Having problems with your Bosch 24 in. SHU43 Built-in Dishwasher ?

The washer does not go through the cycles normally. It get to the number one and stays stuck and keeps washing.


Answers :

Hello,

Welcome to FixYa.

Based on your description
I'd say the issue actually with the control...unfortunately. The "1" being displayed is actually an error code associated with a heating fault.


**B/S/H/ also issued a recall on certain models between 1999 - 2006 depending on the model & serial number, you can check with yours but...you'll need the serial number too. Here`s the link if you want to see for yourself **

http://microsites.boschappliances.com/safetyrecall/dishwasher/


As I've alluded to the issue is likely within the electronic timer/control, specifically the heater relay solder joint. ( a faulty flow switch, ntc or heater can also cause this, but not very probable ).

If you feel capable of checking this on your own, there`s a way to visually inspect the control yourself...it really isn't very complicated.

It will require you to remove the control from the unit and then remove the control from it`s plastic housing and look for a burnt solder contact on the printed circuit board.


dabfa62.jpg


The culprit will 99% of the times be one of the pins from the heater relay,

9f1823d.jpg

**Flip this over and inspect the solder joints, it will be obvious when you see it.**

This ones new, but it's where to look...

9119d99.jpg


...hence the unit sit`s and takes longer & longer to finish because it can`t heat to advance or unless the 2 buttons for "cancel" are pressed...or takes a long time as I mentioned and eventually display's "1" on units with a display and usually very poor cleaning as a result.

You can also run the unit through a regular or econo cycle ...any cycle with the exception of rinse & hold, and with the door panel removed place an ammeter on the gray/black wire it should draw 11 amps during the wash cycle...after it fills and the flow switch indicates it has adequate water to engage the heater.

i.e.

f57273b.jpg
**My Opinion - if you or someone you know is proficient at soldering, a lot of times it can be remedied by simply repairing the solder...but it has to be done well...or it will not last, although Bosch recommend`s replacing the control and I don`t pretend to speak on there behalf nor do I profess to know better. This is just my experience (it work`s) and my opinion (why buy new if one can repair ?)**

**Please disconnect the power or turn off the breaker before attempting any service to the dishwasher.**


If you do not feel comfortable attempting this service, call a local pro, preferably one familiar with Bosch/Thermador/Gaggenau/Siemens, to service your machine.

Hope this answer`s your question, let me know if I can assist you further.
Thank`s for visiting "FixYa" for your repair inquiries. Please take a moment and rate this solution to it's helpfulness.

Good luck.

Regards,

Macmarkus :)
Repair Help & Product Troubleshooting for Bosch 24 in. SHU43 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The washer does not go through the cycles normally. It get to the number one and stays stuck and keeps washing.


Hello,Welcome to FixYa. ... Bosch 24 in. SHU43 Built-in Dishwasher

Hi my nearly 9yr old neff S5555 integrated dishwasher has problems on the control panel the program times come up with the completely the wrong times for the wash ie the 150 one comes up saying 32minutes on a quick wash it gets stuck at 1 minute left and keeps going on, also the delay timer timer is not working ( I have been told this could be a problem with the programmer) . Is it cost effective to get the progammer changed plus engineers cost or shall l look for a new dishwasher? Thanks Su


... Dishwashers

Hi my nearly 9yr old neff S5555XOGB/40 integrated dishwasher has problems on the control panel the program times come up with the completely the wrong times for the wash ie the 150 one comes up saying 32minutes on a quick wash it gets stuck at 1 minute left and keeps going on, also the delay timer timer is not working ( I have been told this could be a problem with the programmer) . Is it cost effective to get the progammer changed plus engineers cost or shall l look for a new dishwasher? Th


... Neff 24 in. S5543X2 Built-in Dishwasher

My dishwasher get's stuck during the cycle and just keeps washing. If I dont move the cycle on manually it will wash and wash for hours!! Can any one help??


