Having problems with your Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher ?

Exactly same problem

\015 Had exactly the same problem on my new machine yesterday ...Cycle never ended and was always stuck at 1 min. Had to finally switch it off and then after all this the damn m/c started leaking profusely from underneath ..Not sure what the problem is ..Have called out an engineer ...\015

Answers :

Had the same problem... needed a new electronic control panel $150. also too much sudsing with gel soap. switch to powder or tablet.
Repair Help & Product Troubleshooting for Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

FDW60 Fault Hi, I have exactly the same problem. My dishwasher starts and washes ok but appears to get very hot during the drying phase and then the two lights fast and eco flash warning of a heater problem. I suspect either the heater, thermostat or control PCB. As the rest of the cycle seems of and the water gets hot then I'm assuming the heater and thermostat are OK. When the dishwasher attempts to dry is when the problem starts. Did anyone find out what there fault was? Thanks


Hold down the start key and you will re- set the D/W. Please Rate This !!! Thank YOU !!! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

KitchenAid dishwasher, Model # KUDP021RBS1 - "Normal and cancel lights blink constantly". I had this same problem about two weeks ago so I googled your site and though the solution I found was not exactly applicable to my problem but I tried and that is - Press high Temp, heated dry, high temp and then heated dry and then cancel button and then close the door. Would you believe it worked like a magic wand. But this same problem resurfaced and I am trying all those old tricks but nothing is worki


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Kenmore dishwasher I have a kenmore dishwasher and in the middle of a cycle all my front panel lights went off. I have checked the power going into the dishwasher it is fine. I also checked the door latch it is fine. Not sure what else to check? Same exact problem model number 665.15934 We have had nothing but problems with all of our sears products - highly suggest to SHOP SOME WHERE ELSE before you get stuck too.


Check the continuity of the thermal fuse (part # 8193762). It's clipped onto the electronic control inside the console.Let me know if you need more help. ... Kenmore Dishwashers

I have the exact same dishwasher and the exact same problem.


... Asko D3251XLHDSS Stainless Steel Dishwasher

Exactly same problem


Had the same problem... needed a new electronic control panel $150. also too much sudsing with gel soap. switch to powder or tablet. ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

I too have this same exact problem!


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Kenmore 16372 / 16374 / 16379 Built-in Dishwasher

Hi , My Bosch dishwasher SHX46A05UC/30 fills up with clean water after sitting a while. Ive read posts and think the problem is the water inlet valve . Where can i find the exact part number or Bosch repair manual on how to fix it.thx. Bosch have no tech support help


... Bosch 24 in. SHX46A05UC Built-In Dishwasher

I have the exact same problem


There may be something in the drain line that that is limiting the flow. A cherry pit for example. Remove the drain line where it connects to the pump inlet (or valve is there is one) below the washer and see if there is anything clogging it there. ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Hi Have a built in AEG OKO Favorit slim dishwasher (can't find exact model no). Problem is that dishwasher tablet dispenser does't open and after 5 minutes get 5 lots of 2 beeps. When I open the dishwasher, the Rinse/Hold, Intensive, and Normal lights are all flashing. Do I need to get an engineer out? Thanks


HI there,If that\015\012lever is broken or in some way defective, it will need to be replaced. As well as controlling cycle times, the timer on many\015\012dishwashers also functions as an actuator for the spring-loaded\015\0 ... Dishwashers

Hotpoint bwd 129 noisy banging sound i have identified the problem and cause the rear support for the top counterweight block has snapped the metal thing underneath but whats the support called exactly so i can order a new one ?


... Hotpoint Bwd12, Bwd129, Bwm129 Washing Machine Pump & Filter Housing - C00092264

ZANUSSI DA6141 Dishwasher Stops about 10min in, and it blows the fuse in the plug, open the door and water is hot, I change the fuse and set it on drain and it drains ok. I looked at the On/Off Switch it appeared to be discoloured so I ordered a new one changed it with no problem but the dishwasher stopped at exactly the same point (I know this as I marked the dial) Any help would be great thanks Nick


... Zanussi 24 in. DA6153 Free-standing Dishwasher

The control panel on my Maytag MDBH970AW is unresponsive, and the latch is stuck in the "open" position (the plastic piece stays pushed in to the handle and won't come down). I've checked that the unit is getting power from the house. Last time I had this exact problem (when it was under warranty), they had to replace the control panel, the latch, and it seemed like most of the door. What should I do?


