Having problems with your Bosch 24 in. SHU43 Built-in Dishwasher ?

Water keeps filling after shutting off machine. Overflows onto the floor. Please help!


Answers :

Hello,
\015\012Most of the time the problem is just the opposite of yours and the dishwasher will not fill...
\015\012This tip is about the dishwasher not filling, but the problem is still the same, only your soleniod valve has dirt under the plunger and it will not shut off. This tip will help you find it and help you to replace it.
\015\012
\015\012http://www.fixya.com/support/r4021363-dishwasher_trouble_no_water_entering
\015\012
\015\012Heatman101
Repair Help & Product Troubleshooting for Bosch 24 in. SHU43 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Water keeps filling after shutting off machine. Overflows onto the floor. Please help!


Hello,\015\012Most of the time the problem is just the opposite of yours and the dishwasher will not fill...\015\012This tip is about the dishwasher not filling, but the problem is still the same, only your soleniod valve has dirt under t ... Bosch 24 in. SHU43 Built-in Dishwasher

Our Miele DW just keeps going through cycles constantly and will not shut off on its own. It has gone all day. When we turned the dial manually to "OFF", the water keeps filling until it overflows the machine onto the floor. So far, our only option has been to turn the machine back on and let it keep running. Any suggestions?


Hi,\015\012\015\012sounds like a faulty electronic unit as i have seen this before where the unit continously fills with water. \015\012you will probably need a service call to repair the unit unless you are happy to fix it yourselv ... Miele 24 in. G865 Built-in Dishwasher

My Bosch SHX46A dishwasher keeps filling up with water and won't stop. The water just keeps coming up through the bottom. It will drain fine, but after the cancel drain sequence, water just keeps coming up, overflowing the tub onto the floor. I had to shut off the water.


... Bosch Dishwashers

My bosch dishwasher runs fine, cleans fine, drains fine....but after it has been just sitting for a while, the bottom very slowly fills up with water. Each time we run the machine the water level drains back to the normal amount in the bottom of the washer after the cycle is complete. The problem is if we are away for a few days, the bottom fills up and overflows onto the floor.


Water inlet valve isn't closing all the way closed. Need a new one ... Bosch 24 in. SHU53 Built-in Dishwasher

Hi, we have a Blanco dishwasher model number BFDW4. The dishwasher has stopped working, it fills with water then stops. We tried cleaning all the filters and we tipped it on it's side on a 45 degree angle to drain the water out of the Overflow reservoir but the machine continues to stop working after filling with water. Please help. Regards. Jayne


Hi,\015\012\015\012Sounds like you may have something jamming the circulation pump from turning. A dishwasher has steps in the cycle to complete before it moves onto the next step. once the unit fills with water it then circulates the wat ... Fisher DS603W / DS603B / DS603I Dishwasher

Nobel stainless dishwasher. water comes in but keeps pumping and does not go into cycle. for example, if we put the washer on towas dishes and leave it over night, in the morning it will still be pumping water into the machine.obviously it does not over fill because i am assuming it goes out the overflow. please help


Lookout the following things:\015\012\015\012\015\012\015\012\015\012\015\012\015\012Water-inlet valve\015\012\015\012The water-inlet valve lets water enter the machine. If this valve is defective, you need to completely rep ... Dishwashers

Overfill Hi Mark ,my Hotpoint BFI 62 at very first use ,takes water but in few minutes later water come out from floor and after that you can hear water drains out,Heavy Duty cycle light flashing rapidly,after some advice looked exactly source of water is from pipe connected to overflow system. That mean it is filling more than required,how it possible new Dishwasher never used before? Please help me to repair because we never try when I bought now is to late for company warranty. [email protected]


... Hotpoint 23 in. BFI62 Built-in Dishwasher

Bosch SMS4012GB dishwasher. Refused to fill. Found tray full of water in base of unit. Mopped up water about 2 litres. Machine works but lower reservoir on the side of the machine with float switch overfills and overflow leaks about an eggcup full each cycle. What is causing the overflow please?


An electric switch activated by air pressure. This device detects air pressure exerted on it through a flexible tube connecting it to part of a water tub. \015\012When activated, this switch then opens an e ... Dishwashers

Whirlpool ADP 4404/5 when left unused but connected to water supply it slowly fills up until it overflows and runs onto kitch floor, i.e while on holiday. I reckon it slowly fills to overflow in about 2 to 3 weeks. Worn seal somewhere?


Hello there and thank you for choosing fixya Yes you are about right normally when the unit fills with water and you dont want it to this means that the water inlet supply valve has seals that are weak in it and the water is leaking bye it or ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Hobart lx-g HI there, I have a weird problem with my dishwasher... when I press the off buttom, instead of staying off... it restarts by itself. Also, when it starts filling up, water overflows from the machine ( when it filling up the temperature rises alot more then usual it reaches 190f) and then i turn off the machine to stop the flooding... can you help?


