Having problems with your Black & Decker Pressure Washers ?

Nozzle won't lock into hose

\015 Tried to fit nozzle into place slid in and tried to turn to lock it and t won't lock into place. When water and pressure is turned on it flies out of hose.\015

Answers :

Some of the locks work by pulling them back to allow the nozzle to be inserted,(rather than turning) then release the ring to lock it in
Repair Help & Product Troubleshooting for Black & Decker Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Nozzle won't lock into hose


Some of the locks work by pulling them back to allow the nozzle to be inserted,(rather than turning) then release the ring to lock it in ... Black & Decker Pressure Washers

Shu9925uc/14 bosch dishwasher leaves standing water in the bottom of the pump. The pump seems to be bad because it wont drain out the back hose. I have run the diswasher full cycle and put the drain hose into the sink to test. It wont drain at all now and I dont hear the pump. Perhaps unrelated: Pump seemed to stop working after the back hose disconnected itself from the back of the unit spilling water all over the floor. When I reconnected the unit to the wall the pump now seems to be disfunct


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dish ... Bosch SHU9925UC Built-in Dishwasher

I have a 2300 psi gas pressure washer, campbell hausfeld, runs fine but water comes out the nozzle like a hose , no high pressure. inlet filter is clean and when you pull the trigger on the nozzle water comes out like a hose but no pressure


If you no longer have High Pressure coming out while machine is running, it's a pump issue. ... Campbell Hausfeld PW2575 Pressure Washer

Lock light wont go off dishwasher wont turn on


Http://shared.whirlpoolcorp.com/assets/pdfs/literature/Use%20and%20Care%20Guide%20-%206-920374.pdf\ ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

My dishwasher wont close. the door wont lock so it wont start. on the top of the dishwasher inside the silver thing is bent down is it supposed to be like that or staight could that be the problem?


... Smeg 24 in. DWF1 2 Free-standing Dishwasher

I have a Kitchen aide dishwasher Model KUDI01ILWH6 that will not turn on..there is a control lock light on and I have tried pushing the cancel button but all that happens is the control lock light flashes 3 times and the dishwasher still wont turn on....Please , how to I disengage the control lock


... KitchenAid Dishwashers

Briggs & Stratton 2200psi/model 020228 siphon hose shoots water out when using high pressure nozzles


... Briggs & Stratton 2200 PSI Gas Pressure Washer

Ge dishwasher water disposal hose wont fit


... Dishwashers

DD601ver2 Top draw wont drain properly.Leaves about 2 inchs of water(clean). Occaisionally u3 code shows.Have tried eveything i can think of. HP is correct Drain hose and filter to pump are both clear. No blockages. Have swapped motors from bottom to top and makes no difference. Have swapped inlet hoses around and no difference. Have run diagnostic and when in drain mode P2 it drains very slowly - takes 1 minute 42 seconds to drain 2 litres of water. Bottom draw takes just 30 seconds to do the s


Check for restriction in sump. ie remove rotor, push pipe cleaner or similar from filter sump into rotor sump ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The lock on light wont go off. We can not start the dishwasher. We have tried holding the noheat option for several seconds and have turned off the circuit box for several minutes and neither one made the lock on light stay off.


That is the correct button to push to turn the control lock off. You can try to reset the control by removing power for two minutes. If the dishwasher is doing the same thing, most likely the touch pad has a shorted button or a bad connection on the ... Kenmore Dishwashers

Lock wont turn off . i hold the heated dry button for more than 3 seconds and it still wont turn off. tried resetting with breaker swicth No luck


I would be more likely to believe that it is the locking solenoid.You say the light is faint, which leads me to believe that there is a high amperage draw from this locking mechanism. Remember, the locking solenoid should definitely affte ... Dishwashers

Admrial dishwasher stopped getting water from hoses, i replaces all the hoses ubder the sink still wont work ,it drains if i put water manualy in to it just does recieve water


Not really all that familliar with the admiroal d/w, but ther eshould be some sort of float switch/ overfill switch inside the tub assembly. usually a mushroom shaped plastic cap in either of the front corners under the lower rack. if that "switch" i ... Dishwashers

My dishwasher 'start" button won't kick in. The machine seems to think it isn't locked - light wont activate, but the door IS locked. I select the cycle and option, but when i push start, it won't stay, The "clean" button keeps flashing. This is 5 years old


