Having problems with your Bosch 24 in. SHU43 Built-in Dishwasher ?

Detergent dispenser spring door is either missing the spring or broken. In any case it opens but is no longer spring loaded. I can't figure a way to remove the assembly unless I have to take off the front cover. Any ideas?


Answers :

Door just pulls off, you will require a new door, spring & possibly a catch. Spring fits onto pin on door and other end onto pin on holder, then fold spring on its-self and re-instate onto runners/slide. Paul Winn Appliance Services. (Cumbria)
Repair Help & Product Troubleshooting for Bosch 24 in. SHU43 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Detergent dispenser spring door is either missing the spring or broken. In any case it opens but is no longer spring loaded. I can't figure a way to remove the assembly unless I have to take off the front cover. Any ideas?


Door just pulls off, you will require a new door, spring & possibly a catch. Spring fits onto pin on door and other end onto pin on holder, then fold spring on its-self and re-instate onto runners/slide. Paul Winn Appliance Services. (Cumbri ... Bosch 24 in. SHU43 Built-in Dishwasher

Dishwasher Model Kenmore # 665 16829000 Dishwasher "Quick Rinse" was blinking and no other buttons would work. Received FixYa solution below: "Check out the console assembly. take off the inside cover and the plastic over the electronics, just remove the two screws holding down the circuit board, pull it to the side, then blow plenty of air through the two holes on either side. The holes that you need to blow air into are not on the circuit board, but on the plastic underneath the circuit boar


Hi\015\012If the control board detects that a key is stuck in the depressed position, the dishwasher operation will be suspended and the control will flash the light for that key until the condition corrected. If a key without a light is ... Dishwashers

Bosch sgs45 The unit take in water but then tries to pump it out every 10 seconds. Checked the drain pump from above and below by removal - all clear. There is a large clear plasic container which seems to be the salt reservoir. This seems to have food residue in it. Any ideas on the way forward would be appreciated


... Bosch Dishwashers

I'm trying to remove the disposal cover in the dishwasher (GE GSD3207P00WW) in order to clean it, but unlike previous models I've dealt with, this one has a filter thing that looks like a tilted plate, just under the main washer, and that has apparently a drainage tube (or some such) that goes down through the disposal cover, so I'm unable to remove it. How does one take that apart?


... Maytag Dishwasher

Due to the my Indesit IDL 530 dishwasher not draining properly, I turned it onto it's left side, removed the base plate and pump and checked for blockages in the pump and associated hoses, which were all clear. However in re-assembling it I have forgotten which way round to connect the twin wire plug to the base plate. I cannot find a relevant wiring diagram online and therefore cannot tell which is the correct way around. I then guessed and re-assembled it anyway, and as you might have g


Hi.There is more than one wire going from control board to the tub. If the connector can be plugged either way without forcing it, then usually does not make any difference the way you plug this determined connector. It will be usef ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I found the problem with my dishwasher, a spring in the handle (154556703 Frigidaire Dishwasher Door Latch) had broken. All I need is the spring, not an entire door latch assembly. Is there any way I can get the part number for the individual spring? V/r Matthew Quirk


... Dishwashers

How to remove cover off Model913T and replace springs dishwasher


Contacted local agent ... Fisher and Paykel Dishwashers

I have an kenmore elite "ultra wash" model 665. not sure the rest.. about 7/8 years old, making loud buzzing sound during wash cycles,starts about 5 minutes into the normal wash cycle. i removed the inlet protector and the chopper area and all was clear.clean...it's running now and seems to be pumping the water, but can live with this buzzing noise,,, any idea, is the pump on it's way out ? just stopped as it kicked into another cycle, at 42 minutes...but it will be back, any ideas ? (back alrea


Buzzing sound may be coming from a solenoid that is mounted under the dishwasher, below the tub ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

Hello,I hope you can answer the question below for me. My dishwasher is a Hotpoint model BFI680 - integrated. I want to replace the old interlocking assembly with a new one as the spring has broken and I can not close the dishwasher door. I have trouble removing the old interlocking assembly though. I can not see any screws that keep it into place as with other models. Instead, it looks like that it is "clipped" to the dishwasher door via the two inner side round holes at the bottom. Tried to re


... Hotpoint 23 in. BFI68 Built-in Dishwasher

I have purchased a repalcement detergent dispenser-assembly and do not know how to take old one out and relpace with new part. The new part has a face plate that snaps on to the screw mounted base plate assembly which attaches to the door. I need to know how to remove the old dispenser and install the new dispenser without breaking parts and scratching the door. Is there a schematic or exploded repair view I can check out or even written directions?


Hello\015\012& Welcome to FixYa\015\012\015\012To replace the detergent\015\012dispenser you can check this video. The video gives you step by step\015\012instructions:\015\012\015 ... KitchenAid 24 in. KUDP02FRSS Stainless Steel Built-in Dishwasher

I bought a Faucet Coupler assembly, but I need to know how to install it. For instance, how do I remove the required covers to remove the old one and install the new? Thank you, Louis L Likes


MAy I get the make and model # to help you more. Also are you trying to replace the supply line to the dishwasher. If not can you please explain your problem some more. ... Dishwashers

My SGS55M72AU/65 does not get rid of its drain water, although that wee pump in the bottom is clearly working (which I could see after removing filters and pump cover). There is no blockage near the drain pipe connection, so I infer there is a blockage somewhere inside the dishwasher, in a place I can't get to without further instruction. I've removed most of the drain water and pulled the unit out, so I could lay it on its side and start taking screws out. But I much prefer to have some guidanc


Ok i am attempting to help you although i dont see your make of dishwasher but im using what i know without manual. to ensure there is a blockage in the dishwasher remove that hose you checked at garbage disposal or vent and leave it disconnected an ... Dishwashers

The Bosch plastic push button (AP2804452) has broken on my SHU9950 dishwasher. The switch itself is still good. I have removed the broken pieces of the bad button from the unit and am now depressing the switch without the button. When I get the new push button, what is the proper way to remove the control panel cover to put the new button in place? Thanks!


