Having problems with your Bauknecht 24 in. GSF8984 Free-standing Dishwasher ?

Bauknecht GSF 4862 error-light (like a waterdrop with 2 lines below it)

\015 I have a Bauknecht GSF 4862, when I start my dishwater after a few minutes the third light (like a waterdrop with 2 lines below it) turns on and it stops! Anyboday can help me out? Regards Frank / Barcelona, Spain\015

Answers :

Repair Help & Product Troubleshooting for Bauknecht 24 in. GSF8984 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bauknecht GSF 4862 error-light (like a waterdrop with 2 lines below it)


... Bauknecht 24 in. GSF8984 Free-standing Dishwasher

Bosch Exxcel Dishwasher (Enr SMS53E12GB/01 FD 9002) bought in July 2010. Error code 15 and "Check Water Supply" light on at same time. Have checked in-line filter in tap connection and all clear, water pressure OK, no kinks/twists in supply hose. Any help would be greatly appreciated - I'll have to call Customer Service in the end as it's outside of my problem-solving ability, but would like to check whether there's a known reset or fix I can try before I call.


... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Bauknecht gsf 1582 error


... Dishwashers

I have had an E24 error message on my Siemens freestanding dishwasher. As well as the Error message the the little tap sign lights up too. Up until now the problem has occurred around 1 in 3 attempts and mainly at night but not in the day. When it does work the washer works perfectly and washes well. Today it will not work at all. The error always comes up 2 minutes into any cycle. I've tried turning the water feed off and on and in the past this has worked. It sounds like no water is gettin


Hi Steve\015\012\015\012E24 error normally indicates failure to drain, the first\015\012thing to check is that the water is actually being supplied to the appliance\015\012and is turned on. If it is then check the water inlet valve, if th ... Siemens 24 in. SE25T250 Free-Standing Dishwasher

Error F9 en Bauknecht gsf- 4862


... Bauknecht 24 in. GSF8984 Free-standing Dishwasher

F1 error dishwasser Bauknecht GSF 4862


... Bauknecht 24 in. GSF8984 Free-standing Dishwasher

At 2 minutes left in the wash cycle, the quick rinse light starts blinking and the timer goes to 0. My dishwasher is a Whirlpool Quiet Partner IV gu1500xtkbo dishwasher. I'm assuming the blinking light is an error code. What does it mean?


... Whirlpool Dishwashers

Our dishwasher Bauknecht GSF 5481 stops washing shortly after start, without heating water. The light for washing program does not light.


... Dishwashers

WWe have a neff dishwasher. It doesn't clean well at the moment and seems to be on cycle for ages. Even after resetting it there is a red tap light on and another red light that looks like an 's' with double lines. Our manuals don't help! Any advice very welcome!


... Neff S5946 Built-In Dishwasher

We were hit by lighting and now my dishwasher top blinks from the minutes to an error code that look like a 118 but i don't see an error code in the book for that. It is a two drawer model


When lightning hits an appliance it hits toward least resistance, you need to replace the board in your dishwasher. ... Dishwashers

Anybody have some information on a Bernstein dishwasher, model 02-200470? There's a symbol that I'd like decoding; it looks like a sine wave with a horizontal line. It's on the machine by the rinse aid / salt lights. On a similar note, is there a particular key combination to force the unit to drain?


... Dishwashers

Dishwasher Bauknecht gsf 5481 error code 9 blinks


... Dishwashers

My Zanussi DE6744 dishwasher won't run it's cycle since I ran a dishwasher cleaner through it. It powers up then stops and flashes 2 green lights alongside a symbol that looks like a bowl with steam rising from it and an arrow with an upright line to it's right. There is also some standing water in the base of the machine. What do these mean.


