Having problems with your Bosch 18 in. SRS45E02 / SRS45E08 Exxcel Slim-Line Free-standing Dishwasher ?

My dishwasher is not filling with water i have tried the water tap and checked the hose pipe it has been working no problem for about 3 years does that mean its wear and tear of the machine ? or could it be something else?


Answers :

This does sound like a problem with the "anti-flood" device that does detect water (leak / spill) at the base of the washer. This device is a protection device that consists of a polystirene float and a micro swithch. Once a water leak or spill is detected it automatically puts the washer in pump out mode and switches the inlet water off. You need to determine if a leak exists that has caused the float to trigger the micro switch and clear the water / leak. This should put the washer back to normal.
Repair Help & Product Troubleshooting for Bosch 18 in. SRS45E02 / SRS45E08 Exxcel Slim-Line Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher is not filling with water i have tried the water tap and checked the hose pipe it has been working no problem for about 3 years does that mean its wear and tear of the machine ? or could it be something else?


This does sound like a problem with the "anti-flood" device that does detect water (leak / spill) at the base of the washer. This device is a protection device that consists of a polystirene float and a micro swithch. Once a water leak or spill is de ... Bosch 18 in. SRS45E02 / SRS45E08 Exxcel Slim-Line Free-standing Dishwasher

I have a danby ddw496w that leaks water from the bottom of the machine when it goes into the drain cycle.it will start coming out the bottom as well as the drain outlet .Could it be a simple hose connection or is there something else that could cause this effect.the rear hoses are tight and it runs fine and does not leak untill it drains


Ditto- same issue, hoses are tight, just leaks through the bottom while draining. Anyone with advice? I just bought mine used, and the previous owner is willing to buy a replacement part, we just have to figure out what we need... ... Danby DDW496W Free-Standing Dishwasher

Glasses int he top rack of my kitchenaid dishwasher don;t get clean. they finish the run spotted and covered in what looks like baked on dirty dishwater. dishes in the lower rack look ok, but the silverware is always dirty, too. i figure it's one of two things - either the top sprayer isn't working, or the machines doesn't drain the dirty water well enough. or maybe it's something else - cycle regulator? the machine is about 4 years old. thanks


If you have hard water, glasses can look spotted and cloudy even after cleaning. Sometimes changing the dishwasher detergent can help. The easiest solution to clearing up glasses that start to look cloudy is to add some vinegar to the bo ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Our Asko D1796 dishwasher has all lights flashing and is displaying a F2 message, which according to the good book means there is too much water in the machine. I have followed the instructions for a normal inlet time but the indicators will not change. Is it trying to tell me the Drain Pump is dead? A new drain pump was fitted three years ago. There is no eidence of water in the machine. Can anyone help? Thanks. Alan


Hi Alan,\015\012\015\012The F2 on Asko means it's sensed an overfill, that in itself though can be provoked by a couple of thing's. First, check for blockage at the end of the drain hose where it connect's to your household plumbing, be it under the ... Asko D1796FI Built-in Dishwasher

I have a JDB1090AWS about 3 years old. We noticed a smell and found cutting boards and plastic cups melted. Machine was off. Had to turn off the breaker. Checked both leads to element & have power even with machine off. Not sure if it could be the limiting thermostat; I assume that is to shut the heat down when it gets too hot. Element is on though when it shouldn't be to begin with. I did have to tighten the water supply. Had some water underneath, but all wires seemed dry. Any tests I should t


The heat element can only get so hot.It's timed so it doesn't exceed a period of on, exposing dishwasher contents to continuous high temps.Watch the timer and take note how long it broils your cookware.Good luck. ... Dishwashers

Bosch SHU3322UC/14 water leak. After running a cycle, dishes are clean and pump evacuates water. After a while clean water starts rising in the washer, eventaully slow leaking at bottom of door. Suspect that the water inlet valve is problem but could this be something else?


