Having problems with your Beko Dishwashers ?

I have a Beko D 2731 FW its about 4 years old and recently it has begun to leave a gritty deposits. I think this may be due to the top spray arm not running as freely as it used to. I would appreciate any help. Thanks.


Answers :

Hello,
Here are a few things to check.

* Worn wash impeller (depending on design). Test by placing a glass upright in upper rack with full charge of water in the basin. Run dishwasher for 30 seconds. Glass should fill up. If not, replace wash impeller.

* Debris caught in spray arm holes. Remove spray arm and clean out with water and compressed air.

* Heating element burned out. Check water temp during wash--should read between 130 to 140 F.

* Insufficient water fill in basin. In most models, proper fill level is just up to the heating element. Much less than this will result in poor cleaning.
Hope this helps.

Repair Help & Product Troubleshooting for Beko Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Beko D 2731 FW its about 4 years old and recently it has begun to leave a gritty deposits. I think this may be due to the top spray arm not running as freely as it used to. I would appreciate any help. Thanks.


Hello,Here are a few things to check.* Worn wash impeller (depending on design). Test by placing a glass upright in upper rack with full charge of water in the basin. Run dishwasher for 30 seconds. Glass should fill up. If not, repl ... Beko Dishwashers

Hi, my hotpoint aquarius df61 makes all the noises of washing, i hear the water going in, motor is running, however i dont believe the spray arms are revolving, so the dishes are not getting clean. i have cleaned the individual holes in the spray arms, but i don't think the water is getting up the back pipe and into the top spray arm. it does not spin at all. no problems draining. help please. and were can i get a copy of the user guide, free preferably. thanks


How old is your machine? it is posible to have something in the watwr pump, you hear the water and the motor, but the fan of the pump (washing pump) is blocket. also the pipes hat make connection to the water pump and the arms. at someoane i found gl ... Dishwashers

Lower spray arm does not spin on my bosch dishwasher model number SHV55M03GB/40. However the top spray arm does spin. I have tried cleaning filters and the actual lower spray arm but found to blockages etc. many help will be greatly appreciated


S.Africa doesnt have same modles as you, but will try and help. Some washers give the operator a choice to run either the top spray arm or the bottom one independently, and/or both together.\015\012Almost certainly, there is a valve that is po ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

My dishes in the top rack don't get clean. The dishwasher is a ge monogram zbd6800kss. i believe the spray arm does not spray water to the top shelf. any help is appreciated


Hi tomcl244,The spray arm may be clogged. Please look at my tip below on how to clean it, as well as nifty things to do to keep your Dishwasher running smoothly: ... GE Monogram ZBD6880K Dishwasher

We have a Frigidaire dishwasher model #FDB634RF bought new. It was used for a not very long period of time but developed problems due to well water with high lime content. now with good cleaning products available it is ready for use again. The problem is the top spray arm that refuses to rotate. I have taken the arm out and thoroughly cleaned it of deposits checked the supply line from the pump and checked the sump for any obstruction. The arm turns freely by hand but water just pours out the


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Frigidaire 24 in. FDB635RF Built-in Dishwasher

Top spray arm won't spin. No clogs. Water runs fine. Arm just won't spin. Will spin freely if I move it


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Kenmore Dishwashers

I have a frigidaire dishwasher - model number PLDB998AC1. There are two spray arms in this dishwasher - lower and upper. The lower works fine but the upper spray arms are not spinning. There is what I think adequate water pressure coming in from the top but no movement on the upper spray arm. Here is what I know: 1) The water pressure and spray arms alternate between top and bottom. 2) The upper spray arm moves freely when I push it gently. 3) I have removed the pump and cleaned out an


... Frigidaire 24 in. GLD2162RDC Stainless Steel Built-in Dishwasher

I have an older bosche dishwasher and the I know the water is flowing into the unit and collecting at the bottom of the drain but it is not getting into the spray arms in the middle and top to work at all. Any help would be appreciated.. Thanks


There is a chacne that the main wash motor is not drawing enough water into the pump to spray through the arms.you can try and add some more water to the dishwasher and see if there is any change.\012if there is no change then you migh need to ... Dishwashers

Dishwasher is 2 years old. Top shelf dishes not getting clean even on on heavy duty and sani rinse cycle. All arms move freely,tried the 2 cups white vinegar in an open container and run cycle. I thought that helped but a few days later we are back to the same thing. No debris around drains. Tried loading differently. I have called for a repair person,but is there anything else I could check on my own?


Sometimes the holes in the arms get blocked up,sweetcorn,rice etc, this then stops the arm spinning and water being sprayed onto plates etc, unscrew it and run water through the centre hole and see what happens. ... KitchenAid Dishwashers

Just replaced the white plastic in-setting of the top sprayer that was broke and while i tightened the "nut/screw" that keeps the spray arm up there it almost feels like it is too tight to turn freely. Should I oil it with something or is there some other reason that it is not as loose as i think it should be to turn (which it's not during the cycle)? thanks for any help.


... Champion 24 in. UH-150B Built-in Dishwasher

Our Bosch dishwasher (model unknown) collects small rock-like deposits in the ends of the top spray arm. From what I've read, these could be calcium or other mineral deposits. Is there a safe agent that can be run through a cycle that will break these up? I've tried 3 different dishwasher cleaners; none seem to help. (Dishes have a white film that can be rinsed off with white vinegar)


Firstly I would suggest you have your water softener system in the dishwasher checked up, if it has one. Without knowing the model number it is very difficult to provide a precise solution.\015\012\015\012The best way to remove the deposi ... Dishwashers

Dishwasher wasn't cleaning, tried cleaning the top spray arm but broke the hook that holds the top spray, looks like a 1/2inch gray plastic nut/bolt with a split prongs at the top. One prong broke so arm will not stay on. Where do i find this nut/bolt/hook. The LG customer service was of zero help.


