Having problems with your Asko D1706 Built-in Dishwasher ?

ASKO D1706 This dishwasher was working well then it tripped out the fusebox and keeps on doing so. The on light is on when connected but when you shut the door it trips the fuse box on the house. The wiring looks ok, there is no water leaks in it. Any ideas


Answers :

I agree with marine0612, It depends on when it blows the fuse box.
Look at the pwr supply box on the dw check for a short to ground in the main pwr wires, otherwise the only field in the dw to trip to breaker is a mtr dead shorted to ground. if that is the case you may want to by a new dw because not to many techs enjoy working on ASKO PRODUCTS or are they certified to do so. so it maybe difficult to get a service company to even look at it and if they do and the mtr is the issue you will be looking at a expensive repair. good luck
Repair Help & Product Troubleshooting for Asko D1706 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

ASKO D1706 This dishwasher was working well then it tripped out the fusebox and keeps on doing so. The on light is on when connected but when you shut the door it trips the fuse box on the house. The wiring looks ok, there is no water leaks in it. Any ideas


I agree with marine0612, It depends on when it blows the fuse box. ... Asko D1706 Built-in Dishwasher

4 years old with light use.fills with water.house fuse blows.reset house fuse & blows every time the door is closed.have striped to a point & can run the mashine if i disconnect the red wire to the heater element.it then fills & will not move on & obviously will not heat.heater element is expensive & looks time consuming to replace. ntc,thermostat,programmer or element ? some ideas or tests please


... Neff 24 in. S5457X0GB Built-in Dishwasher

Hotpoint FDW80P dishwasher trips fuse box when the door closes and before this when it was on the dry cycle


... Hotpoint Dishwashers

I have a aeg 43070 vi dishwasher It keeps tripping the circit breaker on the house fuse box . I have reset the leak cutout by dipping the dishwasher back and stopped the warning sound,but went for about a minute and then trip the electrics again . any ideas whats wrong ?


I assume you are refering to the earth leakage circuit breaker. This trips when a earth leak fault has occured. The normal cause for this could be\015\012A) Water leaking via a pipe at the bottom comming in contact with one of the electric moto ... AEG 23 in. Favorit 44070Vi Built-in Dishwasher

My electrolux dishwasher works when the door is open but when it shuts it trips the power at the fuse box


Hello - From what you have described it sounds like the dishwasher could possibly have a shorted door switch. Contact a professional to move forward accurately. ... Electrolux Dishwashers

Hi, I have a KitchenAidDishwasher (Model KUDP01FL). It's worked well for a few years. Yesterday, when we went to turn it on, none of the lights on the buttons were on. WE can't turn it on at all. The fuse box looks fine, nothing is tripped. Any ideas?


Kill the power to the unit. Pull the control panel down to access the control board located on the right hand side of the panel. There will be 2 wires coming in to a white plastic clip on fuse located on the side of the control board. It will have a ... Dishwashers

Bosch she3ar76UC/07 In the box where the house current is connected , the load wire (white) has been hot and insulation burned. No visible damage on the back side feeding the dishwasher. Cleaned up the white re connected, have power, dishwasher will not turn on. Any ideas, is there a fuse somewhere? Thanks


... Dishwashers

Elite 665.13933K010 The touch panel is inactive. There appears to be no power to it. It has done this before twice...the first time I bumped the top of the door and the lights came on and it worked. Second time, I took it out of the cabinet, turned it upside down and examined everything looking for a loose wire or blown fuse. When I put it back together it worked. Any idea what is happening?


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

IDL750 - Fuse trips when turned on. HELP! We had some electricians here to install a new electrical socket for a new fridge. They put the new socket in the same wiring as for my existing dishwasher!! The first time I tried to start the dishwasher cycle with the new fridge plugged in, the circuit box fuse tripped. Now, even with the fridge turned off, the dishwasher makes the fuse trip when turned on. Is there a fuse inside the dishwasher that has blown and needs to be replaced? or a ground brea


Hi.The first step is understanding if the problem is the socket or the appliance. Find an extension long enough to reach a different socket. Move the appliance to reach the power cord, and connect the dishwasher to a different power sock ... Indesit 24 in. IDL700 Built-In Dishwasher

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

Bosch exxcel Last night when i turned on my dishwasher it tripped the fuses in the house. I have changed the fuse in the plug, but it continues to do it. The lights on the display flash up once and then the fuse box trips again. Not sure what else to check. Can any one give any suggestions?


