Having problems with your Bosch 18 in. SRS45E02 / SRS45E08 Exxcel Slim-Line Free-standing Dishwasher ?

DISHWASHER IS ONLY FILLING WITH A SMALL AMOUNT OF WATER


Answers :

The water level detector pipe could be obstructed / blocked. This thin plastic pipe is at the bottom of the washer and as it fills to the correct level of water the pressure in the pipe activates a water level switch in the washer. Sometimes the air pressure pipe becomes blocked / obstructed or the contacts of the pressure switch become burnt. You can disconnect the pipe and blow through it and the pressure switch is normally factory set and does not need adjusting. Replace it if necessary.
Repair Help & Product Troubleshooting for Bosch 18 in. SRS45E02 / SRS45E08 Exxcel Slim-Line Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have the Siemens SL84A305UC Dishwasher. All of a sudden it stopped cleaning dishes, but everything sounds normal and it fills and drains water, and sounds like it is completing the cycle. In the past when I opened the door while it was actively washing the water would spray out aggressively. Now, when I opened it while it was supposed to be washing I see just a small amount of water coming from the bottom wash blade, and not even enough to turn the blade very far. I thought it was just a c


... Siemens 24 in. SL84A305UC Built-in Dishwasher

My GE dishwasher fills up with a small amount of water, but the main pump never starts. it runs through the cycles, but never sprays water


Has it sat for a long time not being used ?\015\012\015\012some times the pump seal on the vavle gets dry & wont switch..\015\012\015\012There should be a cup looking cover inside bottom..\015\012When first turning o ... Dishwashers

Dish washer does not drain after the cycle is complete. The last few months when the dishwasher is done their would be a small amount of water left in the bottom. It didnt create any problems but would smell after a few days. So we would just run the drain cycle and it would empty. Well i got home to and the wife said the it was really full. The water was dirty and when you run the drain cycle it didnt drain. She said the dishes were clean. So i cleaned the vent, and filled the sink with


Check drain hose and drain pump.End of drain hose must be in same level with machine.Try it. ... KitchenAid KUDR01TJ Dishwasher

Dishwasher fills with water, but will not spray. A small amount of water comes out the bottem spray arm holes but the pressure is very low.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. To start with check the\015\012spray arms and try to clean the holes with a pin or straighten clip as the\015\0 ... Dishwashers

DISHWASHER IS ONLY FILLING WITH A SMALL AMOUNT OF WATER


The water level detector pipe could be obstructed / blocked. This thin plastic pipe is at the bottom of the washer and as it fills to the correct level of water the pressure in the pipe activates a water level switch in the washer. Sometimes the air ... Bosch 18 in. SRS45E02 / SRS45E08 Exxcel Slim-Line Free-standing Dishwasher

Frigidare fdb1500lfco Dishwasher is only filling with small amount of water, then making loud humming noise.


Good Morning Kristen - You may try to reset the dishwasher\012by unplugging it or flipping the household circuit breaker off. Wait approximately\012ten minutes and turn the dishwasher back on. If this proves to be ineffective,\012then the unit may po ... Frigidaire 24 in. FDBB840DC Stainless Steel Built-in Dishwasher

We have a Sears Ultra Wash III dishwasher, model 665.1677993, bought in October, 1995. It is not filling with enough water to get the dishes clean. I took the water valve out and looked at it and it seems okay. It doesn't look like the valve is opening all the way - just my guess. A small stream of water comes out with good pressure, but it is a small stream. I can't find any screens or filters in the water line coming in. The fill cycle lasts only about a minute. Is that adequate? Steve


There should be another letter after the p in your model number. If it's just a B then there are no parts available for that model. Typically a dishwasher will fill for 90 seconds or more. One minute or less sounds like you have a control board is ... Whirlpool GU2400XTP Built-in Dishwasher

Item: Whirlpool Ultra Dishwasher Age: 3 yrs Problem: Not enough water to effectively wash the dishes. State: When the dishwasher is started, the fill valve opens as normal. Only about 1/2 the amount of water is let in when the pump turns on and the washing cycle begins. Opening the door shows that the water level does not reach the bottom of the float. When I close the door, the wash cycle begins again but stops after a few seconds. This is when the water begins to fill again. This time, the wat


Larry,The float is generally for overflow conditions and will interrupt power to the fill valve solenoid. If you are not filling completely in the time allowed by the timer, it is most likely a flow restriction in the water ... Whirlpool GU2400XTP Built-in Dishwasher

G.E. GSD5130 When the dishwasher is pumping out the water a small amount comes in the rotating sprayer head. At the end of the cycle the dishwasher still has water in the bottom. The amount of water varies from just a little to over an inch. I replaced the spring loaded check valve a couple of months earlier and everything worked fine until now. What should I check? Thankyou.


Mike, I just ran into the same problem. I found a second check valve located in the outlet hose of the ELECTRIC drain motor. This motor is located at the right rear underside of d/w and is used only for backflush of the filter. When the unit goes th ... GE GSD5130 Dishwasher

My dishwasher is only 2 years old. My small coffee shop is in an area where we have large quantities of lime. At this point in time the repair people have been out two times and this is not fixed. There appears to be no water being pumped into the dishwasher where it will be heated prior to washing. Also the temp gauge is not working all the time. With no water entering, the small amount of water in there is rising in temperature quickly if the gauge is working. The technician that have be


... Champion Dishwashers

Miele dishwasher makes grinding noise when turned on, there is a light on front next to inlet/drain. So I poured some boiling water into the dishwasher and then left it turned on and could feel the boiling water coming out of the drain hose so I am assuming it is an inlet problem, as it will drain but will not fill or otherwise work.There are a few small cracks in the outer hose of he inlet hose just below the grey box thing, could that be enough to cause the problem? They are only small so I di


