Having problems with your Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher ?

How do you run the diagnostic on a bosch dishwasher model # SHE44C06Uc/22. it counts down to one on the timer and runs forever. can't find it model # diagnostics anywhere. thanks


Answers :

Resoldering the relay, regardless of how proficient one is at soldering, will not be a long term solution. The melted/burned solder joint is a secondary result of the initial failure, which is the relay itself. There is a solution that is more permanent and less costly than replacing the control with a new one.
Do a search for Bosch 266746 control and you will locate someone who has studied the problem and found a safe, long term solution.
Repair Help & Product Troubleshooting for Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you run the diagnostic on a bosch dishwasher model # SHE44C06Uc/22. it counts down to one on the timer and runs forever. can't find it model # diagnostics anywhere. thanks


Resoldering the relay, regardless of how proficient one is at soldering, will not be a long term solution. The melted/burned solder joint is a secondary result of the initial failure, which is the relay itself. There is a solution that is more perman ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

We have a Bosch dishwasher model SHU5315UC/U06. When we ran a "Regular Wash" the dishwasher ran continuously and the timer did not count-down. None of the Delicate or Rinse and Hold buttons responded. The only button that works is the "Scrub Wash", but when we ran it did the same thing. Ran continuously and the timer moved one minute after running about five minutes. I look forward to your solution. Thank you. Jerry


My father-in-law has a Bosch and they had the same problem. The tech guy said it was not heating properly and that caused it to continously run because it won't tick down the timer if it doesn't reach a certain temp, so try turning your faucet as hot ... Dishwashers

We have a Bosch dishwasher SHX46A06 UC/21. It continually runs. We couldn't find a diagnostic test for our model, but we did for another model. We held down the power scrub and regular wash cycles then turned it on and pressed them again. The delicate/econo light started blinking. Looking at some of the blogs, most often it seems to be the heater or the control panel - does this diagnostic test help to pinpoint what could be wrong? Also, where can we find a good manual for our model - we're havi


Here is a link to the service manual http://cgi.ebay.com/Bosch-Dishwasher-Service-Repair-Manual-/250480379703. \015\012 ... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

I have a ge profile quietpower 7 dishwasher. its built in.cannot find manuel and cannot find the serial number anywhere on the dishwasher..i need either your help with serial number or help with why water will not go into the dishwasher. motor runs water decided it wont go in. one day worked perfect and next day stopped working.


Hi\015\012\015\012This is often caused due to the fill valve. You can ... GE Dishwashers

My problem is with a Eurotech Model ED254EG timer will not continue running thru the cycle properly. i.e. In "Light Load" position the timer starts with 59 minutes but actuall runs for 2 1/2 to 3 hour


... EuroTech EDW242C Stainless Steel Built-in Dishwasher

We are working on a Whirlpool Dishwasher Model # DU915PWSS and need to find the "test sequence" aka "key dance" to run a diagnostic. Does anyone have this information? Thanks


Hi, well all this information is in your manuals, accordingly i include a link for your service manual, below.\015\012\015\012http://appliancejunk. ... Dishwashers

I have a Kenmore model 665. It is having an intermittent problem. It goes through the fill cycle, and then stops. Timer does not progress either. Then, at some random moment, it will come back on and finish the entire cycle. This could even be a day or two later. Sometimes it seems a nearby thump will set it off, other times no one is anywhere near it when it comes back on. This happened for a month or so off and on 6 months ago, and then it worked fine for 6 months. Now it's back to it.


Its possible its a door switch thats causing this or the main wire is loose..be careful as you do have 115 volts. i'd turn off power and check where power comes into d/.w and make sure the wire nuts are tight.. the next step is a little more difficul ... Dishwashers

I have a maytag dishwasher model MDB9150AWQ the diagnostics call the turbidity sensor. But I cant find one to buy thay all say NLA can yoy help Ralphj


Since they don't make the one you need anymore, you may not be totally out of luck, usually they make one that will still work but call them directly to confirm this. I think the one located at the following website may work on yours but there was no ... Dishwashers

A screw fell in to the bottom of my dishwasher. In trying to get it out it disappeared. In trying to find it we found another one that looked like it had been there a long time. My dishwasher is old model #DU920GWBD5. Do you think we can run the machine?


... Whirlpool Dishwashers

Dishwasher stalls I have a Bosch dishwasher model # SHU4006UC/U06. The dial stops after going through one cycle and the dishwasher continues to run that cycle and will not advance unless we manually advance the dial. After advancing the dial the dishwasher will stall until we have manually advanced the dial until reaching the "9 o'clock" position. It will then continue until the dry cycle is complete. Thanks!! I have the same problem. I took out the timer control and spraid it with contact clean


If the cycle doesn't complete, check these:Water-heating cycle ... Bosch SHU4006 Dishwasher

My dishwasher 4000 series Model #PLD4375RFC3 isn't working right, when it starts the water runs in than I hear a click like it's trying to start then it doesn't. The timer just keeps counting down it doesn't wash a thing... in order to get the water out I switch to rinse only and it drains the water. What's wrong with it serial # TH91579830.


