Having problems with your Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher ?
Dishwasher not taking in water
\015 I have just bought a secondhand bosch exxcel maxx dishwasher i plumbed it all in switched it on and first wash was perfect with no problems but since then i switch on and i get lots of noise but no water is being taken in but if i pour a bowl full of water inside then start it it runs ok any help plz\015
It could be a few things, one of them is a defective water inlet valve, the water inlet valve lets water enter the dishwasher from the main water line, another thing it could be is a defective float switch, the float switch rises up as water fills the dishwasher.
Repair Help & Product Troubleshooting for Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Dishwasher confused Dishwasher was switched off just after cycle commenced (tablet had been released). On restarting dishwasher, it wouldn't take in water and has just been going through the motions of the cycle without anything happening. Even when the power button on the machine is switched off or the door is opened, the motor continues to run but without water. Water is definitely switched on under sink. I think the computer is confused - can you please help?
I suspect this is nothing to do with switching off during the cycle.take the bottom plate off and check if there is water leaked into the bottom pan. alternatively, if you can, tilt the machine back to 45deg and see if water runs out.most ... Dishwashers
Kenmore Elite: - Stale smell from dishwasher, won't go away, lingers on dishes, glasses. I tried a vinegar remedy suggested by a diy site - it helps for a cycle or two, but the smell comes right back. Diy site suggested taking apart the dishwasher to see if there is food trapped: there always remains a little water at the end of each cycle - but I'm concerned about taking apart my dishwasher if there is another solution. Smell doesn't smell of food to me. What do you think? Hollie Smith
Try useing your heat to dry at the end of wash,or mabey take and blow your unit out with a compressor and attatchment especially the drain outlet. also run a cycle with just a little lime away then flush with a second rinse. ... Kenmore Dishwashers
My dishwasher takes water but does not start to wash it pumps the water out and takes new water and that's going forever
SOUNDS LIKE THOSE LITTLE ROACHES GOT INTO THE CIRCUIT BOARD AND FRIED IT.MAIN CIRCUIT BOARD HAS BEEN SHORTED OUT ... NEFF S54T09X1GB Fully-Intergrated Full Size Dishwasher
Have a Miele G1220SC dishwasher. It recently developed a strange problem: when switching it on ALL program lights come on and the machine starts taking water. after a while it stops taking water and starts to pump water, all the time all program indicators remain on. if you leave it on a while ( about 4 or 5 minutes) it is impossible to switch off the machine with the main switch, all you can do to stop it is unplug it. anyone experienced something like this and have any idea what part is malfun
Follow this steps and fix it. God bless you\012 \012 Heating Element\012 \012 \012 \012 \012 \012 \012 \012 \012 ... Miele Dishwashers
Dishwasher will not fill with water. I've already checked the float assembly, that seems to be working fine. The water just doesn't seem to run into the machine. Little history on an unrelated problem: I want to mentioned that not to long ago my brother tried to put a bunch of celery through the garbage disposal. The sinks and pipes got all clogged up and we had to take them apart to clear up. Immediately afterwards the dishwasher stopped filling with water. I don't see how the two can be r
Hi,\012Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher ... GE 24 in. GLD5500L Built-in Dishwasher
Hello everybody, I hope that you gona a give me some tips for repairing my dishwasher mashine. A few days ago, the error F2 appears on my dishwasher machine (Baucknecht GSI 5894) I checked the pump for the waste water is ok. the tap water is not taking in,I checked the hoses they are ok as well I turned off and on and same time pressed the button reset and choosing the programm on the dishwasher few seconds trying to start and again apperas F2 . Hopefully someone can help me. Best regard
Possible the inlet valve has given up and is not allowing water in.\012Also possible there is a slight leak enough to shut the water off (safety feature) - Check underneath for a float mechanism and any water there. ... Bauknecht Dishwashers
G661 SC My Dishwasher wouldn't take the water, and I had a Technician come by. He opened the right side of the dishwasher and said that I need to replace the large White Plastic Part that transfers the water from the hose to the inside of the dishwasher. Does anybody know the name of it, or where I can find one for this model?
It's called the water intake. They usually dont give too much trouble. Can you give more info on the symptoms please?\015\012Any lights flashing on the machine? If so which ones?\015\012Is any water at all coming in? or is the machine tot ... Miele 24 in. G656SCi Plus SS Built-in Dishwasher
Smeg dishwasher does not take water. all water supply
Smeg 612c does not drain all the water ,have to turn it forward a cycle to drain ... Smeg CSU2001 Built-in Dishwasher
After starting my dishwasher ADG 9340/1 (any program) and after pumping evt. (rest)water , the machine won't take fresh water in and gives an acoustic alarm ! After opening the dishwasher , I can see that the "Start"-led is blinking in sequences of six blinks . Can you give me please, a possible cause and/or solution to this problem !
