Having problems with your Bosch 24 in. SHU53 Built-in Dishwasher ?

Timer runs down to 1 min and just hums water covers the bottom

\015 Bosch model SHU 5316, took the front cover off and the cover for the control panel , checked the connection's all good. same thing still happens\015

Answers :

Need more info on problem does it start washing then run down and hum or what
Repair Help & Product Troubleshooting for Bosch 24 in. SHU53 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Timer runs down to 1 min and just hums water covers the bottom


Need more info on problem does it start washing then run down and hum or what ... Bosch 24 in. SHU53 Built-in Dishwasher

Dishwasher runs for appx 14 min & stops washing half way thru wash cycle. Timer contunies to run. No drain pump out (nothing). Let dishwasher set idle for appx 1 hour and it will re-set. Set timer forward to end of wash cycle and it will complete rinse and final rinse. Then go to dry. Timer works ok.


This sounds like something is stuck in the drain pump. You can remove the inner cover to look for obstructions. You have a dual purpose motor it does the both circulating and draining. The blockage is causing it to overheat and trip the thermal prote ... Whirlpool DU840CWD Dishwasher

I have a Bosch SHU66C02. I opened the door to stop it from running temporarily, while it was sitting not running, it leaked all of the water out of the bottom right corner of the door, and when I went to start it later it just hummed but the timer didn't go down for over an hour. I tried to put more water in but as soon as I started I could hear the water added to drain. I turned the breaker in the fuze box off to it and let it sit for over an hour, but when I restarted, the timer was still at


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a SE24T250 and the timer on the auto programme says 188 mins (it is usually around 120 mins) When the prog runs it doesn't finish and shows 1 minute to go and never gets to the drying or end of cycle part of the programme. Have tried the reset but it still shows 188 mins when complete. Any ideas?


... Siemens Dishwashers

My shx45mouc will run and run even when the timer hits 1 min it will still run untill i stop it


... Bosch Integra 500 SHX45M05UC Stainless Steel 24 in Builtin Dishwasher

For over six months our dishes (especially glass and china) aare covered in a gritty, darkish material. We often have to rewqsh or hand-wah these items afterwards. We have tried numerous rinse additives, run the dishwasher empty, rinsed 2 or 3 times, and disconnected the hose from the drain and run it into a bucket to see these fine particles. I remved and cleaned the bottom filter a month age. It was mildly dirty (not clogged or filthy) but no improvement was seen. Any suggestions? The dishwash


I would guess that you run out of hot water in your house pretty quickly. if so, your water heater tank needs drained. hook a hose to the bottom outlet on the tank. shut off the cold water supply to the tank. open up the hot water on a nearby sin ... Dishwashers

Bottom sprayer does not clean or work, all items on bottom are the same as put in. Top is fine. runs through whole cycle.2 hr 29 min


Check the free rotation of the spray arm. If arm jets are clogged clean them.After placing the dishes see to it that, the arm is freely rotating without any obstacles. ... LG 24 in. LDS 5811 Built-in Dishwasher

My 1yo slimline hotpoint dishwasher LST216 has developed a fault when trying to run the 'normal wash': washing stops after a couple of mins, the lights start flashing and the alarm comes on as soon as the water is being drawn into the machine. When I open the door I can hear a whirling/grating motor noise coming from the bottom of the machine. I have cleaned all filters and have run other programmes to check overall functionality and they all work as expected most of the time. I cannot unders


... Hotpoint Dishwashers

I have LG dishwasher for 2 years now. Working perfectly until one day one glass gets broken during washing cycle. Immideatly we get EO error. We check possible reason of error in the manual then decided to try to fix ourself. We open bottom cover and drain outcoming part. Immideatly we discover a piece of glass that was preventing a small plastic piece to rotate. We remove that piece of glass. Put back covers and machine. We connected it back to outlets and run it. All was working again !!! This


In order to fix problem we disconnected dishwasher, put it on one of side, opened bottom cover - the one that is outside of dishwasher. We find out the part that is\015\012connected to the drain horse. We take of 3 screw and open that part too ... LG Dishwashers

Fisher and Paykel Dishwasher, bottom drawer gets water in it. This drawer is seldom used and when used the water empties completely. However, it always has water standing in it. I run the rinse cycle and it gets all the water out but after time the water is back. It is enough to cover the large removable metal cover.


... Fisher and Paykel Dishwashers

I have a brand new whirlpool DU1055XTV5 dishwasher, installed two days ago. After the cycle completes there is about 1/2" clean standing water left in the bottom. It is not just down in the well area, the whole bottom is covered with water. This is after running a normal cycle with no other options such as sanitize or heat dry. I called Lowes, the store that sold/installed it, and they said this is normal in new dishwashers to keep the parts wet. They said as long as the water does reach th


... Whirlpool DU1055XTS Built-in Dishwasher

Sandy glasses The dishes on the top rack come out with a sandy residue on them....we have tried running it with the jet dry dishwasher cleaner, the vinigar and baking soda...have taken apart and checked all filters and water supply...no help with any of that. I also wonder how much water should be in there when it is running...shouldn't it cover the heating coil in the bottom? My water level is just below the coil.


A simple cleaning with any form of citric acid(tang0 on a regular basis(depending on how hard water is) will cure this "proublem"\015\012\015\012Cleans the internal filter and breaks up hard water residue(calcium) ... Whirlpool GU2400XTP Built-in Dishwasher

Dishwasher timer stops at 28 min but dishwasher still run and timer does not advance


... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Asko D3120 I have resolved the problem of pum always running by tilting the dishwasher but now I have a new problem of the pump not draining the water in the bottom of the dishwasher. I thought it was clogged so I removed the screen and filters but did not stick my hand in the hole to clean... I used the plunger for at least 30 mins. Then I tried to pour a little CLR because I have hard water. NOTHING please help me


In the bottom where the filter are, you can see a yellow 'thing'. Remove this and stick one finger in an try to rotate the pump wing. Try to remove particals that is blocking the pump.\015\012Or there is something in the drain hose. Try to drai ... Asko 24 in. D3120 Dishwasher

Top drawer runs for a while, the timer stops after two minutes and then I get a U2 code. Bottom drawer working fine.


