Having problems with your Bosch 24 in. SHU53 Built-in Dishwasher ?

Timer runs down to one minute and does not complete the cycle.


Answers :

Debbie, there is a Bosch recall covering a number of units sold up until about 2006. Mine is not covered however has exactly the same symptom caused by a defective cold solder joint on the power control for the unit. The symptom you describe is identical. Go online to Bosch.com to determine if your unit is covered and the necessary action. Several of these units caught fire casuing the recall however mine as mentined had teh same defct yet was not included in the recall.
If your unit is an older model like mine which has ever been serviced prior to 2005 it is also possible that the recalled parts were installed during a service procedure
I was able to repair my board myself prior to their recall however BOSCH's official policy is replacement parts only if covered by recall or not.
Repair Help & Product Troubleshooting for Bosch 24 in. SHU53 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Timer runs down to one minute and does not complete the cycle.


Debbie, there is a Bosch recall covering a number of units sold up until about 2006. Mine is not covered however has exactly the same symptom caused by a defective cold solder joint on the power control for the unit. The symptom you describe is iden ... Bosch 24 in. SHU53 Built-in Dishwasher

Bosch dishwasher Dishwasher runs much longer than timer, stays at 88 minutes for an hour! When I open it and then close again, timer will say 90 minutes! It will run for hours till cycle is completed! Most of the time dishes are still wet.


Hello guest. seems you have a leak in the base. Looks as though motor is washing dishes but actually its the drain pump thats been activated which doesnt allow the timer to proceed forward. ... Bosch 24 in. SHU53 Built-in Dishwasher

My dishwasher SL34A015UC / 29 does not complete it's cycle. The cycle will stop with 1 minute left in the rince cycle and continue to run for hours, showing just one minute left. The dishes are not geting clean and there is a unplesent odor inside. I can hear the water draining during the cycle. The drain line is clear and there is plenty of water in the dishwasher. Any thoughts?


... Siemens SL5A70UC 24 in. Built-in Dishwasher

Hello I hope someone can help me. I have a Siemens Hydrosensor Dishwasher that when I start it up in runs for a while and shuts off. I need to open and close the door several times then it may run for a short while, 15 seconds to a couple minutes and then shut down again. Finally, it will run through the rest of the cycle. The issue generally occurs when the digital timer is between 85 and 78. If I just leave it go once it shuts down it does eventually start up and will complete the washing cycl


It sounds like the door switch is at fault, it will cause the symptoms you stated. ... Dishwashers

Dishwasher stalls I have a Bosch dishwasher model # SHU4006UC/U06. The dial stops after going through one cycle and the dishwasher continues to run that cycle and will not advance unless we manually advance the dial. After advancing the dial the dishwasher will stall until we have manually advanced the dial until reaching the "9 o'clock" position. It will then continue until the dry cycle is complete. Thanks!! I have the same problem. I took out the timer control and spraid it with contact clean


If the cycle doesn't complete, check these:Water-heating cycle ... Bosch SHU4006 Dishwasher

I have a SE24T250 and the timer on the auto programme says 188 mins (it is usually around 120 mins) When the prog runs it doesn't finish and shows 1 minute to go and never gets to the drying or end of cycle part of the programme. Have tried the reset but it still shows 188 mins when complete. Any ideas?


... Siemens Dishwashers

It has been flashing an F2 error code and the timer starts at 65 then switches to "1" which stays on during the cycle. Now it will run for about a minute then stops completely. Can you suggest any parts that we can get to fix this?


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012\015\012The "F2" for Asko dishwashers indicates either the unit is overfilling, or the valve itself has failed.\ ... Asko 24 in. 1895 Built-in Dishwasher

I have a Siemens SE24T250GB that will not complete the cycle, it gets stuck with one minute left on the timer. Any help will be gratefully recieved.


