Having problems with your Bosch 24 in. SHU43 Built-in Dishwasher ?

Dishwasher sometimes works

\015 Sometimes will complete cycle or stops partway through.sometimes lights flicker and cycle will not start\015

Answers :

Where is the appliance plugged in if the three pin plug is directly behind it the plug sinks into the insulation on the back then when the appliance cools it pulls the plug out of the wall

Repair Help & Product Troubleshooting for Bosch 24 in. SHU43 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi, We have a Smeg ST 663 dishwasher that does work. However, sometimes when you want to use it and turn the power button on it beeps twice with the red light flashing and you can't get it to work or change the settings. Sometimes if we leave it for a while and try it again later it will work, but it is annoying as sometimes it won't want to work for ages and we really want our dishes cleaned! The dishwasher doesn't have many buttons on it (a power button, cycle selection button and 1/2 load


Hi,\015\012\015\012Turn machine on and press and hold the programme select button till the light goes out about 5-7 seconds see if this resets it if it does start a cycle and see what happens.Otherwise the pcb as its not responding to an ... Smeg Dishwashers

Whirlpool dishwasher The dishwasher works off and on. Every few days it stops going on altogether...only the cancel button goes on and the the dishwasher's timer says 2 minutes. Sometimes the air dry button works,but none of the other buttons work. The problem has been when the repair person comes out, it all of a sudden starts to work and so he can't diagnose the problem. I spoke with someone who said it sounds like with the touch pad or computer control board is bad. You don't seem to list my


THE TECH WHO CAME TO FIX MY DISHWASHER FROM Y=THIS EXACT PROBLEM TOLD ME THAT IT IS CAUSED BY THE WATER THAT TAKES TOO MUCH TIME TO GET WARM, SO YOU HAVE TO MAKE SURE THE WATER IS NOT GOING TO BE COLD BEFORE YOU TURN THE DISHWASHER ON. AS TO FIXING I ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Whirlpool dishwasher The dishwasher works off and on. Every few days it stops going on altogether...only the cancel button goes on and the the dishwasher's timer says 2 minutes. Sometimes the air dry button works,but none of the other buttons work. The problem has been when the repair person comes out, it all of a sudden starts to work and so he can't diagnose the problem. I spoke with someone who said it sounds like with the touch pad or computer control board is bad. You don't seem to list my


Hi there,\015\012\015\012your problem is intermittent and before you start replacing parts, i would recommend that you do these checks:\015\012\015\012unplug the dishwasher from the wall\015\012check the connection betwe ... Dishwashers

I have a Siemans SN34 dishwasher. It appears that the problem has something to do with the electronics since the dishwasher works intermitently. It seems to complete the cycle when it works but sometimes just doesn't start to work. What would you suggest?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. As everything else seems to\015\012be working fine the issue seems to be with the Timer going bad and should be ... Siemens 18 in. SF24A262 ExtraKlasse Free-standing Dishwasher

The dishwasher detergent is not dissolving. There is rinse aid in the dispenser - sometimes the door opens and the detergent comes out and sometimes it doesn't. If the detergent does come out then it is just sitting in the rack - should it drop to the bottom of the dishwasher? I have checked the door cleaned out around it to make sure the hook and release are working. I opened the door and the water is hot.


... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Whirlpool adg We have the whipool dishwasher adg6556 and the on sign blinks and the dishwasher won't work, sometimes we start it several times untill it starts working. Can you, please, tell me what could be the problem?


... Dishwashers

Dishwasher Repair Dishwasher is a Stoves/Newhome DW616 Rotating spray arms do not always operate. This is an intermittent problem - will sometimes work normally for a few days then arms will not move at all with no water coming from them. Machine appears to go through its normal cycle. Some times cycle starts normaly and spray arms stop working part way through.


It could be a motor or a pump issue. The dishwasher has a motor that attached to a pump which forces the water up into the sprayer arms and during the drain cycle, it pushes the water out of the dishwasher. \015\012The motor (and pump) located beneat ... Dishwashers

ZANUSSI Da 6341 dishwasher, Flooding in middle of cycle. Sometimes at start of cycle (5-10 mins) washers floods and water comes out of front. If i move timer to end of cycle pump works and water is pumped to sewer. This doesn't happen every time. Sometimes cycle works perfect and after that doesn't


... Zanussi 24 in. DA6141 Built-in Dishwasher

I have a Bosch SMU2046Uc/14 about 15 years old. Sometimes it works, sometimes not, for the last couple of months. Now it has stopped working completely as if no power. Checked the breaker. Another problem - one of our kids just today jammed the door lock on it and we cannot get the door to latch at all. Can you help with any one of these problems? How do you fix or reset the door latch??? What else can we check to troubleshoot the dishwasher? Thanks!


... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

We haave a Frigidare FGHD2433KB1 dishwasher that we installed in September of 2010. Already it is not working and we are 2 highway hours from the place where we bought it. Sometimes the detergent doesn't open, sometimes dishes are not dry, recently the PF light has been coming on - yet no other appliance has had power interrupted. I am thoroughly disgusted with this machine and there are only two of us in the house so it get light use and we rinse our dishes well before placing in dishwasher.


