ... Dishwashers

Hi my Servis M4905 Dishwasher has stopped working properly, when you set the programme and close the door it seems to start its cycle but after a few minutes it stops all the lights come on except the first one which flashes on and off. The other day it tripped the electric. Do you think it may be the module which has gone faulty


... Servis Dishwashers

We have an Hotpoint FDW70 Dishwasher that for some time has had an A10 fault which although stops the machine some times 70% of the time it does a full cycle. However it is now tripping out the electric at the mains. It is not RCD protected, but does not blow it's own 13amp fuse or that of the fused extention lead it is pluged in to. Tends to blow after about 5 minutes. I know about the fault code A10 being 'Fill Valve Triac' but as not an engineer what is that? and what parts are needed and or


Hi the fill valve triac is the plastic vlave that the inlet hose connects to you can get them for about £10 you reset the machine after replacing it by switching it on, pressing the power button leaving it off for about a minute then switching ... Dishwashers

Hello, We have a combination oven and dishwasher. Last week I filled up the dishwasher and after about 5 minutes a blue spark came out at the bottom and it cut the electricity off. Once the electricity was restored we started it again and after a few minutes it just stopped after filling up with water. It blew a fuse again but only one fuse this time and now doesn't switch on anymore. We have emptied all the water from the dishwasher and checked the filter, etc and wonder what could have gone wr


Hi, I contacted the Rosieres web site in France and sent a message using the link Contact Us. Here is the reply;Dear xxxxx,we advice you to contact:TELE MENAGER VIDEO SERVICE21 rue georges Doublet0610 ... Dishwashers

IDL750 - Fuse trips when turned on. HELP! We had some electricians here to install a new electrical socket for a new fridge. They put the new socket in the same wiring as for my existing dishwasher!! The first time I tried to start the dishwasher cycle with the new fridge plugged in, the circuit box fuse tripped. Now, even with the fridge turned off, the dishwasher makes the fuse trip when turned on. Is there a fuse inside the dishwasher that has blown and needs to be replaced? or a ground brea


Hi.The first step is understanding if the problem is the socket or the appliance. Find an extension long enough to reach a different socket. Move the appliance to reach the power cord, and connect the dishwasher to a different power sock ... Indesit 24 in. IDL700 Built-In Dishwasher

I have a Bosch she44c dishwasher that I used just this morning. This afternoon I went to turn it on and a fuse in the panel box tripped. Is there something in the dishwasher that could go bad that quickly or is it most likely something else? Every time I reset the fuse and turned on the dishwasher, it tripped again. Leaving the dishwasher off, it doesn't trip.


Hi,\015\012\015\012In some cases, the heat element lining wears out and the element shorts out to the chasis of the dishwahser, thus tripping your fuse.\015\012\015\012In other cases, the dishwaser leaks water, and shorts out ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Leaking FDW60 I have a Hotpoint FDW60 dishwasher. yesterday it tripped our house electrics and then we had water flooding out of the dishwasher. Through a process of elimination I have now discovered that water is leaking from the drainage sump in the centre of the babse down onto the motor or other electrics. I have looked for loose hoses and there are none visible from the base of the dishwasher, can you give some ideas where the water might be coming from?


Had a similar problem when I removed the lower spray arm for replacement (see http://www.fixya.com/support/t234402-fdw60_dishwasher ) and didn't put the centre retai ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Dishwasher issues hotpoint dishwasher model HDA1200 used for a year and put into storage for a year. reinstalled this weekend. dishwasher was fussy about the door latch for a minute...door latch did not want to engage all the way...but went into its cycle. we stopped it and added a few dishes for a test run it started right up and ran about 8 minutes and shut itself down. it will not restart. the power supply is ok. no leakage about the door once latch engaged. what can we do?


It can be the 10A fuse located in the back of the machine. but.... storage is kind of a problem with determining what is wrong with it.\015\012Mouse can have chewed the wires, moisture can have rusted or corroded some components.\015\012C ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

We had an electrical surge that knock out some of my appliances. I went to the electrical box and reset all the circuit breakers. Everything worked again except my kenmore dishwasher model 22-16533. I am told there is a combination of buttons you push to reset the dishwasher, but I don't know the code. help!


