Having problems with your AEG Dishwashers ?

Flood protection system on my Oko favorit 4040 has activated. What can I do to rectify.


Answers :

Repair Help & Product Troubleshooting for AEG Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Flood protection system on my Oko favorit 4040 has activated. What can I do to rectify.


... AEG Dishwashers

Flood protection is activating


Had the same problem on a Miele mashing. In my case trying to clear a drain blockage in a kitchen sink had probably forced water back into the washing machine and caused an internal leakage. Rather than remove the whole machine and tip it over, I ope ... Zanussi 24 in. DE6850 Free-standing Dishwasher

Anti flood system triggered Favorit 40660 dishwasher


The problem was solved by opening the machine and finding that the bottom "Y" pipe that has 3 inputs is of extremely poor quality and perforates with pin holes allowing a small amount of water to squirt out. This triggers th ... AEG 24 in. Favorit 40660i Built-in Dishwasher

Aqua stop failure anti flooding system activated


... Smeg Dishwashers

Alarm AL4: protection against flooding is active...........watertap 2 contact service centre.


... Electrolux Dishwashers

How to fix fault 30 and anti flood protection device activated?


... Electrolux Dishwashers

Favorit 35085Vi - possible cause of anti flood system being triggered?


It can only be due to a leak running into the base. Suggest you remove RHSide cover and run washer.again. Inspect while running and see where leak is comming from. My guess, its the main motor. ... AEG Dishwashers

My dishwasher a favorit 65070 is showing an error code of i30. This shows the anti flood system has triggered. How do I fix this please!


... AEG Dishwashers

I have a AEG OKO_ FAVORIT 4040 dishwasher which has had very little use despite its age. The problem is that the switch that detects an over-fill is activated all the time and the pump continues to try and empty an already empty dishwasher even when the main switch is turned off, the only way to stop this is to turn it off at the power point I have had some sucess deactivating this switch by tilting the dishwasher forwards however because of the angle it sometimes overflows when filling. The ma


Hi there,This could be a problem on the control board of the unit. It could be faulty and need replacement or you may try to access the board and try to clean it.Make sure upon doing this all electrical connection to the unit ... Dishwashers

Error code F10, flood protection activated. How to deactivate?


... Asko Dishwashers

My Favorit 50730 the top and middle fault warning lamps flashing in the multi display indicating the 'anti flood system' has been triggered, can you provide a solution please. Thank you.


... AEG 24 in. Favorit 50730W Free-standing Dishwasher

I have an AEG OKO FAVORIT 6040 dishwasher. It


... Dishwashers

AEG Favorit 86070 Vi Dishwasher anti-flood system has been triggered. I this something I can fix myself?


... AEG Dishwashers

Acquastop failure. Code E1 The anti flooding sytem has been activated. The system is tripped in case of water leaks..


... Smeg Dishwashers

Anti flood system been activated, how do i fix it ?


... AEG 24 in. Favorit 50740 Free-standing Dishwasher

Fisher-Paykel DD603 DishDrawer shows F1 fault code. The Flood Switch has been activated. I need instructions on how to re-set the flood switch. I have two drawers that are possitioned one above the other and the are both giving the error of the activated flood switch. Any advice or instruction is greatly appreciated.


Fisher-Paykel DD603 DishDrawer shows F1 fault code. The Flood Switch has been activated. I need instructions on how to re-set the flood switch. I have two drawers that are possitioned one above the other and the are both giving the error of the activ ... Dishwashers

AEG OKO_FAVORIT 6281i dishwasher - error code 20 (Siphon blocked). Out of the blue after 6 years of reliable once-a-day family use, my AEG OKO_FAVORIT 6281i dishwasher started OK but about 3 minutes into the cycle began flashing error code 20. At which point there was a litre or two of cloudy water sitting at the bottom of the machine. Since then I've tried redirecting the drain hose into a bucket, after disconnecting it from the kitchen drain. Same symptom, and no outflow except what was al


... AEG 23 in. Favorit 50750Vi Built-in Dishwasher

I have a zanussi ZSF2440 dishwasher, when it turned on by the power button on the front you can choose a cycle and start it, Once the cycle is started it fills up with water but doesn't stop until it over flows setting off the flood protection, which cuts the power, so all the lights on the display go off and stops the water flow and drains the dishwasher and keeps draining the dish washer while the flood protection is on. It seems as if the dishwasher doesn't know when its reached its correct


... Zanussi Dishwashers

AEG OKO Favorit 4020 no water flowing into spreaders to wash. Water flows out the side outlet and the element heats up but no water?


... Dishwashers

I have an AEG OKO 4040 Favorit which will not perform the main wash cycle. Water fills ok & pumps out ok. Heater element is working fine. any Idas


... Dishwashers

AEG OKO-FAVORIT 50800


C3 error means that there is water at the bottom of the dishwasher. Unplug the dishwasher, slide it forwards and push it back. So it stands on the 2 back knobs. Do this atleast at a anle of 45 degrees. You will see water flowing at the floor.\0 ... AEG Dishwashers

I recently had the e4 error code on my new world dw60 dishwasher. I have since opened it up and replaced the heater element, which appears to have resolved that issue. However, in the process of doing this I incorrectly installed the flood switch back into place, meaning that it was in its closed position (i.e. the position it would be when activated by a flooded base) when I went to turn the dishwasher back on. I have since opened it back up and correctly installed the flood switch, but I ca


... Stoves 27 in. DW60 Built-in Dishwasher

Dishwasher flooding Hi my Asko D1716 Super Cleaning System Dishwasher has started to have a flooding problem. When the cycle finished last night it seemed fine then in the morning the machine was full of water, I scooped out the water and by this evening the machine had flooded onto the kitchen floor. I tried other solutions I found on this website but they didn't suit my dishwasher as it doesn't have the appropriate buttons. Any suggestions would be appreciated!


When you say that you tried other solutions.. it's hard to know which you've tried and which you haven't so I will suggest some basics first.. ( if you've tried them, then disregard)...\015\012Have you checked or addressed the following:\ ... Asko D1716 Built-in Dishwasher

Need to know how to re-set the anti-flood device


I managed to clean the filter inside the dishwasher and drain a little residual water. I then re-plugged in the appliance and the anti-flood device seemed to reset and I have n't had any problems since. ... Dishwashers

The flood switch has been activated on my dishwasher


... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0426 seconds