Having problems with your Asko Dishwashers ?

We are trying to contact the asco centre on 1300002756 and no one is answering the phone! we have an appointment for an agent to come out and repair the dish washer which we have now taken to the tip! 6 years old and burnt out!! Please tell us how we can contact your office. Georg.


Answers :

Repair Help & Product Troubleshooting for Asko Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

We are trying to contact the asco centre on 1300002756 and no one is answering the phone! we have an appointment for an agent to come out and repair the dish washer which we have now taken to the tip! 6 years old and burnt out!! Please tell us how we can contact your office. Georg.


... Asko Dishwashers

Miele Dishwasher Model G1040, Type HG03, NR: 32/65143704 The machine is three years old. The cycle reaches almost to the end, then all three LEDs merge together, and the pump runs continuously, even with the master switch off. I have taken the machine out and removed the base plate. When I first took the machine out of its position, I tipped it backwards and water came out of the bottom. All hoses and parts in the bottom section seem perfect in every way but the inside of the bottom plate indica


... Dishwashers

I borrowed my neighbor's Karcher Model G 2650 OH (it's several years old). It had the yellow tip already on, but after awhile, I took the tip off to use a different tip,and pulled down the brass coupling at the end of the wand to insert the new tip. The problem is that the brass coupling at the end of the wand won't snap into place around the tip -- so I tried another, and another. No luck. And now the original tip that was on the wand won't snap back into place. HELP! I need to get my neighbor


... Karcher Pressure Washers

I have a not quite 2 year old Kenmore dishwasher model #665.1322.(I believe built by Whirlpool) The motor has burnt out. That seems ridiculous to me when there is just my husband & I using it and I've had dishwashers in the past that have lasted 10 - 15 years. Anyways - we have no warranty so we thought we would try to replace th motor - but I can't find anything online. We live in south western Ontario - any suggestions of where we could find a replacement motor?


I have recently had the same problem with the same model. Do you think there's a connection? I'm going to report this to Consumer Reports. ... Kenmore Dishwashers

Kenmore Dishwasher 665.1383 is about 4 years old. The past 2 months it has developed a strong plastic or chemical smell. The smell has tainted brand new glasses that then have the odor when they are taken from the shelf to use. It is very strong during use and can be smelled throughout the house. I have taken everything out down to the screen to look for debris or anything that could cause the smell. I have tried the vinegar remedy and also scrubbed the entire inside with bleach. Nothing


That's not the full model number,there should be four more numbers.anyway does it have a heating element in the bottom of the tub,if so feel it with your hands,a piece of plastic could of hit it and is still melting when you run it,you can try using ... Dishwashers

My GE trash compactor just quit working. A little over 1 year old. I opened it and found inside the motor frame a magnetic contact that is burned up. Nothing else is wrong. This part shouldn't cost more than $10 . I can't find it anywhere. Do I have to buy a new motor for $180 to replace a perfect motor with a burned up $10 contact?


Parts sadly, aren't as inexpensive as they used to be. Hopefully, you can get away with the $25 part.\015\012\015\012http://www.repair ... GE Dishwashers

Hi I have an hinari dishwasher model HDW41SL its about 5 years old it kept blowing the trip switch when I used it. I contact a local maintenance engineer that I use and he said the heater has gone. He has been looking on line and contacting his supplies but no one can supply one. Please do you know where I could get one. Thanking you. Estelle


... Dishwashers

Smeg diswasher model numbe4r DF612SDX. Just coming up for two years old, various codes re error messages. E2, E5, E8. We have taken off the front panel where the buttons are - nothing obvious. We have taken the bottom off and tried to locate a reset button, but can't find one. We have cleared all the filters inside and checked the water intake and the filter there. Out of ideas, can anybody else suggest what we can try?


Any signs or sounds on the machine you here when the problem occur? ... Dishwashers

My dishes are coming out lacking shine and with a cloudy coating on the silverware and glasses. I use CascadeComplete and an additive liquid in the "shine" cup. My Maytag dishwasher is 15 years old. We also have very hard water, so I am being sure to fill the cups full of the powder prior to washing. Any tips? [email protected]


I'm not an expert, but either it's the hard water, or it's not getting the "shine" liquid. I'd look for a soap that specifically says that's for use with hard water. A water softener would be the best solution.Just keep an eye on the "shi ... Maytag Dishwashers

Whirlpool dishwasher top spinner and top rack spinner is not putting out water or very little and not spinning. I have taken apart and cleaned everything including the sump / chopper, can't find any blockage in the tubes that deliver water from the pump to the spinners. Is the Pump or Motor done? how can that be it's less than 5 years old? Its a Whirlpool Quiet Partner I Model DU1055XTPQ3


First, confirm that the holes are not blocked on these arms. (I did not want to assume you have done this.)Then check the impeller on top of the motor stem for being loose or worn/damaged - to rule the impeller out. If it is fine, then ... Whirlpool 24 in. DU1055XTP Built-in Dishwasher

My Bosch Classixx (about 10 years old) dishwasher won't fill The problem has only started since I pulled it out and cleaned! The programme sounds are as normal but no water enters the machine. I detected a small leak on the inlet pipe and tightened that. The machine drains when I add water manually though it has made a lot of gurgling noises for some time now when draining. When tipped on its side water comes out of the bottom of the machine (not entirely clear but not dirty either). When upri


... Bosch SHU9915UC Dishwasher

I have a Whirlpool dishwasher, model DU943 that's under 7 years old. I went to use it last night and it won't power on. I tried selecting all of the cycles, but the dishwasher never came on. I looked through the troubleshooting tips in my manual (like checking the circuit breaker for a tripped fuse, which was fine) and I still have a problem. what else can I try? thanks.


