Having problems with your Asko D1876 Dishwasher ?

The lower shelf/drawer in the dishwasher has rusting pieces mostly at joins and also has upright pieces breaking off. Also a couple of small pieces have broken off the top shelf/drawer. I need to replace both shelves/drawers. how do i order replacement parts and at what cost. pat


Answers :

Hi,\015\012\015\012you'd have to start by providing a make and model & serial number. Check out repairclinic.com, amresupply.com or searspartsdirect.com to name a few, but there are many more on-line appliance part vendors if you do a search with your make & model.\015\012\015\012Hope that help's. Let me know and thanks for coming to fixya. Please reply with a model number for more help and rate the info you received here today.\015\012\015\012Good luck.\015\012\015\012\015\012Macmarkus :)
Repair Help & Product Troubleshooting for Asko D1876 Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The lower shelf/drawer in the dishwasher has rusting pieces mostly at joins and also has upright pieces breaking off. Also a couple of small pieces have broken off the top shelf/drawer. I need to replace both shelves/drawers. how do i order replacement parts and at what cost. pat


Hi,\015\012\015\012you'd have to start by providing a make and model & serial number. Check out repairclinic.com, amresupply.com or searspartsdirect.com to name a few, but there are many more on-line appliance part vendors if you do a search with you ... Asko D1876 Dishwasher

I have a Kenmore Dishwasher Model #665.168790000 and the water fills just fine and empties fine when cancelling cycle but when pressing any wash cycle the pump/motor just makes a loud humming noise and does nothing. I took apoart the lower assemblies to clean everything out but the problem hasn't gone away. Do I need to replace the motor or the whole motor assembly (also contains impeller kit)??? Also, I don't think I need to replace the whole sump & motor assembly do I???


... Kenmore Dishwashers

I have a kudso1flss6 dishwasher with the clean light flashing 7 times. Can I replace just the control unit or do I have to replace the heating element also? I also need to know how to replace the part or parts. Help!


Depress cancel button. Turn off power WHILE STILLL HOLDING DOWN cancel button, turn power back on. Viola! ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Whirlpool dishwasher model DU1055XTSQ2 will not run. Only half of lights on control panel working. Probably need to replace control panel. Do I need to replace the bi-metal fuse also. What does the bi-metal fuse do, how would I know if bi-metal is bad, what are symptoms.


... Whirlpool Dishwashers

Broken fitting The plastic curved piece that attaches the hose to the white fitting on the back of the dishwasher broke, and I need a replacement.  I have been to Home Depot and they don't have anything to fit it, and I was told to go back to the manufacturer for a replacement piece but have looked online and can't find anything that would allow me to order the part.  Help!??


You don't have to change that piece,just tie the hose (drain hose ) to something that is equal height,this prevents siphoning. Please Rate This ! ... Danby 22 in. DDW396 Free-standing Dishwasher

Asko d1976 soap dispenser doesn't open/deliver soap during the cycle - no error codes/water pumps & drains ok Do I need to replace the module or is there a wax motor that needs replacement? Is there a service/repair manual out there for askos? I also have an asko washer (6021) & dryer (T721) so having a service manual would be handy!


... Asko D1976 Built-in Dishwasher

Plastic Pieces We purchased our ASKO 1385 dishwasher 7-8 years ago. Over the years, I have found "small square, thin, pieces of gray plastic" inside. Where are these coming from? Also, we have replaced the drain pump 2 years ago and looks like we'll be replaced the main pump within the next few days as no water is going through. We are looking at paying big $$$ for that pump. Almost half as much as purchasing a new dishwasher. Is this a common problem?


Yes, I have the same problem and it is the upper bearing rack, not the pump impeller. The new bearing kit is $30.00 (another is available for $123.00-the same!!). ... Asko 1385 Dishwasher

I need to install the drain flange and I have a replacement kit but no instructions. There are two rubber and a fiber gasket. I need to know where each of them goes and where and if I need any plumbers putty. Also there is a metal collar.


Need model # of dish washer and part number of flange ... Dishwashers

Need a service/repair manual for a Bosch SGS0905AU/01. The machine is completely dead (no display) after a burnt smell came from it. On the pump motor is a broken/melted brown attachment with a broken ceramic(?) disc inside which looks like some type of capacitor. I really need to know what this is/was so I can replace it. Also, need to know whether there is another fuse somewhere in the machine as that has most likely blown as well. TIA


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012While I can provide a overall Bosch service manual if you post an email address, Based on your description I'd say the issue actually with the motor start relay and consiquently the control...as ... Bosch Dishwashers

My pressure washer is not pressurizing the water. i took the bottom assembly off the pump and there are three spring loaded plastic pieces in there. underneath these springs is a mushroom shaped plastic piece. two of the three mushroom pieces were contorted and need to be replaced. how do i get them?


Craftsman 2200 psi pressure washer 580.752341 ... Pressure Washers

I need to remove a broken heating element from my Whirlpool dishwasher and install the replacement part. I was hoping it would just "pop" out and the new piece would push in, however, it seems that it is not that simple. I need instructions.


