Having problems with your Bosch 24 in. SHU43 Built-in Dishwasher ?

BOSCH DISHWASHER RUNNING TOO LONG PROBLEM

\015 HI,DISHWASHER CLEANS GREAT.BUTTAKES 3-HOURSTO GET THRU ALLCYCLES.\015

Answers :

Bosch dishwashers are designed to heat the water to temp. However it has a 3 hr default if it doesn't reach temp. Start the cycle and see if after 1 hour if the water is hot or cold. If hot, then it is heating the water and the water coming in is just too cold. You may try running the water at the sink to get it hot there first before starting the dw. If the water is cold, then your unit isn't heating the water. At this point I pull the outer door panel, find the largest wires on the control unit and put my meter leads on them then start the machine. You will see 120 volts on your meter. Start the machine in light washes and with in 10 to 15 minutes you should see 0 voltage. Than means the relay has closed in the control and the hot line of the 120 volts is being sent to the heater. If this never happens, then you have a bad control. Bosch dishwashers have a 5 yr part warranty on the electronic control. Now If you get the 0 volts, I will put my amp meter on one of the same wires and check for 9 to 11amps. If that isn't there, then you have a bad heater assy. Hope this helps
Repair Help & Product Troubleshooting for Bosch 24 in. SHU43 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher keeps running I have a Bosche dishwasher and the water keeps running. As long as we run it and don't stop it, the pump will continue to drain about every 3 minutes. The water just keeps running though. If we open it to empty the dishes, the cycle will stop. But the water keeps running, filling the tub, and then overflows, flooding the kitchen and drains through our wood floors to the basement below. Our ASKO seems to have a similar problem. I started the dishwasher, and the water ke


Open up the door, get out the control unit. Pry open the unit's plastic case and look at the board. Burnt spot? If so, the heater circuit burnt out (happens a lot on Bosches) and the control is waiting for the water temp to rise, but of course it ... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

BOSCH DISHWASHER RUNNING TOO LONG PROBLEM


Bosch dishwashers are designed to heat the water to temp. However it has a 3 hr default if it doesn't reach temp. Start the cycle and see if after 1 hour if the water is hot or cold. If hot, then it is heating the water and the water coming in is jus ... Bosch 24 in. SHU43 Built-in Dishwasher

Bosch dishwasher running to long and not sanitzing dishes


... Dishwashers

We have a KitchenAid dishwasher (KUDI01FLSS6) which has not been working properly for a long time. We have the dreaded green blinking light mystery. We understand that this could indicate several different problems. We have found that if we run the sink water until it is hot, then start the dishwasher, and then after ten minutes we open then shut the door, it will consistently run the full cycle perfectly. Does this give you any hint of what might be the problem component -sensor, element, the


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

BOSCH Dishwasher Problem I have a dishwasher (SHV46C13UC/33) that when I start any of the three cycles it continues to run until I open it and do the 'cancel' function. The 'rinse/drain' seems to be running fine, but there is a film left after that mode. I've checked the water inlet, which is open and fine. And, it does drain properly. Is there a SENSOR I need to clean periodically? Or, is the man control module the problem? What's going on?


I would check the float switch in the bottom should be a mushroom shaped thing that turns the pump off after the water level in the machine has dropped to a certain level or has totally emptied. ... Bosch 24 in. SHV46C13UC Free-Standing Dishwasher

My Bosch dishwasher has had a problem since we had it installed. It smells like garbage after sitting for a few hours. This problem is there whether it has been run or not. Water is always standing in the large drain tube under the "filter" and it doesn't look clean. I contacted Bosch by phone as soon as this was discovered - in a matter of days after purchase - and was told by a rather haughty service person to leave the dishwasher door open. Not a practical suggestion even if it didn't sm


Was the drain tube that hooks into the sink drain passed over the partition between the sink area and washer area or through a low-level hole. If through a low-level hole, try rerouting the tube over the partition. This forms a 'trap area' to isolate ... Bosch 24 in. SHU43 Built-in Dishwasher

Water seems to be leaking into the dishwasher at the end of the cycle the water appears to be clean, so I am wondering about a seal of some kind on the hot water line leaking or whatever. It is a Bosch Dishwasher SHU series 3200 My problem is the same. Water leaks in to bottom of dishwasher over about a 2-3 day period. The dishwasher runs fine. It does not ever run over. The water seems to stop entering the dishwasher after it reaches a certain level.


You have a bad water valve. When the unit is off, the valve should seal and the water should not flow. Something has gotten in the valve and is keeping the needle up or the diaphram in the valve has deteriorated. replace the water valve and you wil ... Dishwashers

Bosch Dishwasher I currently own a Bosch dishwasher. One of the selling points, if I'm remembering right, of the dishwasher was it was supposed to super heat the hot water that is coming in from the tap. I have 3 problems. We have to rinse the dishes by hand before putting them in the dishwasher, Otherwise they won't come out clean. The dishwasher will run for four hours sometimes longer. It doesn't seem like it is heating the water any hotter than what comes out of the tap.


