Having problems with your Bosch 24 in. SHU5305UC Built-in Dishwasher ?

Replacing a drain hose

\015 How do you replace the drain hose on a Bosch SHU5305CU dishwasher?\015\012\015\012I have pulled it out from under the ocunter. The drain hose enters the back of the dishwasher but runs around to the front. I can't find any way to detach it, or even free it from whatever is holding it in place. I need to replace it because it developed a split (hole) in the hose near the point where it connects to the garbage disposal. Needless to say, this sprays water everywhere when the dishwasher is running.\015\012\015\012Help.\015\012\015\012Thanks,\015\012\015\012Jim\015

Answers :

If you remove the steel left side panel you can see that the drain hose only extends a short way into the machine. Where the hose enters the pan is a white clip that has a small square hole this clip can either be removed by pushing on it from the inside or prying the small square hole with a screwdriver. the drain hose is held in place by a black triangular clip on the plastic drain loop simply pull the clip off and slide the drain hose down then pull it out from the back of the machine.
Repair Help & Product Troubleshooting for Bosch 24 in. SHU5305UC Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I am replacing the drain hose on my LG Dishwasher LDS5811BB. The new hose they gave me has an additional piece connected onto the hose. I don't know what it is or what it is for. The original drain hose was composed soley of a gray hose with the to end connectectors. This new hose is similar with an additional white, hard plastic, U-shaped hose with a black hose extending off the end of the U-shaped end. Is this an air gap extension, and if so, what do I connect it to or can I cap it off?


... Dishwashers

Whirlpool dishwasher will not drain. All hoses are clear. I replaced the air gap too. The dishwasher will drain into a bucket when I detatch the hose from the air gap, but not into the drain/disposal when I replace it.


Http://www.partselect.com/repair.aspx?appliance=dishwasher&part=water-wont-drain\015\012\015\012\015\012\015\ ... Whirlpool GU2400XTP Built-in Dishwasher

We're trying to install our dishwasher and there is a 3rd hose attached on the side. It appears to be a drain of some kind, part number, we think, printed on it is FRU 10967 19/07/04 08:33 Can you tell us what it is and where and how to attach. The one it's replacing only had the water hose and the drain hose, no third hose. Thanks


I just installed my Bosch dishwasher a few days ago and wondered about the same thing. The instructions for hooking up water supply and drain lines did not mention this third hose at all. \012\012However, 'the third hose' (which appears open on ... Bosch 24 in. SHU43 Built-in Dishwasher

What is the rubber hose that comes out of the t at the top of the loop of my dishwashers drain hose and what doese it connect to. The old drain hose I am replacing did not have that.


This hose?http://www.amazon.com/gp/product/B00379N7U6/ref=oh_details_o00_s00_i01If so, the black hose is some part of the upg ... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Bosch dishwasher SHX46A05UC/40 is making noise when draining. I have cleaned the screen and hose back to the drain and removed all debris. So it seem to be the 'drain pump'. But replacing it - now that seem complex - is it? Looks like I would have to stand the DW on its head and remove the base and then replace the pump. Anyone know if I am on the right track? Could it be something else?


... Dishwashers

Trying to replace drain hose on LG dishwasher. Replacement hose has a white U shaped fitting at top of loop with a black hose coming off of middle of the U with no apparent connection point in dishwasher. Any ideas?


... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

GE Dishwasher model PDW8200J03BB stopped draining. Removed the drain pump, checked with Voltmeter and there is resistance on ohms X10 of about 3. The flap is in place so water isn't shooting back into the sump inlet. Replaced the sump inlet about 6 months ago because it was deteriorated due to hard water. Pump worked fine after that. Checked drain hoses and air gap. Was able to blow water through. Pump only trickles water out at air gap. Does the pump need replaced?


Clear the line from the air gap to the drain,, if the rest is clear the only thing it can be is the propellers on the pump, i which case you will need to change the pump ... GE 25 in. Profile PDW8200J Built-in Dishwasher

I am trying to install a new Maytag MDBH945AWB Dishwasher and have to run the drain hose under the machine in order to get it to the sink. Each time I try to use the hose that comes with the machine it snaps in two and breaks. I have tried to look for a replacement hose that would stand up to the abuse but all I can find is the original. Is there a replacement I can get that is more flexible than the one that comes with it? At this point I am rather embarrased about going back to Home Depot


Hi...home depot sells clear PVC hoses, They come in various lengths up to 100 ft. You can use hose clamps to connect it to the T-fitting. ... Dishwashers

Removed rear toe-plate to detect leak. Leak caused by broken drain hose. Hose replaced. To do this the unit was tipped forward onto its front door to allow access to the base area. Water allowed to drain out the front base area. Unit re-assembled but now does not switch on. Water connected. Base-plate dry. No water was detected at upper-front control panel. Power is connected and reaching unit ( multi-meter test ). Tipping the unit forward seems to be the cause. Is there any fuse,


The micro switches are frequently replaced on the door handle and they don't need to ever get wet. A lot of amp draw burns those switches up while they are dry. If they were wet and power was applied then they got fried my friend. The good news is th ... Dishwashers

I have a broken drain hose on my LG Dishwasher (Model LD-1403W1). I have the part to replace it and cannot see how this is done. Can you assist with instructions on how to replace thew drainage hose. Thanks for any help you can give


... Dishwashers

9e error code on Samsung dishwasher. dmr77lhs. Already replaced drain hose, worked for 3 months, then 9e came back. Replaced supply hose but did not change error status.