This is probably heating issue. The cycle will not advance if the water is not up to the proper temperature.Next time you run a cycle, open up the door after a few minutes. A large ball of steam should roll out of the machine. No steam = ... Whirlpool 24 in. ADP5962 Free-standing Dishwasher

Smeg Allegra We start our Smeg Allegra with a 'dial' control. It has started to get stuck, and unless nudged forward, will stay on the same wash cycle permanently. never switching itself off. Is there an easy remedy to this, or do we have to bin it and buy a new one?


... Smeg 24 in. DWF1 2 Free-standing Dishwasher

The top level is not getting clean. We think the passage to the top water jet is clogged. There are two holes in the back that the washing arm fits into, depending on what level the top rack is set at, and one of them is stuck open. We have not been happy with this dishwasher from the start and are trying to decide if we should get it fixed or just buy a new one.


Sometimes it is not worth the headache.dishwashers are a dime a dozen,if you want to happy,just replace it,most dishwashers are unrepairable.no matter what the maytag man says. ... Dishwashers

Hi, My haier dishwasher is getting stuck mid cycle. Could you tell me why this keeps happening. It gets stuck mid cycle after the wash and rinse and then it wont drain or dry dishes properly. It has never been used before. Please help. Kind regard Katie Hopkins.


... Haier Dishwashers

During wash cycle it gets stuck and won't move past the wash cycle. On a regular wash it is at 28minutes and when it is on a fast wash it is at 25 minutes. If I stop it and turn on the rinse cycle it will run through the 12minute rinse cycle with no problems. It is only the top dishwasher that does this, the bottom one is running just fine.


I've got the same problem with the bottom drawer on the DD605. No fault codes were set. I checked the heating element and it produced heat quickly. I suspect that the water temp sensor isn't satisfied, and the timer is waiting for the water to rea ... Fisher and Paykel DD605BK Dishwasher

Beko washing machine wm5100w my washing machine wont work it wont start and and the ready and wash dots keep flashing and the spin and end one stays on thanks


... Dishwashers

ASKO d 3122.. Keeps filling up the overflow area on the bottom of dishwasher. WHich sets of the overflow switch, then i get the flashing tea cup again. I will empty the over flow area. It will reset, We get one good wash out of it then on the next load it will stop work ing again and get the flashing Tea cup again, Back to unplugging the unit and draining the overflow area again.


... Dishwashers

Bosch SHU 3032 dishwasher gets stuck halfway through the wash cycle and just continues to wash until you manually advance it. I turned in on before bed one night and it was still running the next morning. Ouch!


Hi,\015\012 It obviously sounds like a timer issue here, and as it's embedded in a big chip on the control board, I would think a new control board is needed.\015\012 The exception to this is if it is not heating at all, in which case it ... Bosch 24 in. SHU30 Built-in Dishwasher

My emilia dishwasher is not heating the water and not washing properly also the dial gets stuck on one spot the dial gets stu


... Dishwashers

My dishes do not get clean. Bowls or pans usually have a geasy film on them and I have to wash my dishes before I put them in the dishwasher or they do not come clean. I have had to do this since day one. My model number ls LDF6920BB. Serial number 810KWEL00004.


... LG LDF6920BB Fully Integrated Dishwasher with 5 Wash Cycles 3 Spray Arms

I have a Candy CD650 dishwasher which is not washing properly. Basically, the detergent tablets seem to be getting stuck in the tray. Most times I open the door, the tablet is a pile of mush inside the tray. Other times it is on the bottom of the dishwasher - again a pile of mush! Sometimes, it starts the program & sounds like it's about to start a wash cycle, but then gives up! it gives one short woosh, the stops again. Any ideas how to fix this? I don't have a manual so can't look there.