Dishwasher overflows I have a Maytag PDB3600AWX dishwasher. The pump works well, pumps all water out of the tub when reaching the appropriate cycle state. However, it keeps taking in water when it's not running / turned on (e.g., overnight) and the tub starts overflowing, cuasing obvious leakages (to the basement). What part needs to be replaced? Thanks, C Artz
Sounds like you've got a problem with the water intake valve(s). If it takes on water without water running in the sink, that is where I would look. If it happens when you use the sink, then I would also check your drain hose placement ... Dishwashers
Can you please tell me where i can find a manual for dishwasher tisira l65x. we have just had it installed by landlord and it is not letting water through. we have checked the plumbing and it is fine but the dishwasher is not taking the water
Hi and weclome to FixYa, I am Kelly. \015\012\015\012This is a new unit..... Look inside the bottom tub area for a domed plastic float and remove the packing tape from it. (usually either front left or front center. Also if there is a f ... Dishwashers
Dishwasher model: se6 tie1 Fitted under kitchen work-top. Problem: After setting a program & switching on & closing door ? there is a normal sound from within but if door is opened there is no evidence of water being pumped in. I previously cleared food debris from the drainage pump area (including under the pump cover), checked the spray arms and checked the water supply was getting as far as the long in-take pipe. As it seems problematic to remove the (screwed in) dishwasher, I have not che
I have a Frigidaire dishwasher that is beginning to leak from the bottom. After taking off the lower front floor panel and looking under the unit, then pouring a bowl of water into the washer the water drips through unit onto the floor. What do you recommend? This is still an attractive dishwasher.
... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher
I have a Whirlpool DUC600 dishwasher. It was working fine until last night it refuse to take the water in....it will empty alright but will not take water in .......can u tell me what"s wrong?
Hi,\012Here is a tip that will help you to find out why water will not come into thedishwasher... Dishwasher Trouble No Water entering Dishwasher ... Dishwashers
We have Kenmore that is 7 years old. It is one of these models : 665.11072912; 665.11072913; 665.11072914: 665.11072922; 665.11072929. The dishwasher is making a very very loud sound, taking very long to run and is not cleaing dishes. Water is coming out and draining. Water is very hot. Could the filter be blocked and if so how do we access it to take a look and clean it out Candace
... Kenmore Dishwashers
My Siemens dishwasher takes 4+ hours to complete a cycle. The inlet water supply has been always COLD, which means that the dishwasher always managed to heat the water properly. What could be happening now?
... Siemens 24 in. SE53200 Built-In Dishwasher
In between wash cycles, water seems to back up into the dishwasher. I had a plumber take a look at the drain and disposal in the kitchen sink to see if there was an issue there. He suggested to have appliance repair tech to come look and indicated that he believed that the issue may be the "cylianoid" valve. Does the this valve prevent water from backing up into the dishwasher after it has drained?
... KitchenAid 24 in. KUDI02CRBS stainless Steel Built-in Dishwasher
When dishwasher is set to begin, sensor takes very long period of time. Cycles are longer than minutes indicated. Dishwasher fills with water but does not wash. Water then drains as though cycle is complete and moves to next cycle. Then the process continues. When cycle for drying is reached, much heat is given and occasionally it smells as though there is burning. A 82 minute procedure turns into hours.
... Kenmore 24 in. 16532 - Multiple Color Built-in Dishwasher
My Delonghi Dishwasher keeps turning off. The dishwasher is turned on at the power point. The water is turned on. Okay When I press the POWER botton on the front it wont stay on. I have to keep my finger on the POWER button and then press the START button for washer to work. If I do this it will then pump out any water in the bottom and start to work. ***BUT when you take your finger of the POWER button the washer just turns off and stops working. Do you have any idea what could be the problem p
Yes, the power button is faulty. by pressing the power button forcefully, you are in effect allowing the contacts to close. Replace it. ... Dishwashers
FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with
... Hotpoint 24 in. FDW60 Free-standing Dishwasher
Banging water pipes when dishwasher takes in water. This has happened only after I put a new shower in & I had an air lock. This has now gone. The dishwasher has an aqua stop, should this be primed
Hi friend \015\012\015\012show the good plubler its take $20 ur problem will sloves\015\012\015\0120 ... Dishwashers
Dishwasher does not take final rinse water
... Siemens 24 in. SE55A560 Built-in Dishwasher
Hi :) We have a Bosch slimline dishwasher type SRS56A02 GB/08 - it doesn't draw in water - the timer counts down but nothing happens. We checked these pages and cleaned the filters on the inlet water line but no change :( I saw that it might be the inlet water valve - is this easy to get to - do we need to take off panels? if so, is there a manual available please? Over the past week or so it had got noiser - it was at its quietest while the water was draining out of the machine.
The dishwasher takes water in (not to much as when you open the door later, there is hardly water visible) and then it sounds as if it is busy heating the water. Then all of a suddden it will trip the power switch on the distribution board. My impression is that it is not takingin enough water and the heating part causes the trip failure. Your comments and advice to resolve will be aapreciated. Planning to open it up this weekend (machine not that old)
Usually ,there will be a float in the bottom of a dishwasher that shuts down the waterflow when it has received enough water. it works just like the float in a toilet tank (if you are familiar with that) you are definitely on the correct path in thin ... Indesit Dishwashers
Overfill Hi Mark ,my Hotpoint BFI 62 at very first use ,takes water but in few minutes later water come out from floor and after that you can hear water drains out,Heavy Duty cycle light flashing rapidly,after some advice looked exactly source of water is from pipe connected to overflow system. That mean it is filling more than required,how it possible new Dishwasher never used before? Please help me to repair because we never try when I bought now is to late for company warranty. [email protected]
... Hotpoint 23 in. BFI62 Built-in Dishwasher