Having problems with your Baumatic Dishwashers ?

No water getting through hearing a long buzzing noise through the cycle dishes still dirty


Answers :

Clogged supply line or clogged inlet filter or crimped supply line or supply line shut off valve turned the wrong way.
Repair Help & Product Troubleshooting for Baumatic Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No water getting through hearing a long buzzing noise through the cycle dishes still dirty


Clogged supply line or clogged inlet filter or crimped supply line or supply line shut off valve turned the wrong way. ... Baumatic Dishwashers

After 3 years it just started making a loud noise, I am no expert but it sounds like a fan in a motor. I have only heard it today, but I am betting it will still happen next load too. I didn't change any of the settings, have been running the same way forever. When I did hear this noise I started pushing buttons to see if I could get it to stop, no good, no change. The cycle has completed and everything looks ok, waiting on the dishes to dry. Drainage has never been a problem for me either.


I would say this is a build up of lime.try changing your tablets and checking your salt levels.there is no fan .try what i say and see what happens.have you found a glass broken it could be as simple as that but i dont think its serious.adrian,,,, ... GE Nautilus 24" Built-in Dishwasher

My dishwasher runs 2 hours as a complete cycle. I think it is never going to finish but I have not stopped it in mid cycle. Dishes are very clean but they should when it runs this long. I hear it change cycles so I know it is not stuck on 1 cycle. It also makes a lot of noise. 2 hours of noise. HELP!!! How long it it suppose to run?


That means that the machine does not detect that one condition to continue the cycle is met.Sometimes\015\012 when this happen unesperience repairers replace the timer board , an \015\012expensive part that rarely fails. The timer b ... Whirlpool DU1055XTS Built-in Dishwasher

Dishwasher is not cleaning well, dirty film all over everything, like its not rinsing. In rinse cycle only, some water comes out of lower left port inside but nothing else. Hear a low buzz underneath unit like a motor or pump is energized but no water getting to the top.During normal wash cycle, buzz from underneath seems to cycle on and off, say every minute or so like its cycling on an overload. Do I have a bad pump and if so how do I get to it?


Hi. This may well be a pump issue, or an obstructed hose assembly, as well. Your symptoms are indicating that the impeller may be damaged. In order to pull the necessary schematics, I will need the entire model number. This ID tag will allow me to pu ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

Dirty dishes The dishwasher does not wash the dishes properly seems to make all the normal noises but when finished its cycles the dishes are still dirty. Reading some of the other reviews sounds like I might have a inlet valve problem. Is there any way i can test if the inlet valve is functioning properly.


If water comes into machine then valve is ok.\015\012open machine when in cycle and look to see if spray arms are rotating\015\012if not, then take out and clean.\015\012spray arms only rotate with water jetting out of angled nozzle ... Dishwashers

I have a Whirlpool quiet partner III dishwasher that began to make a loud scratchy noise when the cycle started. This went on for a few months but it was still cleaning the dishes. Last weekend we tried it and it just kind of stopped---there is a kind of buzzing at the point when the cycle should start and then it does nothing. It does still drain of the cancel cycle. What does this sound like


There could be some debris obstructing the spray arm assembly from turning freely, puting extra working load on the motor and it now started to cut off(thats why you get the buzzing noise) since the motor also activates the water pump(reversible) it ... Whirlpool Dishwashers

Dishes are still dirty after a completed cycle. There are still food particles harden on the plates and glasses. I can hear it draining. but it appears that the dirty water is draining back into the dishwasher


... Whirlpool DU960PW Dishwasher

I have a 13 month old (Thanks Sears warranty!) Kenmore Portable Dishwasher Model 665.17769. It drains poorly, taking 2-3 times after load is completed running thru the ''cancel/drain'' cycle to clean it out. It is not getting dishes clean either, presumambly because the dirty water isn't being flushed out at cycle end and instead of rinsing with fresh water, it's still screwing with the dirty water. Manual doesn't offer any advice except to see if the hose is kinked (it isn't). I made sure nothi


Hello Linda it sounds like you may have a piece of glass or some other hard material in your drain pump which is partially blocking the draining process. Remove the hose in the base of the machine, then unscrew the drain pump and physically examine ... Kenmore Dishwashers

I have a MDBH945AWW that is just over one year old. It has just started making a various new noises. Grinding, loud buzzing and such. Still cleaned the dishes and completed the full cycle. I followed the solution that bgreenatown gave for removing obstacles. Found some soft material but did not seem that it would cause an obstruction. Removed it and put it back together but it is still making noises. Any next steps?