... Siemens 24 in. SE25T250 Free-Standing Dishwasher

Dishwasher runs for appx 14 min & stops washing half way thru wash cycle. Timer contunies to run. No drain pump out (nothing). Let dishwasher set idle for appx 1 hour and it will re-set. Set timer forward to end of wash cycle and it will complete rinse and final rinse. Then go to dry. Timer works ok.


This sounds like something is stuck in the drain pump. You can remove the inner cover to look for obstructions. You have a dual purpose motor it does the both circulating and draining. The blockage is causing it to overheat and trip the thermal prote ... Whirlpool DU840CWD Dishwasher

The washer won't complete it's cycle. It just runs and runs. One time I got it to complete by turning it off, then switching to the Rinse and Hold cycle, but now nothing works. It doesn't drain the water, it appears to be stuck in the wash part of the cycle.


... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

My problem is with a Eurotech Model ED254EG timer will not continue running thru the cycle properly. i.e. In "Light Load" position the timer starts with 59 minutes but actuall runs for 2 1/2 to 3 hour


... EuroTech EDW242C Stainless Steel Built-in Dishwasher

When I start the top drawer it defaults to 5 minutes (with the lights Heavy, Fast, Rinse highlighted) runs for a couple minutes, then stops and the LED starts randomly cycling through all kinds of codes very quickly. There is water in the tub that has not drained after completing the couple minutes of operation. This cycle repeats itself if I hit the power button again after the LED starts freaking out. The 5 min cycle shows in the LED, sometimes with the no circulation error, sometimes with the


Here is the solution: \015\012http://applianceguru.com/forum1/24814.html ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

During wash cycle it gets stuck and won't move past the wash cycle. On a regular wash it is at 28minutes and when it is on a fast wash it is at 25 minutes. If I stop it and turn on the rinse cycle it will run through the 12minute rinse cycle with no problems. It is only the top dishwasher that does this, the bottom one is running just fine.


I've got the same problem with the bottom drawer on the DD605. No fault codes were set. I checked the heating element and it produced heat quickly. I suspect that the water temp sensor isn't satisfied, and the timer is waiting for the water to rea ... Fisher and Paykel DD605BK Dishwasher

I have a maytag dishwasher. The wash cycle runs for approximately 10 minutes, then shuts off. The timer will say 90 minutes +/- then will go to 1 minute and turn off? There is a grinding noise when the cycle first starts. Any ideas?


... Dishwashers

No matter which cycle selection in pushed, the dishwasher only starts up in the "normal" 93 min cycle. If I try other cycle options, and persist, I get an ER message and the cycle stops prior to the soap powder door opening and never completes the cycle. Only with turning off power for several minutes and receiving the PF message, and resetting ONE TIME that message can I then select any cycle, at which time the machine "defaults" to the "normal" full cycle. If I do not disturb that cycle, it wi


Looks like you are having a good deal of problems with the dishwasher.\015\012\015\012It will be helpful if you provide the make and model no. of the dishwasher.\015\012\015\012At this stage I can speculate the controller (ass ... Dishwashers

Blowing fuse... We've replaced the overheating fuse located in the control board area about 5 times. It has just blown again after using the dishwaser one time--before it would go about a month before blowing the fuse. It seems to get about a few minutes away from completing the wash cycle and does not complete the draining process. Help!! We don't know what to do next--replacing the fuse is costing about $15 each time, before you know it we could have bought a new one! Thanks for the help. Ti


Tim, this blown fuse issue was pretty common on this model. Whirlpool, which made this model came out with a fuse kit that included a terminal and heavier guage wire to eliminate this problem. It just splices right into the control board, easy job. T ... Kenmore 17024 Built-in Dishwasher

My Whirlpool Gold Quiet Partner III was DOA when I went to use it today. I unplugged/plugged it back in, at which time the "China Crystal" LED flashed a sequence of 3 flashes, then 3 more flashes, pause, 3 + 3 more, pause, 3+3 more, pause, etc., etc. And it would not run on any other cycle, but it did seem to run thru that one OK. Upon completion of the cycle, it was DOA again. Did the "Normal/Air Dry/Normal" button sequence, and now the Rinse Only button is steadily flashing. Any suggestions? I


When the rinse light is flashing steadily then the reset procedure for your model is pressing the "Normal/Air Dry/Normal" buttons.\015\012\015\012If it did not reset your dishwasher the control board must have fa ... Whirlpool GU2400XTP Built-in Dishwasher

My dishwasher will not stop running. The timer gets to one minute and will not stop. When i open the door the water is full of suds. When i close the door the timer resets to 13 minutes and continues to wash.