The first thing I would do is check the float to be sure it is not stuck in the over filled position. Then I would check the drain to be sure that there is nothing clogged in the drain line. Then I would check to make sure the fill valve is working a ... Zanussi 24 in. DE6744 Free-Standing Dishwasher

I have an LG Dishwasher Model LDF7810BB. I have no response at all from the control panel, no lights at all, no error messages - completely dead. The unit worked quite well for 2 years, then just quit. I have good power at junction box. I have taken the unit apart, tested the line filter box on the R of the dishwasher (actually jumped it). No response. Thoughts? Allan.


... LG 24 in. LDF7810 Built-in Dishwasher

I have a hotpoint bfi 62 dishwasher. It fails to start and the Daily Cycle light is flashing to indicate an error. Can you advise me of the likely problem.


... Hotpoint 23 in. BFI62 Built-in Dishwasher

Dishwasher is making a metalic rattling/clanking noise when first starting and periodically through the wash cycle. Sounds like the noise is in the door, but hard to tell. No error lights have come on. The dishes appear clean, but the noise is getting worse.


... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

Same question: When starting my Bauknecht GSF 5481 dishwasher the problem is that I start the dishwasher and after some time - when finished or close to finish - it changes to rinsing and the light on top of the START buton start to blink and I cant change the program. What to do?


... Bauknecht 24 in. GSF8971 Built-in Dishwasher

I have an old Bauknecht dishwasher GSF 3160 S that a friend gave us 10 years ago. It was stored for that time, and now if I try to use it, it leaks out through the bottom and floods the kitchen. I would like to know 1) is it worth fixing from the point of view of how energy/water efficient (or inefficient) an old dishwasher is - if you know the specs for this particular machine, and 2) what needs to be changed if it is worthwhile fixing. I don't know what else might not work, because I only pu


... Bauknecht Dishwashers

When i start my dishwasher it sounds like it is filling normally then error lights 1 &3 (3h&9h) flash rapidly and water begins to drain away


\015\012This indicates an error with the pressure switch and indicates that it is jammed on full. First try switching off ther AC power to the washer and letting it stand for 30 minutes. Then switch back on the AC power and ... Indesit 18 in. D41 Slim-Line Free-standing Dishwasher

WP DW Mod # GU1200XTLS0: this unit filled with water and just stopped running. I have power to the unit. The control panel does not light up at all. Its wierd that I have power to the board and all the wires seem to have power! No burnt spots and no burnt smell on the board.Hmmm! Door latch and switches all check ok. Oddly it seems like the line power to DW goes all the way thru the unit and back through the nutural wire. Could the motor windings be burnt out?


Hello , there should be a fuse located by or on the side of the board with 2 wires going to it , one from the latch and one from the board ,it does come off , use an ohm meter to check it , it should ohm out or have low resistance make sure to take t ... Whirlpool GU1200XTLS Stainless Steel Dishwasher

Error code 4 for bauknecht gsf 3321 what does it mean?


... Dishwashers

Hi, I have a Miele dishwasher G2150 that after 7-10 minutes on any cycle the rinse, dry, and end lights flash amber. I called the 800 number and they walked me through the diagnostic sequence and they said it was an error code 12 something to do with water restriction. I removed and checked the bottom "L" filter(clean), the wheel (moves freely, not dirty), and the grey in line filter screen on the intake hose,( clean also). I can feel the water coming through the intake hose, water comes in thro


... Miele G2150SC Dishwasher

Bauknecht GSF 7397 error code F8 displaed. what does it mean?


... Bauknecht Dishwashers

My Teka Dishwasher DW7 80 FI does the first water intake operation, it sounds like rinsing, and the you hear the pump evacuating the water and two beeps as when it finishes the complete cycle. About 6 minutes. Then Stops. The lights that stayed on says error E8 according to the manual. I have done the suggested fix as ending the cycle manually and turning off and on the DW. I tested "many" times in various modes and the same preemptive end.


Hi.E8 is alternate washing system malfunction.The alternate washing system consists of a valve located in the underside of the appliance and connected to the impeller motor. The valve opens and closes switching spray on and of ... Dishwashers

Dishwasher Bauknecht gsf 1351 users manual


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1815 seconds