Having problems with your Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher ?

Blocked dishwasher how do you remove the white plastic unit in the photo

\015 Https://badge.facebook.com/badge/529764533.7751.1101809074.png\015

Answers :

Can't see the picture very well, but you could try using a hair dryer to soften the fat, then start the machine, it will pump and then as soon as it starts to fill open the door and manually add some boiling water and a dishwasher tab. let it run for a few minutes then cancel the cycle. Hopefully when the pump sends the hot water out it will clear the fat.
Repair Help & Product Troubleshooting for Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Blocked dishwasher how do you remove the white plastic unit in the photo


Can't see the picture very well, but you could try using a hair dryer to soften the fat, then start the machine, it will pump and then as soon as it starts to fill open the door and manually add some boiling water and a dishwasher tab. let it run for ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

I have an Asko DW1875 dishwasher (10yrs old) which has just recently started having problems. The initial symptom was that during a washing cycle, unit showed '1' and inside became very hot (melting some plastic cups/plates in unit). On further investigation (with diagnostic mode), the dishwasher is filling and draining with no problem. When circulation pump runs there is barely any water pressure in blades (just dribbles out) and water leaks into undertray via a plastic white tab near front (v


... Asko D1876 Dishwasher

Poor drying, mold building up in the tub. The condensing drying system is not working well. I pulled the unit out and removed a panel on the left side (facing washer). Saw that the plastic box that appears to be set up for moist air removal and vents to the tub had considerable mold in it at the top of one of the passage ways. Looked like it might be blocking air flow. Could this be a cause of poor drying? Can this unit be removed and cleaned? Also soap isn't dissolving. Bad board controllin


Hi.Poor drying is often caused by a faulty moisture sensor. If there is mold covering the sensor housing , that can be cause for the problem. Regarding the door detergent drawer problem, that is often caused by a defective doo ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Kitchenaid Dishwasher model # KUDS25SHBS1 has started making noise. Noise happens when unit is draining so perhaps its the same mechanism that houses the grinder. Can definetly hear a clicking as something spins around to drain the unit. I have removed the washing armature and plastic skirt around bottom and felt underneath the skirted area, but don't feel anything caught or jammed. Noise is getting louder as more draining cycles are being utilized (i.e. as we use the machine more). Anyone have


Looks like motor noise. Check the pump. ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

SHX46B I have a 4 year old Dishwasher that filled up with clean water on it's own and leaked on the floor. There appears to ba a float switch switch on the very bottom of the unit that runs the pump if this happens. It won't stop until I remove the water caught in the plastic base on the very bottom of the unit. Drain is clear and this machine has worked fine until now. I'm thinking it may be a bad or leaky fill valve but how can I check?


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a Frigidaire dishwasher. Model FDB520RHS0, Serial TH92539147. The drum fills with water but will not drain. I purchased the unit about 2 years ago. It has been used sparingly and mostly on light wash. I removed the basket and could find nothing blocking the drain. Is there a fix? Can I replace the drain pump? The unit is making a noise as if it is trying to drain but nothing is happening. I have checked the drain line for clogs and it is clear and the terminal end is conn


... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher

HI dishwasher will not drain if i remove all the water will run thro cycle and stops with a couple of cms of water left have tryed to find filter inside and failed, removed sides and can see a pump on right hand side can turn impeller easily, is this the drain pump? if not how do i get at pump and or filter. is it possible that plastic chamber on left hand side could be blocked assume this transfers heat Robert


... Bosch 18 in. SRS55L02 Logixx Slim-Line Free-standing Dishwasher

Dishwasher was cutting out intermittently,totally dead no power then after 15mins or so,finally went bang this am,smoke etc,took insection cover off at bottom swit6ched on again to see spark dead short on unknown unit with four wire block connector attatched,two white to same connector and two purple,left disconnected and workin fine,hot water,inlet and outlet both working fine so what does that unit do?


... Bosch 18 in. SRS43E02 Slim-Line Built-in Dishwasher

Hi I've inherited a Zanussi DA6142 Dishwasher from a recent house move. It was treated quite poorly by students who I suspect ran it without the filters in place. I've used a dishwasher cleaner and was able to pull out the lower spray arm and rinse out all the crud that was blocking it (small stones, food, plastic, pieces of glass, paper, etc) but I cannot for the life of me work out how to get the upper spray arm out. The PDF manual I've downloaded for this model says DO NOT remove upper spra


... Zanussi Dishwashers

The Bosch plastic push button (AP2804452) has broken on my SHU9950 dishwasher. The switch itself is still good. I have removed the broken pieces of the bad button from the unit and am now depressing the switch without the button. When I get the new push button, what is the proper way to remove the control panel cover to put the new button in place? Thanks!


... Dishwashers

We just hooked up our old built in GE dishwasher and the water is shooting out the left side of the unit where the black water hose enters the tub. Shouldn't the water be entering into the wash arm? The hose isn't clogged. It attaches to a white plastic piece that is part of the unit itself. The water is entering both the tub but also shooting out of 2 slits approx 1 1/2" each. located right below where u attach the hose.. Any help would be greatly appreciated!


... GE GSD5130 Dishwasher

Technika dishwasher ARDO LPA 97. Water not draining properly. Am checking for a blockage but unable to remove round white plastic pit at the bottom. Does it come out and if so how? If not, is there another way to clear blockage?


