Having problems with your AEG 24 in. Favorit 80820 Free-standing Dishwasher ?
C3 code (anti-flood sytem triggered). No obvious leaks, nor has M/C been moved from position/disturbed since installation @ 7 years ago
Repair Help & Product Troubleshooting for AEG 24 in. Favorit 80820 Free-standing Dishwasher
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
C3 code (anti-flood sytem triggered). No obvious leaks, nor has M/C been moved from position/disturbed since installation @ 7 years ago
... AEG 24 in. Favorit 80820 Free-standing Dishwasher
I have an LDS5811 and I just started getting an IE error. The manual says its a water inlet problem. I have not moved the unit since installing 3 years ago and have not disturbed the water supply. I checked the inlet tube and all appears OK. Any other suggestions?
I have had this error occur often due to faulty flow meter -remove left hand side panel, there is a large plastic component with three wires(red, white, black), these wires go up and connect onto main control board. Check these three thin wires for b ... LG Dishwashers
Dirty dishes Pump went on this machine about 6 months ago. Since the install of the new pump the dishes do not come clean. Particles finely ground or tomato seeds, sesame seeds etc. get blasted back on the dishes in the final rinse cycle. Repair guy has no clue... could there be a pinched line upon install that won't allow complete drainage, or the wrong pump? Is ther filter screen? I have done the vinegar reoutine plus a purchased cleaner to no avail. The machine is a bout 13 years old. Thank y
... KitchenAid Dishwashers
My KitchenAid MOO-KUDIO11LBL6, was installed about 3 or 4 years ago. It's been working great twice a week on average and then quit. The lock light does not go on nor do others. I am packing to move and don't have manual handy. What do to?
Hi,\015\012If your dishwasher doesn't work at all, check these:Power from the house ... KitchenAid Dishwashers
Hello expert, We are having a new kitchen floor laid and the contractor moved the Whirlpool dishwasher out to lay the floor under. Since it was replaced into it's normal under the counter spot, green "clean" light flashing in succession with a brief stop then starts again. Not really bothered as long as it worked, but of course it doesn't work - What do you suggest?? P.S. Had a problem app. 2 years ago when someone backed into the control panel, also ceased working and repairman charged ex
Someone grabbed the control panel and knocked it around or flexed it whist moving it in and out of your counter.\015\012\015\012Either the PCB board behind the little buttons flexed and cracked, or the ribbon cable that connects the PCB b ... Dishwashers
I have a JennAire jdb1090aws dishwasher. It's about 4 years old. The symptom is no water flowing through dishwasher. Approx 3 months after installation, the same symptom occurred. Tech resolved with float switch adjustment (no charge). Has run fine every since. I have not checked water supply, but doubt this is the problem (new water heater 3 months ago, sediment gone). I suspect the float switch is bad or out of adjustment. How do I trouble shoot float switch in dishwasher? Connect ohm mete
Hi,The procedure to test the float switch :-http://www.partselect.com/dishwasher+test-float-switch+repair.htmMost for no water entering the dishwasher, there are 2 main causes. One is the float switch and the other ... Jenn-Air 24 in. JDB1100AW Built-in Dishwasher
Dishwasher - The dishes and glasses do not come out clean. There is approx 2 inches of soapy/dirty water that remains at the bottom of the dishwasher. I was told by the sales people that this was normal in order to keep the ... moist. I have since leared that this is not normal. The washer was purchased approx 1 1/2 years ago and was installed last January. Problem has always existed. I have replaced the Drain Pump because when I spoke to someone at GE that was thought to be the problem. NO
Your problem is to removed the clogged into the drain.. I'll post back again and post here the steps to removed the clog..Thanks ... Dishwashers
I recently had the e4 error code on my new world dw60 dishwasher. I have since opened it up and replaced the heater element, which appears to have resolved that issue. However, in the process of doing this I incorrectly installed the flood switch back into place, meaning that it was in its closed position (i.e. the position it would be when activated by a flooded base) when I went to turn the dishwasher back on. I have since opened it back up and correctly installed the flood switch, but I ca
... Stoves 27 in. DW60 Built-in Dishwasher
Newdishwasher installed October. Seems to be making "put putting sounds" clicking noises. Programme just not moving on. Filters clean. Shouldnt be kinks anywhere, as the machine has worked great since installation, and hasnt been moved atall.. Machine is AEG Favorit 35020 V1
... AEG Dishwashers
Dishwasher is 8yrs old. We have lived in our home for the last three years and for the past 2 1/2 has given us great service. Now for thew past 3-4 months our dishes and untinsails have a heavy residue on them at the end of a completed cycle. We have had a new piston assy , timer, and rinse aid dispenser install. We have tried advertised cleansers to no avail. Since the last two items have been installed, we have tried twice to no avail.
Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... GE Nautilus 24" Built-in Dishwasher
The dishes are wet when the cycle is finished and the dishwasher smells sour. This dishwasher was installed 4 days ago and this has been happeningt since installation.
Call the store that you bought it from and speak to the manager. Have him send a different person out to check this out. Your heated dry button is either not depressed or the heater is out but the foul smell is not acceptable. The best of luck to you ... Dishwashers
I own a Bosch dishwasher. It is about 5 years old. In the last year I have noticed that is isn't cleaning well and that there is a white residue on all the dishes and especially on the inside of the dishwasher. I poured a whole gallon of white vinegar into the dishwasher about a month ago and let it run the whole cycle without dishes. Since then the white residue has deminished, but now the dishes are not clean when I run the dishwasher. I notice the white residue mostly on the silverware w
\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 ... Dishwashers
Dishes have a chalky white residue after cleaning, especially on aluminum pots. This model was installed a little less than a year ago and the residue started appearing a few weeks ago.
Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... KitchenAid KUDC03IVWH Builtin Dishwasher
Just had a Bosch dishwasher installed in my new kitchen. The plumber who installed it ran it and it worked. Now we cannot get it to run. We have tried everything. Restarted several times, turned the circuit breaker off and on, changed the cycle and nothing works. The light comes on but it does not get water or run. What are we doing wrong. The dishwasher is brand new out of box but we bought it 4 years ago and remodeling was delayed. Model #SHU5314UC/U06 FD#8001
Test the door switch. It can be faulty or misaligned. You can also check the back of the unit and/or remove the rear panel and take a look at the thermal fuse. It may be bad not allowing enough current flow to operate the machine. ... Bosch SHU5316UC Dishwasher
I have mold in my dishwasher. This happened about 6 mos ago and I used the vinegar and scrub method to get rid of it...it was a pain in the fanny! Now the mold is back...the dishwasher has also not been drying the dishes very well either, although in truth it never has. There must be some other reason that the mold is back! Oh, and I've used Jet Dry since I bought the machine 7 years ago, and have tried the ''leave the door open to dry the dishes'' .... any thoughts?
Get rid of the mold - Pour about 2 cups of bleach in the dishwasher with about 1 cup of salt, and a gallon of cold water, use the light wash, not heated. Make sure when you start the cycle it doesn't drain first or you lose the bleach. Also I don't ... Dishwashers
Bosch dishwasher, Model SMU 7056, UC 09, FD 7309. My older unit has operated flawlessly for years. Two days ago it started to "stall" in one cycle and not progress to the next, e.g., stayed in the wash cycle and would not move on to rinse. In addition the heat generated in the machine was way below normal. A repairman told me that if the water doesn't get hot enough, the unit will not move on to the next cycle. I always use the "Regular Wash" option, but tried other options such as 'Economy
... Bosch Dishwashers
Our Whirlpool dishwasher is two years old and using the same dishwasher and glass cleaning fluid since we installed the unit we are now getting soapy suds in the washer when we open the door. The installer told us to put cooking fluid in several times and run the machine on "rinse". We did this several time and we are still getting suds. Frank Hill 508-879-7425
Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure ... Whirlpool Dishwashers
Just had a Bosch dishwasher installed in my new kitchen. The plumber who installed it ran it and it worked. Now we cannot get it to run. We have tried everything. Restarted several times, turned the circuit breaker off and on, changed the cycle and nothing works. The light comes on but it does not get water or run. What are we doing wrong. The dishwasher is brand new out of box but we bought it 4 years ago and remodeling was delayed.
Do you have the manual?What is the exact model #?Thanks~! ... Dishwashers
Water is not flowing into the dishwasher and as a consequence it overheats. In the couple of weeks prior we noticed unusual noises and taking longer to complete washing. Also since about two weeks ago dishes have had white mineral deposits and film on glasses. I suspect that the water pump is not working. I cannot find the salesslip from sears to see when we purchased the machine but I sus pect it was about 6 years ago. We are debating wther to have a service call, possibly including replac
Hi,\012Here is a tip that will help you to find out why water will not come into thedishwasher... Dishwasher Trouble No Water entering Dishwasher ... Kenmore 24 in. 16262 Built-in Dishwasher
Hello! I have a Frigidaire (made by Electrolux) Gallery Professional Series gas range/electric oven, model #FGF379WJCA (manufactured in 1998). The appliance came with the house we moved into 2 years ago. I have the owner's manual and gone through the book but can't resolve two questions. 1) One of the burners will not light. When I try to turn it on, the other three burners' electrodes will flash, but the 4th one will not. I can light the burner with a lighter, so there is gas coming throu
\012The front controll pannel lights and clock are not on. \012There is power to the unit. \012Is there a reset botton somewhere? ... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher
I have a Dewalt 3100 psi pressure washer which is hardly used since I bought it almost 2 years ago. It cannot start. It is full of gas and I have gone thru all the basic steps prior to pulling to start. it does not seems it wants to start.
... Dewalt 3800 PSI Pressure Washer
We came home from holidays a few years ago and the dishwasher (Westinghouse 905) just didn't turn on. We've tried it repeatedly since then and are unable to get it to turn on. The power point works for other appliances. Should we replace it or could someone fix it? And is it a plumber or electrician you get to fix dishwashers?
Appliances that sit without use, usually have more problems than just the original problem.\015\012\015\012In your case I would first check the power conection on the dishwasher. located under the machine\015\012\015\012If thi ... Dishwashers
My Whirlpool Quiet Partner II (model# DU1145XTPBA) was quiet when I first installed it in Nov/2007. It is only 2.5 years old and the motor has since become much louder. Any issues with this model that I'm not aware of that need attention?
... Whirlpool Dishwashers
When I push the start button on my dish washer, nothing happens. Part of the problem is, is that I never use it, but I don't want it not to work. It was like new when I moved here two years ago, but I don't have enough dishes to wash in it, so it sits all time.
A dishwasher is like a car and needs to be used once in a while. If you put your car in the garage and don't try to start it for a year, chances are, it will not start. A dishwasher should have at least some water in the pump to prevent the seals f ... GE Nautilus 24" Built-in Dishwasher
Broken dishwasher It started when my dishwasher flooded my kitchen. I drained it and turned it on, it was fine. then it happened again. I have drained it then when I went to turn it on again it just sounds like it is running with no water. If I put water into the bottom it will drain but it will not fill up. I bought this house 3 years ago I am unsure how old the dishwasher, do I need to get a new one?
I have a kenmore model 665 168 29000 the mounting bracket have broken from under the cabinet, so when you open the door and pull the racks out the machine moves forward, how can i fix this????? ... Bosch 23 in. SHU33A Built-In Dishwasher