Having problems with your Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher ?

I have a bosch Exxcel slimline, nearly three years old. Last night it ran all night on a 119 minute programm. It was stuck on 1 minute. Now I acnt get it to start on any programme. It starts up ok nut the timer doesn't advance at all! I checked the pump, that's ok and cleaned out the food filters, reloaded salt and rinse aid.


Answers :

I have a bosch exxcell about 3 yaers old the program gets stuck on 120 all night whats wrong
Repair Help & Product Troubleshooting for Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a bosch Exxcel slimline, nearly three years old. Last night it ran all night on a 119 minute programm. It was stuck on 1 minute. Now I acnt get it to start on any programme. It starts up ok nut the timer doesn't advance at all! I checked the pump, that's ok and cleaned out the food filters, reloaded salt and rinse aid.


I have a bosch exxcell about 3 yaers old the program gets stuck on 120 all night whats wrong ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

Ge model # gsc3200j01ww dishwasher. when the door latch is closed, nothing happens. motor does not start. if the timer is advanced to the next part of the cycle, water will spray into unit until float valve is triggered. water will not pump out, motor does not start. bailed out water, checked for stuck float valve-ok. removed drain screens and filters, cleaned. no motor, drain, or start. what parts should i check? always rinsed dishes before putting in washer. unit is portable or undercounter


... GE 25 in. GSC3200J Built-in Dishwasher

I HAVE A BAUMATIC D/WASHER BHD5 TYPE DW-24E1,(ABOUT 8 YEARS OLD) IT IS A WHILE SINCE LAST USED THEN 1 NIGHT AS IF IT HAD STARTED BY IT'SELF IT STARTED MAKING A BEEPING NOISE ALL 4 INDICATING LIGHTS AS WELL AS SALT AND RINSE AID WERE FLASHING HAVE SINCE TOPPED UP SALT AND RINSE AID BUT ROUGHLY 1 MINUTE AFTER STARTING IT BEGINS TO BEEP AND ALL LIGHTS FLASH. COULD YOU TELL ME THE PROBLEM. MANY THANKS


... Baumatic Dishwashers

My Bosch dishwasher SGS46E26GB/90 makes a knocking noise when started. the timer does not advance and the check water light comes on.There is water in the bottom (up to the bottom of the door) . If I reset the DW the water drains ok. If I mess with the buttons E3 shows on the display the 'quick' light stays on and the eco light flashes. I've checked the filter where the water hose is fastens to the rear. I've cleaned the filters at the bottom of the DW and cleaned out the pump area under them.


... Dishwashers

We have a Brandt Aa Class Dishwasher that will start and run the fill cycle for about a minute with the red operating light on but then stops and the red light goes out. I suspect it may be a timer related problem but can you tell me where the timer is on this model ? I have checked the filter and that the water supply and drain hoses are not kinked.


... Dishwashers

Bosch SHY66C My Bosch dishwasher won't fill with water.  All electrical connections are fine and I can hear it make a sound as if it is trying to start about every 2 minutes.  There was water in the bottom so I used a shop vac and pulled it all out but it still won't start and is doing the same thing.  I checked the solenoid with a multi-meter and it appears to be working.  My power went out last night for about two hours and that's all I can think of that might have affected it.  The dishwasher


I'm a novice on this question, but i agree with the above statement about check the stuck float switch or check for a bad safety switch or lockout switch of some sort. I would suspect something is definately faulty in that area. Will the dishwasher r ... Dishwashers

Hello, my Hoover D7610 dishwasher has developed a problem, I would appreciate your advice.On starting a wash it appears to be working OK through what I believe to be a rinse cycle but then after about 20 minutes water pours out from the bottom of the door. Manually clicking the timer-programer forward stops the leaking but the machine needs manual advancement except for the last 2 cycles when the timer seems to work OK. After the 1st cycle there is no more water leaking from the machine but all


... Hoover Dishwashers

Hi, my LG LD2120WH dishwasher stopped working recently because of the detergent container being empty and the salt level too low. After replacing these the machine still doesnt want to start washing. The timer displays fine but doesnt count down either and the machine turns off after a couple of minutes. Please help.


... Dishwashers

Carlton Cs1w. Hi I have a Carlton slimline dishwasher. No problem with filling, heating and emptying. But if I set it to full programme it sticks. Starting with pan setting and letting run right through programme it just keeps sticking. On last programme timer moves ok for first 10 or so minutes then gets no further. Tried different settings, checked everything I can think of and cleaned added salt etc. Got given. Last owner only used a few times, moved house and no room for it. But was sitting


... Dishwashers

I have a Bosch SHU3032UC and when I try to start the wash cycle the cycle timer has not been moving (even after being left of 15+ minutes) and no water is entering the dishwasher. I have also checked and confirmed that the external water inlet valve on the hose is open. Any ideas?


Hello, Welcome to FixYa.Based on your d ... Bosch 23 in. SHU303 Built-in Dishwasher

My dishwasher started making a whirring sound around 20 minutes into its cycle. I took off the drain pipe to check for obstructions, however it was clear. I started the cycle from the start again, and it started the whirring sound from the start of the cycle. There was a small amount of water that drained into the bucket where I had placed the drain hose, however there was not much water in the machine to start with (I checked when it started whirring the first time and there was no water in the


Hi.\015\012\015\012A blocked pump in absence of water won't be noisy from start. Check that\015\012 the whirring sound is not given by the spray arms. Test without baskets\015\012 and check the spray arms assembly.\015\012\015 ... Fisher and Paykel DS605I Built-in Dishwasher

Kenmore dishwasher 665.17534202. something is wrong with either the timer or the motor. On a normal cycle it starts at 78 minutes and gets down to 48 minutes and it stays stuck at 48 minutes for appro