Depend on how the heating element goes through the tub you do have to go underneath (if it goes down through the tub in the front) or even remove the dishwasher from the cabinet (if it does it on the back of the dishwasher). The tub is made of ... Whirlpool GU1200XTLS Stainless Steel Dishwasher

We recieved a dishwasher that had tons of lime and scale. well i remove that mostly by hand by taking the bottom part and disassemblying it and soaking it in CLR and slowly removing the calcium lime and whatever else there was. but i am kind of a thorough person and the bar =on the back of the dish wash needs to be removed and the back of it cleaned and probably soaked also if not replaced but i will just clean it for right now if i can. HOW do you remove it? I need a step by step on how to remo


Instead of going through all that effort, and still not being able to get to everything, just use a product called "Dishwasher Magic". It is a dishwasher cleaner and disinfectant, and cleans limescale and rust out of the dishwasher by just running i ... Maytag 24 in. MDB4600A Built-in Dishwasher

Whirlpool - Quit Partner I - DU1048XTP: Start at the beginning - Dishwasher would go through most of it's wash cycle and stop and the 'Start/Resume' LED would start flashing. Would press 'Start/Resume' and wash cycle would start again and run non-stop. Would have to hit 'Cancel/Drain' to stop. Called local service tech and he said board would need to be replaced. First board he brought failed right away, second board was installed. Tech also replaced latch handle assembly because it was missing


Have you asked the technician if the water temperature is OK.\015\012\015\012Run it again and after 30 minutes cancel and see if water temperature is warm or not. If not warm enough, then likely causes are heater is faulty or if you are u ... Whirlpool Dishwashers

Hi i have a technika bellissimo dishwasher and the cutlery basket has perished, i need to find a replacement. Also, the powder, tablet dispenser does not close or open properly so i need to just put the tablet straight in the dishwasher is there a spare part for this? many thanks!


Make sure the top drawer is fully pushed in when closing the dishwasher - that fixed the dispenser problem for us ... Dishwashers

I have no heat my hot water coming in is as warm as it gets and on dry it will not heat up. Is there a fuse or circut breaker for the element or do I need to replace it. Also if I could ask how hard is it to replace. Thank You Very Much Dino


Just call me on +263912639492, thta's easy.thank you.\012\012Dr. Kelson ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

Piece that holds upper spray arm has come unattached. Is it possible to reattach or does entire outlet piece need replaced?


... Bosch 24 in. SHV46C13UC Free-Standing Dishwasher

I need just the adapter piece for the sink so the removable hose can be attached and detached properly. I had my sink replaced and unfortunately this piece was thrown away with the old sink. Do you know where I can get one? Regards, Michael


... Kenmore 24 in. 17849 Free-standing Dishwasher

I have a McCULLOCH 1500 psi pressure washer and it seems like I need the top part of therod where the waer comes out it no longer adjusts the water stream seems like a little plastic defkector that you adjust your stream with, snapped and broke looks like I HAVE TO REPLACE THE ENTIRE TOP PART OF THE 2 PIECE ROD on the bar it says the following max130barmax60C PA66-GF30 Where could I purchase this piece Andy Nowostawsky my adress is 15447-rue d'esterel Pierrefonds,Quebec H9H 1Y9


... McCulloch Pressure Washers

Broken Piece The center piece that comes up during washing cracked and has come apart. Is this a replaceable part? I am reluctant to call a repair man to pay him to tell me I need a new machine!


... GE 24 in. GSD5930 Built-in Dishwasher

My dishwasher makes a banging sound, I've checked the arm & even when the washers is empty it still makes that sound. NOW I've ALSO got a sound like a "clothes washer in spin cycle mode" also in the wash mode of my dishwasher. Do I need a service call or should I just replace it since it seems to be falling apart....it's only 2 yrs with min use


Hi,This is quite a common problem. I would be able to help you, if you could provide few more details. When did you hear the banging noise i.e when filling, start of the cycle, mid cycle or it is always there?Thanks!! ... GE 24 in. Profile PDW7800 Built-in Dishwasher

After a power surge the dishwasher does not work at all. It just beeps constantly. There are no lights on the touch pad at all. The only thing that stops it from beeping is to remove the 2 pin black and white wires. I replaced the control module. Nothing changes. Do I need to replace the touch pad? What about the 3 digit clock? These parts together cost 145 dollars. I do not want to buy these parts and put them in to find out that did not fix the issue. I also unplugged the


... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

I have a Karcher 550M pressure washer and was using today when all of a sudden the water started to pour through the handle hence lost the pressure of the water. Is this a rubber washer issue or the gun needs replacing or simpler than that. To be honest although I have had the washer for about 3/4 years now It is hardly used. Also can I fix it and where would I purchase the allen key to replace. Thanks Brian


... Karcher Pressure Washer Gun 91120200 91120200

How do I disconnect the electrical wire plugs from the door handle in order to replace the handle? The plugs won't pull straight off and so I am wondering if there is any piece of equipment needed to disengage the plugs from the prongs.


First shut off the power to the dish washer. The plugs are just verry hard to pull off. You may brake the switch on the old handle but if you have the right new part it should have new switches on it. Just pull hard side to side wiggle off. ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

Door on dishwasher, model KUDSO1FKSS1, came crashing down. I removed the front under panel and discovered 2 nylon cables hanging down and 1 piece of broken plastic. Does anyone have a diagram of how these need to be installed? and, should springs be replaced at this time as well?


Hello, Welcome to FixYa.\015\012\015\012While I don`t have diagram or illustration I can give some insight because this is actually very common.\015\012\015\012It is a fairly minor procedure to replace it/them. Slide the entir ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Poor washing The soap door opens but soap still in there after wash cycle. We got lower spray arm off and one plastic piece but can't get all the way to the pump. Pump appears to possibly be cracked so we suspect it needs replacing, but we can't get it out.


Before you suspect the pump and motor assy, do you hang the silverware basket on the front side of the lower rack or if not did one of the holders for the rack fall off and you replaced it? I have found that id the basket is hung on the rack that tal ... Whirlpool 24 in. GU1500XT - Multiple Color Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1108 seconds