... Bosch Dishwashers

"Sensing" Light Moved a 5 year old dishwasher that was functioning just fine to a different location. Hooked everything up and gave it a test run without any dishes in it. Fills and heats water properly, then buzzing noise heard for a ling time and then it drains the water out, with out circulating the water into the washer arms, etc. Any guesses? Could something have gotten lodged in the pump during transport?


There is a relay on the soap dispenser, if it is a Kenmore quietguard 4, I had the same type of noise, the repairman replaced the dispenser, which to me made no sense, because the relay is activated from the control board. After the $130. for the soa ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My dishwasher is a swan sdw7030w, water is going in and out the machine but no water is getting through to man part wher dishes are, am putting it on and it's jumping from my choosen cycle to economy while beeping, the salt light and starish looking 1 are both on as well, can anyone help me? It was working fine n old house, could it possibly be my water pressure as I can't think of anything else as a woman. Please help me.


... Dishwashers

My dishwasher is a swan sdw7030w, water is going in and out the machine but no water is getting through to man part wher dishes are, am putting it on and it's jumping from my choosen cycle to economy while beeping, the salt light and starish looking 1 are both on as well, can anyone help me? It was working fine n old house, could it possibly be my water pressure as I can't think of anything else as a woman. Please help me.


... Dishwashers

My Whirlpool Gold Series 980 dishwater no longer fills up with enough water to drive the washing arms, so the dishes do not come out clean. I cleaned the filter on the water intake valve (which was really clogged) and it still did the same thing. Replaced the inlet valve and still no change. The water does not reach the level of the overfill float switch, so that’s not it. Its been working fine for 4-5 years, what else could it be? Thank you.


I hve provided u with all details .read it carefully .it has all the resolutions for all possibilities ... Whirlpool Dishwashers

The water level in my Whirlpool Gold dishwasher does not seem to be high enough to clean the dishes. Also, the detergent dispenser opens but the detergent does not wash out of it. How do I increase the water level? Also, could it be something else besides the water level?


Screw fell into wash moduel. how do i remove the lower arm ect. Thank's ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

There is loud rumbling noise as the water fills the machine. What is up with this? Is it the water valve or something else?


Hello,\015\012\015\012Based on your description I`d certainly think it is an inlet/water valve. It sound`s like the valve may be creating "water hammer" which can happen if it is failing.\015\012\015\012If you go to an on-line ... Asko D1716 Built-in Dishwasher

Hi, I have a Karcher 3.75 jubilee powerwasher, there is water coming out from where the high pressure hose connects to the machine and the unit pulses when idling but works perfectly without drop in water pressure, when trigger on gun is pulled, on closer examination the metal connection on the hose turns, is this the problem or something else. thank you.


... Karcher Pressure Washers

Dishwasher leaking. I was supplied a flat seal ring of about 100mm dia., 10mm wide & 1 mm thick for the machine when I bought the house. Water on the floor tells me something underneath is leaking for the first time. The machine is about 10 yr old and in very good order .This seal could be the problem so before I go getting service personel in I'd like to know if replacing this and the door seal are jobs a careful handyman can do ?


I would say you could do it with out a tech.More then likely you can find information on the web on how to do it step by step or hey use this site more then likely one of us has had the same problem. ... Dishwashers

Hello What does the error code A13 represent. The soap dispenser seems Ok. Could it be related to something else. The machine starts up Ok, but about 6 seconds into a cycle A13 flashes up and the machine stops. Help me...I'M GOING OUT OF MY MIND


As you correctly pointed out A13 error is linked to the failure of the detergent dispenser lid operation.\015\012\015\012If the lid is not opening at the correct time in the wash cycle, then the detergent will not be getting dispensed. ... Indesit 24 in. DE73 Evolution Free-standing Dishwasher

Jenn-air dishwasher JDB-5 (jdb1105awb) will not drain. Have repeatedly prompted drain cycle (start/cancel twice) there is what seems to be a pump noise for a minute or two, but no water flow noise and water level is the same in the bottom. The manual is sparce on trouble shooting and schematics. I suspect something is clogging the drain path. No changes to the drain hose routing. Machine has been installed for three years with no major issues. What is the recommended disassembly sequen


... Jenn-Air JDB6510 Built-in Dishwasher

Dishes are no longer coming out as clean as they used to, especially bowls or utinsiles with dried on food. The machine appears to function ok, but is about 8 years old. The machine just seems tired. Am I looking at a worn out pump or something else?