Hi,How many Blinks are there?Is it 7 Clean Light Blinks?Let me know, so that we could proceed.Hope i helped you.Thanks for using ' Fixya ' and have a nice day!! ... Kenmore 24 in. 17032 Built-in Dishwasher

Dd601 ver2 Top draw wont drain properly.Leaves about 2 inchs of water(clean). Occaisionally u3 code shows.Have tried eveything i can think of. HP is correct Drain hose and filter to pump are both clear. No blockages. Have swapped motors from bottom to top and makes no difference. Have swapped inlet hoses around and no difference. Have run diagnostic and when in drain mode P2 it drains very slowly - takes 1 minute 42 seconds to drain 2 litres of water. Bottom draw takes just 30 seconds to do the


I had the problem with the top draw not draining properly and the dishwasher showing the U3 fault code on my DD601 v.1, I did'nt have a copy of the dishwasher manual so it took the following steps, this is best done out side to save on messing your k ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Bosch wont Hello i have a Bosch DLX Series dishwasher and i put it outside and covered it while i did my kitchen remodel.. 6 months later kitchen is done and i move the washer back in. It turns on and it sounds like its running but it wont take in water from the hose. which is on and connected. any suggestions thanks very much...Steve


Faulty inlet valve or water in the bottom tray which will activate the float swich and pump out any water. See that this moves up and down freely. Turn electrics off first. ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

I can't connect the garden hose to the water inlet. I am using a size 5/8'' hose but it wont connect to the unit. Please help!


Karcher electric pressure washers typically are supplied fitted with the male half of a standard Hozelock connector. You need the female half secured to the end of your hose, and then they just click together. ... Karcher PSI Electric Pressure Washer

The lock light on my kenmore elite dishwasher #15962990 wont stop blinking. It wont reset to run a cycle. How do I reset the control panel??? HELP!!


Hi\015\012\015\012To reset the control panel press and hold the RINSE ONLY/AIR DRY button for 15 seconds. Hope this helps....please let me know if you need further help.\015\012\015\012Daniel ... Kenmore Dishwashers

My LG dishwasher wont drain the water, I have checked all the hoses they are not crimped, The water wont drain on the last cycle.


Hiiiiiiii\015\012i need the download for webcam LG but i no knew name or type my webcam\015\012it without any think\015\012i need for help me ... LG Dishwashers

Scunci steamer wont work. steam wont come out of the hose


... Pressure Washers

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Programming lights are lighting up when i turn machine on but wont set on a programme. Also the door wont lock in to place?


... Maytag 24 in. MDB8751A Jetclean II Built-in Dishwasher

Our washer had been woring fine earlier this afternoon. After a short (about 10 minute) break, it developed only hose pressure. We disassembled the nozzle, figuring there might be some obstruction; also made sure the hose wasn't kinked. No luck even though the motor is apparently running fine. It's about one year old. What do I do now?


Can you see my posting: "Karcher - no pressure", also my own comment where I describe my later technical findings - mashed up gearbox. Could it be the same problem as yours, where the motor sounds to be running just fine but there is simply no press ... Karcher PSI Electric Pressure Washer

My Ge profile Triton Dishwasher wont start when I lock it just keeps beeping and the" normal "light flashes there was something stuck in the turnstile and it stopped and beeped all night when I took it out it was left this way I have turned the power off and on and I still cant reset it any ideas it just wont reset


... GE Dishwashers

My GE Adora wont get the close clean, as a matter of fact it wont even get all of the cloths in the load dry. We have already checked the hoses to make sure that the water is not being blocked in any way at least up to the machine. HELP!! We're starting to stink!


Slightly confused here. Do you have a washer, a dryer or a dishwasher.\015\012\015\012Please provide the full model number to help understand the problem so that I can provide a solution . ... GE Adora GHDA656LSS Stainless Steel Built-in Dishwasher

Dishwasher wont let u select a cycle...all buttons seem locked...ive unplugged it for 5 seconds or so and then plugged it back in and the normal wash button light comes on and the heated dry button light comes on, but it wont start and it doesnt respond when buttons are pushed...please help. thanks


... GE GLD4560NSS Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0617 seconds