Your control board is bad. ... Bosch 24 in. SHU43 Built-in Dishwasher

Bosch dishwasher runs too long - Bosch Evolution 500 SHE55M05UC Stainless Steel Built-in Dishwasher


... Bosch Evolution 500 SHE55M05UC Stainless Steel Built-in Dishwasher

We have a Bosch Diswasher Model SHX-46A05UC that we purchased three years ago. We have loved it! This week it started running a long long time and won't finish on its own. Also the santitized cycle is not working. We live in a remote mountain town and our local appliance repair man refuses to work on it because it is a Bosche and he hates them. Please help! Can we do something on our own before having to pull the dishwasher and take it out of town for repair? Thank you...Jackie


... Bosch Dishwashers

II HAVE A KITCHEN AID DISHWASHER MOD#KUDP01LWH1. THE DISHWASHER TAKE TOO LONG TO RUN THE CYCLE. I FOUND OUT THAT THE ELEMENT DIDN'T WORK, I REPLACED THE ELEMENT STILL THE PROBLEM THERE. WHAT ELSE COUL BE THE PROBLEM


... KitchenAid Dishwashers

Hose hookups My Bosch SHU43 dishwasher has no manuals. My problem is that I have one long hose that should be the discharge hose but no fitting to hook it to my disposal nipple. My other problem is there is another hose that exits the dishwasher about mid level but does not hook to anything. Should this hook to the supply?


The smaller hose should be 3/8" is the water feed the larger hose is the discharge. you can open the front panel (2 torks screws) and you will see the water inlet valve in the left towards the center the electrial box is on the far right ten determin ... Bosch 24 in. SHU43 Built-in Dishwasher

My Bosch dishwasher runs long. I notice the water in the bottom isn't very hot. (I've turned on the faucet and let the hot water run before I started dishwasher.).


Hello,Welcome to FixYa. ... Bosch Dishwashers

Bosch dishwasher SHX46A -cycle runs too long (4 hours)- items still wet. The economy cycle also runs too long - should be about 80 minutes and it ran for 200 minutes.


It sounds like there's a problem with the dishwasher's heating element. The dishwasher uses the heating element to heat the water to certain temperatures, and it will wait (run for extra time) for the water to reach this temperature, and may eventua ... Bosch 24 in. SHX46A05 Stainless Steel Built-in Dishwasher

Bosch dishwasher runs too long, over 130 minutes on regular cycle, then when it gets to the final minute, it continues to run for a long time. The sanitized light doesn't come on, and dishes are not hot and not dry.


Http://www.acmehowto.com/howto/appliance/dishwasher/dishwasher.php\015\012\015\012Please find above, a troubleshooting how to ... Dishwashers

Bosch dishwasher I am looking for a wire diagram for a Bosch dish washer mod # SMU2046UC SER# ? FD 7609 470358 my problem is the timer will run but there is no operation at any point on the timer dial, and I cant find a wireing diagram for this unit. so that I can try to trouble shoot this problem.


... Dishwashers

I have a Bosch Model SHE99C Dishwasher. When the dishwasher runs, but no water is coming out. Is there a way to run a test cycle to find out what the problem is?


... Bosch SHE99C05UC Dishwasher

Bosch Running a LONG LONG Time and Watering Remaining


Hi,\015\012You could try running the machine with the drain hose leading to a large bucket. If it works OK in this situation then the blockage will be most likely where the drain hose joins the house drainage system - often at a junction under ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Bosch SHX46A05UC14 dishwasher. The dishwasher is in a new home I just purchased. I tried to run the dishwasher on a normal cycle. However, when I push POWER and NORMAL CYCLE it makes a buzzing noise...and that's it. I opened the dishwasher and on the base of the dishwasher there was a screen that could be removed. I noticed that there was still some anti-freeze fluid in there (because the house was winterized). Could there be a simple solution to this problem?


... Bosch 24 in. SHU43 Built-in Dishwasher

Dishwasher stalls I have a Bosch dishwasher model # SHU4006UC/U06. The dial stops after going through one cycle and the dishwasher continues to run that cycle and will not advance unless we manually advance the dial. After advancing the dial the dishwasher will stall until we have manually advanced the dial until reaching the "9 o'clock" position. It will then continue until the dry cycle is complete. Thanks!! I have the same problem. I took out the timer control and spraid it with contact clean


If the cycle doesn't complete, check these:Water-heating cycle ... Bosch SHU4006 Dishwasher

Installing a built-in LG dishwasher; got everything ready to go, but a problem with the hot water line coming in. It is barely long enough to reach to the front where I've installed the elbow. Since I have to back the dishwasher in to the 24 in. hole there is no room for error in terms of not running over this hose with the bottom of the dishwasher. Any tricks to handling this situation?


Hi, best way would be to install a "spring" attached to the back of the dishwasher. The hose would connect to that and easily "pull-away" when moving or "pull-tight" taking up the slack. A much simpler method is to tie a piece of string to the hot wa ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Just got a new Bosch dishwasher (forget which model). After the dishwashing cycle has ended (even long after), the dishwasher and dishes are still wet. Was this an installation problem? Thanks


Hi -\015\012\015\012I can't see how any installation problem would cause this - if the dishes are still wet at the end of the cycle, you'll probably find the water isn't heating during the wash cycle. The dishwasher uses steam to heat the washi ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

Bosch Dishwasher SHU33-Long Cycle, no Sanitize Light


... Bosch SHU3306UC Built-in Dishwasher

We have a Bosch SHE45M06UC/50 dishwasher that is acting a bit nutty, first of all the timers are all wrong, mostly too short for what the manual says except the quick cycle and it is too long. There is on some cycles a very long delay before it begins to fill and it seems to alternate between pumping and running randomly


Hi,\015\012\015\012The first thing to note with your make of D/W is the display only shows "estimated time" not actual time. There are just too many variables to give actual times, i.e. water temp. at inlet, drain hose length & diameter, as well as p ... Bosch Dishwashers

Our Bosch model SHE44CO dishwasher run cycle has progressively increased. It now runs twice as long as it once did. Help????


Hello,Based on your description I'd say the issue is with the control. Bosch has had a history of this exact problem I'm about to lay out for you and this is the first thing I'd be looking for if called out to service the unit with the sy ... Bosch 24 in. SHE44C05UC Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2014 seconds