... Frigidaire Dishwashers

My 2008 frigidaire 24" dishwasher model #FDB1050REC is not washing during the cycle. I have run the test cycle and the tub is filling up and draining but no washing is taking place during the wash cycle. The dishwasher has an electronic control board and therfore no mechanical timer. I put test leads to check for voltage on the power leads to the main washing pump, which I have already replaced with a new one, and I'm only registering a low voltage of around 10 or 11 VAC. With the cycle off I'm


If you have replace the motor and this did not fix your problem then yes replace the control board ... Dishwashers

My bosch dishwasher control panel displays 0H on the time delay. When I start it the OH go to 2H. It then starts running and does not stop. The cycle minutes don't display. It's model number SHU5302UC 14. I do not have a manual and cannot find one online. Thanks


Check to see if your unit has a recall on it because if it does you will get a free control module from bosch.\015\012your problem is the control module. thermador .com is the site to lookup. gaggenau,bosch,thermador they are the same ccompany. ... Bosch 24 in. SHU53 Built-in Dishwasher

My bosch dishwasher model shu5306 uc/u12 counts down to one minute left then just keeps running


Your d/w has a faulty control board... only solution is to replace it. ... Bosch Dishwashers

Have an dishwasher that i need to tilt back to get it finish the cycle.It gets to a certin point in the cycle then stops. i looked it up on the net and this has been a nice temporary solution but I need to figure this one out. Ts a free standing bosch but i cannot find the exact model number anywhere. Can you help.


Go to appliancepros.com to find your model it sounds like the water pump is failing they have a 800 number where they can help you figure out whats wrong and what model it is for sure. hope this helps you. ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

I HAVE A MAYTAG MODEL MDBTT59AWQ DISHWASHER THAT WILL NOT START UP. LIGHT ON CONTROL PANAL FOR HEAVY AND LIGHT LOAD LIGHTS, DELAY ONE DOESNT AND THE START/CANCEL ONE DOESN'T LIGHT EITHER. WORKED FINE A COUPLE DAYS AGO. TRYING TO FIND A MANUAL OR PARTS BREAK DOWN BUT CANT SEEM TO FIND ONE FOR THAT MODEL.


... Maytag Dishwasher

Our Hotpoint Dishwasher Model HDA200X-73BA has two little white plastic pipe stubs poking out of the bottom of the dishwasher. During one of the cycles--(I don't think it is the drain cycle)-- some water is being released from one of these pipe stubs and then it stops and the other one runs some water. They each only run for a few seconds, but the water is just running on the floor. These little pipe stubs are about one half inch in diameter and project out of the bottom of the dishwasher about


Hello. go to the sears direct website, click on the blue link below, and enter your model number. ou can then access an excellent parts diagram which will show these stubs and what may be missing from them. Joe\015\012\015\012 ... Hotpoint Dishwashers

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

ON REGULAR WASH CYCLE , WATER DOES NOT DRAIN FROM TUB AT END OF CYCLE. A FRIEND SAID I NEEDED NEW TIMER, BUT WEB SEARCH SAYS THERE ARE 2 DIFFERENT TIMERS LISTED FOR THIS MODEL AT ONE PRICE AND THEN DOUBLE THE PRICE FOR OTHER. DO I NEED TIMER, WHICH ONE. UNIT IS 13 YEARS OLD, WORTH REPAIRING ???


Hi,Typically when a dishwasher does not drain it is not due to the timer. The most common reason for it not to drain is a clog in the hose between the pump on the dishwasher and the outlet it drains into, like the pipe under the sink or g ... Magic Chef 24 in. DU4500 Built-in Dishwasher

I need to find out the serial # of a Bosch dishwasher Model # SHX56B05UC. Any number will do. I trashed mine and now I find I need the serial number or one like it. Thanks you so much, Monty


Hi,One of the serial numbers for your modelTH43115371Thanks. ... Bosch 24 in. SHX56B05 Stainless Steel Built-in Dishwasher

I have a coleman powermate pressure washer, model #PW0832000. It's over 10 yrs old, but brand new sitting in the box. Trouble is, I have no owner's (operator) manual. I would like to find one. Do you know a source to find one?


Well, you may be out of luck with Coleman's customer service. They have gone out of business, from what I understand. I have a pressure washer just like that one. You may be able to find one on ebay, or one online that someone has scanned. ... Coleman Pressure Washers

My Amana SofSound 2 (model DWA33AL) is not draining and I am unable to find an owner's manual so that I can take it apart and find the problem. Can anyone provide some suggestions? The ones that are posted do not apply to this model Thank you for your help


... Amana 24 in. ADB1500AWS Stainless Steel Dishwasher

Amana dishwasher, model adb2200aws, ser #, 26650464e. history: quit running, no lights, nothing. replaced the door switch, ran for three days, replaced the switches on both sides of door switch, ran three days, quit. replaced the circuit panel , ran one time, quit. not lights, nothing. when I take it apart sometimes, that is take off inside cover on door, it might run or not. seems like the current isn't getting in as no lights will come one.


I have the same problem with mine as well but I found out that if you take a space heater to it and warm the control panel up for about 5 minutes, everything works great. This model of dishwasher seems to be problematic in any environment under 70-75 ... Amana Dishwashers

I have a dishlex global 270 i cant find a model no i only have a serial and manufacturers no. What i wanted to find out is does this model have an element that heats the water. I only have one hose and when i used it with cold water it didnt heat up so i am using hot water.


Hi\015\012\015\012\015\012Thanks for using FixYa. I hope you understand that no one can tell you what are the specifications of the product until you provide the model no# however, dishlex usually have element in their dishwa ... Dishwashers

I'm trying to find the correct filter for a Bosch dishwasher Model SHE55M02UC. I find two different one's online and am not sure which is the correct one I need. Thanks


... Bosch Evolution 500 SHE55M05UC Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1429 seconds