Hi,\015\012This soound is from the pump assembly. Looks like the "CHOPPER ASSEMBLY". Try to pull the pump apart and take a look.Go to www.sears.com and put in your model number, ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

I have a bosch SHU6802UC dish washer. Recently the cycles were getting very long (3+ hours) and now when you press power/start, the unit turns on and you can hear the rather loud hum (pump?) of the cycle starting but it does not do anything else, just continues the loud hum. No cycle, does not fill with water, nothing. I ran the diaognostic and it immediately came up "7" on the display. Any thoughts or direction would be greatly appreciated. FYI, I did thuroughly clean it which made no di


There are a few possibities...if you remove the lid and take the two t20 screw off the left side panel at the front you could check the pressure chamber and its hose are not blocked. Use the link and go to page 4, part 263834 and 361113. You ca ... Dishwashers

Frigidaire dishwasher 15 months old. just started not washing dishes very well. set it for high temp wash. put plenty of fresh dishwashing liquid in. the unit goes thru a full cycle. you open the door and dishes are still dirty. there is always lots of dishwash liquid in the door. some of it runs down the inside of the door of the unit. just does not use all of it so dishes dont get cleaned. what could it be?


First I would check to see if it is getting enough water. There is a screen in the water inlet valve that tends to pick up debris. Follow the links Di ... Frigidaire Dishwashers

I am getting a clicking/ticking noise (1 click/second) from my Maytag (model MDB9100)dishwasher after it goes through its auto clean normal wash cycle. At the end of the cycle the arrow = clean and the clicking sound is there. I opened the washer door for about 1 minute noted the soap containers are empty, dishes clean, machine still hot/steamy. Closed the washer door and the clicking sound resumes. Please advise.


This is the heated dry timer going through the drying cycle until the dishes are dry. The dry cycle runs on a timer and it will click through the cycle until it finishes the amount of time preset on the timer to dry the dishes. ... Maytag MDB9100A Dishwasher

Dirty dishes the dishwasher sounds and appears to be operating normally but the dishes are not getting clean. now i've noticed dishwasher soap still in the dispenser after the washing cycle has been completed. I'm thinking maybe i have plugged water jets? Anyone have any suggestions? Thanks.


Plugged jets, possiblemore likely it is leftover food reminance left in the pump area. and on certain dishwashers it could be a swollen check valve, not allowing the evacuation of the used dirty water.does your soap dispenser open? ... Dishwashers

KENMORE QUIETGUARD STANDARD BUILT-IN DISHWASHER 587.15149400. WHENEVER I TURN IT ON THERE IS A LOUD HUMMING NOISE AND THEN IT GETS QUIET. I GUESS IT IS WHEN THE WATER IS SUPPOSED TO SPRAY B/C IT'S NOT SPRAYING OR CLEANING THE DISHES. WHENEVER IT IS DONE RUNNING, THE DISHES ARE STILL DIRTY AND SOAP IS RUNNING DOWN THE DOOR. PLEASE HELP..


Do you have water in the dishwasher after the loud humming noise? Sounds like you have the water to the dishwasher turned off, or you have a bad water fill valve. Make sure your water to the dishwasher is turned on completely, test you dishwasher, ... Dishwashers

My dishwasher detergent dispenser still has the detergent in it when the dishwasher is complete with the cycles. I hear it fill and go through the process but dishes are dirty and soap isn't gone


Sounds like it is not getting enough water ( up to element) The water has to be 130 F to work well. Is the water draining out after fill . Just open during cycle and check these things ... Kenmore Dishwashers

Our bosch dishwasher gets stuck on the last minute of the cycle ....says "1" for as long as we let it and we hear water swishing around and the dishes come out wet- we have to just stop it.