... Maytag 24 in. MDBH970AWS Built-in Dishwasher

Most plastic ware like plastic glasses and some of the other dishes but not all come out with a hard to remove white coating no matter how much rinse agent I use. I use Cascade Complete powder for soap and Cascade Crystal Clear rinse agent what Bosch recommends the exact amount according to the owners manual. This problem started about a month ago, before that the machine worked well.


... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

I have a Zanussi dishwasher model IT 5614. When I turn the dishwasher on, the indicator light is already stuck at "BIO 50" and won't move, and the dishwasher won't start when the door is closed. This just happened today. The indicator light for dishwasher salt was also on, so I added dishwasher salt and that light went off, but the machine is still stuck. The instruction book says that when this happens, technical assistance is needed. What exactly is the problem, and is it anything I can


It has been suggested to switch the machine on/off a couple of times and the flashing light will not reappear. Until this light goes off the dishwasher will not start. All the filters should be cleaned free of any leftover food particles. What i mean ... Dishwashers

Problems Really don't know the exact model but the machine wash clothes normally but when finish don't do anything to dump water nor to squeez.


Kenmore dishwaher mod. 363.14482100 lower spray arm\015\012wont operate on its cycle and dishes are staying soapy\015\012after dishes done. ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

I have a Fisher and Paykel Nautilus DW920 dishwasher. However, the door to the detergent dispenser does not open reliably every load -- usually I have to open the dishwasher door about 20 minutes into the load and open the soap dispenser myself. The catch on the dispenser will have released, but the dispenser door will not have sprung open. I am not sure exactly what the problem is -- the soap dispenser door simply seems a bit stiff in its holster. Given a little nudge, it springs open fine. I h


... Dishwashers

Exact same problem


You'll have to remove the DW out from under the counter.. looking at the front of DW you ne to remove the left panel.. you will find the red plunger.. its part of the fill system... ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Maytag MDB7100AWW dishwasher that makes a lot of noise from the motor at the end of the drain cycle. When there is water in the dishwasher it doesn't make any noise and washes well. This url (http://www.applianceaid.com/maytag-dish-noise.html) describes my problem exactly but I can't remove this part. I have unscrewed the 3 screws keeping it in place but it seems to be still attached to the motor. How can I remove it?


... Maytag MDB7100AWB Dishwasher

We're having same problem with our whirlpool GOld quiet partner III. We moved into our house three years ago and no manueal was left. I am sure its a filter or plug but I can't seem to figure out how to get to the filter or plug. I can take off the arm but then nothing. Is there a manuel I can get or can someone explain exactly where the parts are that I need to check? Dishes have grit on them, white spots, just not clean at all. Thanks!


The problem is hard water. There is a new product out called the dishwasher filtration system. It filters the water before it enters your dishwasher. It works amazing and has a money back guarantee. You will love the ... Whirlpool GU2400XTP Built-in Dishwasher

SMEG Dishwasher decor door problem


... Smeg Dishwashers

I'm having a problem with my Miele dishwasher G 879 SCVi I asked for assistance on 2/12/10 and paid $6.00. I have yet to get a response. Please let me know when I will as I need the problem addressed before Christmas Day. The problem again is that all the lights on the diswasher panel are all flashing at the same time when switched on. It may need to be reset somehow, as the power went off, which may have caused the problem. Your urgent assistance is required. Thank you


... Dishwashers

We have a Miele dishwasher. We've had a technician come because the water is not hot enough; the dishes are not dried when we empty it as a matter of fact glasses are stained and wet. After he left, the problems remained. :( We now have an additional problem. We have mildew in our dishwasher!!!!! WE wash dishes daily. WHY do we have these problems? Can we get a technician to resolve these problems permanently? Should we buy another brand?


I may be just repeating what the technician has done, please bear with me. Check first if the heating element inside the dishwasher is heating up to the temperature it is supposed to. You can do a manual inspection just to figure out. It may be a ... Miele Dishwashers

Kew Alto Force X-TRA cold water supply pressure sensor problem


Have the same p-washer (5-6 years old) and the same problem. Opened it and the pressure switch is the crook. A plastic pin has an inner and an outer spring on it (two consentric springs). The smaller inner spring is completely rusted away so the sw ... Pressure Washers

Pressure washer problem


... Honda Maxus Prosumer MX5223 Pressure Washer

Pressure washer problem


... Honda Maxus Prosumer MX5223 Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0771 seconds