... Candy 24 in. CD650 Free-standing Dishwasher

Bosch sgs5312gb/07 dishwasher not getting hot - was stuck on rince mode - have got it off that setting - tried to use it - stays on wash and is not getting hot


If you open up the control panel (access by removing the front door panel) you'll find a circuit board and the relay. I suspect you'll find that a solder joint on the relay has burnt out - if so, easy to fix with a blob of solder - good luck ... Dishwashers

Our Bosch Dishwasher SHX46A does not advance from wash cycle. It get's stuck and just keeps washing.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012Based on your description I`d guess you have a problem with the unit failing to heat the water adequately which prevents it from advancing, that can be a result of a fault ... Dishwashers

Bosch dishwasher, Model SMU 7056, UC 09, FD 7309. My older unit has operated flawlessly for years. Two days ago it started to "stall" in one cycle and not progress to the next, e.g., stayed in the wash cycle and would not move on to rinse. In addition the heat generated in the machine was way below normal. A repairman told me that if the water doesn't get hot enough, the unit will not move on to the next cycle. I always use the "Regular Wash" option, but tried other options such as 'Economy


... Bosch Dishwashers

Classique Dishwasher I have classique dishwasher its the biggest load of rubbish i have ever used - i have had 2 new ones due to buying new houses - they dont wash properly and the tablets either stay in the dispenser or smear everywhere - cant wait to get rid of it


... Jenn-Air 24 in. JDB8910 Built-in Dishwasher

Dishwasher gets stuck in middle of wash cycle and stays on.


Hi,\015\012It would seem that your dishwashe timer has a spot that it will go to and then not proceed any further. This is not uncommon, you can manual advance it to get it through a cycle for now.\015\012\015\012To get a replacemen ... Bosch Dishwashers

Our kitchen aid dishwasher, model # 8524570 is stuck on the number 2 - can't get it off this cycle to wash the dishes. Please advise.


... KitchenAid Dishwashers

My dishwasher stays stuck on '1 minute', and will not complete the ccycle or drain the water. I tried to do another cycle on it, and it went to 8 minutes, and then jumped backl to 13 minutes, and repeated that pattern until I finally just opened it to stop it. I had one visit from a repairman last week, who said it could be a number of possibilities, and he charged me $75 and said he would return in a few days when he was not so busy. I am fairly handy, and if I knew exactly what part to replac


Make sure that the drain spigot is not blocked under the sink. Water has to pump out OK.\012Then the most likely fault is the release valve at the bottom of the heat exchanger. It jams because the plunger corrodes. To see to this you will need a comp ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Dishwasher gets stuck in one of the wash cycles and won't advance to the next cycle. It could run all day.


... Kenmore 15892 Built-in Dishwasher

Water vALVE DOES NOT QUITE SHUT OFF. AFTER WASH COMPLETED, water leaks slowly into tub and overflows onto floor. iT IS TYPE 1353-1. wHAT IS PART NUMBER FOR WATER VALVE? pRICE AND WHERE i CAN GET ONE? tHank you Kenneth Oag


Hello,\015\012If you can supply the Product number or model number I would be able to help.It would not be a major expense for a new inlet valve.Check if the drain pipe from the dishwasher if going into a pipe outlet in wall that it is not too ... Dishwashers

TIMER GETS STUCK AND KEEPS WASHING FOR HOURS ON END


This is probably not a timer problem. The timer will not advance if the water is not up to the proper temperature.\015\012\015\012Next time you run a cycle, open up the door after a few minutes. A large ball of steam should roll out of ... Dishwashers

My DD603 was leaking (both top and bottom) and I went to this web site and the person recommended changing the Lid Actuators which stopped the leaking for about one month. Now each time I run the dishwasher I get about 1-2 quarts of water on the floor. After reading the number of dissatisfied customers should I just buy a new dishwasher or keep chasing the all the problems associated with the DD-603?


In my honest opinion I would just buy a new one. I would say the same thing to change the lid actuators agian. Iam sure it would stop like before and then return later. It may be more cost effective time wise to just replace the unit. Sorry bbest of ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1649 seconds