Hi there,Usually a U2 code means there is a problem with closing the draw fully, and hence the dishwasher thinks the door isnt closed and will not start up. This could be because A) there is something impeding the draw from closing (check ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

We have a maytag dishwasher MBDTT79A and it does not fill up with water. runs through cycle but everything dry. wifey stopped cycle in middle and it did have about 1/2" to 3/4" covering bottom.( I never saw this when i stopped it during cycle).


Hi,\012Here is a tip that will help you to find out why water will not come into thedishwasher... Dishwasher Trouble No Water entering Dishwasher ... Maytag Dishwasher

Timer doesn't countdown (pauses for long periods) in the wash cycle. 3.5 hours to run a 66 min cycle. Model is the GU1500XT


Hello,\015\012The timer is bad and will not work correctly.\015\012You need to replace the timer.\015\012\015\012http://www.fixya.com/ ... Dishwashers

My dishlex globale 300 has a modle no that is dx300wa*02 the eco light and pump keeps running i have recieved advice to drain/dryout the kidney shapped over flow tray but mine doesn't seem to have one. i've taken off the bottom cover to get a closer look but still can't see it i've also tried tipping the washer on it's left side right side,backside and even upside down to try and drain the extra water but that has made no difference please help


Hi,\015\012Try taking the dishwasher out of its wall space and tipping it back and forth. Apparently the weight of water gathering in some component triggers the 'eco' function. Allow it to evaporate by waiting for few days. ... Dishwashers

Kitchen Aid Dishwasher KUDR24SEBLO does not drain 100%. I have removed the drain hose and chcked the sink P-Trap, [it drains thru the garbage disposer]. Unit is 10 years old, otherwise works fine. I am having difficulty removing the impeller and items above the pump to see if it is clogged. Do you think I have a partially clogged pump or a timer issue that prevents the pump from completely emptying the bottom of the dishwasher? We have run the dishwasher 20-30 times since observing the problem.


Hi there,\012Please check out the following -Pump - Your dishwasher pump ejects the water. The pump is usually mounted directly to the motor, then attached to the bottom of the dishwasher. You can reach the pu ... KitchenAid Dishwashers

Regular cycle took 3 hours then would not shut off. Stopped at 1 min. soapy water still filled the bottom, dishes had soap on them. water finally drained almost out but I am afraid too run another cycle. any ideas? thanks


There is a heating element in the dishwasher that heats the water to about 155F at which point a thermostat closes and sends power to the timer to advance. If the water does not reach this temp, the dishwasher will not advance. Often the problem lies ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Dishwasher not draining E25 error code (Bosch exxcel) . I have cleaned filters & removed pump inspection cover to check / clean debris I have also checked the waste water pipe is not kinked, it runs for 1hr 15 mins last time and then cut out with the error code displayed.


Gr8 stuff klaudi & Nypmh - rocking it back 45% worked a treat. Bloody BonzaShell XX ... Bosch Dishwashers

Lost Power We always run the unit before bed on the delay timer. I heard it kick on last night. When we woke up this morning I first noticed that the clean light wasn't on. Then I noticed that the dishes were still very damp. Lastly it has about a inch of water laying in the bottom of it. It appears that it just lost power during the cycle. What are some areas I may trouble shoot before calling in a repair person. Thanks


Replace the thermal fuse inside the control panel.\015\012Part #3376359 ... Whirlpool DU960PW Dishwasher

Greetings, My Viking disk washer Model # Dfud042 runs 4-5 min then makes several cliking sounds and stops. The program light for the light china is blinking, the soap dispinser still has soap in it, and water remains in bottom of the washer. Regards, James Parker


Hi,\015\012If it is filling and draining ok, then I suggest the problem lies with the main heating element.\015\012Disconnect from the supply and turn off water. Pull forward, to gain access to the element from underneath.\015\012Te ... Viking DFUD042 Built-in Dishwasher

Ran the dishwasher and the water didn't drain completely. Checked the drain line for clog - it was clear. Scooped out the remaining water (barely covered the flat wire mesh filter in bottonm of the machine) and cleaned off the canister mesh filter and carefully relocked the filtyer in place. Tried to run the machine last night. Soap tray opened but apparently no water cycled through the machine as all the soap was in the bottom of the machine. The heat never turned on to dry the dishes and


Hello Ramona Doug,\015\012 Try disconnecting power from your dishwasher for a few minutes to clear the memory and then reapply power again. Start a wash cycle without dishes on the hottest water setting and after a few minutes.. pause the wash ... Bosch Dishwashers

Kenmore Dishwasher My dishwasher fills with water and then stops. I hear the cycle timer continue all the way through the cycle. I pulled the screen off the bottom inside of the dishwaher and stuck my hand in the diswasher drain. Originally I felt and cleared what appeared to be a torn up rubber band. I feel a thin straight metal pin that I can rotate and I believe it causes the pump to rotate as well. Once I do that the dishwasher will run normally thorough a complete cycle...BUT I have to


If you have either dry bearings in the motor or sticky grease buildup in the pump bearing/seal, it can cause the motor to stick rather than rotate on startup. More likely to be greasy crud buildup. \015\012\015\012The best you can do without disasse ... Kenmore 24 in. 15149 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1274 seconds