Having problems with your Alfred Karcher K255 Electric Pressure Washer ?
Wont turn on , light on plug will not stay on after release of button
Most likely faulty switch. Use licensed repairman for electrical hazard.
Repair Help & Product Troubleshooting for Alfred Karcher K255 Electric Pressure Washer
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Wont turn on , light on plug will not stay on after release of button
Most likely faulty switch. Use licensed repairman for electrical hazard. ... Alfred Karcher K255 Electric Pressure Washer
Electrolux dishwasher all lights blinking and wont turn on push start button either all lights flash or normal light stays on either case the dishwasher wont run a cycle
Remove the toe kick by loosening 2 screws. There is a panel there with little lights that correspond to specific problems. The light that is on will correspond to the problem that the dishwasher has detected. Correct the problem and you should be goo ... Electrolux 24 in. EDW5500DSS Stainless Steel Built-in Dishwasher
EDW5505EPS Electrolux Dishwasher. One cycle light stays on, but the other lights will not turn on when buttons are depressed. Unit will not turn on at all. I assume the control board is bad? How difficult is it to replace the control panel? Just remove the screws holding the stainless panel on? I assume the panel simply plugs in.
Hello,\015\012Have you tried holding the cancel button down for about 15 seconds as these units can sometimes get stuck in a cycle. Try this anyway first.\015\012\015\012Hope I helped. ... Electrolux 24 in. EDW5505EPS Stainless Steel Built-in Dishwasher
Matsui MF160 integrated dishwasher: Had problems for a while now with the buttons on the control panel ie: on button needed to be pressed down hard for it to connect and sometimes the wash cycle programme buttons would just keep flashing between the three of them and then they would settle down, for the past few days the on button light has stayed on and wont go off and now all the lights on the control panel have gone off and the dishwasher wont work at all, we have tried dis-connecting it, che
Dishwasher wont let u select a cycle...all buttons seem locked...ive unplugged it for 5 seconds or so and then plugged it back in and the normal wash button light comes on and the heated dry button light comes on, but it wont start and it doesnt respond when buttons are pushed...please help. thanks
... GE GLD4560NSS Stainless Steel Built-in Dishwasher
My Delonghi Dishwasher keeps turning off. The dishwasher is turned on at the power point. The water is turned on. Okay When I press the POWER botton on the front it wont stay on. I have to keep my finger on the POWER button and then press the START button for washer to work. If I do this it will then pump out any water in the bottom and start to work. ***BUT when you take your finger of the POWER button the washer just turns off and stops working. Do you have any idea what could be the problem p
Yes, the power button is faulty. by pressing the power button forcefully, you are in effect allowing the contacts to close. Replace it. ... Dishwashers
I have the kitchenaid dishwasher model #kudv03ctss0.the clean light stay blinking and when i hit the start it just blinks and then stops but the clean light stay blinking constantly.if i hit the cancel button i hear a um noise as if it going to turn on but nothing happens and the light stays blinking. what do you think might be the issue .
Dear friend,\015\012ngfam at you service! happy to assist!\015\012It's an electronic problem!The lights are called codes and need to be diagnoed by a factory service person!!We sell appliances for 65 years an ... Dishwashers
Dishwasher wont turn on dwa73a Amana built in. I turned off circuit breaker and now there's blinking lights on the air temp and water temp. Never use these buttons. I can't get any button to work much less get it turned on.
Hi\015\012\015\012You will have to first check/test the door latch assembly,\015\012if that is fine and the door is closing properly then it means that the control\015\012board is bad and should be replaced. Hope this helps...please post ... Amana 24 in. DWA73A Built-in Dishwasher
My Frigidaire Dishwasher FDB1050RES2 gets stuck in a rinse cycle. The light on the front will be lit "clean" but the bottom of the washer is full of water. Opening the door does not turn off the "clean" light. For me to get it to run, I have to unplug it, plug it back in, push the start button until the ?washing? light comes on. I then push the start button once more and the dishwasher will begin to drain. I open the door as soon as I hear the water stop draining into the sink drain. This
By the descrition you are giving you will need to replace the main control board.Part number 154568401.you may also need to check the float switch.The part will run about 110.00 dollars from a local parts store ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher
My bosch she43f won't turn on. It has power, can turn the power button on and off, but the other 4 buttons won't release, it has the regular wash and rinse and hold are depressed. No light comes on above them. Can't push the other buttons.
... Bosch Dishwashers
REFRIGERATOR LG LFC25760SW WILL NOT TURN LIGHT OFF. AREA WHERE BULB IS OVERHEATED, MELTING PLASTIC SURROUNDING IT. HOW CAN I SOLVE THIS PROBLEM? THE DOOR EVEN WHEN HELD OPEN AND THE BUTTONS THAT TURN THE LIGHT OFF WERE PRESSED DIDN'T WORK, LIGHT STILL STAYS ON. WHAT CAN I DO?
