Having problems with your Bosch 24 in. SHU43 Built-in Dishwasher ?
Turn on, it hums but no water.. the water line is new.
\015 Dish washer water would not feed \015\012I turned it on,, it has a very soft humming. something is wrking.. but water valve apparently not open. is there a \015\012the model is Shu43c07uc/14\015
Many new supply lines have a safety valve built in to prevent flooding in case of major malfuction. Floodsaver is one of the brands. They can be identified by a small silver cylinder at the water valve end under your sink. I have found that then valves can close under certain conditions other than a malfunction. Try turning off the supply valve and then very slowly, reopen it. Sometimes, I have had to turn off the water supply valve, disconnect the line to relieve the pressure, reattach and SLOWLY turn the water back on. If this fails, next try the diagnostic procedures here:
best of luck!
best of luck!
Repair Help & Product Troubleshooting for Bosch 24 in. SHU43 Built-in Dishwasher
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Turn on, it hums but no water.. the water line is new.
Many new supply lines have a safety valve built in to prevent flooding in case of major malfuction. Floodsaver is one of the brands. They can be identified by a small silver cylinder at the water valve end under your sink. I have found that then valv ... Bosch 24 in. SHU43 Built-in Dishwasher
New wdf 530 dishwasher turns on but no water comes in. Water lines connected and in good working order.
... Whirlpool WDF530PAYW Dishwasher with Resource-Efficient Wash System -
We have a Frigidaire dishwasher model #FDB634RF bought new. It was used for a not very long period of time but developed problems due to well water with high lime content. now with good cleaning products available it is ready for use again. The problem is the top spray arm that refuses to rotate. I have taken the arm out and thoroughly cleaned it of deposits checked the supply line from the pump and checked the sump for any obstruction. The arm turns freely by hand but water just pours out the
Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Frigidaire 24 in. FDB635RF Built-in Dishwasher
Disposal plugged up and water backed up into dishwasher. Cleared disposal and dishwasher drain line. Checked around sump but dishwasher won't pump out. Sounds like pump is trying to run. I can blow air through the drain hose from the disposal and get bubbles in the water. Turned off breaker for 1 min. then tried reset. Can hear pump humming.
The pump is humming because its still trying to get all the water out of the unit. Deinstall the dishwasher and pull the entire dishwasher out from under your cabinet. Next step would be to disconnect the drain line from the drain pump and check to ... Dishwashers
I removed an old dishwasher and replaced it with this GE 24" Profile GSD533ODO1WW unit. It seems to run through the cycles like it should but it doesn't seem to run any water for some reason. I hooked up a new water line to it and turned it on. There where no leaks that I could see. Is there any installation manual that you could send me to make sure that I didn't miss anything or is there anything that you can tell me that I should look for? Thanks, Jesse
My new bosch dishwasher doesen't clean the top rack of glasses, ran it 3 times, no difference. also the soap dispenser opens up but the powdered detergent won't dissolve, the same soap has been in the dispenser for 3 cycles. i turned up the water heater temp to try to fix the problem it seems to have no effect. the dishwasher is 2 weeks old. could my water supply line be too small or are they a stndard size. thanks
... Bosch Dishwashers
I just installed a new Kitchenaid dishwasher (Model KUDE60FVSS3). After filling with soap, closing the door and starting the machine, it fills with water, waits a couple of minutes and then I can hear low humming noices coming from down below. After opening the door it appears that neither spray arm has turned as if to wash. This dishwasher was purchased new a few years ago and kept in storage as our basement was being finished. This dishwasher has never completed one cycle. Any and all inf
If you have a garbage disposal, there is a plug in the dishwasher that has to be removed for the washer to drain. ... KitchenAid KUDE60FVSS 24 in Builtin Dishwasher
Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to
Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers
European Bosch SKT 5002/02. Was disconnected by our plumber to install new cabinets. Not used during winter, as it is never used in winters. Fills with water, makes no noises but does nothing else. Have been told on-line to try to turn the motor (blades, I suppose) but it looks like the whole unit is behind galvanized panels and I don't want to do what I shouldn't......