The likely cause of this is a failed heater element which would cause the fuse to blow. You will need to get the heater element checked out and replaced if necessary. A visual inspection of the element may reveal the problem jf not an electrical test ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

While on vacation our house had been checked at one week later &again 2 weeks later, @ 3 weeks check, floor in front of dish washer & entire kitchen had standing water , as DW door was opened bottom of DW had water standing up to bottom of door . Water supply to house was shut off before we left. , Since we returned home we have used DW daily with no indication of where this water came from. Any ideas ? Thanks, Bob


Take a long shot. Say your mains leak a little, quite possible, and you machine's inlet solenoid valve leaks a bit, say about a litre a day - you probably would not notice it during the normal course of events, in a week it would leak a ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I just bought this house with this dishwasher built in. I have pushed the door shut, pressed the heat dry button to lock the door and pressed the start button. Nothing happens. Now I can't even get the lights on front to turn off. The lock button flashes as though the door is open, but its not as far as I can tell. I have to press the latch in to open the door. I'd like to use it... any ideas. Its a Kenmore Elite model # 665 17052 402. Thank You


... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

Hi there My Bosch Exxcel Dishwasher is tripping out the fusebox RCD and I think there is an earthing problem. It will run for 3 or 4 minutes and then the house alarm goes off and the cooker clock needs resetting! I have tried to look in the back but don't know how to remove the panels. I've tried tipping it to 45 degrees to see if there is any water in the innards but non water came out. I have no idea what to look for - and no manual to help me get inside the beast! Thanks in advance.


It will probably be the water heater element is failing and shorting out.\015\012\015\012Be careful as you do not want to electrocute yourself ! ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

Electrolux ESL 63010 dishwasher. This worked fine until the door catch broke. I replaced the catch but could not remember which way round the two electrical leads went (red and black). I tried both ways with the same result. The lights come on the control panel and I can change the programme, but on closing the door the house fuses blow. I have checked the earth cable is fine. Any ideas?


Red - is active powerblack - ground or neutral ... Electrolux Dishwashers

I have a whirlpool portable dishwasher model # dp940pwpq2. I think it stopped working in middle of cycle has standing water in bottom no power to front control unit door seems to close and latch properly, not sure if it's door switch or control s thermal fuse doesn't look bad any ideas?


... Whirlpool DP940PWSQ Free-Standing Dishwasher

Cycle interrruption Recently, about 20 minutes into the wash cycle, the unit shuts down and the lights start blinking - usually "Pots & Pans" & "Quick Rinse" simultaneously. No other buttons respond and I cannot get it to finish the cycle. Only shutting down the unit at the fuse box eliminates the lights. I've checked for blockages and nothing found. Manual does not offer any help or suggestions. Any ideas??


Relace control board. ... Kenmore 24 in. 16032 Built-in Dishwasher

Kenmore dishwasher... filled up with water and its lights went off.. no buttons work acts like no power. check the house fuse box - ok ... check the 2 door switch - ok .. checked the thermal fuse - ok ... so, i picked up a new board and changed it out. still wouldn't run.


Did you check power to the unit? Double check the common and grounds. When servicing I will disconect(unplug from wall) power to the unit. Is it pluged in? Use another outlet(the outlet under the sink may be wired thru a switch for a disposer)even ... Kenmore 24 in. 16032 Built-in Dishwasher

We went to run our dishwasher and lights are out....nothing works......house fuse fine. Been told to look for fuse box inside of dishwasher panel but cannot identify.


If the circuit breaker is good then you need to check the main power line to the unit and make sure everything is connected properly. ... KitchenAid Dishwashers

My Beko D3422 FS was washing normally and the residual current device tripped approximately half way through the cycle. I have unplugged the dishwasher and checked the plug socket with various other appliances. None have tripped the RCD. I have stripped the Dishwasher to look for any disconnected terminals or shorted wires and cannot find anything obviously burnt or any signs of shorting. The 13amp fuse in the dishwasher plug is fine. Are there any components I can test or replace which wouldgi


... Dishwashers

KitchenAid Dishwasher (KUDP01FL) - unable to remove two wires from thermal fuse box. Help


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

Leaking FDW60 I have a Hotpoint FDW60 dishwasher. yesterday it tripped our house electrics and then we had water flooding out of the dishwasher. Through a process of elimination I have now discovered that water is leaking from the drainage sump in the centre of the babse down onto the motor or other electrics. I have looked for loose hoses and there are none visible from the base of the dishwasher, can you give some ideas where the water might be coming from?


Had a similar problem when I removed the lower spray arm for replacement (see http://www.fixya.com/support/t234402-fdw60_dishwasher ) and didn't put the centre retai ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a whirlpool DU915 built in dishwasher. During the last pre wash cycle after filling with water, it suddenly stopped and the lights on tne control panel went out as it was suddenly unplugged. All connections are still intact, the breaker box to the house has been checked. The shared outlet is still working, as the garbage disposal still operates normally. The latch on the door appears to be functioning. Can you please give me a direction to look?


... Dishwashers

I have a Neff S544X2gb/17 dishwasher which seems to be dead i.e no programme lights on. Have checked fuse in plug, dishwasher on/off switch which has live going to it and out, interferance filter is ok as is wiring harness in door panel. When you first switch on, for a split second you can hear a noise coming from the aquastop valve. Any ideas?


... Neff Dishwashers

The handle on the dishwasher is broken and the door doesn't shut all the way. I removed the screws to look inside and there are wires that go into this component that is connected to the handle. Is this something I can fix? How would I find the parts.


... Amana 24 in. ADB2500AW Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1413 seconds