... Frigidaire FDB956RB Built-in Dishwasher

Smeg Dishwasher ST 663 sometimes won't work


My dish washer stops after i5 minutes, don't know what the problem is, water is going in but just suddenly stops, i changed the hose but still the same. Any help welcome ... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

We have an AM-14 dishwasher. It now will not work on auto. It would sometimes and then not and now only on manual. We have had a couple people in to look at it. One says the main board was bad, so it was replaced and the problem continues. The board that was removed was put into another washer and it worked ok. We were told then that that a wire from the motor was wrong and thats when we called in another person. That person said the board was bad and they couldn't work on it. We are in Lancaste


... Hobart AM14-253 Free-standing Dishwasher

Kitchenaid dishwasher dishwasher is 5 yrs old. Recently the dishes don;t look dry and sometimes aren't clean even when you use the scrub feature. Hot water works at sink but we don't see steam coming out of dishwasher and the door doesn't feel hot to touch as it used to. Help please.


May have a heating problem.need to check for power to element,if no could be board fault,broken wire in door,if power is getting to element the the element could be faulty.hope this helps. ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Kenmore Elite Dishwasher, Model 665.15979992 No Heat Dry Button/Light: The dishwasher will not work. Have tried to no avail the various alternatives listed in this thread and others. Here's what the dishwasher is doing: To start off, the red light on the "No Heat/Dry" button is on - sometimes it's on steady; other times it blinks depending on whether other buttons have been pushed. Pushing any other button also causes the "Lock On" red light to come on. Pushing the "Cancel" button causes all


Have you checked the thermal cutoff switch located inside the door by doing a continuity test to it if this is sounding like where your problem are is coming from on this diagram ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Lights work, dishwasher works but "start" button won't start it. I can get it to work sometimes by hitting a few of the buttons back and forth. Otherwise, I can't get it to start.


... GE 24 in. Monogram ZBD6880KSS Stainless Steel Built-in Dishwasher

Kenmore Dishwasher- Console panel not working right , sometimes it starts and then shuts off in the middle of the cycle. Sometimes multible function lights are flashing but dish washer won't start


... Kenmore Dishwashers

Bosch SHV46C Bosch dishwasher (SHV46C13UC) doesn't "start". When I start the cycle, it makes a noise but doesn't fill with water. The drain pump is working because I poured water into the basin and watched it disappear. The noise that it's making is a constant low-toned rumble/hum. I sometimes would hear this noise at the end of a cycle when things were working fine.


Replace the fill valve that sound is it trying to open ... Bosch 24 in. SHV46C13UC Free-Standing Dishwasher

My Amana ADB1500AWW3 dishwasher (put in use this May) control panel sometimes works sometimes doesn't. Push start button, nothing happens.


... Amana 24 in. ADB1500AW Built-in Dishwasher

GE GSD6610GOOB not cycling properly. Our dishwasher is about 6 years old and has been nothing but trouble the past year or so. We've already paid too much money repairing it the first time, (it simply stopped working - the control panel was totally dead) and don't want to pay anymore. Current problem - the machine starts up and fills with water and it sounds like it's running OK, then it will just stop, sometimes for a couple of minutes sometimes longer. Then it will start up again - and


... GE 24 in. GSD6600G Built-In Dishwasher

Codes Hi, my dishwasher keeps showing me either F7 or F9 when it doesn't want to work. Yet sometimes it works perfectly. Can you please tell me what these codes mean. Thanks


IDEAR FRIEND,\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012ngfam1 here for you!\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012I am happy to be of assistance!\015\012\015\012\015\012 ... Dishwashers

I have the double drawer dishwasher. It is 3 years old. For about 1 year now one of the programmes - the second one along which is for quite dirty crockery and cutlery (programme is about 99 minutes) - STOPS after about 60 minutes. It bleeps and flashes and the pot wash programme and eco button are on when I open the drawer. Sometimes the programme works right through. No pattern or consistency. Also the dishwasher isn't cleaning terribly well. I've checked the filters as much as I can an


A few things you could do.\015\012\015\012Is this happening with both drawers.\015\012\015\012Take a clean damp cloth and wipe the switches and the inside panel.\015\012\015\012Get a couple of Finish dishwasher cle ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

In our church one of our dishwashers is a model WM5H. Sometimes it will work fine. Other times the light never comes on. I have had two service calls and it works fine while they are there.


The door switch, by door hinge, resets the timer for the next cycle. The door needs to stay open for about 8 seconds to complete the reset. \015\012\015\012There is also a switch inside the door at the handle. This can cause a similar ... Dishwashers

My maytag dishwasher lower and upper spray arms are working intermittently. Sometimes there is plenty of water spraying around, other times, I can hear what sounds like the motor running but the arms are not moving (or not moving much) and very little water is splashing around. When this happens, the detergent sometimes doesn't even get washed out of its compartment.


Pour 1 Cup of Muriatic Acid (Can be purchased at your local Pool Supply Store) into the bottom of the washer and a little in the soap dish. Run the Dishwasher through 5 cycles. Check to see If this helps. If not Try the same process with CLR house cl ... Maytag 24 in. MDB4000 Built-in Dishwasher

Matsui MF160 integrated dishwasher: Had problems for a while now with the buttons on the control panel ie: on button needed to be pressed down hard for it to connect and sometimes the wash cycle programme buttons would just keep flashing between the three of them and then they would settle down, for the past few days the on button light has stayed on and wont go off and now all the lights on the control panel have gone off and the dishwasher wont work at all, we have tried dis-connecting it, che


... Dishwashers

Our Blanco dishwasher works sometimes, other times it sounds like it is going but the water does not go. It was doing it every now & then, but now it is lucky if it works at all. Can you help? model BFDW 650S. Thanks Donna


If there's no water entering your dishwasher, check these:--\015\012\015\012\015\012Water-inlet valve\015\012\015\012\015\012The water-inlet valve lets water enter the machine. If this valve is defec ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1709 seconds