Hi,\012That is not that hard to fix and you can easily buy the parts yourselfonline...Here is a tip that will help you with the online buying...How to Buy ... LG LDF6810 Built-in Dishwasher

I have a Frigidaire Ultra Quiet Plus dishwasher. The top spray arm isn't spinning during wash. The bottom spins fine and I can spin the top freely by hand. It appears there is not enough water pressure gettig to the top spray arm. Any suggestions? Tanks, Sam


I may have the answer. I had what sounded to be the same problem. I found the dishes were dirty after they were cleaned, but I found there may have been a big pot lid blocking the upper arm. I decided to run the machine again, and after a bit open ... Frigidaire Dishwashers

Makes grinding noise.spray arm on top not moving. spray arm on bottom barely moving. grinds when draining too. removed and cleaned out holes in bottom spray arm, didn't help, but found piece of black plastic/porcelain with rust on it in the lower spray arm that looks like it may be part of a bushing?


Very possible that it is a fin off the impellers or could be a bushing ... Dishwashers

Spray arm, 3rd level, fell off. Flower-like looking ring is still attached to top of dishwasher and arm itself is no longer attached. How can I reattach the spray arm to the flower-looking like ring?I have Frigidaire model number PLD4555FRC0; part # of spray arm, 3rd level, grey is 154478202. I called help line and got someone whose accent I could not understand. I think his name was Victor. He left the line and never came back but, before he left, he said he was looking for the part...why he, t


Unscrew the flower looking piece, there is a white plastic retaining clip inside- press it back together. ... Frigidaire PLD4555RFC Dishwasher

The lower spray arm came off during a dishwasher cycle and melted. The dishwasher is okay but I need a replacement spray arm for a Sears Galaxy dishwasher model number 587.15139400 I have searched google for replacement parts for this model and have not found a place where I can get a lower spray arm. Any help would be appreciated.


Sears parts dept ... Sears 24 in. 14181 Built-in Dishwasher

Upper spray arm is not turning and I don't think water is coming out. Dishes on top are not coming clean. Dishes on bottom are clean (as clean as they get with this dishwasher). How do I remove upper spray arm. Also I'm not sure how to remove lower dish rack to access upper spray arm. Any help appreicated. Kitchenaid model KUDP01FLSS5 Chris


Hi Chris,It sounds to me like a restriction in the pump. I put together some information here on cleaning it out. If you try these please give me some feedback as to if they help or not.Thanks! ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

Help! My dishwasher runs thru it's cycles but when I open it I find my second detergent cup still full of soap and my dishes still dirty. I have an older maytag dishwasher but have never had this problem with it. I've tried running a short prewash cycle with the soap despenser open to wash out the soap from the open second despenser but it doesn't wash it out. I know water is coming out of the spray arms but can't see if the arms are spinning although when running it does sound like they ar


Hi,\012There are three common problems that cause the Soap Dispenser or Cup not to open. I have a tip that will explain these problems in detail....Dishwasher Repair Problem ... Dishwashers

My ASKO dishwasher DW95.4 do not work well. There is a problem with the water curculation. The water level is OK. There is hardly any water comming out of the top spinning arm. The top spinning arm do not rotat. There is no obstruction. It spinns freely by hand. Please help


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Asko 24 in. D3112 Free-Standing Dishwasher

Hello, Please help. I follow recommendations for cleaning: sewer pump, cleaning arms, screens of the dishwasher. However, still machine is not working. water is not going through arms: lower, middle or top. Also, I get water into dishwater when it starts, and when I open i hear noise for water dripping into hot elements,but no water is running throughout. PLEASE HELP


... KitchenAid 24 in. KUDP01IL Stainless Steel Free-standing Dishwasher

I have a Whirlpool dishwasher (Model #: du800cwdb5) and need help going about the repairs myself. When the dishwasher is turned on, the spray arm at the bottom does not spin, nor does it spray any water and the spray tower produces water but, rather than spraying, the water just kind of bubbles out of the top of the tower. The tower does also does not extend up as it supposed to.


There is something clogged in the motor/pump or its intake ... Dishwashers

Baumatic BDW13 Problem with lower spray arm: arm is not being fed with water and is consequently not turning. (Note: top arm is turning as usual.) Might this be a problem with the recirculation motor? Any help most welcome! Jonathan Drennan


I think that you may be on the half wash setting, check to see if the light labeled as number 4 is on while washing, if it is, then you need to simple turn off this option. Let me know if it isn't. ... Baumatic 23 in. BDW13 Built-in Dishwasher

Dishwasher not cleaning dishes; water not coming out of top spray arm


You are right to go to the inlet filters. If they are clogged you would lose pressure, but not that much...The pressure pump is probably not outputting any longer. Locate it and see if it is moving freely. ... Dishwashers

Top rack not cleaning and spray arm possibly not moving


I removed the lower arm, the strainer, and three screws (Torx, but I used small allen wrench). I took of the pump cover, and found a small white ball blocking the tube that goes to the top rack sprayer. I put everything back except the ball. It has w ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Top rack not cleaning and spray arm possibly not moving


Hello--our Kenmore Elite has been showing exactly the same symptoms.  Since it's under warranty I had a technician take a look at it, in fact he just finished putting it back together: problem was accumulated food and junk around the inlet filte ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1481 seconds