Having problems with your Asko D1776 Built-in Dishwasher ?

I have an F2 error and the fan or dryer keeps running...i understand that this means a high water level and i have already checked the screens and filters. but how do i turn off the dryer so i may safely inspect the pump and drainage system?


Answers :

Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012Sorry you have had to wait so long for a reply, it seems there are only a limited number of techs here familiar with Asko. Anyway, yes F2 normally would indicate a hi water level detected...normally. The difefrence in your case being the fact of the condensor/dry fan running. This is a red flag. In these scenario's 99% of the time the control is at fault. If you remove the door and control panel and visually inspect the control you will most certainly see burnt circuits on the control.\015\012If you have not already found the problem or hired a tech to look at the dishwasher, let me know and I'll guide you in what to do and to look for in more detail.\015\012\015\012I'll watch for a reply, \015\012\015\012Macmarkus :)
Repair Help & Product Troubleshooting for Asko D1776 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have an F2 error and the fan or dryer keeps running...i understand that this means a high water level and i have already checked the screens and filters. but how do i turn off the dryer so i may safely inspect the pump and drainage system?


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012Sorry you have had to wait so long for a reply, it seems there are only a limited number of techs here familiar with Asko. Anyway, yes F2 normally would indicate a hi water level detected...norma ... Asko D1776 Built-in Dishwasher

Ref: NEFF Dishwasher S5555XOGB/70 (FD No. 8602) Problem: Does not drain at end of wash cycle. Checks/Symptoms: 1. No blockage in whole of drainage system, system and filters are clean. 2. Pump does operate mid wash cycle ? drainage tube can be felt pulsing and pipe gets warm right through to the main drain connection at the ?U? bend. 3. At end of wash cycle the pump appears to still be trying to run but there is no flow, even when the door is opened. If machine is emptied by hand the pum


... Dishwashers

Bosch Dishwasher has started acting upo. If I turn on the dishwasher it runs the pump for approx 2 seconds then cuts out. This carries on the cycle spraying the soapy suds around the compartment but there is no running pump sound. Any idea how I can access the pump to either attempt to clean it out or to replace it? Or does this indicate another fault that may need attention. Any idea of the cost of parts UK. Thanks for assistance ****


Most dishwashers pump out briefly before filling in order to clear pressure chamber. The next step is the water fill which is monitored by the pressure/level switch. Once water level is attained timer will advance through cold rinse cycle. If no fill ... Dishwashers

Hi, Bosch dishwasher will not pump out the water and is covering the filter. Machine is not going thru its programme. Filter checked,no blockage. drainage pump chamber checked for blockages and none. pump impeller turns help Darryl


... Dishwashers

Zanussi Dishwasher (Table Top) DCS 12 W Machine it stuck ON with the drainage pump running and all lights OFF. Pump is still running when the door is opened. What do I need to do. I have unplugged the dishwasher from electric to shut it down, but when electric is turned back on the pump keeps going. Help.....Dave


... Dishwashers

Installed an older model dishwasher for a friend power works oes throuth the cycles but its not pumping water into the uniT there is no clogs and i hear the pump turn on. unsure why its not getting water into the unit another friend thinks its cause the air tube isnt hooked up but i think it may be something more then that any ideas


You will need to disassemble the bottom part where the bottom rotary spray nozzle is(the part that shoots water upwards). The impeller might have come loose or it is clogged in that area. ... Hotpoint Dishwashers

There is problem with the drainage from my guess. There is waste water left after turning it on, and it doesn't go away. However, hot steam and water are running properly. I found a guy who fix the pump, but that guy says it's not because of the pump itself.


Hello JohnnyblHope you've solve your problem by now. Without more information I guess your drain valve is defective and not letting the water to drain out. All the best Dickson ... Moyer Diebel 24 in. 501HT Built-in Dishwasher

Husky 2000s Pressure washer :Will not turn on,not the motor or pump....NOTHING.The lady at the support center told me (i purchased this at a garage sale)I have NO warrenty;but she did to turn the fan manuelly because it may be stuck.......the ONLY thing that works is the green/ready light.


... Pressure Washers

Zanussi dce5655 How can I find a "service manual" for this dishwasher? We wish to test the electrics to see if the pump is faulty as water is not pumping out and fault in drainage system (worked fine this morning).


Try calling the manufacturer of this macxhine and asking them or try googling you particular machine ... Zanussi 21 in. DCE5655 Free-standing Dishwasher

My Kenmore model 665 15759 quit working. The pots/pans button is flashing. It will not pump the water out and seems dead. I turned off the breaker and tried to reset it but that did not work. any ideas as to what the problem may be??


... Dishwashers

Bosch dishwasher shu42l controller may not be turning of circulating pump


... Bosch Dishwashers

Upper spray arm is not turning round even though water is coming through. We have checked the internal system for blockages and the machine is filling / draining as normal. When a full programme is run, many of the dishes, particularly on the top shelf, are dirty and many have hardly been touched by water. Could a pump or other part be faulty?


I found the problem to be neither blockages of the upper arm or roof spray arm or the upper basket arm hitting the the back of the dishwasher. the problem was that the pump inlet where the food scraps are macerated was blocked with all manner of gung ... Dishwashers

A GE triton dishwasher causes hammer noise when stops filling. The sink faucet works fine as do all the other faucets in the house. I cleaned all of the traps in the dishwasher. Because the sink works, I don't think it is a sink valve problem. I turned off the water to the house and drained the system, the air chambers should be good. Is there some component of the dishwasher that could be causing the noise? Would cleaning the pump help? If so, how would I do that?