The problem with the machine restarting is with your keypad, the on button is stuck on and needs to be replaced or you can continue unplugging it. Your other problems are most likely caused by lime build up, is the inside of your machine white. I ... Hobart 24 in. LXIH-3 Built-in Dishwasher

I have a Kenmore model 587.1610 dishwasher that doesn't fill all the way when starting a load. I checked the float switch and it is working fine. The fill soleniod is also working fine and is clean. It just seems to time out before it fills all the way.also to compound the problem it doesn't seem to want to start all the wash cycle even after I have re-started the machine and it has filled to capacity. please help thanks Danny


... Dishwashers

Dishwasher keeps running I have a Bosche dishwasher and the water keeps running. As long as we run it and don't stop it, the pump will continue to drain about every 3 minutes. The water just keeps running though. If we open it to empty the dishes, the cycle will stop. But the water keeps running, filling the tub, and then overflows, flooding the kitchen and drains through our wood floors to the basement below. Our ASKO seems to have a similar problem. I started the dishwasher, and the water ke


Open up the door, get out the control unit. Pry open the unit's plastic case and look at the board. Burnt spot? If so, the heater circuit burnt out (happens a lot on Bosches) and the control is waiting for the water temp to rise, but of course it ... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

We have a hotpoint fdf780 dishwasher and at the start of the cycle the machine fills with some cold water a nd then does nothing else .the machine isnt showing any fault code please help as half term


... Hotpoint Dishwashers

Had new kitchen so just re connected my dishwasher. Warning light to check water has come on. hoses and water going into machine seems ok but machine seems to be slow at filling. looked at filters in case of blockage with no result. Any ideas would be helpful please Merry Christmas Janice


I would remove the water line going to the dishwasher and let it run into a bucket. Sometimes on older shut off valves when you shut them off and try to turn them back on they get gunked up or dont open all the way. If you have good water pressure to ... Bosch Dishwashers

Just installed bosch SHE68E15UC dishwasher today and during first cycle E15 error came up and unit will not go into another cycle or allow me to program anything else - sanitize and rinse aid lights are blinking - water went into the machine and it started filling the bottom and wasnt draining - i then adjusted the filter and the water drained - but e15 error persists - what should i do - is it install issue or machine issue - please help- thank you so much


... Dishwashers

Our dishwasher has a problem that keeps on re-occuring: Rubber hose, front right (Standing in-front of machine Model: extreme clean KD 12WW) keeps on dislodging from connection to what looks like the pump. I can not afford to pay the repairman R600-00 every 3 months and despite glueing and clamping, it doesn't last. Help please


... Kelvinator MDP531RF Dishwasher

I have a cda cw 496 dishwasher, the water is draining and filling up to the machine, but the rotating arms are not getting the flow of water and not moving. I have checked the machine for blockages, checked the pipes etc and wonder whether it is an electronic programmer problem. PLease help


Sounds like the circulation pump. I had the same problem on my CW496. The original circulation pump was pretty cheap and nasty and although it was still working had lost a lot of power and was struggling to turn the rotating arms. The dishes were sti ... Dishwashers

Turn the machine on it makes all the right noises but there doesn't seem to be any water going into the machine. the hose that fills it is ok and water is coming through it . i just dont know where its going once its supposed to come out of the wash bars as they seem to remain dry please help


Your inlet valve has a screen on it.This is probaly clogged, it does happen. At the bottom of your dishwasher ther will be 2 - 4 screws holding the front panels on. UNPLUG FIRST! Remove the panel/s. TURN OFF WATER TO DISHWASHER! you Will have a cop ... Jenn-Air JDB6510 Built-in Dishwasher

Our Kemore dishwasher is leaking water onto floor, and the water valve continues to pour water when machine was turned off, but is not leaking water now. There is also standing water at bottom of tub from running machine last night. Can I test to see if it is fill valve or the overfill float? Are these easily replaced?


You just need to clean the pump area in the bottom of your unit :)try to take spray arm out if you can and then open pump cover clean it good but watch for broken glass in it ...and thats it :) ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

Turn the machine on it makes all the right noises but there doesn't seem to be any water going into the machine. the hose that fills it is ok and water is coming through it . i just dont know where its going once its supposed to come out of the wash bars as they seem to remain dry please help


It sounds as if your inlet water valve or it's solenoid has failed.Please reply with the make & model # of the dishwasher.Thanks!!nc ... Dishwashers

Ariston dishwasher i have an ariston built in dishwasher. It wont start washing cycle, and has 2 flashing lights from the left (total 4 lights)...can anyone help. i cant find the model number on the machine. The lights looking like sprinkiling water..i have filled the salt, and rise etc but still it wont come on please help


I have a brand new ariston ll-64 and the wash cycle won't start and two flashing lights ... Ariston Technologies L63 Free-Standing Dishwasher

Over flowing Ugh, My dishwasher works great most of the time UNTIL it overflows onto the kitchen floor (what a mess) What's up with this? Nothing is blocking the overflow thingy HELP!!!!!


My dishwasher will not drain sometimes and overflow other times. What can I do to solve this problem? ... KitchenAid 24 in. KUDG25SH Built-in Dishwasher

Bosch Dishwasher SHV4313GB/17 Wont switch off ! The machine keeps running even when you open the door The pump is trying to drain water away (even though there is no water left in machine ) Have tried to reset it as instructed but to no avail. It has beeped like it has finished cycle but the pump wont switch off HELP PLEASE !


Introduction: This may work for your problem, but only if you're finding that you cannot get further water to flow into your machine. If your machine fills OK, then this ISN'T a solution to your problem. If your machine doesn't fill but your drain m ... Dishwashers

Turn the machine on it makes all the right noises but there doesn't seem to be any water going into the machine. the hose that fills it is ok and water is coming through it . i just dont know where its going once its supposed to come out of the wash bars as they seem to remain dry please help Jenn Air Quiet Series


Hi\015\012\015\012 \015\012\015\012Thanks for using\015\012FixYa. It means that the water inlet valve has gone bad and needs to be\015\012replaced. Please do\015\012accept the solution if the issue is resol ... Jenn-Air JDB6510 Built-in Dishwasher

My dish wash machine (HOBART FX/CV series) is programmed to PO1 and it should be running for short cycle but what's happening is it keeps on running for a long time...please help..many thanks..


... Hobart 24 in. LXIH-3 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0994 seconds