Having problems with your Bosch 24 in. SHU5305UC Built-in Dishwasher ?

Dishwasher problem SHU4322 UC012 AT FIRST THE DRAINDIDN'T WORK. SO IS VACUUMED OUT THE WATER AND NOW IT DRAINS FINE. BUT NOW THE DISHWAHER WON'T BRING IN NEW WATER.


Answers :

There is a float in the tub looks like a little dome or such if its not touching the micro switch under it and pressing down on the leaver then the washer thinks its over filling and will not let the valve turn on remove the lower panel to see if its on the switch if not make sure the water is on then start the washer and see if the valve solenoid is getting power
Repair Help & Product Troubleshooting for Bosch 24 in. SHU5305UC Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher problem SHU4322 UC012 AT FIRST THE DRAINDIDN'T WORK. SO IS VACUUMED OUT THE WATER AND NOW IT DRAINS FINE. BUT NOW THE DISHWAHER WON'T BRING IN NEW WATER.


There is a float in the tub looks like a little dome or such if its not touching the micro switch under it and pressing down on the leaver then the washer thinks its over filling and will not let the valve turn on remove the lower ... Bosch 24 in. SHU5305UC Built-in Dishwasher

Bosch SGS5312GB/12 Dishwasher I had a control board. Worked fine except didn't heat the water. Got it repaired (new PCB). Now the only thing it does is drain. Clicks every 20 secs and carries on draining. Got a new board. Does everything (including heat the water) except it does not drain before, between, or at the end of cycles. It does drain when while filling, and if the flood detection rod is raised manually (also drains if the inlet pipe beyond the pressure sensor is blocked - found


... Bosch Dishwashers

MyTecnik dishwasher, TKD795/3 is draining out as soon as you switch on and continues doing this even with the door open. If you reset and try to start a new programme ot continues to drain and the water tap symbol comes on. I have disconneted to water supply and checked the little red filter and it was fine. The water pressure seem fine and not sure what to do now.


... Tecnik 18 in. TKD7000 Built-in Dishwasher

Water wont drain out of bottom of tub. The dishwasher works fine, it just wont drain the dirty water out. If I restart it to wash again, the dishes are washed in the dirty water.


Hi, A clog in the drain line or air gap (if there is one) is the usual reason that a dishwasher won't drain. Often the problem is at the point where the drain line attaches to the garbage disposer or househ ... GE Nautilus 24" Built-in Dishwasher

Broken dishwasher It started when my dishwasher flooded my kitchen. I drained it and turned it on, it was fine. then it happened again. I have drained it then when I went to turn it on again it just sounds like it is running with no water. If I put water into the bottom it will drain but it will not fill up. I bought this house 3 years ago I am unsure how old the dishwasher, do I need to get a new one?


I have a kenmore model 665 168 29000 the mounting bracket have broken from under the cabinet, so when you open the door and pull the racks out the machine moves forward, how can i fix this????? ... Bosch 23 in. SHU33A Built-In Dishwasher

EDW5500DSS wont completely drain water Okay so now that my dishwasher runs, when it finishes a cycle it has a nice puddle of water at the bottom that never drains completely out. I am assuming its a relay or something because I looked for a floating switch (did not find), I can hear a pump sound as if it wants to pump the remaining water out, but, it doesn't. I really want to solve this problem soon so I can order the new door seal and needed part together. Checked the line out and of course i


The srainer over the pump could be clogged not letting the water drain quick enough. Be sure the screen is cleane out. I believe you would have already checked and cleaned this. I believe it is the impeller on the pump that pumps the water that is ei ... Dishwashers

Constant draining my candy cs445 17" is stuck on drain, it just sucks water out and wont stop. Turning the dial to stop does nothing, if i fill it with a sacepan of water it juts empties, and when all the waters gone its just keeps emptying, would a float switch be the problem or possibly a new dial ?


I would check the float.clean it up real good.make sure it moves freely.let me know ... Candy 17 in. CS455 Built-in Dishwasher

Just installed a new Hot Point dishwasher.Mo #HDA2100N10WW. I AM HAVING PROBLEMS GETTING THE WATER TO DRAIN OUT. THE OLD MACHINE WOULD DRAIN FINE. IS IT POSSIBLE I FORGOT TO REMOVE SOMETHING ON NEW DISHWASHER?


Remove the drain hose from the sink and see if it will drain into a pail, if not then you have a problem with the machine that is covered under warranty ... Dishwashers

MY TECHNIKA DISHWASHER WONT DRAIN THE WATER SO IT STOPS HALFWAY IN THE CYCLE. THIS HAPPENED BEFORE AND THE TECHNICIAN MAUALLY DRAINED IT BY PRESSING A SERIES OF BUTTONS AND IT WORKED FINE. WHERE CAN i FIND OUT WHAT BUTTONS TO PRESS TO DRAIN IT MYSELF. THANKS


... Dishwashers

I have just inherited a NEFF dishwasher in my new house and it will switch on and go into cycle, it will drain if I put water in it but it will not fill with water despite the water supply being ok (the washing machine comes off the same source and is fine).