The cause of the hammering noise, (slamming) is due to the water inlet valve on the Dishwasher (DW) shutting off abrutly once the DW reaches the proper amount of water.\015\012\015\012If this is an older DW, you might want to replace the ... GE Dishwashers

Miele dishwasher machine running & doesn't stop when prog selector knob is turned to off, start/stop button doesn't stop it. Stops only using on/off button. Seems to be emptying as pumps out water when poured in manually. May be G646 SC


My O/H found a considerable amount of gunge in the inlet pipe; that seems to have solved it! Thanks for your interest.Enid ... Miele 24 in. G646SC Plus Free-Standing Dishwasher

Dishlex global 450 _ how do i fix fill level time fault? displaying oF? Hi There, I have the above dishwasher and saw your advice on fixing fill levels - my display is showing the oF message and the pump to drain remains on whilst mains is connected. turning off mains does not clear message. holding eco button down does not clear message? is there anything else i should do in terms of removing parts to assist the process? I have cleaned out all of the drainage bowl and all is clear. i would pref


... Dishwashers

I have a hotpoint aquarius df23 dishwasher. when i turn it on for a wash there is no water coming into the dishwasher. i have put water in with a bowl and it works as normal until it drains the water out. my washing machine is plumbed in to the same pipework and it is working fine. does the dishawasher have a water pump that may need replacing????


Most likely you have an air lock in the dishwasher.\015\0121. Refill the salt compartment.2. Turn of the water supply at the mains.3. Disconnect the diswashers water hose from the mains supply.4. Lower the water hose and allow ... Dishwashers

Hi I have a Bosch sms 4012 dishwasher that was in our house when we bought it around 14yrs ago.It really has been an excellent appliance but for the past few months the control knobs have become 'sticky'and relatively hard to turn. Now the dishwasher is not completing the cycle properly by stopping intermittantly,taking almost double the cycle time to complete and not draining properly. Do you think this is just a blockage in the drainage system or something much more complex requiring a technic


... Dishwashers

Bosch SHX46A (6 years old) Selected regular cycle, pressed On and closed door. Cycle did not start normally. Pump runs, but no water is coming into the DW. I confirmed the water supply line is turned on. I opened door, turned off On/Off switch, then poured water into drain. Then turned On/Off switch on. DW began pumping water OUT of the DW. Also, it doesn't matter if the door is open or closed - if you turn the DW on, the pump will run. I suspect a problem with the electrical controls, or perha


From your description, I doubt that the problem is door latch is the cause.\015\012\015\012The first thing that a modern dishwasher does before it begins to fill with water is run the drain pump.  It appears that this DW is not progressing ... Bosch Integra® 500 SHX46A0 Dishwasher

Inlet/Drain light is on. I have cleaned the drain pump and non-return valve, rinsed under water, removes all foriegn objects, turned the drain pump impeller (which turns freely) and carefully replaced the non-return valve and secured it with the locking clamp. I tried turning off the dishwasher and teuned it back on. No warning light shows but as soon as I try the dishwasher on a wash cycle it fails to pump water into the machine and release the washing tablet door. The programme unit makes a no


Is the water inlet turned off by chance? Is there no water at all inside the dishwasher? ... Miele 24 in. G643Vi Plus Built-In Dishwasher

I have a CDA WC140 Integrated Dishwasher. Does anyone know the best way to access the drain pump and hose for inspection and possible pump replacement.


... Dishwashers

ASKO dishwasher D3122 drain pump wont stop pumping and the machine wont respond when we press any of the program or start/stop buttons. the program light is flashing. We can turn the power off with the main switch on top of the door but when turning it back on the pump starts pumping again. please tell me how to fix this problem so we can get it up and running again.


... Asko D3122XLSS Stainless Steel Dishwasher

The unit fills up with water but the circulation pump wont turn on. if i jump the pump it works. the pump is connected to the timer board. is there any sensor that would cuase the timer board not to turn on the circulation pump. this unit seems to be manufactured by ASKO mod. DW20.3 i dont want to replace the board ($375.00) if not nessary. thank you


Hi\015\012\015\012\015\012Thanks for using FixYa. There is no sensor on your dishwasher for drainage purpose however, it uses a drain solenoid to open and close the dishwasher drain port. If this \015\012solenoid ... Dishwashers

I have a Miele G 892 SCU PLUS Dishwasher. I have clean the filters, check the pump and could turn the impeller both ways. I turn on the dishwasher and it will pump out any water and fill then heat the


... Miele Dishwashers

When you turn it on the pump kicks on and it pumps water out of the resivior at the bottom of the washer. It sounds like thats as far as it gets.Does the pump turn on and off buy a timer or is there a float switch?


There is a float switch in the base if you tip machine to the left water will trickle out allowing you to reset machine but if it has a leak you will have the problem return until leak found. ... Bosch 23 in. SHU3307UC Built-in Dishwasher

Hotpoint BF1620 dishwasher will not turn off only at socket. noise is like the continual pump of emptying dishwasher. tries changing programme, turning on off, keeps turning itself on and pumping


There is a malfunction of the washer controller. Hence the mode is not shifting off from the pump as it does not end the programme. Hence you will have to confirm the output of the controller if the drive is short or functioning by itself. Since even ... Hotpoint Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1229 seconds