Having problems with your Bosch 24 in. SHU43 Built-in Dishwasher ?

Unit does not turn on or intermitent

\015 Have repaired a break in the door panel wiring; unti was working fine, then became intermittent and has now stopped. Assume it could be the same door wiring. Other places to look?\015\012\015\012Thanks!\015

Answers :

Bottom of the door as the loom passes under the drip tray it catches rubs and then breaks around thsat area new door loom is available as spare part
good hunting

Repair Help & Product Troubleshooting for Bosch 24 in. SHU43 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Unit does not turn on or intermitent


Bottom of the door as the loom passes under the drip tray it catches rubs and then breaks around thsat area new door loom is available as spare part good hunting ... Bosch 24 in. SHU43 Built-in Dishwasher

I have an Electrolux ESL6114, The problem the progamme does not finish and when I turn off the appliance there is still water in the filter area at the bottom of the unit. There is a intermitant noise like the pump runs for a second then stops this goes on and on. Any help please.


... Electrolux 23 in. ESL6114 Built-in Dishwasher

Dishwasher (Model # SHU6806UC), unit is about 8 years old, very light use, less than once a month, and no previous problems. Turned on unit and after about 10 minutes, I found water on floor coming from dishwasher. Turned unit off and turned off water shut-off valve. Removed dishwasher from cabinet. Found mice had chewed a hole in water discharge hose under unit, inspected all hoses, and found another hole chewed in the 13" flex hose in the front of the unit. Also found the float chewed to alm


Hi,\015\012 Check the valve is open where the supply gets its water from the sink supply.There is a garden hose type swivel adapter after the valve, Close the valve tightly and then unscrew that hose coupling and see if the hose is full of w ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

When i go to turn the unit on the green light comes on for about 10 sec. then the unit turns off. model #gu1200xtkto. the water line going yo the unit is fine. could this be the pump?


... Whirlpool Dishwashers

I have a Miele Built-In Icognito 658/850 SCVi. The intake/drain light is on, and I have followed the directions in the manual. The light turns off after I follow the directions and the unit turns on but there is no water running through the unit. When I open up the unit, the light is then on again.


Check to see if the water \015\012\011\011\011shut-off valve (located under the sink, it is an electromagnet valve, located at the pipe's entrance to the machine) is open. If you get water to \015\012\011\011\011the dishwasher, but there is still no ... Dishwashers

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a General Electric Potscrubber dishwasher. When the cycle is finished, the water does not drain into the sink.I turned the unit upside down to look into the bottom. The motor turns freely. The instruction sheet I found in the bottom of the unit said to remove the filter screen and check the piston valve. I looked at what I thought was the piston valve, but I'm not sure how to check it. The line to the sink seems to be clear. The model of my unit is GSC3230Z03WW. The serial number is AZ627


... GE Dishwashers

For my Kudi01dl model dishwasher, the rinse light is on, but the unit will not respond to any buttons being pressed and won't turn on. When I press any buttons, two horizontal lines show in the front, but go off as soon as I let go of the button. Is there a ways to reset the unit? Everything was functioning fine the last time I used it. I use it about once a day. The problem started when I heard sounds coming from the unit, very loud motor sounds. The door was closed but I had not turned


... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

I have a GE gss1800z02. When the unit is turned on it starts to work, then sparks start coming out of the bottom of the unit. If the unit is off and the circuit breaker is on, their is a sound similar to a TV being turned on about every 30 seconds.


... GE Dishwashers

Kenmore Ultra Wash Model 665.15801891 (Serial FJ3403697). This is in the USA. Unit will not run. Two lights are lit on the display panel and do not go off - 'Drying' and the #2 on 'Delay Hours'.rn I have turned off the power at the breaker box hoping it would reset. Once power is turned back on the Lock light comes on. I can clear that by pressing 'No Heat Dry' for 4 seconds but then the 2 lights mentioned above come on and do not go off. Any suggestions? Can you tell how old the unit is by t


Plase confirm if your model has the same front panel as the one shown in this manual.\015\012In that case try this sequence to reset the dis ... Kenmore 15899 Built-in Dishwasher

The unit fills up with water but the circulation pump wont turn on. if i jump the pump it works. the pump is connected to the timer board. is there any sensor that would cuase the timer board not to turn on the circulation pump. this unit seems to be manufactured by ASKO mod. DW20.3 i dont want to replace the board ($375.00) if not nessary. thank you


Hi\015\012\015\012\015\012Thanks for using FixYa. There is no sensor on your dishwasher for drainage purpose however, it uses a drain solenoid to open and close the dishwasher drain port. If this \015\012solenoid ... Dishwashers

I have a McCulloch FHH18A power washer. When plug it in without the water turned on, the pump will start. As soon as I turn the water on to the unit, the GFCI power cord trips. Water does flow through the unit as I have water at the wand nozzle when not plugged in. Any suggestions?


