Having problems with your Asko D1716 Built-in Dishwasher ?

Asko Performer 1353-1 - is this a 120 or 220 system?

\015 Serial # 9420 80545. I was given this dishwasher. It was previously wired directly into juction box. Three large gauge wires in non-metalic sheathing plus another ground wire. I took the dishwasher to an appliance repair shop to have a plug in power cable put in and they thought from looking at the wires that it's a 220 system. The installation manuel I was given with the dishwasher says its 120 and there are two diagrams - alternative one for a power supply cord and alternative 2 for conduit. I believe its now set up for alt. 2 and I want to do alt 1 - providing its 120. I'm thinking perhaps this is set up to have a ground as part of the power supply cord and and independent ground?\015\012Thanks\015\012Pete Parmenter\015

Answers :

Repair Help & Product Troubleshooting for Asko D1716 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Asko Performer 1353-1 - is this a 120 or 220 system?


... Asko D1716 Built-in Dishwasher

I have a Hotpoint Dishwasher model no BFV620,hope anyone can help,the problem is 1(listed as pre wash) and 2(listed as wash) flashes rapidly when system starts to drain ,and the system does not drain completly ,still dirty water in bottom of the dishwasher,checked instruction manual and this lists any other forms of lights flashing but not the 2 mentioned,any advice would be greatly appreciated


... Hotpoint 23 in. BFV62 Built-in Dishwasher

Replaced control board 447325 in bosch SHU66C05UC/23; FD860300407. What code to select 0,1,2,3,4?


... Dishwashers

Ref: NEFF Dishwasher S5555XOGB/70 (FD No. 8602) Problem: Does not drain at end of wash cycle. Checks/Symptoms: 1. No blockage in whole of drainage system, system and filters are clean. 2. Pump does operate mid wash cycle ? drainage tube can be felt pulsing and pipe gets warm right through to the main drain connection at the ?U? bend. 3. At end of wash cycle the pump appears to still be trying to run but there is no flow, even when the door is opened. If machine is emptied by hand the pum


... Dishwashers

Even after ensuring that really hot water is coming from the faucet and placing the unit on the Delicate/Econo setting we consistently get a 2 HR reading. We have also had it where the unit gets stuck on Cycle 1 and we have to reset to go to CL and clear the system of its waste water. Is this a mechanical issue or a circuit board issue.


Did you discover the source of the 2HR reading? Mine's doing the same thing, except the drain pump keeps running and running as well...\015\012Any ideas?\015\012I can't imagine it's anything but the circuit board (for the third time in t ... Bosch SHU5316UC Dishwasher

Dish Washer, Electrolux Home Products, Model FDB2510LCC0, Serial NO: 7H34962223 Machine does not drain or add water. The machine has been worked for a couple of years. I checked the following: 1. Overfill Protector not stuck 2. Motor turns on and the machine cycles correctly 3. Since the machine has been running correctly the unit is hooked up correctly: hoses, garbage disposal, knockout plug. Again everything has worked and the motor does cycle and the machine will perform the different cycles


... Electrolux 23 in. ESI602 Free-standing Dishwasher

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

Asko dishwasher model DW 20.3 whichi s without a doubt the worst dishwasher I have ever had. The low water usage is the only plus -- and why we bought it since we have septic. Anyhow, we have a persistant "funk" (bad, rotten smell) in the dishwasher that gets on and in all of our dishes and glasses and china... it is nauseating. I have tried everything, including all of the recommendations to (1) use a very small amount of detergent (2) get biodegradable detergent (3) use more rinse agent (4)


... Asko Dishwashers

I have a GE Profile Performance Dishwasher. Triton: Triclean Wash System Quiet Power III. Every morning when I open up the dishwasher to empty the clean dishes there is about 2 inches of water at the bottom. What can I do to fix this problem?


... GE Dishwashers

I have an Arthur Martin ASF 2655 and the timer continues to turn from 0 to 1 to 2...... how do i reinitialise it


... Electrolux EWDW6505GS Fully Integrated Dishwasher with 9 Wash Cycles, Nylon Racks, Wave-Touch Contro... 24 in. Built-in Dishwasher

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

Whirlpool DU1145XTPPB7 Whirlpool DU1145XTPB7 model. Normal cycle light started blinking sometime during end of wash cycle. It will not do anything. Things I have already tried and not worked: 1. Unpluged and pluged unit back in. 2. System reset w/ heat-dry button, etc. Any help would be greatly appreciated


These dishwashers normally have a "Control Lock" mode.  It's in the manual.  It is provided for child safety.  It's often controlled by holding the "No Heat Dry" button for 4 seconds or more -- same procedure turns it on or off. ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

We have an Asko D1606 that we purchased in 2001. there are two problems. 1. It often leaves several centimetres water in the bottom of the dishwaser at the end of the cycle. 2. The motor is now on all the time even when the wash cycle dial is at 12 o'clock (i.e. it should not be on).