... Dishwashers

I have kenmore dishwasher model no. 665.1371 I'm getting a leak just under the door area the connects to dish washer are good, there is white plastic unit the water line is hook to is dripping from that area but I can't see were it is coming from sometimes it stop on it's own for a couple of weeks and starts up again. Thank you your time


... Kenmore Dishwashers

While installing maytag dishwasher mdbh949awb, a wire became unplugged under the machine; noticed it dangling down after all water, drain etc. were connected. It's a brown wire; 2 strand; it has a white plastic plug/connector on the end. Any proposed solutions, short of removing the machine and starting over, would be greatly appreciated Thanks.


... Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher

THE DISHWasher drains into the garbage disposal, there appears to be a plug in the disposal unti blocking the drain. how do i remove the plug? The disposal unit is ACE 2000 1/2hp. thanks


Take a flat blade screwdriver and hammer / hit it good and it will pop out . make shure you remove the dime sized plug or your disposal will sound very bad .. mm ... Dishwashers

Dishwasher is 16 months old. Recently, it won't get tea stains from spoons or cups and there is a white film on plastics. I have run unit once with vinegar. I tried using less detergent and no change (Cascade Complete). (Neighbors using same detergnet on different machine with no problems so it's not the water.) I always select High water temp and air dry on normanl wash. My hunch is that the motor is going bad and therefore it is not pushing the water with enough force.


Hello, there are a few thinks to check on the dishwasher. Circulation, drainage - no backflow back into tub, and water temp. If all three are good, then you have hard water. \015\0121. circulation - These MDB models are very good with water circul ... Maytag MDBH985AWB / MDBH985AWS 24 in. Built-in Dishwasher

GSD4000N Dishwasher not draining. I removed the sprayer arm, the round flat screen, the cage over the drain and the other plastic fixture that sits down in the drain area. I found a white ball sitting in there. I can also put fingers on something down there that is kind of like a wing nut that spins but doesn't seem to loosen anything. I'm officially stuck. Any help appreciated.


... GE 24 in. GSD4000J Built-in Dishwasher

Leaking Hoover D821 dishwasher when pumping in fresh water. Panels have been removed. Leaking from plastic container on side of unit. What is this and how is it replaced?


... Dishwashers

I have a GE Model#GSD433OZOOWW dishwasher, I am changing the color from white to black. I have ordered all the parts to do this but the insert for the eschutcheon is no longer available. Is there a safe way to remove the old insert? or should I just paint the plastic black? Thanks in advance


... Dishwashers

I have an Amana SofSound Dishwasher. The front door will not close. I checked, there is nothing blocking the door. I push in and the white plastic handle appers, but will not latch closed.


... Amana DWA63A Dishwasher

I have a hotpoint dishwasher model# HDA1000G00WH. until recently never noticed rinsed water not drained after washing/rinse cycle completed. water level just above the drain cover. i removed the cover to see if i might find something clogging the drain screen but found nothing. i removed the plastic water "return" line & it was not plugged. thinking about pulling the dishwasher out, disconnect the plastic line connected to the bottom of the dishwasher, then remove the "bowel-like" container wher


Take out the pump. You should find a broken rubber flapper indide blocking the outlet tube. Cheap to repair. ... Hotpoint 24 in. HDA3740G Stainless Steel Built-in Dishwasher

I want to remove the white plastic wheel that propels water into the circulating arms. It is held with one screw which I cannot seem to be able to loosen. This white plastic wheel has 2 small holes in the surface which are perhaps there for some special tool to hold the wheel stationary in order to loosen the screw holding this wheel in place. Underneath this gray plastic housing is the heating element. I want to remove it in order to clean accumulated deposits of gunk.


It's reverse threaded. ... LG 24 in. LDS 5811 Built-in Dishwasher

Dishwasher (Model # SHU6806UC), unit is about 8 years old, very light use, less than once a month, and no previous problems. Turned on unit and after about 10 minutes, I found water on floor coming from dishwasher. Turned unit off and turned off water shut-off valve. Removed dishwasher from cabinet. Found mice had chewed a hole in water discharge hose under unit, inspected all hoses, and found another hole chewed in the 13" flex hose in the front of the unit. Also found the float chewed to alm


Hi,\015\012 Check the valve is open where the supply gets its water from the sink supply.There is a garden hose type swivel adapter after the valve, Close the valve tightly and then unscrew that hose coupling and see if the hose is full of w ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Dear sir In an attempt to dislodge a blockage of my sewer line using Draino and a plunger some of the Drano ended up in the dishwasher and now the dishwasher will not run. My dishwasher is a SHU3036UC/U12. When starting the unit up it empties the unit but the cycle newer ends, in other words the timer does not advance to the next cycle, I have determined that the timer motor works by removing it from the unit and supplying it with power. One thought is, can the water level switch be stuck in


HiCheck this video and clean the drain pump assembly: ... Bosch SHU3036UC Dishwasher

Kitchen Aid Dishwasher KUDR24SEBLO does not drain 100%. I have removed the drain hose and chcked the sink P-Trap, [it drains thru the garbage disposer]. Unit is 10 years old, otherwise works fine. I am having difficulty removing the impeller and items above the pump to see if it is clogged. Do you think I have a partially clogged pump or a timer issue that prevents the pump from completely emptying the bottom of the dishwasher? We have run the dishwasher 20-30 times since observing the problem.


Hi there,\012Please check out the following -Pump - Your dishwasher pump ejects the water. The pump is usually mounted directly to the motor, then attached to the bottom of the dishwasher. You can reach the pu ... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2311 seconds