I would guess there is a leak somewhere inside the unit that is spraying water on some electrical component and causing a ground fault. ... McCulloch FHH18A Electric Pressure Washer

ASKO D1996 D/W won't turn on. I have 2 ASKO dishwashers. Unit won't turn on - no lights accross the top. Service company rep says unit is getting power to the on/off switch but not downstre


... Asko Dishwashers

Limited pressure since water is releasing from inside the unit. Also, the unit will NOT turn off when using the hand unit. Unit is only two years old. Do you have local service in the Chicago NW area (Barrington)?


You can find a service center for your area on the link below.\015\012\015\012 ... Karcher K2.26 Electric Power Washer

The water discharge line is connected to a unit that is mounted to the sink. This unit in turn has another line that is connected the the house drain. This unit is sparying all over the sink, counter and floor. What is the purpose of this unit and why couldn't the drain from the dishwasher be connected directly to the house drain?


It is a unit to stop water flowing back into the Washer... I suspect it is blocked... You probably need a Plumber? ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Bosch Integra 500 dishwasher turns on and starts wash cycle, turns off after 90 seconds and then there is no power on the button panel at all. The dishwasher is full of water. Now the unit will not turn on or off. There is power to the outlet the dishwasher is plugged into.


Your controlboard is no good. find out if its a recall unit go to thermador.com which is the company that owns bosch and they can tell you the price if you have to oreder it or if its free for part and you pay labor to install ... Bosch Integra® 500 SHX46A0 Dishwasher

Unit turns on but water does not fill the unit and yes water is on to the unit. What is my problem. Is it in the control panel or is there a float somewhere?


Your problem is the flow Meter / Regen unit ... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Water was turned off while we were on vacation. Wife ran dishwasher without turning on the water. Turned on the water this morning, however unit won't pump water into the washer .


\012Hi,\012Here is a tip that will help you to find out why water will not come into the dishwasher... ... Maytag Dishwasher

Kuppersbusch IGV 645.0 built in dish washer has started to make its audable intermitent beep alarm, with start light flashing, have checked the (rubbish) instruction manual it suggests filters are blocked but they are not, turn it back on and it sounds as if its working but just keeps beeping, can you advise pleas?, The last time this happened I turned it off at the mains for three hours then turned it back on to find the alarm had cleared


... Kuppersbusch Dishwashers

Odd operation Unit turns on, slowly heats up. When wash cycle starts, temp drops 20 degrees. Unit never seems to drain completely. when cycle finishes, Booster heater temp can drop as much as 40 deg (122F) Heater slowly recovers, but unit never seems to go into rinse cycle.


This unit is a sanitizer, not a full fledged dishwasher. It is designed for restaurants and bars where the primary use is washing glassware. The behavior you describe is normal for this model. The manual can be found at the following link: ... Hobart 24 in. LXIH-3 Built-in Dishwasher

We have a 100% failure rate on multiple parts on two Maytag dishwasher units and no longer can get replacement parts from anyone. Any ideas of what to do? Here is the latest summary we sent to Maytag: Thank you for the help last fall. As a follow-up, we are still having very bad results with your product. You authorized replacement of the unit which was done. After one dishwashing, THE NEW UNIT SHOWED THE SAME PROBLEM (WOULD NOT TURN ON). I called in and you referred us to a senior te


Well iam sorry to here of you major problems.if the control board has been replaced several times and no luck fixing it there may be a problem with the main power supplied to the unit,as well as having a problem with the wiring harness.usually a manu ... Maytag 24 in. MDBH940AW Built-in Dishwasher

Inlet/Drain light is on. I have cleaned the drain pump and non-return valve, rinsed under water, removes all foriegn objects, turned the drain pump impeller (which turns freely) and carefully replaced the non-return valve and secured it with the locking clamp. I tried turning off the dishwasher and teuned it back on. No warning light shows but as soon as I try the dishwasher on a wash cycle it fails to pump water into the machine and release the washing tablet door. The programme unit makes a no


Is the water inlet turned off by chance? Is there no water at all inside the dishwasher? ... Miele 24 in. G643Vi Plus Built-In Dishwasher

Bought a 3 year old unit for my son in law, picked it up at a storage unit. Unit panel will only turn on when the door is open. When we close the door the lights go off and it won't start. HELP


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. This issue can be either due to a faulty door latch or\015\012door lock switch which is not engaging its ... Bosch Integra® 500 SHX46A0 Dishwasher

I have a LG LD-14AW2 dishwasher, today I set it to run and came in and although the lights were still lit up the tome was not moving, I turned the unit off and waited a while then turned it back on. The power turns on and I set the type of wash but when I press start it beeps twice and won't start. Can you help, I have had nothing but trouble with this dishwasher since it was installed!


V\\:* {behavior:url(#default#VML);}\015\012o\\:* {behavior:url(#default#VML);}\015\012w\\:* {behavior:url(#default#VML);}\015\012.shape {behavior:url(#default#VML);}\015\012\015\012\015\012 \015\012 Normal\015\012 0\015\012 \015\012 \015\012 fal ... Dishwashers

Karcher 3.86M Electric pressure washer. Plugged it into outlet. Unit started running. turned it to off position. Attached hose. Turned on water valve. Turned on switch. Squeezed trigger. Nothing happened. Will not run. Ciruit breaker was reset.


... Karcher PSI Electric Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0801 seconds