Hi.Re:"Have been told on-line to try to turn the motor (blades, I suppose)" Someone has probably told you to energize the impeller pump motor directly by jumping its contacts to find out if the motor is working. That is a deli ... Bosch 22 in. SKT5108 Free-standing Dishwasher
Disconnected dishwasher and moved out in order to tile the kitchen floor. Ten days later reconnected dishwasher. Turned on water supply to leak check -- no water is getting into the washer. - Ran hot water from sink side to see if that would help, no such luck - Disconnected water line and water is in the line up to the connection point at dishwasher. Looked inside valve of dishwasher for obstruction - no such luck - Disconnected both ends of water line and blew in line to check for obst
... Bosch Evolution 500 SHE45M05UC Stainless Steel Dishwasher
I ran a load of laundry in whirlpoo[ duet ht, model ghw9400pl4, error code p-09 was indicated. water was overflowing from door, and water was continuing to fill the tub. I turned off the faucets, unplugged & restarted in drain mode it hummed but would not drain. I turned the faucets back on and retried to drain but it would only hum. I manually removed the water by losening pump filter. There was no debree in filter except for a little bit of hair. The pump & vain was free & clean, and I co
It is your mixer value that is malfunctioning. ... Whirlpool Dishwashers
Water I have a brand new house with all new appliances. I went to turn on my dishwasher and it comes on but no water. I turned on the valve under the sink but I still do do not get ant water... Please help.. Steve
Reach inside your d/w and jiggle the mushroom shaped float switch located on floor of d/w. should move freely up and down if its stuck up(or something lodged under it your unit wont fill with water ... GE 25 in. Nautilus GSC3400J Free-standing Dishwasher
Bosch SHX46A (6 years old) Selected regular cycle, pressed On and closed door. Cycle did not start normally. Pump runs, but no water is coming into the DW. I confirmed the water supply line is turned on. I opened door, turned off On/Off switch, then poured water into drain. Then turned On/Off switch on. DW began pumping water OUT of the DW. Also, it doesn't matter if the door is open or closed - if you turn the DW on, the pump will run. I suspect a problem with the electrical controls, or perha
From your description, I doubt that the problem is door latch is the cause.\015\012\015\012The first thing that a modern dishwasher does before it begins to fill with water is run the drain pump. It appears that this DW is not progressing ... Bosch Integra® 500 SHX46A0 Dishwasher
Amana Dishwasher dishwasher will fill with water, then will proceed to just hum through the wash cycle, no water is pumping through the turning blades. It will stay humming until you turn it off by hand ( dial will stop mid way through cycle)
Sounds like something is jamming your wash inpeller start at the washer arm and go down till you get to the wash impeller and see whats sticking it like broken glass small peice of bone toothpick etc ... Dishwashers
I have an avanti dw 18 dishwasher . the problem i am having is the when i turn the on button on the motor goes on however no water fills up. The motor is only humming. But; when i press down the float from inside the machine the water fills up and the machine starts to work. after the water drains again the motor continues to run and hum and the dial does not move. when i manually move the dial nothing seems to change . the motor continues to only hum. Even when the dial is in the stop position
... Avanti Dishwashers
Brand new Stanley 1800 power washer - just bought it yesterday. Powered it on - realized I hadn't turned the water on - so turned it off - turned the water on and turned the Stanley back on - it ran for a second and powered off. Now it won't turn on again. Did I burn out the motor?
... Stanley Pressure Washers
No water is coming thru the water valve to fill the dishwasher. The water is turned on. I had a Kenmore portable dishwasher and we just converted it to a built-in. The electricity is on and the water line installed. When I turn on the dishwasher, it comes on ok but no water is coming into the machine.
Most probable cause a faulty intake solenoid. OK start simple and go from there.If your have power and light etc come on then we know you are good for power. I'll assume that is OK. If\012you are not getting any li ... Dishwashers
Electrolux Dishwasher 24 " not enough water new fill valve new float hot water Water lines clear. water too low float never rises amd the dishwasher runs water barly covers the top of the filter straner Model FDBB2455FS0
If i was at your home as a repairman this is what i would do.if your water pressure was good at the kitchen sink,i would turn water off to dishwasher undo water connection at the fill valve,and place water line in a bucket and turn on wa ... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher
I have a Bosch SHU9915UC/U11 dishwasher, installed in 2002. Recently, our hot water heater had to be replaced, and we were without hot water for five days. Air got into the hot water pipes, and dried out all the debri in the lines. When we got the new hot water heater going, all of the sediment in the pipes ended up in the in-line screen filters in various appliances (clothes washer, etc.). I have cleaned these out, and these appliances are fine. Since then, the dishwasher has been shutting
All inlet valves have a screen built into the valve itself,shut off the water remove the entire valve and you will be able to see built in screen,if you flush out the debris from it and re-install the valve it should work fine. ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher
My Siemens dishwasher SL34A sometimes makes loud vibration noises from the supply line at the water pump connection. I can turn off the water and back on it will quit, but sometimes starts again. And it does not matter how open or closed the supply line valve is either. I'm told it is likely the water pump, but this model has a combination water pump/motor assembly and I do not care to put another $230 into it. thx, TS.
... Siemens 24 in. SL34A006UC Built-in Dishwasher
I have abrand new Black and Decker 1900 psi pressure washer. When I hook the water hose up to the machine and turn on the water, water sprays out out of the bottom without the machine being turned on. Thank you
... Pressure Washers
I have an electrolux slimline dishwasher model number esl 4115.On every cycle it starts with pumping out any excess water but will go no further.I have tried putting water in and all it does is pump out the water and continues with a humming noise.once opened the humming noise continues and the programme light continues to flash.there is another simble which is -] but with an arrow rather then a line that flashes 3 times.It seems to be stuck on empty.In the handbook it states that the anti-flood
... Electrolux 18 in. ESL4114 Slim-Line Built-in Dishwasher
GU2700 Whirlpool - Does NOT FILL 2 Gallons on INITAL FILL - unit has new parts FILL VALVE IS NEW OVER FILL SWITCH IS NEW while filling if you reach under the unit and push the over fill float up it turns off the fill cycle - if you let go - unit keeps filling - but does not add the correct 2 gallons - water is not even close to the heating element - does not have enough water to come out of the TOP SPRAY Arm
... Whirlpool Dishwashers
Dishwasher was making a loud hum. I turned it off and started it this morning. Seemed to be working fine, but after about 5 minutes it started making the same loud hum. The first time it seemed to be between cycles with no water, this time there water moving as normal except for the loud hum.
... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher
I've moved to another home and would like to re-connect my dishwasher. I am new to this & need to tap into the hot water line from the sink. HELP! How do I run the water line in an L configuration and then screw in the supply line from the dishwasher?
If you new home doesn't already have a branch line for a dishwaher, I'd get a plumber to install a copper T on the existing line then a second shut-off valve for the dishwasher. If there is ever a problem with the dishwasher, you can shut off its wa ... Kenmore 24 in. 16182 / 16189 Built-in Dishwasher