... Dishwashers

My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers

I have an Asko 1595 which will not finish the last 1 minute of any cycle except the 3 min. rinse cycle.


... Asko 1595 Dishwasher

Kenmore dishwasher 665.13843K601 ser. FU4806977 STOCK 13843K TYPE 575-0 Tried to turn it on won't start/ run/ perform any functions The following buttons light up but will not perform functions; Smart wash and heated dry also lights up like it should, pots and pans, normal, fast wash, high temp, sani rinse The following buttons do not perform functions or light up Quick rinse, Turbo ZOne, Delay Hrs., Cancel/Drain, Start/Resume I killed the power to it for 1 minute for reset but d


The touch pad is not working. Pull the front kick plate from font/bottom of machine and there is a 'TECH SHEET'. This has a complete diagnostic sequence for you to go through and verify the functions for you. ... Dishwashers

OE Error I'm getting an OE error which is a drainage trouble error. I checked the hose and the drain, and everything is clear. My diswhwasher runs 98% of its full cycle and usually with 2 minutes to go I get this error. I have 2 opinins as to why this is happeneing. 1. Maybe the clog is in my trash compactor, however that seems to be working fine and my sink is funning with no slow down. 2. My 2nd theory is I have to reset the progam within the dishwasher. Like how sometimes I


Had the same problem and had the pump replaced ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

Soap problems Not only won't the soap dissolve but there are granules on the inside of my glasses. The dishes are also not getting very clean. I have been using cascade 2 in 1 action packs for a few months now with no problem, they've been great. I ran a wash 2 days ago and when it was done, I opened it up and the dishes were still dirty and the action pack was just sitting there slightly open with detergent sitting on the bottom of the machine. I had done a wash 2 days before with no problem.


Either: 1. not enough water gets into the dishwasher. open the dishwasher 3-4 times during cycle, you should see some (quite some) water at least once, if not - check water valve, water level float and water pressure. 2. the pum ... Kenmore 24 in. 15689 Built-in Dishwasher

Indesit di620 dishwasher. after normal cycle request (2) on the 1-4 options the bleeping sounds and after 2 minutes both the 2 and 3 lights start to flash together. Any suggestions what the fault is? Thanks


... Dishwashers

I lost the manual for my dishwasher. I have two questions: (1) How does Light Wash differ in its cycle from Normal Wash? It seems it should be (but isn't) shorter. (2) When using the Light Wash cycle, should I put soap only in 1 of the cups for dispensing (leaving the pre-wash cup empty)?


\015\012We need the Model Number off the inside of the door to get you the manual please post this first so we can Help you Thanks ... Dishwashers

Dishwasher runs the wash cycle from 84 min to 1 minute. Then continues to run at 1 minute and does not finish the cycle. When reset is performed, the dishwasher empties.


Hi\015\012\015\012\015\012\015\012\015\012The main reason for the cycle not to go through properly or rather taking a longer time is due to the temperature of the water. Make sure that the water level should not cover the ele ... Bosch SHU5315UC Dishwasher

My Kenmore elite dishwasher 665.13793K600 has 2 problems: 1. won't drain water 2. won't even start working today Please help!


I have a Kenmore model # 665.13793K600 and it has been having a small puddle of water remaining in the bottom at the end of each cycle. I've taken it apart and cleaned it. I'm thinking I may have the drain hose incorrectly positioned or it could even ... Kenmore 24 in. 15079 Built-in Dishwasher

I have a maytag mdb6100 dishwasher with 2 problems. (1) the water does not drain and (2) food is left on the dishes after the wash cycle. I have checked the hose and there are no kinks or clogs.


... Maytag 24 in. MDB8600AW Jetclean II Built-in Dishwasher

My dishwasher runs 2 hours as a complete cycle. I think it is never going to finish but I have not stopped it in mid cycle. Dishes are very clean but they should when it runs this long. I hear it change cycles so I know it is not stuck on 1 cycle. It also makes a lot of noise. 2 hours of noise. HELP!!! How long it it suppose to run?


That means that the machine does not detect that one condition to continue the cycle is met.Sometimes\015\012 when this happen unesperience repairers replace the timer board , an \015\012expensive part that rarely fails. The timer b ... Whirlpool DU1055XTS Built-in Dishwasher

2 problems 1- dishes coated with white-ish film that won't rinse off, has to be hand washed with soap to remove. 2- heating element isn't heating up at all


The problem is hard water. Go to www.dishwasherfilter.com. They have a new product out that solves this problem once and for all. It filters the water entering your d ... Asko D1706 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0684 seconds