Having problems with your Belling Dishwashers ?

The wheels that hold the runners keep coming off,


Answers :

Repair Help & Product Troubleshooting for Belling Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The wheels that hold the runners keep coming off,


... Belling Dishwashers

Dishes not coming out clean, water is coming out of arms but doesn't appear to be rotating (either top or bottom). Trying to figure out the test cycle on the shu3302uc model (when I hold down pwr scrub and reg wash) the pwr scrub and rinse/hold light will keep blinking when complete, when I use pwr scrub and rinse and hold, both these will keep blinking after cycle is run.


There is a recall repair notice for this model (and several other models) on the Bosch website. There is a faulty controller which may cause a fire! They have an 800 number for setting up a recall repair appointment. Check it out! We just found o ... Bosch 23 in. SHU3302UC Built-in Dishwasher

We have a Whirlpool mod# DU1055XTVD0 dishwasher .. the blue latch designed to keep the lid to the detergent dispenser closed after filling has come loose from the inside door panel and now will not stay in place to keep the detergent lid shut. We did find a small o-ring in the bottom of the tub that apparently is part of what helps maybe hold this latch in place, but obviously there must be something else that fits inside the hole the latch goes in that keeps it secure. This


... Whirlpool Dishwashers

Whirlpool Quiet Partner II - top rack side rail is coming off of tub wheel. The thread holding the tub wheel screw in the wall of the dishwasher is stripped so the tub wheel sits at an angle away from


... Whirlpool Dishwashers

My accusense light keeps coming on and blinks continuously. I tried the heat-dry, normal sequence and it would reset to 2 minutes. After the 2 minutes cycle, the accusensor blinking would begin again. Then I tried holding the heat-dry button in for 5-seconds. This looked like it worked so we set a normal cycle without heat-dry. Äll looked good, but a few minutes in, the normal light was off, the accusensor was blinking again and the heated-dry was on again! Is the unit possessed? Other id


... Whirlpool GU2400XTP Built-in Dishwasher

I have a Frigidaire FBD1250REQ0 dishwasher, and the top rack keeps coming off the wheels on the right hand side. How do I fix this? Also, when we push the start button the washer does not aways start. We have to open and close the door and try again, usually several times. Is this fixable?


Hello,what this simply mean is that there has been a lost or pastier connection on the power distributor from the panel to the control unit .what you are to do to solve this problem is to unscrew the washer from the screws then trace the ... Frigidaire 24 in. FDB1250RE Built-in Dishwasher

Du945pwpq0 the wheel that the upper dish track rides on screw keeps coming loose from tub?


Check and see if your aloud to use loc-tite sealant. ... Whirlpool Dishwashers

Hi i have a whirlpool dish washer - model : ADP4731/5 , AAA class . I keep getting a F7 error message and it is not allowing me to turn the washer on , if i hold the start button down it allows the washer to go for 30 seconds before the error comes back up and it stops working again


... Whirlpool Dishwashers

I want to remove the white plastic wheel that propels water into the circulating arms. It is held with one screw which I cannot seem to be able to loosen. This white plastic wheel has 2 small holes in the surface which are perhaps there for some special tool to hold the wheel stationary in order to loosen the screw holding this wheel in place. Underneath this gray plastic housing is the heating element. I want to remove it in order to clean accumulated deposits of gunk.


It's reverse threaded. ... LG 24 in. LDS 5811 Built-in Dishwasher

My dishwasher keeps filling with water and the water then starts to come out of the bottom of the door. It therefore does not go into any cycle but keeps trying to fill with water but the water keeps coming out of the bottom of the dorr from the inside


... KitchenAid KUDS24SE Built-in Dishwasher

My Bosch SHX46A dishwasher keeps filling up with water and won't stop. The water just keeps coming up through the bottom. It will drain fine, but after the cancel drain sequence, water just keeps coming up, overflowing the tub onto the floor. I had to shut off the water.


... Bosch Dishwashers

Model #363.14232100 dishwasher. When you turn the switch to on, it will not come on. If you keep turning the knob slowly you can hear the dishwasher trying to start up,but it doesn't. Keep turning the knob and its the same thing, sounds like it will start, but it doesn't. It did fill with water, but once it was opened it didn't start up where it left off. The lock switch was in position, and still nothing. Now I have water in the bottom but can't get the thing to come on. Any suggestions? Help!


... Kenmore 24 in. 16539 Built-in Dishwasher

My dishwasher was not getting the dishes clean, so i started taking the lower end apart to clean, got to a gray wheel looking object with a screw in the top which was recessed and still the wheel looking object will not come off, it will spin but will not come off, I need to finish taking it off because I dropped a screw down in the bottom area where the water settles.


