Having problems with your Bosch 24 in. SHU43 Built-in Dishwasher ?

Bosch shu3036 upper arm with low pressure

\015 Dishwasher shu3036us/uc12 doesn't get upper rack clean. Arm moves infrequently and I suspect lack of water pressure.Opened the unit and saw black gasket material inside the water valve assembly blocking about 25% of the inlet screen. Cleaned it out. (Not sure where that would have come from.)But is this more of an impeller problem? Do I need to rebuild the circulation pump? Replace with a new one?\015

Answers :

I don't have a solution. I also have a Bosch SHU3036 dishwasher. It is 8 years old and last Thursday it stopped heating and the rinse cycle ran for hours before I noticed it in the middle of hte night. Two repairmen who came yesterday (got them off the Bosch website) seemed to have no clue. Does anyone have a suggestion?
Check water level should just appear above filter failing that a common fault on these is the impellor wings have worn you need to strip wash motor down to get impellor cover off
Repair Help & Product Troubleshooting for Bosch 24 in. SHU43 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch shu3036 upper arm with low pressure


I don't have a solution. I also have a Bosch SHU3036 dishwasher. It is 8 years old and last Thursday it stopped heating and the rinse cycle ran for hours before I noticed it in the middle of hte night. Two repairmen who came yesterday (got them of ... Bosch 24 in. SHU43 Built-in Dishwasher

Bosch dishwasher, low water pressure, arms not turning


... Bosch 24 in. SHX46B05 Stainless Steel Built-in Dishwasher

I have a frigidaire dishwasher - model number PLDB998AC1. There are two spray arms in this dishwasher - lower and upper. The lower works fine but the upper spray arms are not spinning. There is what I think adequate water pressure coming in from the top but no movement on the upper spray arm. Here is what I know: 1) The water pressure and spray arms alternate between top and bottom. 2) The upper spray arm moves freely when I push it gently. 3) I have removed the pump and cleaned out an


... Frigidaire 24 in. GLD2162RDC Stainless Steel Built-in Dishwasher

VERY LOW WATER PRESSURE TO THE LOWER AND UPPER SPRAY ARMS. FILLS AND EMPTIES NORMALLY


Hello there:i will post this solution in 2 separate post due to the length of it ok Water-inlet valve\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 ... Bosch 24 in. SHY56A05 Stainless Steel Built-In Dishwasher

Bosch SHU4302 WITH REPAIRED PC BOARD has been working fine for several years now seems stuck in rinse/drain mode and is not quite pumping cabinet dry. I have removed the screens and located the small impeller at bottom below cover. The impeller rotates as though it has multiple spring loaded stop positions. When I turn on the unit and open the door water is trickling from the sprayer arms at low pressure. It seems stuck in rinse mode and will not advance cycles or reset when shut off.


... Bosch Dishwashers

LG LDS5811WW Low pressure out of spray arms


On the LG LDF xxxx dishwasher family, the Vario feature uses a motor/check valve to switch between "full power" cleaning from _either_ the lower or the upper spray arms, never at the same time. So, not seeing the upper arm spin during the lower arm ... LG 24 in. LDS 5811ST Stainless Steel Built-in Dishwasher

Low water pressure arms will not spin


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Very low pressure getting to spray arms


I removed the lower spray arm, and then the filter. I found that there was a lot of buildup under the filter area. I scraped the buildup off. I found that it was restricting the input of water flow to the pump ... Whirlpool GU2400XTP Built-in Dishwasher

I have a 13 year old Siemens SE64630GB. It isn't cleaning items in the upper basket and I believe it's due to lack of water pressure in the upper spray arm leading to little or no rotation of the arm. Have cleaned out the drainage pump and removed and cleaned both the water feed pipe to the upper arm (a lot of gunk in there) and the spray arm itself (which also had blocked nozzles) - no apparent blockages now. Could there be a blockage in the circulation pump and if so how do I access this pump


... Siemens Dishwashers

My Kitchen Aid KUDS01DJSS0 seems to have water going to the upper spray arm (I see water coming out of the unit just beneath the upper rack), but the pressure doesn't seem to be high enough to clean the upper rack. No evidence that water is coming out of the spray arm on the very top. Lower rack dishes seem to clean OK. I have already removed the whole upper spray arm assembly and inspected the flapper valves that the middle sprayer goes into. I suspect that it's not making good enough contac


... KitchenAid Dishwashers

Bosch SHX56B Dishwasher rotating arms dont get pressure


... Bosch Dishwashers

Whirlpool 6600 24 inch dishwasher: low pressure,arms not spinning


Your water pump is blocked. You will either call a repair person or disable the top of the pumb (inside the dishwasher, bottom) and check the water input duck. It just might be just some food, etc.. that is blocking the input. But if you don't see an ... Whirlpool 24 in. ADP6940 Dishwasher

