Having problems with your Beko Dishwashers ?

Failed auto defrost

\015 My Beko Larder fridge has stopped automatically defrosting, resulting in thick ice building up at the top and rear. I have followed all the instructions in the manual, cleared the drainage channels etc, but to no avail.\015\012\015\012Is this a known problem?\015\012Is there a reasonable cost repair?\015\012\015\012Thanks\015\012\015\012Ray Green\015

Answers :

Repair Help & Product Troubleshooting for Beko Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Failed auto defrost


... Beko Dishwashers

I have 3 Heller wall timers model DTW and all have failed in the same way. When they switch on (in auto or manual) the relay continually cycles on and off (relay not holding in). I've contacted He


... Dishwashers

Bosch Exxcel Auto Option, 2004. SGS56E02 GB/47 Stopped mid program all program lights flashing, on re-set several program lights illuminated, able to select rinse program but several lights illuminated and fails to pump out at end of rinse. What has gone wrong?


... Bosch 24 in. SGS57E02 / SGS57E08 Exxcel Free-standing Dishwasher

My Samsung DMT800 series dishwasher has had the main control board replaced under warranty three times since I've had it. The problem: The unit won't activate via the touch buttons until I pull the plug for a second and "re-boot" the device. It then works for a few days or a week and fails again. The last board was replaced two weeks ago and it has failed only once. I'm waiting for it to fail again before I call Sears home services again. Has anyone else had this issue? My repair man has said y


... Samsung Dishwashers

Machine runs until manually shutting down, or until auto-shut down. In either case machine will not start back up for sveral minutes. Can I replace, disable, or remove the auto shut down feature. It's bexcome quite a problem. Please help. Mark


Hi and welcome to FixYa, I am Kelly. \015\012 \015\012I note that your question was 3 months ago. I answered a current post today that had your exact same symptoms. Your post was revealed after I answered the curre ... Dewalt DPD3100 Gas Pressure Washer

Fagor 6kg dishwasher FUS-3611 IT problem.Select the wash option, but fails to start wash and door lock light fails to light. please help


... Fagor Dishwashers

KitchenAid 24 in KUDM0IT JWH0 auto test mode? Starts, fills, but doesn't wash or rinse, just hums, drains fine. There was **** in the screen with the chopper under the filter (clogged) a piece of glass got caught under there, I removed it, it worked fine until I removed the glass. I just did the auto test mode thing and it did some filling and then drained. Still not working though


... KitchenAid 24 in. KUDS02SR Built-in Dishwasher

Bosch dishwasher model shx36l fails to stop pumping. The drain was clogged. I cleared the drain. Dishasher backed up, water overflowed. Clog has been fixed. Dishwasher will not stop trying to pump water out. There is NO water inside dishwasher. I wish to run another load however unit fails to respond. Pump is operating even when front door to doshwasher is open. Turning the power button to OFF is the only remedy to stop drain pump from operating. How to fix?


... Bosch Integra® 500 SHX46A0 Dishwasher

I have a miele washer unit model G7881. it has failed towards the end of the cycle showing F22 and still has water in the bottom... Might this be a failed drain pump?


Failed or blocked most likely blocked ... Dishwashers

1. changing dishwasher settings from the various dishwashing selections (i.e., auto, auto plus, regular, delicate, etc.). I cannot change the settings from one to another. 2. getting film free cleaning results. Honestly this dishwasher has never provided crystal clean (filmless glasses) or completely dries the full load.


... Bosch SHX68M06UC 24 in. Built-in Dishwasher

We have a ASKO D3450, and it have worked perfectly well for 8 years. Today we have a problem with it. It look like the children-secure is activated becouse the AUTO-lamp is lightning. We try to turn it off, by turn off the power, hold the two keybuttons and turn it on again, press program; and then the AUTO-light should be turned off, but this dosent happend. When we close the door, the machine start to wash, but it seems that no program is activated, and the soap chamber does not open at all.


You have lost the control board.... ... Asko 24 in. D3450 Dishwasher

The reset switch on my NS powerwasher has failed twice. the replacement i got from NS was installed by their approved service center in antiock illinois, but it failed to reset the motor. Is there a service center in NE Illinois or SE Wisconsin that can service my washer?


Hi\015\012\015\012I see you are having very bad luck with service on this washer so I'm sorry to hear that. From my knowledge of North Star they usually have fairly good customer support and it irritates me to see you are having these pro ... North Star Pressure Washers

My Maytag MDB8951AWS Dishwasher buttons do not respond, except Auto Clean, Start/Cancel and Delay. Consequently the only way to wash is on auto clean. I have tried disconnecting the power for an extended period to reset it. This hasn't worked is there a key combination to reset? Thnaks


... Dishwashers

Dishwasher not emptying at the end of its cycle. If water siphoned out will work temporarily then fails again, with water remaining standing inside machine. Check water indicator light is on, goes off when water siphoned off, then comes on again when machine again fails to drain


Not sure of your light indicator; check the manual. But fyi there should be a little water left in, so the rubber seal doesn't dry out. More than that, and could be clogged drain or bad solenoid, which tells it to open and drain. See: http://www.part ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

Asko D3450, Stops with flashing "auto" and "pot", all the water has been drained. If I poor more water into the dishwasher and restart the flush program it will empty the water before it starts to fill water.after the program has flushed it stops with the flashing "auto and casserole" lights.