... Dishwashers

FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Dishwasher filling I have a Diplomat dishwasher. When it fills with water, only a certain amount flows through into the machine and the water backs up and floods the kitchen


Check to see if you have anything plugged ... Dishwashers

Our 2 month old Frigidaire FGHD2433KF1 dishwasher is producing a very strong foul odor. It is not connected to a garbage disposal and we only see a small amount of water in the bottom of tub when the dishwasher is off. When I use the sanitize cycle, it seems that the smell is even more intense, not sure if that could be do to a small amount of steam escaping on the highest setting ? We have no idea what to check any suggestions would be much appreciated


Do you have it connected to an air gap? If not this can allow the water to drain back into the dishwasher and will sometimes have food particles in it making it stink. ... Dishwashers

We are having water leak from the bottom of our Roper Dishwasher door. THe model # is RUD5750DG3. I have taken the inside door frame off and found a small white rubber seal had dislodged inside. i placed it back in the only sopt it fits but water is still leaking. I have checked to make sure the water is not leaking from any where else on the dishasher. This occurs when the water inside is spraying and eventually fills up on the bottom. We no longer have our manual as the dishwasher cam


Try to fix the rubber seal which has come out by fixing it through super glue or apoxy seal which will stop the water spill and leakage.\015\012Please give more details of you dwasher ..... the Make and model so that i can send you the manual f ... Dishwashers

Smeg DWF612WH dishwasher has developed a leak. Water comes out of the rectangular hole on the side of the water softner used to mount what looks like a level or pressure switch. A few seconds after the fill valve opens water leaks out, not a lot just a small trickle. After the washer has filled and goes ito its cycle, it does not leak again. Over the past weeks the problem has got progressively worse.


... Smeg 24 in. DWF612WH Free-standing Dishwasher

I have a Kenmore Model 665.15955792 dishwasher. Water is leaking out the bottom of the door. I changed the door seal and the defusers but it continued. I took off the front of the door and I see the water filling into the base of the machine. When the dishwasher starts the cleam cycle, water is pushed up into the small square holes in the bottom of the door and then splashes up over the lip of the door and out onto the floor. It has never done this before, just started recently. I have had the d


... Kenmore Dishwashers

Dishwasher I bought a 2006 Kenmore dishwasher model #66516032400 and the water does not totally drain out from the dishwasher. There is always a small amount of water left at the bottom. Has done this from day 1.


Check whether the drain line was assembled exactly as per Kenmore's instructions.\015\012Good luck! ... Kenmore 24 in. 16032 Built-in Dishwasher

I have a Kenmore Elite dishwasher (2004) and recently it has been leaking internally at a very slow pace. When not in use it will slowly fill until the floor of the unit is filled and then leak onto the kitchen floor unless we press the drain button and then it drains completely. The water seems to be coming from the front of the washer, potentially from the door itself. The amount of leakage is barely discernible but will fill over the course of a 24 hour period. The dishwasher otherwise wo


Hello,\015\012The water is admitted into the dishwasher through a little magnetically controlled valve underneath your dishwasher. This valve opens and shuts electrically. There is a little plunger in it that is pushed shut by a spring when no ... Kenmore Dishwashers

I have an Asco D3350 dishwasher. When the cycle starts the machine fills with water and when there appears to be the right amount of water in the machine an error code F4 shows on the panel. 3 clicks can be heard during the first 5 seconds of the F4 code showing. If I cancel the cycle and start it again it pumps out the water and then fills again and the code returns. Any ideas?


... Asko 24 in. D3350 Dishwasher

I have a whirlpool dishwasher DWF 415. During the last two wash cycles There has been a small amount of water under the dishwasher (about a large glassful). It is coming out of a small plastic pipe at


... Whirlpool Dishwashers

Hi, I have a Kenwood KDW 12ST3A Dishwasher. Doesn't matter which programme you set it going on it will evacuate a small amout of water and then freezes. I can hear a low pitched buzzing noise but nothing else happens. I'm not sure if it allows a small amount of water to enter the machine. Any ideas?


... Dishwashers

Our KitchenAid KUDS011JBS1 dishwasher sometimes leaks water on our kitchen floor. It seems to drip from the bottom edge of the door onto the floor. It's not a huge amount of water, but is enough to be a concern... it leaves a small puddle on the floor. What should I check and how do I fix this? I'm hoping it's an inexpensive and easy fix. Note that we've had this dishwasher for 8 years and have only noticed leaking during the past 6 months.


... Dishwashers

Bosch dishwasher model SHV6803UC/12 - washing cycle finishes with substantial water in pan. Dishwasher turns on intermittently following cycle and drain small amount of water but never close to completely draining pan.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I`ll start by letting you know there are many things which can manifest in the manner you`re describing...or even how one interprets what you`re ... Bosch 24 in. SHX46A05 Stainless Steel Built-in Dishwasher

Water leak have the Ge triton dishwasher (Model # GSD5320D02BB, bought it n 2001) and currently have very small amount of water leaking out of the door during a run cycle. I did check levels when running and that seems to be fine......meaning the dishwasher is level and not an over-flow problem. My next thought is maybe it is a faulty door gasket. So my question is, where is the door gasket located and how do I replace it? (and where do I order this part from?). Looked for diagrams to follow and


They are in the bottom left and right of the door opening. GE likes to use L-shaped, molded and ribbed seals on most of their models - hopefully also on yours. Typically these can be removed by hand and easily replaced without taking anything apart. ... GE Tritonr XL GSD6260JCC Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1579 seconds