Having problems with your Bosch 24 in. SHU30 Built-in Dishwasher ?

Does my Bosch SHU3032UC have a heat booster?

\015 Does my Bosch SHU3032UC have a heat booster so I can reduce my water heater temperature to 120 degrees F and still end up with clean dishes? Also, I'm concerned that if I lower the hot water supply temperature the dishwasher may be damaged or become ineffective. Thanks!\015

Answers :

The dishwasher has a built in instantaneous water heater, so even if the water feeding the d/w is cold the machine will heat it the the temp required for the cycle you have choosen. Reducing the temp will not effect the wash quality at all, in fact having a lower temp or cold water filling the machine will make the drying cycle at the end of the program more effective.
\015\012Hope this helps, please leave feedback.
Repair Help & Product Troubleshooting for Bosch 24 in. SHU30 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Does my Bosch SHU3032UC have a heat booster?


The dishwasher has a built in instantaneous water heater, so even if the water feeding the d/w is cold the machine will heat it the the temp required for the cycle you have choosen. Reducing the temp will not effect the wash quality at all, in fact h ... Bosch 24 in. SHU30 Built-in Dishwasher

Hobart AM14/1 free standing dishwasher with booster. Booster will not heat up beyond 41C. All three heating elements check ok with Ohm meter. High limit not tripped. Temperature screw up at maximum, when you turn the screw, you can hear thermostat click at lower temperature on and off. When turning on main power for dishwasher, heater in dishwasher works fine, but no relays click in the booster tank area. Have not checked for power at booster, have checked all fuses with meter and are ok. Ple


... Hobart AM14-253 Free-standing Dishwasher

Bosch Dishwasher I currently own a Bosch dishwasher. One of the selling points, if I'm remembering right, of the dishwasher was it was supposed to super heat the hot water that is coming in from the tap. I have 3 problems. We have to rinse the dishes by hand before putting them in the dishwasher, Otherwise they won't come out clean. The dishwasher will run for four hours sometimes longer. It doesn't seem like it is heating the water any hotter than what comes out of the tap.


Your control board is bad. ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Bosch DLX series dishwasher and no manual. The heat dry doesn't work or at least not well. There is no heat on/off switch. How do I ensure the heat is on so I can stop drying my dishes by hand?


... Bosch Dishwashers

Bosch dishwasher shx46b02uc has stopped drying. Per online comments, they seem to point to either a corroded wire or a bad heating element. We've replaced the heating element and all the wires looks fine. All other functions work - just not the heat. Open to suggestions.


Hello,Welcome to FixYa.Based on your description ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Bosch Dishwasher SMS4602eu is not heating up. I have tested the heating element for continuity and this seems to be fine. Any other suggestions would be greatly appreciated?


... Bosch SMS63E Dishwasher

I have a bosch she44c05uc dishwasher that get stuck on 1 and won't finish. The water will pump out when I cancel. The water will pump in but won't heat up. The final heating doesn't seem to work also. I have removed the circuit board and there appears to be NO solder issues. What else can it be?


... Bosch 24 in. SHE44C05UC Stainless Steel Built-in Dishwasher

Bosch sg14305au/12... NO HEAT - Bosch Dishwashers


... Bosch Dishwashers

I have a Bosch Classixx SGS43CO2GB which is working but not heating the water or drying? Is this something I can fix myself, and if so where could I get another heating element? THanks


... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Bosch Classixx dishwasher: Initially no water feed and 'water check' light came on. Removed side panel, emptied water from base. Ran OK for a week or so. The problem then repeated so side panel removed, float switch operation checked (OK) drained water from sump below polystyrene float. Ran OK but contents came out dirty and cold - no heat. Side panels off again, water in base but no obvious leak when watched during cycle - still no heat. Help please.


Http://www.repairclinic.com/Dishwasher-Repair-Help\015\012\015\012\015\012\015\012 ... Dishwashers

My dishwasher does not do a hot wash. Why is this? If I need to replace the heating element, how do i gain access to heating element on my Bosch classixx dishwasher?