Hi, this is timer failure. simply replacing the timer module(control) will fix this issue. ... Bosch SHU5307UC Built-in Dishwasher

My fisher and paykel 605 diswasher seems to have a problem... the timer stop at around 58 minutes on normal cycle or 25 minutes on fast cycle? Can you tell me what I can do for this situation? The botton diswasher works fine...but not the top one? Thanks for your help. Marc


... Fisher and Paykel DD605SS Stainless Steel Dishwasher

I have a Bosch SGS43A22 Dishwasher approx 8 years old. When I start a cycle it fills, runs for about 15 minutes, then drops out about a litre of water from the bottom of the door, then completes the cycle without any more leaking. I have run the machine with the front panel off and can see that water bypasses the top of the seal and fills the well of the seal then pours out. It only happens the once. The seal is fitted correctly. Any solutions?


After 8 years service the seal may have perished, so you should feel for a crack by stretching the rubber where you noticed the leak. ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Bosch she3arf2uc107 dishwasher ran normal wash cycle and got down to one minute and continued to run staying on one minute. What is the problem


... Bosch Dishwashers

Takes more than 2 hours to complete a one hour cycle. Will sit on "1" minute left for the last 45-60 mins. If the door is opened during this long one minute the washer still has water in it and will reset to 13 mins remaining.


Hello,\015\012\015\012Welcome to fixya.\015\012 \015\012**What I`m about to share applies to Almost all Electronic control B/S/H/ dishwashers. That includes Bosch, Thermador ... Bosch SHU5315UC Dishwasher

Hi, I have a GE dishwasher. The model is GSD2204PWW, (it's a canadian model) I bought it 2 years ago. Lately, the water comes inside the dishwasher during the washing cycle, but it is drain out few minutes later, it completes its cycle and the other ones perfectly. So please, does anyone know how I can fix it? it that one : http://***.geappliances.ca/jsp/ge_Features.jsp?model_id=55511&product_id=23&cmb_Brands=---&cmb_Colours=---&cmb_496=---&cmb_565=---&cmb_PriceMax=---&cmb_PriceMin=---&count=1


Hello, tamaraI\012 was trying to help you out here. I am not sure if this well help you? \012But here is a link to about everything you want to know about your \012dishwasher, from repair to trouble shooting on most common dis ... Maytag Dishwasher

We have a Bosch dishwasher model SHU5315UC/U06. When we ran a "Regular Wash" the dishwasher ran continuously and the timer did not count-down. None of the Delicate or Rinse and Hold buttons responded. The only button that works is the "Scrub Wash", but when we ran it did the same thing. Ran continuously and the timer moved one minute after running about five minutes. I look forward to your solution. Thank you. Jerry


My father-in-law has a Bosch and they had the same problem. The tech guy said it was not heating properly and that caused it to continously run because it won't tick down the timer if it doesn't reach a certain temp, so try turning your faucet as hot ... Dishwashers

Siemens aquaVario I have a 2007 (?) Siemens Aquavario Automatic 3 in 1 dishwasser. One of the programs got stuck with 1 minute at the timer. It was running like this most likely for more then one hour over the normally scheduled time; we don't know for sure since we were out of the house. It produced some sort of 'sucking / blowing' sound and continued doing so after I opened and closed the door again. After the reset (pushing two buttons at the same time) the timer went back to zero but the sou


... Siemens Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1485 seconds