Turn the unit off so the bulb can cool and just take it out. Sounds like there is a problem with the switch, as to the melted surround if it is part of the liner there aint nothing you can do, save patch it with fiberglass and resin. ... Dishwashers
My indesit DIF 04 dishwasher has stopped working the start button, soak button and eco wash buttons are flashing continously, the machine will not turn off I have plugged it out from the socket but once plugged back in the same lights start flashing again
ASKO dishwasher D3122 drain pump wont stop pumping and the machine wont respond when we press any of the program or start/stop buttons. the program light is flashing. We can turn the power off with the main switch on top of the door but when turning it back on the pump starts pumping again. please tell me how to fix this problem so we can get it up and running again.
... Asko D3122XLSS Stainless Steel Dishwasher
I have a Kitchen aide dishwasher Model KUDI01ILWH6 that will not turn on..there is a control lock light on and I have tried pushing the cancel button but all that happens is the control lock light flashes 3 times and the dishwasher still wont turn on....Please , how to I disengage the control lock
... KitchenAid Dishwashers
Campbell hausfeld standard duty electric pressuse washer serial 15930 water wizard .. I cannot locate the reset button and after a short while it wont turn on at all it powers off automatically. and after checking cords and plugs it wont turn on at all..
... Campbell Hausfeld 1,350 Psi Electric Pressure Washer With Auto Detail Kit #PW1350
Have whirlpool gold dishwasher made in Mexico, the control lock light stays on, when i push it and hold it just blinks three times and then stays on steady and then does the same over and over, before it did this I noticed the lights for different cycles flashing randomly, and even pushing cancel button once in a while would start the machine up....I have tried to unplug the machine and then plug back in, but nothing is helping....any ideas??
... Whirlpool Dishwashers
My electric pressure washer's motor will not start. the 110 plug has a test/reset fuse on it. when i plug it in the light comes on. i push test- it turns off but motor does not run. i push reset and the light stays on.
With the water faucet turned fully on and the power switch on squeeze and hold the trigger for at least 10 seconds to let the water flow push the air out and then it should start up. ... Campbell Hausfeld PW1750 Electric Pressure Washer
My Kitchenaid dishwasher kudr25shbt1 will turn on by itself. The child lock light stays lit along with the cancel light and can cannot be turned off by pushing the energy saver button. The machine will not operate in this condition.What part has failed .
No question about it, the electronic board needs to be replaced. Often the capacitors break down and create problems like you are experiencing. ... KitchenAid 24 in. KUDR25SH Built-in Dishwasher
My Asko D1996 Dishwasher will not start. The control panel has 3 lights staying on - position #1, 6 and 7 and are unresponsive no matter what buttons are pushed - even after turning the power off at the breaker, the outlet and the on/off button.I've tried holding down the start button for several seconds to reset but this did not work. I have also cleared the drain, filters and removed any water and pushed and held the Start button to reset.
... Asko Dishwashers
My power button cover broke on the dishwasher and I figured out the part number I needed, but when I put it back together I got the wires crossed on the board and door switch. Now the control lights up , but the dishwasher will not run a cycle. THe question is does the plug on the door switch have to be a certain way, because there are three wires and you can connect the plug both ways. I did turn the plug, but it still does not run. Did I break the switch? Bosch SHU9956uc/14
The wires do have to be a certain way on the door. Otherwise a door open can tell the board that's it shut and vice versa. The easiest way to do it, is test the switch with an ohmmeter, place the meter on the switch, push button in and see if the rea ... Bosch SHU9956 Built-in Dishwasher
We have a Beko DWD5410W dishwasher that has worked fine...until today - the 'wash' light is on but it is not wasing. I have pressed in the 'start' button and held for 5 seconds to reset and it then springs to life draining out or whatever that noise is, and then if I turn the dial to a setting (even the cold prewash) and press 'start' again it starts whirring away, then after about 10 seconds just stops, with the 'wash' light staying on. Not blocked, I have checked - this likely to be a frozen p
My dishwasher 'start" button won't kick in. The machine seems to think it isn't locked - light wont activate, but the door IS locked. I select the cycle and option, but when i push start, it won't stay, The "clean" button keeps flashing. This is 5 years old
Hi,How many Blinks are there?Is it 7 Clean Light Blinks?Let me know, so that we could proceed.Hope i helped you.Thanks for using ' Fixya ' and have a nice day!! ... Kenmore 24 in. 17032 Built-in Dishwasher
I have a GE dishwasher with front control panel and at first the wash and dry lights stayed on and it was beeping every 30 sec. when I turned the breaker off for the required 30 sec. the lights started flashing and it is still beeping. The control panel seems to be frozen as it is not working and wont do anything.. everything was working fine before this. I bought it at Home Depot on 3/14/07 and had it installed by a licened electricion. Help
Call ge @ 800-386-1215 for service ... Dishwashers
The lock on light wont go off. We can not start the dishwasher. We have tried holding the noheat option for several seconds and have turned off the circuit box for several minutes and neither one made the lock on light stay off.
That is the correct button to push to turn the control lock off. You can try to reset the control by removing power for two minutes. If the dishwasher is doing the same thing, most likely the touch pad has a shorted button or a bad connection on the ... Kenmore Dishwashers
I have a diplomat hja 8630 integrated dishwasher and it has stopped working. When I turn it on all the program lights stay on, including the 'play' light and the dishwasher wont work no matter what I do. Hope someone can help