Bosch dishwasher low water pressure


... Bosch 24 in. SHX46B05 Stainless Steel Built-in Dishwasher

Hi there I have a Bosch SGV4313GB/17 Dishwasher the problem is there insuffient water pressure to feed the washer arm and they are not rotating Ihave cleaned the arms and circulation pump impeller with white vinegar ,I have also overriden the door switch and operated the dishwasher with arms removed and the circulation pump seem to be working but with insuffient pressure also the machine does not fill to the depth it did when it was fine! How does one tell if it is the impeller or the


Ours is a SHU3300UC/06 model, basic model which we bought in 1999 so have had 9 years of trouble free service.Recently\015\012we noticed that there was soap left in the soap dispenser after the\015\012machine had finished all the cycles. On fu ... Dishwashers

I have a Frigidaire dishwasher, FDB-1100RHC, that is not cleaning dishes. My fiance cleaned the trap at the bottom of the washer, removing both the small basket and the larger mesh grid. After replacing both, the washer doesn't seem to have enough water pressure to spin the lower and/or upper arms. If I interrupt a cycle and open the door, water is dribbling out of the upper arms, but they are not rotating and do not move from whatever position you place them in. Both arms are completely uno


Hello :)don't feel bad, I run into this kind of problem at least once a week.\015\012It does sound like the pressure isn't there so you're not getting water to the upper spray arm. What you need to do is take the pump apart, which i ... Frigidaire Dishwashers

BOSCH DISHWASHER SHU43C06UC/17 NO WATER UPPER ARM


Ours is a SHU3300UC/06 model, basic model which we bought in 1999 so have had 9 years of trouble free service.Recently\015\012we noticed that there was soap left in the soap dispenser after the\015\012machine had finished all the cycles. On fu ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a mod. GSD2200G00WW . It has low water level and not enough pressure to turn the spray arm. When first starting i see water coming in but not enough. I added water in manually with a container and turned on and the spray arm rotated fine. I closed the door and turned back on and the water drained out of it instantly back to a low level. What now?


... GE Dishwashers

How does the upper arm on a Bosch dishwasher connect? It broke off ordered the new part and the part does not connnect? The piece I am trying to connect the upper arm into must be broken?


... Bosch SHU3305 Dishwasher

Bosch E15, I see from your site is a water pressure problem. (thanks) I think we have solved that, it old house water pressure gets low, needed resetting. But now how do I clear the error so I can try it? Sounds like there is air in the system. It is a French Bosch machine, the robinet ferme is blinking, sel & liquid rincage are lit, auto 45-65 is blinking. We opened it while it was running, and this all happened from that.


... Dishwashers

I have a Whirlpool Gold Quiet Partner III that is 8 years old and recently stopped cleaning top rack dishes. I remember finding a mylar like piece in the bottom of the tub and threw it away thinking it came off of something we washed (I know, bad thinking.) The mylar piece measured roughly 3-4inx2in and was folded in half. Anyways....the upper arm does not spin and the detergent doesnt get fully dispensed so dishes dont get fully cleaned. I am guessing not enough water pressure to upper arm. Wou


I'm having a similar issue. Are you sure the arm isn't moving at all?\015\012\015\012Generally what I'm finding is either you have a clog or the pump motor is bad.\015\012Hear is the service manual.\015\012 ... Dishwashers

There is no water coming out of the upper arms. The upper arm assembly is clean. is there a filter somewhere I can clean to increase the water pressure?


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... LG 24 in. LDS 5811ST Stainless Steel Built-in Dishwasher

Two problems: the water pressure in the arms is low. If you pop the door, arms are not spinning as it should. Each time you start and stop, the arms move a tiny bit. Have cleaned the filters and the spray arms completely. Also, detergent door no longer pops open.


Hello, Welcome to fixya.\015\012 \015\012I just came ... Bosch SHU3306UC Built-in Dishwasher

My Bosch dishwasher, S9J1F will not clean things properly, I've changed the arms, cleaned it. I think the arms don't seem to spin properly, (I bypassed the door switch so I could see them spin)I have tried new arms though, pump pressure or ?


Not enuff water in it or pump blockage or bad pump impeller. if you ran it with the door open even if the arms didn't turn you should have got drenched is the bottom covered with water about 1 inch deep some times the fill valve screens get clogged a ... Bosch Dishwashers

I have a kitchen aid dishwasher. The upper spray arm is getting water and getting enough water pressure but wont seem to spin. Ive ran a lot of tests but nothing. ive cleaned out the spray arm and port that gets water to the spray arm. Cant seem to fix it. Any ideas?


Hi,When my wife started complaining about her dishwasher not getting the top rack clean this is what I found and I wrote a tip about it...Dishwasher Spray Arms not Spinning ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Follow-up I've removed the lower arm, I'll spend some time and see whether I can get the pobem sorted out. My wife noticed the the detergent was smeared all over the door and repeated tries didn't get it out. Therefore, the water is not spraying. I can confirm the water is filling on the bottom and draining. The heater is working well. I am thinking there is no pressure to send the water through the tubing to the upper and lower arms. The motor is hot to touch (118 degrees with my temp probe). I


... Kenmore 24 in. 15199 / 15194 / 15192 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0691 seconds