Hi, a common problem with these machines is the solder coming away from the heater relay. A simple repair if your lucky. Run a continuity test on the element with a multimeter before replacing it, as it is a massive job to change it. I just changed m ... Bosch SHU9950 Dishwasher

Bosch SGS5312GB/12 Dishwasher I had a control board. Worked fine except didn't heat the water. Got it repaired (new PCB). Now the only thing it does is drain. Clicks every 20 secs and carries on draining. Got a new board. Does everything (including heat the water) except it does not drain before, between, or at the end of cycles. It does drain when while filling, and if the flood detection rod is raised manually (also drains if the inlet pipe beyond the pressure sensor is blocked - found


... Bosch Dishwashers

Bosch dishwasher Does not heat up in the washing cycle and does not drain down at the end of the cycle. End of cycle the display sticks at 1 and the drain pump operates until the machine is switched off or reset. Followed the suggestion in another thread to look for a burnt solder joint on the control board. Unfortunately my machine is a later model than the board shown and has no poor joints on the board. It would seem from previous answers that the problem is either the controller, the heating


1) The water must be preheating by heating elements and thermostat see how to do it.\015\0122) Timer , test for defective,clean the contact, repair wires for loose, broken, or burn.\015\012\015\012God bless you.\015\012 ... Dishwashers

I have a Bosch SHE56C05UC/40. The unit fills and drains ok but the circulation pump will not operate. I run the diagnosis according to another of you posts and came with an error code E1 which is a heating code. Why would this prevent the pump from running? Your diagram show a flow switch in the heating circuit which won't close unless the pump runs. A diagram of the pump circuit would helllllp.


Follow the instruction code in your ins.manual if you do not have go for free download : www. fitness.manualsonline.com or www.ret ... Bosch SHE56C02UC / SHE56C06UC Dishwasher

We have a Hobart Dishwasher Model # WM5H. Our Booster heater will not heat the water hot enough. We have cleaned the lime out of the heater, and then it will work for a few weeks and then will not heat the water hot enough again. Any Suggestions.


... Dishwashers

Bosch dishwasher i have dishwasher that seems to progress to fast through cycle and does not heat water leaving dishes dirty. Is it likely to be timer unit or heating element Thanks


I'm probably sounding like a broken record, but id f its got buttons on the front and not a knob, its probably the control board. Unplug the unit or flip the breaker.Take off the outer door and the control panel by removing all those torx screws down ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Hiya, I have a Bosch Dishwasher SGV4313GB that wont heat the water, it gets stuck with cold water continually washing (pre wash??) the delf. Its a built in and I have opened the inside metal panel and exposed the control unit (PCB) there is no blackened/loose soldered joint to be resoldered. I am at a loss as to what else in the heating circuit to look for. Can you point me in the direction of what I should look for next? Kind regards Mark


... Bosch Dishwashers

Bosch dishwasher heating element will not heat up


... Bosch Dishwashers

Installing new heating element in Bosch dishwasher


In order to replace te heater in that unit, it must be remove from cabinet, and taken apart, it is very labor intensive, in order to access the heater, youll need to remove eh lower plastic pan from D/W. in order to get that removed, ... Bosch 24 in. SHU53 Built-in Dishwasher

4 year old Bosch SRS43C12GB/14 dishwasher running a full cycle but not heating water


... Dishwashers

Bosch Exxcel (SGS47E02, I think) no longer heating water


You will have to check the the temp sensor. if the temp sensor is ok.then the control panel needs to be checked.If the control panel does not see a temp sensor, it never turns he heater on. There is a thermostat on top of the water heater. ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

How do I replace the heating element for a Bosch SHU53 dishwasher


Are you sure its the element, the control boards on them get bad soldering joints and the you get the impression that the element is bad, but its the solder joint that controls the element that goes bad....you can resolder that ... Bosch 24 in. SHU53 Built-in Dishwasher

Bosch dishwasher no heat


... Bosch Dishwashers

Bosch Dishwasher Water Not Heating


Depends on if it is the controller board (easy, just behind the door and requires a torx 20 screw driver) or if it is the heating element. The latter is easy, but time consuming, as it requires you to pull the dishwasher out, detach the bottom, tilt ... Bosch Dishwashers

Bosch diswasher SGS5942 does not heat up


This is a common problem with dishwashers.the thermostats are faulty and be replaced by someone who knows what they are doing. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0799 seconds