Having problems with your Bosch 23 in. SHU5302UC Built-in Dishwasher ?

I've got a Bosch SHU5315. I'm unable to cancel the wash cycle which has been stuck at 1 min. remaining for about 15 min. now. Pressing the cancel button does nothing and if I press the power off and then on again, the remaining time resets to 13 min. Any idea of what's going on? Thanks


Answers :

Repair Help & Product Troubleshooting for Bosch 23 in. SHU5302UC Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I've got a Bosch SHU5315. I'm unable to cancel the wash cycle which has been stuck at 1 min. remaining for about 15 min. now. Pressing the cancel button does nothing and if I press the power off and then on again, the remaining time resets to 13 min. Any idea of what's going on? Thanks


... Bosch 23 in. SHU5302UC Built-in Dishwasher

Dishwasher Normally, after the dishwasher cleans the load, it displays green light next to clean. Once the door is opened, the light goes off an dishwasher is ready for next load. But from few days, after opening the dishwasher door, the clean light does not go off, it remains lit. Dishwasher doe snot reset for next cycle. So, I have to go in the basement and trip the main power to dishwasher. That resets the dishwasher. This needs to be done before each cycle. Not sure how to resolve the issue.


Make sure that you do not open the door during the wash cycle. Wait until all the cycles \015\012are complete before opening the door. Especially don't open the door \015\012during the drying cycle. ... Dishwashers

Kenmore Ultra Wash Model 665.15801891 (Serial FJ3403697). This is in the USA. Unit will not run. Two lights are lit on the display panel and do not go off - 'Drying' and the #2 on 'Delay Hours'.rn I have turned off the power at the breaker box hoping it would reset. Once power is turned back on the Lock light comes on. I can clear that by pressing 'No Heat Dry' for 4 seconds but then the 2 lights mentioned above come on and do not go off. Any suggestions? Can you tell how old the unit is by t


Plase confirm if your model has the same front panel as the one shown in this manual.\015\012In that case try this sequence to reset the dis ... Kenmore 15899 Built-in Dishwasher

We have a new Whirlpool Dishwasher Model GU3200XTVY3, serial # F00404693 bought in April 2010. Yesterday,when we pressed the "normal" button, it started flashing then when we pressed the "cancel" button, it started flashing also. The dishwasher will not start when we pressed the "start" button. We tried to reset by turning off the power to the dishwasher and then turned it back on. All lights were off and then we pressed the "normal" button and it started flashing again. When we tried to pr


... Whirlpool 24 in. GU3200XTPS Stainless Steel Built-in Dishwasher

My Bosch SHE45M built-in dishwasher is suddenly taking an extra-long time to go through its cycles. On Regular wash it will countdown from 117 minutes to 31 minutes. When it hits that time it resets to 87 minutes, then counts down to 1 minute and will not stop. I have to hit the cancel-reset buttons for it to drain. I have tried to do a hard reset by cutting the power at the breaker for 20 minutes or more. I'm interested in potential parts and a description of how to fit it! Thanks in advance.


... Bosch SHE45M06UC Built-in Dishwasher

Our Bosch dishwasher #SHU9922UC (FD8007) will not turn on properly. Only its drain pump starts -- and keeps running -- when it's powered on and the door's closed. Pressing the two "drain cancel" buttons for more than 3 seconds doesn't help. Neither does cutting off power, then turning it back on in the hopes of resetting the machine's 'computer'. No water inflow occurs. Help?


I had a similar issue after I replaced a bad drain pump, seems the logic got hung up.. I poured in a pitcher of water, closed the door, it drained and was then ok - worth a try. If not, you may have a bad water level switch. ... Dishwashers

Our Frigidaire dishwasher, Model # FDB2410LDS0 has power and will start on any cycle, but after filling with water, there is a pause and then the lights just start blinking and it stops at around the 92 mins remaining display. We have tried shutting the breaker off for 10 mins, then back on, hoping to reset it with no luck. Any thoughts?


... Dishwashers

Model DU948 Whirlpool dishwasher stuck, won't start, has power and water. Tried pressing cancel but another button and that one blink constantly and nothing happens. we've reset the circuit breaker.


... Whirlpool DU1055XTSQ Built-in Dishwasher

My Frigidare GLD2250RDB1 will not drain. When I press the Cancel button it just clicks. Also, when pushing the Normal Wash button and Start it is very delayed in starting. I have turned the power off to the dishwasher to reset it, but it does the samething. I have cleaned the screen in the bottom of the dishwasher.


Control board failure is monster problem with the entire line of Frigidaire dishwashers.Secondly the drain pump could be bad. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

KUDS02SRSRSS1 dishwasher.......remodeling kitchen, disconnected dishwasher.....reconnected and have power (lights are working), however when hit start or cancel button on front door, nothing happens. Is there a "reset sequence" of buttons that I need to press?