... Neff 24 in. S5409X0 Built-in Dishwasher

Dw44zp fithe bottom was full of water and would not drain, fixed the drain issue with new hose and clan out of basin. Next I restart the dishwasher to see it run and NOW the drain pump runs forever and wont go thru the cycles ??rst


... Thermador DW44Z Built-in Dishwasher

I have a EuroTech dishwasher Model# EDW254E/SB. It was working fine but now it gives the Err code:er1 Its not letting incoming water in i know that. As well I have been told to try reducing the water pressure at the facet. Did that nothing.It drains but wont cycle to the next stage and let water in. I am presuming there is a valve of some sort not opening? And does the dishwasher have to be completly romoved to fix. Thanks


Hi and welcome to FixYa. I am Kelly. \015\012\015\012This is a water level sensing problem. Look inside your lower wash tub area and see if you either see a circular device off to one side or a finger like device sticking up about 2 inc ... Dishwashers

My built in Whirlpool adg 9340 washer won't start a cycle at all. It seems to start a cycle and after 1 minute it stops and it starts beeping. Also water remains on the bottom. As soon as the cycle starts it drains that water and brings new water in which stays there. It won't work for more than 1 minute....


... Dishwashers

New SHE4AM16UC, professionally installed eight months ago. Worked fine with very light usage until now. Dishwasher starts normally but stops and signals "clean" after less than five minutes on any cycle. One inch of water in bottom that (I think) drains when a new cycle starts. Soap tablets are not ejected from compartment. Bosch authorized repairman says he now has two client dishwashers with identical symptoms and is asking Bosch support for ideas (he's changed pump, control unit, and float sw


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the clean light flashes, pauses, and then repeats.\015\012When the dishwasher doesn't sense a water t ... Bosch SHE4AM16UC 24 in. Built-in Dishwasher

My bosh dishwasher SHX55M06UC/46 will not drain. A new disposal was put in and the dishwasher drain plug was not punched out and the dishwasher was ran that way. Now it just holds water in the bottom. I've tried resetting or canceling the wash cycle but that doesn't work and the washing cycle works fine. I'm hoping there is a reset or a safety for the pump if it gets clogged.


... Dishwashers

Whirlpool Model DU8770XY purchased new in 1992 has just started to overflow through the air gap kit 300096. This unit has been working fine for the past 18 years. I checked the unit and drain tail section under the sink along with the P-trap and the water flows through them just fine. The kit is clean with no visible obstruction.


... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

My masterclean 4000 has been making very loud noises and now it wont finish draining from the last load and when i tried a new load it wont work at all. a water filling soound happens for abt 5 seconds then absolutely nothing happens at all. what do i do?


... Amana 24 in. ADB1500AWS Stainless Steel Dishwasher

The ge profile dishwasher model PDW8280J10SS was purchased about 2 yrs ago. It was working fine up until Jan. 2009. It ran fine but the water stopped draining. I read were you should run the garbage disposal prior to running the dishwasher. I drained the water and did this. It worked fine for a while then the problem was back. Once again, Drained all the water, sucked it out with a turkey baister, moved the dishwasher and checked hoses etc. Once again, it worked fine for about 10-14 runs. It now


It is probably clogged at the pump or before. See if you can get outlet hose off the bottom before the pump. ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

Whirlpool Quiet Wash Plus dishwasher Model DU920PFGZ3. Worked fine until I replaced the insinkerator and forgot to punch the drain plug leaving water standing on the bottom of the machine. I punched the drain opening, and pushed the cancel/drain cycle button. It drained fine but since no water comes from the spray arms. I have removed the arm all the way down..NOTHING!! Some research indicated it could be the water inlet valve. When the buttons are pushed, it cycles but no spray or water.


... Dishwashers

Put a new disposal in and didnt take the plug out. The dishwasher would fill up, and not drain. Took the plug out, and replaced the line, and now the dishwasher wont fill up with water. HELP!!!


... Maytag 24 in. DWD1500A Built-in Dishwasher

I have a new FDB520RHS2A Frigidaire dishwasher which remains in the wash cycle after I've started it. It sounds as if it is changing cycles but the wash light stays lit and never switches to rinse. The machine continues to run for hours if I don't stop it. We've checked the drain to the garbage disposal and it is clear. the water temp seems to be hot enough but how do I check that? Any ideas on what we should check before we bring it back to the store? Your help is much appreciated. Thanks!


... Dishwashers

Hi i have a beko dishwasher dwd 4310s it wont drain the water properly ive checed the filters and there fine any sugestions cheers


... Dishwashers

Hotpoint dishwasher BFI620 not drained and won't now work: Moved into a new house and acquired a built in dishwasher. First load was fine - or so I thought. Washed and rinsed ok, but large amount of water left in the bottom of the machine which means it now won't work. I've taken out the filter and it appears to be clear, also checked the hose for any kinks, but now I'm stuck. Any ideas?


... Dishwashers

New - 3 months 665.1389 Kenmore dishwasher worked fine until today. end of cycle - water in bottom no directions in use guide how to clean drain or ?? No large items have been allowed on the dishes. don't have any helps in the guide about repair


... Dishwashers

I have a Kenmore dishwasher that will not pump water through the spray arms. It fills ok and drains fine but wont go into the wash cycle? Any idea of possible problems


Look inside of the dishwasher to be sure that the tubes leading to the spray arms are not disconnected. If those tubes are in place, then the problem is with the main motor/pump in the base of the unit. That Kenmore part is about $150.00 plus labor ... Kenmore 15762 Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1223 seconds