Hello,\015\012\015\012Those are common issues with dishwasher's as they age, and very good questions. The Asko dishwasher however is a very good hi-end machine and typically good for much more than 8yrs. That being said, 8yrs. is subjective isn't it ... Asko D1706 Built-in Dishwasher

Dishwasher doesn't want to fill with water...float switch acts opposite of what it should....when I depress it the water solenoid activates and fills. Is this normal or could there be something else wrong?


If the switch is working opposite of what it should be doing then it is shorting out inside and needs replaced its as simple as that so replace the switch.the only other thing that could be wrong is if a wire has come off and the circuit is not compl ... GE Adora GHDA650LBB / GHDA650LWW Built-in Dishwasher

My AEG Favorit Sensorlogic Turbodry dishwasher is making 3 short continuous beeps which I understand means the leak prevention system has kicked in. Is there something I can do to reset or must I call a repair man/ There is no water in the machine it has all drained.The machine no is actually a F86050VI


Open the left metal panel, if the white plastic tank is black at the bottom or is not clean: remove it, open it, clean it (make sure the water flows through properly) and put it back in. ... AEG 24 in. Favorit 80860iW Built-in Dishwasher

8 year old maytag, clean lime build-up 2 times a year and all the spinning parts look clean and no wear but all of asudden the washer does not clean the dishes very well. Plenty of hot water, soap is dispenced, cleaned screan in bottom, don' really see anything out of place. what could the problem be? Thanks Rick L.


Hi,\012In you case check the heating element first...\012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... \012 ... Maytag Dishwashers

Model number 665.13763k600 Seems like dishes on the top rack do not get hit with a lot of water. Also, when soap packets are put into the soap compartment, the soap packets no longer dissolve. It appears that there may be a problem with water flow. Have had the unit for a few years. Wondering if it could be a filter or something?


... Kenmore 24 in. 16039 Built-in Dishwasher

Have got a bauknecht dishwasher model no gcx 5521. had the same problem last year. water is not going into the machine it looks like the water stop device activated. I think its something to do with a flowmeter. just wanting to know how to reset it without having to call an engineer


Have got a bauknecht gsx4756 which when started beeps continually and start light flashes. it automaticaly then flashes the rinse button as well. I have reset holding down start and mode selection button next to the start button the fault keeps recur ... Bauknecht Dishwashers

I have a dishwasher model 66516979200 it doesnt dry the dishes i saw the heat sensing light on an opened it and felt the heating element and it was not hot at all ive checked the water temp at the sink and it is at 120 could the heating element be the problen or something else


... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Maytag Model No WU202 is running through all cycles but is not pumping out the water from the tub. I can hear the pump running and a gurgling sound. Could it be the micro mesh filter that is plugged? Any detailed drawings available of the lower wash assembly and instructions to take it appart? This machine is more than twenty years old.


Hi,It sounds like your belt broke. Open the bottom access panel below your door and check. The part is :-http://www.repairclinic.com/SSPartDetail.aspx?PartID=2814&PPStack=1If you take off the front ... Maytag Dishwashers

I have a craftsman 580.752020 pressurewasher bought it last year and it worked fine until yesterday it now shoots a very puny steam of water with no pressure at all I cant hook the hose direct to the machine because it has a quick up is there any other test I could run


... Electric Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1333 seconds