Http://www.allrepairmanuals.com/kenmore-dishwasher.htm?model_number=+665.17534202 ... Dishwashers

Fills with water, sounds like it starts to pump water then stops, then start again. It attempts to start pumping water 3 or 4 times them turns off leaving the water in the tub. I have read about the water needing to heat up for the cycle to advance. When I check the water that is left in the tub it is warm but not hot. The heating element is not hot either. I did a continuity test on the heating element and it seems to check out ok. I also did a continuity test on the red wire from the heating e


You have a wash pump problem. can be 1 of 3 things. most likely something is caught in the pump impelor if not the wash pump motor may be faulty or ceized or it could be the capacitor for the wash pump motor is faulty. you can try removing the wash p ... Maytag MDB7100AWB Dishwasher

I have a Bosch SHU43 dishwasher, about 6 years old. After starting a cycle, it will run for a while, perhaps 1/2 to 2/3 of the way through the cycle, then shut off. After 10-20 minutes it will start up again, run for a few minutes, then shut off again. It ends up taking about 12 hours for a cycle to finish. The problem started off somewhat intermittent and has gotten worse over the last few weeks. I've checked the electrical box in the front right bottom, and the connection is good. I've even


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I`m not sure since you didn`t mention it or perhaps I just interpreted it this way, but is it consistent at the same time or approximately or is ... Bosch 24 in. SHU43 Built-in Dishwasher

My Hotpoint diswasher suddenly stopped working last night. It seems like it has no power to it, as the motor or pump does not seem to come on at all. Obviously when I get home from work, I will check the obvious first - making sure it has power to it, connections are secure etc. (I had a wire break before) If it does have power, I would assume checking the door switch and timer is next. Any suggestions, and any suggestions for checking the door switch and timer??


Sounds like your on the right track. I would use an ohmeter to check the resistance of the door switch by placing the meter probes on each side of the switch. Test while opened and closed position. Same with timer ... Hotpoint Dishwashers

I pressed the POWER button to turn on the dishwasher. I pressed the SELECT button, hit HEATED DRY button and the LIGHT WASH buttons. I then hit the START/PAUSE button to start the cycle. All lights came on as normal & I heard the machine trying to **** up water like it normally does. Within 5 minutes or so, the machine started to BEEP & BEEP every minute. When I came to the check why the beeping noise was on, I saw that all the WASH PROGRAM lights were all blinking. I hit the START/PAUSE


... Haier ESD210 / ESD211 Built-in Dishwasher

I have a smeg dishwasher df612sdx the lights come on but it doesnt start when you push the start button. The 3 hr 6hr and 9hr timer doesnt work and if you switch it off and on it moves through the programmes but no sign of life. Thanks


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. As the lights are working then it means that the control panel\015\012is working fine. This issue can be ... Dishwashers

Candy washing machine runs through programme and stops at the point where it drains the drum to start the spin. Have switched it off and turned timer to correct position and it drains and spins OK (1200 spin) Tried other programmes on timer but same thing, stopping at point where the pump drains and the spin starts. Have checked the pump and is OK any ideas please, I am quite capable of taking the machine apart for repair. Thanks in anticipation Pete


... Dishwashers

My problem is with a Eurotech Model ED254EG timer will not continue running thru the cycle properly. i.e. In "Light Load" position the timer starts with 59 minutes but actuall runs for 2 1/2 to 3 hour


... EuroTech EDW242C Stainless Steel Built-in Dishwasher

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

LED timer keeps adding minutes. Manual calls for approximate 90 minutes. With each use it is increased. When it gets to about 140 minutes I unplug it and it starts over. Any suggestions?


Hello- This type uses a touchpad assembly that is linked to control by a ribbon connector. Faults and errors occur when one of these three parts fail. On-site diagnostics by a pro is necessary to tell which of these has failed. Sorry- no magic bullet ... GE Profile PDW8400J Built-in Dishwasher

When I start my Zanussi built in Aquasave zt685 on a normal 65 degree wash it works for a five minutes or so and then stops. When I check, the display has changed to Rinse and Hold. Re-starting it on the quick wash program has the same effect but if I keep re-starting it eventually completes the cycle.


... Zanussi ZT485 Built-in Dishwasher

I have a Kenmore dishwasher model #17519200. I loaded it last night as usual and closed the door. I pressed the wash cycle I wanted and pressed the start button. I heard it starting to fill with water as usual. After it filled with water it should have gone into the wash cycle mode but it just started making a buzzing noise for about a minute or two then just stopped. I pressed cancel to drain it and it drains fine. I have kept trying to re-run it but it just does the same thing I described.


... Dishwashers

I have a Bosch SMU2046UC/14 dishwasher that makes some noise but will not start the wash cycle. I found that the noise was from the timer motor by removing the front of the door. The timer continues to run and but only advances until half way through the wash cycle where it stops permanently. Is this a problem with the timer or could something else be causing this problem.


HI. The timer motor mechanism regulates the length of time power is to be routed to each component. If the timer motor does not advance properly, it can result in a wide range of problems. Common symptoms will usually include sticking in a cycle(fail ... Bosch 24 in. SMU40 Built-in Dishwasher

New pressure washer runs starts and runs for 30-45 minutes with no problems then dies and will not restart. Once it cools for a few minutes it will restart but will die again quickly. If it is allowed to sit for 30+ minutes it will run for another half hour but then dies again. Changed oil, gas, checked all obvious areas. Any suggestions?


Try removing the carb bowl and check for dirt/water etc , also if the machine is over heating it may be getting vapour locked ... Honda Pressure Washer PSI 3000
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1475 seconds