If there is still standing water in the bottom of the dishwasher, remove it with a wet vac then look for the missing screw. It might be in the vac.\015\012\015\012If no luck, try using a good small stick magnet to retrieve the screw. The ... Maytag 24 in. MDB4000 Built-in Dishwasher

Don't know the brand of my jetted bathtub, which blows water. The round on-off dial just stopped functioning - stuck in ON mode. Using GFIC, it turns on & off just fine, so problem is with the round knob. Unassembled dial and removed. Have piece that turns, round at top, narrow flat at bottom with a little black metal wheel that comes out. Wheel function not clear, given how dial turns unrelated to wheel. Inside hole, all plastic. Center spike fits into removed piece with wheels. 2 black pl


Ok this is not that easy to picture, any chance of emailing photo?([email protected]) the electrical connections will be somewhat remote to the dial so as to isolate the wet user from the power! can you after switching off at the breaker, get behi ... Dishwashers

Water is not coming to the washing machine, when I hold the start button down the pump runs a bit like trying to start but no water comes in. The water connection is OK but is there anything else we c


Is this a dishwasher or a clothes washer? Have you checked to make sure there is water flowing into the unit and someone has not shut off the valves to the water lines? ... Whirlpool Dishwashers

I have G1023U CS Built - Under D/washwer and red light on drain keeps coming on. All dishes are wet but the tablet has not been released. Have reset more than once and also turned power switch for over an 3 hrs. When I tried another cycle you can hear a noise as if starting then the water coming through then the drain light comes on.


... Miele G2732SCIWHWH Dishwasher

Zanussi DES 959 - AL5 warning keeps coming up indicating either the filters are blocked or there is no water coming in. Filters are clear and there is water coming in - what next?


... Dishwashers

Water softener Salt residue remains on the dishes. The water softener is going throught salt like crazy. I fill the salt and make sure that the light is off before I start the cylce. Within the first 20-45 mins the salt light comes on again and the dishes will not wash properly. We have come to the conclusion that the salt is being distributed to quicky but cannot figure out why the light keeps coming on. The switch inside the cap for the salt is set a the min.


Just a thought, I hope the lady did not use table salt :-) ... Danby 17 in. DDW1802W Designer Series Built-in Dishwasher

Asko D3251 - the swivel part that is supposed to keep the top rack from coming all the way out is constantly turned the wrong way. The rack comes out and dishes get broken. Has anyone come up with a solution for this?


... Asko D3251HDSS Stainless Steel Built-in Dishwasher

I have a whirlpool du1100xtps sudenly stop working when I plug the machine, the stop/drain button comes on, and about 15 seconds later turns off and the normal button comes on but blinking and after about 15 seconds the stop/drain buttom comes on too also blinking and then just keeps going on like that and nothing else happens??????? how can I fix it, or what is wrong with the machine?


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

LG Dishwasher My LG Dishwasher Model: LD 14AW2 Electronic stand alone keeps on coming up with an error E1? I am not sure what it is because we have no instruction manual. The dishwasher is about 2 1/2 years old. I am doing a standard (Normal) wash. It starts to put the water in side then comes up with the error.


I have same dishwasher first check the water is cumming in if not remove the left side cover.1) the bottom tray is full of water you have a leak . replace the leaking part . 2) you will see a foam float toward the back of ma ... Dishwashers

My dishwasher also gets stuck at 1 minute and it keeps on going and going . I had to turn it off. I called up bosch and they told me to hold the power and the rinse and hold button for 5 seconds but it did not solve the problem - now i have to go through the exopense of bringing in a technicien do you have any solutions???


Well basicly the technicien came and knew nothing - he tried a few things so he is alreadyto change the electric board and we all know how expensive that is - any way he left saying he will come back today with a new board  - after he left i wen ... Bosch 24 in. SHU5305UC Built-in Dishwasher

Bosch Dishwasher Cycles will not stop running. They keep starting over. Help please!! Our 2 year old dishwasher will not stop running. It gets to the end of the cycle and starts over again. Plus, the cycles seem to have gotten longer. We called the Bosch repair number and they want $150 in cash to come out and look at it. Then they will come out and fix it!!!! Unbelievable!!!


Carry out a reset.\015\012This should reset the board back to factory settings,\015\012Deep Diver ... Bosch 24 in. SHU5305UC Built-in Dishwasher

Bosch Dishwasher our disherwasher keeps coming up with the letter (F) on the front screen goes any one knw what this is. I have no water coming through the machine have checked the hoses the are not blocked. Help needed....


What is your model number? list it so I can look it up, also check to see if there is any water standing in the bottom pan,not inside where dishes go, down behind where toe plate is.Remove toe kick plate,remove panel behind kick plate.If there is wat ... Dishwashers

The slide on the upper basket keeps falling out. It's been fixed twice but doesn't hold. The second repair man who put the slide back in the rollers said he couldn't see anything wrong with it, but it still didn't hold, so he called your tech dept. who said they had roller and slide kits at a total cost of $66 for this model. The slide kit had a new part number but the tech department didn't tell the repair man why they'd changed the part. The roller kit was one for dishwashers the sides o


One option is installing stainless steel washers on the rack supports that screw into the side of the tub. The rack falls down because there is too much "slop" with the rack...a couple small washers to space them tighter normally does the trick. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0573 seconds