Hello,Welcome to FixYa.Based on your description "bosch dishwasher gets stuck on the last minute of the cycle ....says "1" for as l ... Bosch Dishwashers

It's like my whirlpool is not getting any water...it was working fine yesterday and today when I started it I opened it after the cycle was done - the dishwashing liquid was pooled at the bottom and the dishes were still dirty help?


On the bottom of the inside remove bottom rack and you will find a plastic float. it is most likely stuck in the up position. jiggle shake , turn and it should go down and allow it to "think" it is empty to allow fill. good luck, let me know. ... Whirlpool GU2400XTP Built-in Dishwasher

Kenmore model 665.16509200 Does not clean very well and now dry cycle not working. Wash cycle takes almost 2 hours, and still dishes had gradoo and white detergent on them, even ones that were clean when they went in. The drying coil had plastic melted on it once before, so that could have caused that malfunction. I am not so concerned about that, it is the dirty dishes after 2 hours that is driving me nuts. The short wash cycle leaves EVERYTHING dirty, so I just quite even trying that.


... Kenmore 13599 / 13594 / 13592 Built-in Dishwasher

I bought a used GE Triton XL d/w with no manual. It worked great but now it is not cleaning anything, when the cycle is over the soap cup is open but half of the soap is still inside of the cup. I opened the d/w during a cycle and the dishes are wet top and bottom racks so I know it's getting water but the dishes are still filthy. Why is the soap not working? It's like water is spraying everywhere but the door where the cup is!


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... GE Tritonr XL GSD6260JCC Dishwasher

Kenmore Dishwasher doesn't rinse? It sounds to be working fine, however, at end of cycle, dishes are still dirty, and the front door on the inside is still dirty. Obviously there is a problem here maybe with water pressure or something. There is steam at end of cycle, can't tell about water other than that.


Try opening the dishwasher during the wash cycle stop it and open it if water is in the bottom it is filling whn you open do 1 or 2 times to check to see if spry arms are spinning if they are check to see if soap dispenser is working also use dishwas ... Kenmore Dishwashers

I have a Maytage Jet Clean dishwasher that is not getting the dishes clean. When the cycle is finished, there is still detergent in the cups and the dishes are not clean. I have tried running the cycle again and it is still the same way.


\015\012I attempted to locate an answer to resolve the issue for you, but you have not provided me with enough information to access my service database. Please observe the TIP below, and post me back and I will be happy to assist y ... Maytag Dishwashers

I have a GE Potscrubber 720 and there is water in the bottom of the dishwasher and I tried to clear it by starting a cycle and it still keeps water in the bottom of the washer. When I run a cycle there is caked on soap on the inside door and dishes and the dishes are filthy. I found a long thin piece of metal by the drain it is long and straight and a break on one end and an "L" shaped bend on the other.. Any ideas where to start looking for problems? As I have no experience in repairing dishwas


... GE 24 in. GSD2600GBB Built-in Dishwasher

I have a Kenmore diswasher model 587 1525. I can hear the water filling and rinsing, but during the wash cycle I do not hear the motor. At the end of the wash cycle and when I open the door I see the detergent tablet is sitting on the floor. The dishes are not cleaned. Does this mean that the motor has failed or is it the control card. I can hear some clicking noise while the motor should be running. Maybe solenoids cycling.


... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

Dishes still dirty, or gritty after wash cycle completes.


If you have suds that may be the problem.\015\012The motor sucks in water/suds due to the air bubbles it cavitates.\015\012Once suds get into a unit it will take several cycles to clear them.\015\012\015\012Run a cycle, do not ... Dishwashers

Our KitchenAid dishwasher (KUDS03CTSS) does not clean the dishes. We have tried the normal and heavy duty cycle and rinse the dishes before putting them in the dishwasher. Dishes are still dirty once the cycle has finished.


You will have to remove the filter and clean the chopping assembly. Glass, pieces of plastic debris has probably jammed it up. ... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1981 seconds