Having problems with your Bosch 24 in. SHU43 Built-in Dishwasher ?

I have a SHU43C05UC/22 Bosch dishwasher that runs fine till it gets to wash then it seems to stick there. the timer times down to 1 and it stays there for a really long time. it doesn't appear that the washer ever gets out of the wash cycle. when you stop/open the door there is still soapy water in the tub. You can cancel the program and it will drain the tub fine then you have to select rinse and hold to clean out the soap out.


Answers :

Repair Help & Product Troubleshooting for Bosch 24 in. SHU43 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a SHU43C05UC/22 Bosch dishwasher that runs fine till it gets to wash then it seems to stick there. the timer times down to 1 and it stays there for a really long time. it doesn't appear that the washer ever gets out of the wash cycle. when you stop/open the door there is still soapy water in the tub. You can cancel the program and it will drain the tub fine then you have to select rinse and hold to clean out the soap out.


... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Kenmore dishwasher (363.16222100) that isn't getting water into the unit/tube. All the other cycles seem to be working fine. I've replaced to water inlet valve and it's still not getting water into the tub to start the wash. Checked the water line and it's fine. Any ideas?


The only thing left is to replace the main control board ... Dishwashers

G.e dishwasher.gsd2230f00ww washes and drains fine but water leaks back into tub gradually. Getting worse now probably 1 quart per day THIS IS MY FIRST TIME ON THIS SITE. IF I will be billed-forget it.


... GE Nautilus 24" Built-in Dishwasher

I have a Kenmore dishwasher model #665.13842K601. The problem that it has is that it does not seem to be pumping the water around the tub after it fills. It will fill and drain fine but will not wash. I have removed the spray arms and checked all the parts that I can get to from the inside but fear that it may be a pump or jammed impeller. it does make a faint buzzing sound when it should be operating. Any input would be great. Thanks, Matt


It sounds like you have a circulation problem which means that the circulation pump has gone bad. \015\012Circulation pump - http://www.appl ... Kenmore Dishwashers

I'm trying to get my GE GSD1200G00WW to work. When it is put on the wash cycle, I can hear the pump running but the tub does not fill with water. I checked the float and it seems fine. Water valve maybe?


Confirm 120V across the water valve terminals in a couple of minutes into a wash or rinse cycle. (when you turn it on at the beginning of the wash cycle it will drain first, and then will energize the water valve to fill up.)If there is 120V ac ... GE GSD1000 Dishwasher

Normal wash cycle- tub fills (?), then comes a loud hummmm and nothing happens. I noticed water level didn't reach heater coil and added water until limiter switch clicked. Still just a loud hummmm. Machine was well into its regular cycle when this first occurred, but now, won't even get past initial fill. Pushing the "Cancel/drain" button activates motor and pump: they work fine.


You are an expert enough reading this. But with a terrible complicated dishwasher. First clear the waterlevel problem.\015\012Rest is a result. You do not need me, join us. Next time buy something more plain. ... Dishwashers

It seems that not enough water gets into the tub. There is no kink in the water line. If you manually add water it drains out before resuming wash cycle. The water doesn't get around to wash the dishes let alone rinse the soap off the door!


If the machine has stopped half way through due to switching off or power intruption this could happen.\015\012\015\012So allow the machine to complete the cycle. \015\012Do no worry running it empty.\015\012\015\012It s ... LG LDF6810ST Stainless Steel Built-in Dishwasher

My Bosch SHU 3030 gets stuck during the washing cycle and will continue to run indefinately until the wash cycle knob is rotated a little bit, then it will work fine for a few more minutes until the knob gets stuck again. Whats my solution?


... Bosch Dishwashers

Hi, I have a 3 year old Nemo F&P dishwasher which turns itself on and off for about 3 seconds each on/off continually.Eventually it does get enough water to wash but never goes into the wash cycle properly, ie the water just sits at the bottom. We dont think it's water pressure and it was working fine until recently.Could it be an electrical problem with the signal to fill properly not getting through? Thanks


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the cycle doesn't\015\012complete, then the first thing ... Fisher and Paykel Dishwashers

Kenmore dishwasher type 573-D, model 665.16034402. Items on top rack don't get washed. Items on bottom rack are washed fine. Appears top sprayer and maybe middle sprayer aren't getting water. At rear of washer, top rubber flapper valve (which feeds middle sprayer when top rack is in raised position) is stuck open, bottom flapper valve looks OK. We use top rack in raised position so this doesn't seem to be the problem.


... Kenmore Dishwashers

Ge triton I got my GE triton about 2 years ago and it has worked fine since. For some reason, now, it won't stop running through the wash cycle. I can't get it to turn off. I push the reset button hoping it will stop and all it does is go to "sensing" then back to wash. I have to open it to get it to stop temporarily, but there is water sitting at the bottom of it. Any suggetions?


Turned the breaker off and then on again.....\015\012Works like a charm!!!\015\012Thanks ... GE 24 in. GSD6660GSS Built-in Dishwasher

Pots/pan light blinks alternately with the normal wash button. Sometimes the cycle will start and then the lights come on. Once they start blinking, the cycle stops and I can't get it to start again. Unplugging it for a few days has worked a few times. But it just keeps getting more frequent. If it does start up, it heats fine and washes perfectly.


... Whirlpool DU1055XTSQ Built-in Dishwasher

Cancel wash working fine. when ready to wash get humming sound. pumpmotor not turning. A glass dish broke a week ago and work fine till know remove screen today found some small brokeb glass - like when a harden glass brakes? if something is in the pump how do i remove pump


In\015\012most dishwashers, the water pump is located under the lower sprayer\015\012arm. This component pumps the water through the dishwasher. The pump\015\012has two impellers, top and bottom. These, as well as other components,\015\012can become ... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher

My 3-yr old GE Profile dishwasher lost power soon after initiating wash cycle. Checked braker switch...fine. Checked outlet power...fine. Dishwasher power mysteriously came back on approximately 12 hours later. Initiated another wash cycle and lost power again after a few minutes. Water remains in bottom of tub. What's wrong????