I get this error code every 9 months or so with my DMR78.... Every time, I pull the dishwasher out, remove the cover, and then clean out the float on the left side of the dishwasher (the white plastic piece in the bottom center in the attached ... Dishwashers

I have a haier dishwasher model WQP12 AFM, I've replaced the wash pump motor and drain pump (they had been damaged with water after last repair person didn't put widget around drain hose which split and water accumulated on bottom). It well for about two weeks, then it would not go through it's cycle and I noted water not heating up. Have checked element with meter, thats fine, I replaced timersince it wasn't going through its cycle and that has not changed anything. Any suggustions?? Cheers


... Haier Dishwashers

I got this dishwasher from a friend that had mice chew the hoses and i was told that it worked perfect before the mice chewed it. I replaced the drain and fill hoses plus the power cord. when i put everything back together and power on I get F1 on the top drawer and the rotor rotates and the heater plate turns on. The botton drawer does nothing with no display. I checked all the wires with a meter and found good continuity thru every pin. I replaced the main filter board. I even switched the


Did the F1 error in the top drawer disappear after you replaced the mains filter board? ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Need to replace damaged drain hose


Ok, i figured it out: \015\012pull open the drawer about 250mm. if you look at the outer plastic skin of the drawer, you will see on each side a round plug down near the bottom of the drum about 50mm in from the front panel. these look as if you can ... Fisher DD603B / DD603W / DD603H Dishwasher

Replacing a drain hose


If you remove the steel left side panel you can see that the drain hose only extends a short way into the machine. Where the hose enters the pan is a white clip that has a small square hole this clip can either be removed by pushing on it from the in ... Bosch 24 in. SHU5305UC Built-in Dishwasher

Replacing drain hose of Haier portable dishwasher HDP18PA


How do i get to the hoses on maytag portable dishwasher ... Haier HDP18PA Stainless Steel Free-Standing Dishwasher

Not draining goes through the cycle but is not draining. I have pulled the filter, cleaned it. Took off the drain hose from the new garbage disposal amd tried to syphin out the water no luck. I have not pulle the dishwasher yet. It just started to do this ands we just had to replace the garbage disposal. Might this have caused the garbage disposal to burn out as well?


Did you remove the plug in your disposal so the dishwasher can drain??? ... Bosch 24 in. SHU43 Built-in Dishwasher

The dishwasher does not drain, i just replace my garbage disposal and now the dishwasher does not drain, i did reconnect the dishwasher drain hose to the garbage disposal


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I just came accross your post and immediately I thought, " drain plug in garb not punched out" this is very common when a new garb or dishwasher is installed..so much If I had a dollar for every ... Bosch 24 in. SHU43 Built-in Dishwasher

My dishwasher won't drain. It starts a cycle but doesn't finish draining the water. I checked the outlet hose and it's clear. I was able to siphon off the water and start a new cycle but the water still won't drain. Time to replace the pump?


Hi,\015\012Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...Dishwasher Problems - Water will not drain ... Kenmore 15879 Built-in Dishwasher

My GE monogram dishwasher won't drain. The (3 different) repairmen who came to my home checked the hoses, replaced the pump and replaced the motor. Nothing worked, and they suggested that the home warranty people replace the unit. The company, however, won't allow me to do this since we don't have a "diagnosable problem". What else can I check?


Some models (for example most GE dishwashers) use a drain solenoid to drain water out. Sometimes the solenoid gets stuck, preventing the water from draining out. Try to free up the solenoid. If unsuccessful, you might have to replace the pump assembl ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Water will not drain out of bottom of dishwasher.It will go through the whole cycle but will not drain. This is a Frigidaire model no.FDB510LCS3 Serial no.is:noth70219331.Pump hose was disconnected and drained completely,dishwasher was put through another cycle and still ended up with water puddled in the bottom!! Could this dishwasher be called a lemon??? Does the pump need replacing?? I have noticed on your website that many others are having the same problem.To me it appears that it may be sh


Check the input to the drain hose to make sure it is not blocked by something like a cherry pit.  That could cause the water to not drain fully. ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

Dishwasher is draining slower than normal and sometimes doesn't drain at all, I have replaced drain hose...still having same problems.


The drain pump /valve is the faulty component and must be checked , this is at the drain of the chamber and water is flushed . Normally it gets clogged due to dirt accumulation of the dishwasher.\012So have it removed ,give voltage to test outs ... Frigidaire FDB1050REM Dishwasher

SHU66C05 Unit will not drain at the end of a cycle. I can use the cacel/drain to manually get dishwasher to drain so don't think it is the motor/ drain pump. I replaced the air trap and the hose to the disposal, (neither appeared clogged) so I think it a problem with the swiching board.


Yes it appears to be in the micro controller board. Try to get the same version board being software driven. Better to take the help of the BOSCH service provider. ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a Bosch SGE63E05UC dishwasher that keeps intermittently showing an "E:25" error code. Occasionally it will get all the way through a cycle without going into error, but more often than not it will error and stop. So far the main control module in the front panel and drain pump have been replaced and the problem persists. All hoses have been checked and are clean (unit is only 1 year old) and drains well, when it does drain. Any suggestions?


... Bosch SGE63E05UC 24 in Builtin Dishwasher

Drain Hose Replacement


Drain hoses are quite standard. the rubber spigot at each end can be different sizes and some have a right angle bend at the end. suggest you take out the old hose and take it along to match up - easiest way ... Miele Touchtronic G892 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0951 seconds