Hello- This unit has a thermal fuse inside the door panel on the control. This part is replaceable. If it is bad, replace.- and would suggest not using heated dry as this is most common cause of fuse failure. Let me know if this info helps- have more ... Whirlpool Dishwashers

Got a Dewalt 3800 PSI Pressure Washer with 4.0 GPM with a Honda GX 390 gas engine. Tipped it up to roll it out to my truck and got a big puddle of water with what looked like Pump oil in the puddle. Can you help???? It is less than a year old with 10-15 hours on it.....


Could very well be. Did you check the oil level and condition of oil? If its too full or if its light brown milky, then water has entered crankcase. Pressure washer pumps cannot stand to ever let run dry. Even a little. Also excessive idling will ov ... Dewalt 3800 PSI Pressure Washer

What is the tipping point for replace rather than fix, specifically for a 10 year old kitchenaid superba dishwasher?


Now lol when the repair is a 1/4 of a new one ... Dishwashers

I have a Whirpool DU1145XTPQA dishwasher... It has started "Not Draining the water" at the end of the cycle. Dishwasher is only 2-3 years old. I have completly disconnected it and have taken it to my garage so It could be tested in a more userfriendly envoronment... I have found no blockage of any line..... The screen in the dishwasher is completely cleen...yet , when you press drain, It drains at a very very slow rate. I have noticed a small 40 Watt pump (drain pump) that attaches to the mai


There is only one motor that drains the unit.it seems to me that the impellar wheel is not turning fast enough to do the job,you have eliminated all other possible cause with the exception of the main board.\015\012\015\012replace the dra ... Dishwashers

Hi there,i have a brand new but 3 year old,diplomat 8332,just fitted it,it does the pre was ok,pumps out the water,goes to next stage,you can hear water entering the machine,shortly after it has started the main wash,it starts to cut out intermittantly,then F2 code appears,and a bleep.i have taken the lower panel off and checked for leaks and to see if the valve was free,all ok,also relay click in front panel,safety cut out ? any ideas please.


... Dishwashers

I have a fisher paykel soft touch dishwasher about 10 years old. The F1 message came on and we have taken out the inside filters and cleaned enitirely., Was working fine until it came on by itself during the night. Unit is dry but the F1 light remains on. Do they have a sensor and where is it located?


The sensor is a flood switch at the base of the housing under the drawer. ... Fisher and Paykel 24 in. DS603H I Built-In Dishwasher

Whirlpool-Gold GU2500XTPT6 - Quiet Partner III (3-1/2 years old) - Electronic Fuse has blown; I replaced it and one week later it failed again. Any tips on next steps?


... Whirlpool Dishwashers

I have a 13-year-old Maytag DWU9906BAE. It has worked well but the door now opens too far - about 20 degrees lower than horizontal. I've taken the door apart and the reason is that the upright part of the two L-shaped hinge plates no longer catch on the back of the door jamb; for some reason they are now angled too far out and miss the catch plate on the back of the jamb completely. I'm no expert but they don't look warped, nor does the frame that they attach to. They're made of stamped


... Maytag Dishwashers

Stihl re 127 is has a loss of preasure and is leeking a lot of water from the bottom, i thought i might be a valve that i could replace and have taken the front off but there is nothing obviouse, and the machin is only a couple of years old any idears?


... Pressure Washers

Kenmore Elite Dishwasher element melted pan. What can we use to plug it? What caused this problem? Model #665.16559202 this is not more than 3 years old. Looks brand new except the hole burnt in corner of pan by the element connection.


Hi their problem prob-ely caused by loose connection to heater, as far as repairing the hole is concerned i would be cautious as if fault was to reoccur you could have a potential fire hazard ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

Bosch (not sure of the model but it is at least 6 or 7 years old). It is a built-in with a dial (cycle) and buttons (on/off and type of wash/rinse). The dishwasher accumulates mildew and frequently needs to be taken apart and cleaned.


Your condenser dryer has ceased functioning. try opening the machine for an hour or so after the wash cycle has fininshed ... Bosch 24 in. SHU53 Built-in Dishwasher

Have a 2+year old LG LDF6810ST dishwasher that shows no error codes but is not cleaning like it used to. Have city water, do not leave excess food on dishes when loading, am only using powder after reading other tips about the use of gels. There is excess moisture in the tub and on dishes after the cycle. Does not appear to be drying as it previously did. Any ideas?


Try these things in order:-Try to use a name brand powder, rather then a generic. Even a small box. I had similar problems with my LG dishwasher when I tried to save money by buying a generic powder. My dishes did not get clean and whi ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Maytag dishwasher we have a dishwasher that is a few years old. we have been noticing a film on everything we wash in it. we have used the dishwash dispencer that you use to clean a dishwasher and i use jet dry with no solution. we have taken out the spray arms and cleaned them with no solution. our next step is to raise the temp of the water'


Go buy a product called Lemi-shine and run it thru your dishwasher empty to clean out any hard water and soap deposits. If you can try using only about 2 table spoons of detergent and stay clear of the premeasured tablets. Most of the dishwashers bei ... Dishwashers

I have a Whirlpool Gold (Quite Partner) Dishwasher that is about 9 years old. I was using a liquid gel Dishwasher liquid and it has been working fine. After I switched to a Cascade Action Pads (solid powder pallets), its detergent dispenser did not open during the wash cycle. I cleaned the dispenser and switched back to liquid gel. Now the detergent dispenser (that looks clean and fine otherwise) has stopped opening during the wash cycle. What's wrong and what can be done? I can be contacted


As well as controlling cycle times, the \015\012timer on many dishwashers also functions as an actuator for the \015\012spring-loaded dispenser door. At a certain specific time during the \015\012cycle, the timer will activate a lever that in turn op ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0772 seconds