Water level switch is no operative..i have same problem 5,6 months ago ...\015\012regards Peter ... Asko 24 in. D3250 Built-in Dishwasher

My model # is 8573030. the machine is about 4 years old. the control panel failed after about 1 1/2 yrs. it has failed again. can I fix this myself? if so where can I find the parts?


Hi there. The correct part number for your replacement control board will be W10084141. The original control board that was shipped with this unit dose not exist anymore, at this time. Due to this f ... KitchenAid Dishwashers

I have a Karcher K3.48M electric pressure washer which used to shut off when you weren't using the cleaning wand. This no longer happens and there is alot of water running out of the bottom of the unit. (This didn't used ot be the case) I expect a leak somewhere inside the unit, but I'm wondering even more if there is a pressure switch which has failed that cased the leak. In other words, if I find and repair the leak and there is a failed pressure switch, it will likely only break again. I can'


Hi you will have a 8 digit number on a silver plate on the machine with a number like 1.141-470.0\015\012Then go to www.karcher.com then on the left click on Europe, then you ... Karcher PSI Electric Pressure Washer

I set my dishwasher to pots and pans to run a dishwasher cleaner, and now when I push the auto button, the time reads 2hrs. instead of the 93 mins. it always read before. How do I reset the auto button to the way it came?


... Maytag MDB7100AWB Dishwasher

The controls are intermittent, and at the times they fail to work the lights also fail. Always the ones (buttons)on the left side...the pots/pans side always seem to respond ... I suspect i need a new controller due likely to corrosion but is this a likely scenario? and if so, which part no.


... Whirlpool 24 in. DU910PFG Built-in Dishwasher

Bimetal fuse The incoming power was blinking off and on due to a storm, it caused the bi metal fuse to fail in the dishwasher when it was not operating, the fuse was replaced with kit #w10258275, now two weeks later the fuse has failed again while operating.These fuses are expensive, I would like to know the value (amps) of these fuses so that the system can checked to try and find out the reason for failure, or maybe you might have an idea where to start. Thanks Tad


... KitchenAid 24 in. KUDI02IR Built-in Dishwasher

My SE53200GB/01 fails to input water. I have checked the inlet supply hoses and filters and they are clear. I have tried different programmes and they all activate but the water fails to enter the main chamber. Any ideas what may be the problem. Could the Aqua-Stop mechanism have kicked in and if so, how do I rectify it? Thanks


Your aquastop system is activated :deactivate by turning off the water supply, running the dishwasher so \012that it is expecting to fill (if you hold the grey square box at this \012point, you should feel it slightly vibrating, which is a good sign ... Siemens Dishwashers

I wanted to heat up a cup of tea. As I've done many times before, I pressed Time, then 1:20 seconds, then I pressed Auto Start, but fear I may have touched the button below it, which says Start in small red print. The oven wouldn't switch on, and I noticed a small green u-shaped mark had appeared at the base of the 1: I pressed Clear, and repeated my movements, making sure this time that I pressed Auto Start. Again, nothing happened. I've cleared the touchpad several times, but the oven won't


... Danby 22 in. DDW399 Free-standing Dishwasher

Code F2 I just replaced the door switch on an inoperable DD-602. My top drawer was working fine, but my bottom one has been offline for a while (door switch failed and I never got around to fixing it since I had the top). Well, my top finally failed too so I replaced both switches. Looks like everything is good on the top, but my bottom is erroring with an F2 code now. Kindof makes a thumping noise as it starts the cycle -- maybe 3-5 short thumps and then a 10 second delay, repeats. Any ideas? C


F2= \015\012The motor has not\015\012been sensed rotating\015\012\003 Foreign object has jammed the rotor\015\012\003 The rotor has failed\015\012\003 The hall sensor has failed\015\012\003 The electronic controller has ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Dewalt 3800 pressure washer fitted with a 67DX39G11 pump. Started unit up for the first this year, has pressure for 15 seconds then nothing. Water is flowing through okay, everything seems in order but no pressure. Unit is 2 years old but has only 15 hours of total running time. I think the pump has failed, is it normal for a pump to fail with only 15 hours on the clock?


... Dewalt 3800 PSI Pressure Washer

Display fails to illuminate on diplay board, 12v to card but fails to power on. hotpoint dishwasher lft228a


... Indesit Hotpoint Dishwasher Control Pcb C00261863 Genuine
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0214 seconds