First thing i would check is the actual wiring behind the toes kick\015\012you will seea wire box, shut the breaker off, open up the box and double check all your connections there,\015\012 the next step would be to check the voltage ac ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

My dishwasher was moved for kitchen rennovations. When hooked back up again it would not fill up. It will run through a cycle but no water enters. If I squeeze the rubber hose that leads from the electronic valve to the tub it gets hot indicating that I am forcing hot water through the line. If I pour water into the tub it will wash the dishes but at the final 6 minute point it will go no further, I assume because it is not getting rinse water.


Hello,\015\012Make sure that a wire did not get bumped off of the soleniod valve. It sits usually on the bottom front left hand corner of the dishwasher.\015\012If the wires are both on the valve then the valve may need ot be replaced... ... Dishwashers

During wash cycle it gets stuck and won't move past the wash cycle. On a regular wash it is at 28minutes and when it is on a fast wash it is at 25 minutes. If I stop it and turn on the rinse cycle it will run through the 12minute rinse cycle with no problems. It is only the top dishwasher that does this, the bottom one is running just fine.


I've got the same problem with the bottom drawer on the DD605. No fault codes were set. I checked the heating element and it produced heat quickly. I suspect that the water temp sensor isn't satisfied, and the timer is waiting for the water to rea ... Fisher and Paykel DD605BK Dishwasher

Stops mid-cycle I have a MDB7100AWB that has been working fine for the last 7 years. Now all of the sudden it will not complete a wash cycle in any mode (including auto clean). It consistantly stops at 85 on normal wash & at 65 on light wash and then clicks/buzzes about every 3 seconds, like it wants to continue - but never does. Any clues as to what to try? Is 7 years all I can expect to get?


Hi SaviorSound,\015\012\015\012I'm Harvey the Master Plumbr.\015\012\015\012Your question is: You have a MDB7100AWB that has been working fine for the last 7 years. Now all of the sudden it will not complete a wash cycle in a ... Maytag MDB7100AWB Dishwasher

Our dishwasher seems to be stuck in drain mode. My daughter put the wrong kind of soap in it. She accidently put Regular dish washing soap in rather than machine dish washing soap. We've got all the suds out. Seems to drain water just fine. However we cant seem to get it to add water. Does the soap have anything to do with it? Anything I can do from my end? Please Advise. Thanks


Plastic base is full of water. Need to remove whole unit to access bottom and dry it out. ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Loud noise The dishwasher was in the middle of the wash cycle when it started making a loud noise. I turned it off and then restarted it. It began washing fine but in a few minutes it made the noise again. Now it won't do anything. I can't get the water to drain out. It won't even start.


Very loud squeaking sound, at the start of each cycle. ... Kenmore 16639 Built-in Dishwasher

The water is not getting up to the middle spin bar or the top one, so nothing on the top rack is getting cleaned and everything is left with soapy film, so it is not rinsing properly. There is water coming in at the side for the intial fill and from the bottom to wash.


Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Whirlpool adp8540 - goes throught the wash cycle without the soap door opening, the water gets into the soap box, and the powder or tablet (I've tried all the brands) are wet but remain in the soap box. When I flick the level on the soap box, works just fine, just doesn't happen during the wash cycle.


Normally, the dispenser is waterproof when closed, so the detergent should not get wet. Most likely the actuator of the dispenser works and does open the door, but something is blocking it from opening all the way. Look for stuff not it its place, ie ... Whirlpool Dishwashers

Hello, I've been working on a Bosch Dishwasher. It has no display of any kind, and there's a strange grunting sound coming from the wash motor when power is applied (like if you had just plugged it in), as if it's trying to start. The junction box is getting 120V, all connections to the junction box are fine, and the display board and the main control board are all getting the proper voltage. Now, we've already replaced the main control board and the problem persists. The tech line suggested


... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

Model she44c02uc; 2 years old. no matter which cycle we pick, it just keeps on running..it gets down to about 15 minutes on the countdown timer, and then resets itself to 80 minutes or so and washes over again...if we manually turn it off and then push quick wash, it seems to finish, but doesn't dry the dishes.......we have tried all suggestions in the manual and cleaned both filters; the line is not clogged...the sink and disposal both work fine. thanks


Hi,gibpru,ngafm at your service,You said, no matter which cycle you pick, it just keeps on running..it gets down\015\012to about 15 minutes on the countdown timer, and then resets itself to\015\01280 minutes or so and washes o ... Bosch Dishwashers

Water wont drain out of bottom of tub. The dishwasher works fine, it just wont drain the dirty water out. If I restart it to wash again, the dishes are washed in the dirty water.


Hi, A clog in the drain line or air gap (if there is one) is the usual reason that a dishwasher won't drain. Often the problem is at the point where the drain line attaches to the garbage disposer or househ ... GE Nautilus 24" Built-in Dishwasher

Westinghouse undercounter dishwasher. after shutting door with latch, comes on when dial knob turned to selected wash. was taken out to redo floor underneath. after being placed back in position, did at least 2 loads fine. now after dial knob gets to selected wash, dishwasher light comes on and i can hear the motor try but then starts clicking. there is also water at the bottom inside the dishwasher


This seems to be a drainage problem, obviously. There may be some food debris in the drain tube where it connects to the drain pipe. It would be easy to detach and do a visual check, and see if you can clear the clog. Also, try to s ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0875 seconds