... Dishwashers

Hi I have 4 yo sgs53e Bosch dishwasher which will not drain. I have removed and cleaned the filter, have undone the screw and removed the white cover, cleaned the tracks and ensured that the little propeller thing turns in both directions (requires a bit of a turn but does turn). I have run out of ideas as to what to do next.


Are you sure it is not draining ? \015\012what are thy symptoms ?\015\012mine (same model) stopped working yesterday.\015\012if you try to terminate the wash (follow instructions in manual), does it drain ?\015\012if it does ( ... Dishwashers

Am trying to deal with source of non-draining problem-drains but not complteley. Have remove three screws from love plate but cannot seem now to remove the assembly (which also golds the lower spray rotor). Any ideas.


If it is a Bosch, the following just worked for me: pull out screens and on left side of sump (looking down into bottom, 9:00 position) has a torx screw holding cover over drain pump, remove screw, cover has tab towards backside to lift towards you. ... Dishwashers

I have a whirpool Quiet Partner III, and the top layer of glasses is not getting clean. I had a technichian out some time ago, and the problrem was caused by food debris trppaed in the filter in the wash module. He saud it was easy to clean that out, so I have removed the lower spray arm, but cannot undo the 4th screw that will allow me to take the grey round filter cover off to remove the food or paper debris. It is under the white flat pipe that delivers water to the wash module, and I cannot


I had same problem, would not clean well and fixed it. . I cracked open the door during wash cycle and used screwdriver to defeat the door lockout. The water from the bottom sprayer was only shooting half way to the top of dishwasher. To fix I remove ... Whirlpool Dishwashers

I have a GE dishwasher (GSD4020Y70BB) new in 1996. I replaced the whole motor assembly in 2007, seal was leaking. My dishes are not getting clean now, dried food left on plates, coffee stains in cups not being cleaned. I removed main spray arm, found nothing, turned washer on and plenty of water gushing out. I took the cover off sump all clean. I removed the filter screen in the back, there appears to be a valve with some soft rubber around it. Water gushes out of this, does stop during the cyc


Have you checked the drain pump impeller and drain hose? I am curious if there is a back siphon from the drain hose or the waste outlet at the garbage disposal might be blocked or plugged with food debris.\015\012I wou ... Dishwashers

My kenmore dishwasher won't open all the way unless we remove the kick panel?? What could it be?


... Kenmore 15522 Built-in Dishwasher

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a Whirlpool DU810SWLQ0 that will not drain. I've pulled the unit out, snaked the drain tube, pulled the motor/pump, and pipe assemblies, and cleaned the food trap, which I also removed. I've run the dishwasher with a bit of bleach, and the water will pump in, get processed by the agitator, and be heated. When the rinse cycle comes, dishes get covered in food, and are never clean. Waste water was being used for a clean rinse. I've run the dishwasher with the drain dangling in a bucket,


Refer the wash system assembly dwg. Check if the ball (item 21) is sitting correctly. If it is out of ali ... Dishwashers

12 year old Maytag top of the line dishwasher, won't fill about 1/2 way through the cycle. timer still advances. checked the float assembly, valve, etc. any ideas?


... Maytag DWU9962 Dishwasher

My Electrolux DW is not removing all the detergent on the rinse cycle leaving the dishes covered with residue. Any ideas?


Hi,The scum, film and white residue problems have started since the reduction of phosphates in dishwasher detergents.Here is a tip that will help you to solve the problem of films, residue, and scum in your ... Electrolux 24 in. EDW5500DSS Stainless Steel Built-in Dishwasher

Hello. Have a Neff S5457 that is not working properly. It sounds as though it's working but on getting the crockery out, it is obsvious that it isn't. Have checked all the filters in the machine that are easily checked and all are OK. On taking all the filters out, I can see some philips screwheads in the 'sump' of the machine. Wouldit useful to remove these and see what's under the white plastic covers down there? Are there any other areas that I can check or test? I also wonder if the pump is


Clean the nosels of the arm's, check if the tetergent is pumped (if you have an automatic detergent dispenser) check whit dishwasher unpluget!!! you can check and the pump but be carreful how you put it back. also you can check and the hoses to be cl ... Neff 24 in. S5457X0GB Built-in Dishwasher

Kenmore Model 1590 Dishwasher, 1985, sitting unused since about 1994. Takes water into tub but never goes through any washing/rinsing cycles; water stands in bottom (I stop it below door level). A click, like a solenoid activation from the timer area, but motor never does anything. Removed the shroud covering what I assume is the impeller, which was stuck, but freed it by turning several times...made no difference. Suggestions??


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0813 seconds