Hi pedelz,First please check if your dishwasher is receiving power from the outlet.You can reset the control by pressing these buttons in this order\015\012fairly quickly: HEATED DRY - NORMAL WASH - HEATED DRY - NO ... Dishwashers

Fdw60 dishwasher yet again my dishwasher has broken again, now it is trippin my electric in the house, the problem that was starting up was a eco light flashing i read on here what to do and that seemed to of fixed it, but since i did that it starts up and as soon as water starts to enter it trips my electric and advice would be great


Hold the start key down and it should re-set . Please Rate This ! Thanx!! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

When we switch the dishwasher on it trips the electricity. It's worked fine for 2 years but now won't work at all and just trips the electricity.


Your dishwasher has a serious electrical safety fault which is causing the protective breaker to trip (although it may have a simple and cheap cause). With all due respect, your question clearly demonstrates that you lack the knowledge and skills to ... Beko Dishwashers

SHE4AM15UC/05 dishwasher will not start When I turn on light for regular wash lights up but will not start after I push start button. When I turned it on the rinse agent light was on, I added some and that light is no longer on but after several tries it will no start. Electricity went out yesterday but dishwasher was no on when it went out..


... Bosch SHE4AM15SS Stainless Steel 24 in. Dishwasher

DISHWASHER STOPPING I HAVE A WHIRLPOOL ADG 7560/01 DISHWASHER. AFTER 4-5 MINUTES IT STOPS AND HAS A CONTINUOUS BEEPING AND THE START LIGHT FLASHES 4 TIMES THEN A PAUSE etc. I HAVE CLEANED THE FILTER LIFTED THE MESH AND CLEANED THE BOWL OF ANY DEBRIS AND WATER. I HAVE ISOLATED IT FROM THE ELECTRIC SOURCE LEFT IT FOR 10 MINUTES AND STARTED IT AGAIN TO FIND IT DOES THE SAME . LOST IS THE WORD THAT SPRING TO MIND. HELP!! MARTIN


... Dishwashers

My dishwasher tripps out when it is plugged in, how can it be resolved? ----- when i plug the dishwasher into the socket, it cuts the power supply to some electrical points around the house. It trips out a switch in the electrical terminal box, what can i do about this?


There is a shorted component in the dishwasher that must be found and repaired. Requires hands on troubleshooting.Eric ... Dishwashers

Creda dishwasher had filled with water but then tripped the electric unable to switch it back on as it continually trips electric


... Creda 24 in. DWI34 Built-in Dishwasher

Neff dishwasher trips the electricity


It could be faulty wireing in the dishwasher connection or you could have a leak in the washer causing the wires to get wet. I would have an electrician have a look at it. ... Neff 24 in. S5456 Built-in Dishwasher

My dishwasher stays stuck on '1 minute', and will not complete the ccycle or drain the water. I tried to do another cycle on it, and it went to 8 minutes, and then jumped backl to 13 minutes, and repeated that pattern until I finally just opened it to stop it. I had one visit from a repairman last week, who said it could be a number of possibilities, and he charged me $75 and said he would return in a few days when he was not so busy. I am fairly handy, and if I knew exactly what part to replac


Make sure that the drain spigot is not blocked under the sink. Water has to pump out OK.\012Then the most likely fault is the release valve at the bottom of the heat exchanger. It jams because the plunger corrodes. To see to this you will need a comp ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Trip switch My Dishwasher keeps tripping my trip switch in the electric box everytime i turn it on


Is the dishwasher on its own circut breaker if so whats the size ... Hotpoint 23 in. BFI62 Built-in Dishwasher

Got a Indesit Di620 Dishwasher that trips RCD after power up & immediateley as you shut door.Fault is definately related to pressure switch, disconnected pipe to switch and then able to start cycle, without tripping, small amount of water out of pipe,but cycle only lasts for a few minutes, then stops. ( blowing into pressure switch trips rcd )How can i test switch, or is it a water level problem ??Any help would be good, thanks S.C


... Dishwashers

Dishwasher trips the electric when the door is closed


... Zanussi 24 in. ZSF6150 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2275 seconds