I am assuming you have tried to turn the power off and on again after a delay.\015\012\015\012Most likely the door switch is not engaging. Have you tried to push the door a bit hard. Sometimes the dishwasher is not aligned correctly with ... KitchenAid 24 in. KUDS02SRSS Stainless Steel Built-in Dishwasher

Lock on led keeps flashing. Can not cancel it, when pressed it also starts flashing. Control touch pad not functioning. When able to get going usually after turning off power for a while, it does not complete the cycle and the lock on led starts flashing again. Thanks


Hi,\015\012The flashing lock light problem might be caused by a stuck key on the touch panel console.If the control board detects that a key is stuck, then the dishwasher will suspend operation until the key is unstuck. If a key without a ... Dishwashers

I have a Indesit IDL 600 S dishwasher. Yesterday a cycle there was unfortunatly a power failure. I am now, unable to get the machine to regain any of it's cycles, it just remains stuck in it's first position (light one on) and will go no further. Is there a way I am able to reset the machine? Many thanks


... Indesit 24 in. IDL500 Built-In Dishwasher

Arthur martin asf2656a. The dishwasher was on a 50- deg eco setting and got stuck at 30 mins and will not stop or go further. If I turn off the power it remains stuck. There may be a blockage. How do I get into it? there is a large plastic cover on the base apparently with componenets attached. O see no fixing screws


... Dishwashers

I have a Whirlpool Quiet Partner II. The normal light is blinking. If I press start it does nothing. If I press cancel, the cancel light blinks too. We turned off the power and let It sit for a few minutes. Powered it back on and same thing.


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

My kenmore elite model # 253.4448370 keeps beeping and won't stop. We try to press reset button because high temp and power failure lights are flashing but when we press reset button it doesn't seem like the button works..it doesn't reset like it use to...does anyone know how to make this beeping stop? It appears that the temps are right for both frig and feezer but beeping won't stop...HELP!!


... Kenmore Dishwashers

Hi, Had a power cut at my home and my Caple Di455DL Dishwasher was mid cycle on a glasswash program at the time, since power has been regained it will not restart or reset itself, it just lets a pulse of four beeps go once the door is shut and makes a sounds like its trying to pump out water? tried turning off at mains etc but cant get it to reset!


... Dishwashers

Hello, my Siemens integrated dishwasher no: SE64M359GB stopped working mid-cycle with 35mins remaining. It is displaying the red tap emblem. Usually the dishwasher starts when the dishwasher door is closed fully (having pressed the power button). However, it is making a noise as soon as the power button is pressed. I have checked the water supply and pipes and they are OK. The filters are also clean and OK. We have an electric de-scaler on our system so I imagine calcium build up should n


... Siemens Dishwashers

For my Kudi01dl model dishwasher, the rinse light is on, but the unit will not respond to any buttons being pressed and won't turn on. When I press any buttons, two horizontal lines show in the front, but go off as soon as I let go of the button. Is there a ways to reset the unit? Everything was functioning fine the last time I used it. I use it about once a day. The problem started when I heard sounds coming from the unit, very loud motor sounds. The door was closed but I had not turned


... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

I have a kitchenaid dishwasher, SS, model # KUDIO1ILBL6. When you press the ''normal'' button to run it, nothing happens. Tried other cycles and same thing, the green light goes on above the cycle but its just not starting. I tried resetting by opening, pressing high temp scrub then energy saver dry, high temp scrub, energy save dry, then close and hit cancel. Is there any other combo to reset it? or does it sound like something else is wrong? thanks!


... KitchenAid Dishwashers

GE GSD4920Z dishwasher. Problem is that it does not drain completely at the end of the cycle--about an inch of water remains. After checking for clogs, etc, we followed a troubleshooting procedure which involves a hard reset (power off, then reset twice at beginning of cycle) and this procedure successfully drains the tub. However the next time that it's used on a normal cycle, water remains again. Suggestions?


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa.\015\012Dishwasher not draining properly or not draining at all issues can arise due\015\012to different reasons. Usually, these issues are related to kinked hoses,\015\012knocked o ... GE 24 in. GSD4920Z Built-in Dishwasher

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

I have a Whirlpool Gold Quietwash Plus (part # 9744480), due to a number of opening and closings of the door, the lights on the front panel now just blink. How can I reset the control panel.. I have tried power scour>air dry>power scour>air dry and only end up with both blinking instead of going into control diagnostics by pushing pots&pans. The unit will attempt to start then just go to blinking lights.. Thanks


I would cut the power to it for awile 5mi and try it that may do it ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a Whirlpool dishwasher model #DU920PFGQ4. The controls locked light is flashing, and when I press the air dry key for 5 seconds it won't unlock, however the cancel/drain light starts flashing. When I press the cancel key the controls lock light will stop flashing, but will resume as soon as I release the cancel key. I have tried disconnecting power for 24 hours, but as soon as I plug it back up it does the same thing. Nothing else on the control panel will work.


... Whirlpool Dishwashers

My kenmore dishwasher, model 665.16473300 has stopped working. Now the lights just flash at the Smart Wash, Normal Wash, and Cancel. I've reset the power and it just comes back. I've taken the drain area apart and made sure there are no obstructions. The buttons seem to respond, as after I reset the unit (breaker), only the Smartwash button is flashing. I push cancel and then it starts flashing. So I think the buttons work, but it's locked up.


IS THE WATER TURNED ON TO THE DISHWASHER ... Dishwashers

I have a Kitchenaid Kudioflss2 dishwasher.The normal cycle light on the display will not go off. None of the other lights will go on. I've completely disconnected the key pad from the unit and have shut off the power. None of the buttons are stuck down. I tried alternating between two buttons normal ,cancel,normal, cancel etc. and a few other combo's.The manuel under the kick plate is missing.Should i just buy a new keypad(part that lights up) or could it be the interface(part where all the wire


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1251 seconds