Having problems with your Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher ?

Hi can you tell me how much resistance i should have on a indesco 950H1I dishwasher motor please as it hums but doesnt spin,,,it is free turning


Answers :

Hi, it has 90 Ohms between red & blue, 70 Ohms between blue & black and finally 160 Ohms between red & black (total). Hope it still helps.
Repair Help & Product Troubleshooting for Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi can you tell me how much resistance i should have on a indesco 950H1I dishwasher motor please as it hums but doesnt spin,,,it is free turning


Hi, it has 90 Ohms between red & blue, 70 Ohms between blue & black and finally 160 Ohms between red & black (total). Hope it still helps. ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Maytag DWU6402AAB dishwasher hums but motor does not run. I've taken the inside apart down to the disk-shaped impeller. It turns freely so the pump and motor are not stuck. When control knob is turned motor hums at the places where it normally should run. The water valve & heating coil seem to be operationg normally. i assume the next step is to test the motor &/or motor relay. Is this correct and how do I do that?


... Dishwashers

I have an avanti dw 18 dishwasher . the problem i am having is the when i turn the on button on the motor goes on however no water fills up. The motor is only humming. But; when i press down the float from inside the machine the water fills up and the machine starts to work. after the water drains again the motor continues to run and hum and the dial does not move. when i manually move the dial nothing seems to change . the motor continues to only hum. Even when the dial is in the stop position


... Avanti Dishwashers

When i turn my Viking dishwasher on the motor starts to run but no water comes out. It was humming along for several hours before i realized that nothing was really happening. I turned it of and then tried again but the same thing happened. It sound like a motor and/or pump working but no water enters the chamber. Thanks, Jonathan


It sounds like the Water Supply Solenoid is bad. I would change that and let all of us know what happens. ... Dishwashers

My garbage disposal had something stuck in it. i did not know and the sink was backed up. i started the dishwasher and it sounded like the motor was running like a drain emptying...i thought it would stop but continued. i unplugged the dishwasher, freed the garbage disposal and the drain is now clear. i turned on the dishwasher and the sound is the same. the large POT light is lit up and when you try to shut it off it doesnt stop running. i unplugged it for fear of breaking something. HEL


Hello,Welcome to FixYa.Based on your post, the ... Asko D3251HDSS Stainless Steel Built-in Dishwasher

My 9-year old KitchenAid KUDS01LJ dishwasher will not begin a cycle. It will fill with water then there is just a loud humming sound. If I hit the stop button it will drain and shut off. I've checked the motor and it is not jammed and turns easily. Do you think the motor is shot?


... KitchenAid KUDS01IJ - Multiple Color Dishwasher

The dishwasher fills with water and heats the water but does nothing that requires the motor to turn. It turns easily with my finger rotating it, but not under its own power; no click, no hum no movement no nothing.


... Estate 24 in. TUD6700KQ / TUD6700KT / TUD6700KB Built-in Dishwasher

Dishwasher GU1500 Whirlpool--motor just hums and blades do not turn. Dishwasher fills correctly and drains well.


This strongly indicates the motor capacitor - normally mounted on or close to the motor. easy to replace and a cheap part. also possible motor seized - disconnect from mains and see if motor turns by hand ... Dishwashers

Hello I just borrowed a k archer k 2.87 water blaster from a friend and forgot to turn water on before starting motor. Motor stopped after a few seconds and now won't start. Online guide says to change fuse but nz version doesnt have fuse in plug. Do i have to take machine apart?HELP Please!


Most of the time it is the GFCI on the end of the plug that goes bad. If it were me I would cut off the GFCI and wire in a standard 120v plug. If it still doesn't work after that then there is a good chance that something electric internally has gone ... Karcher PSI Electric Pressure Washer

Dishwasher when turned to usual dial number hums enthusiastically but does nothing, no water, dial does not advance. If dial is advanced manually, some cold water is produced; dishwasher tablet is released but not dissovlved. All rotor arms and water intake areas are free of obstacles and blockage (as far as we can see). Any ideas?


Removed the filter and shopping for a replacement. An "in progress" report - not completely solved yet. ... Dishwashers

Our dishwasher works great other than it is as loud as a lawn mower, we have to turn up the tv when it is on. The dishwasher was very quiet when we first got it 3 yrs. ago and now it sounds like the motor is just very loud, please help!


Hello Wayne, based on the symptoms you are describing, it\012sounds like the unit could possibly have a faulty drain motor or pump. I\012suggest cleaning the dishwasher completely to see if it will reduce the noise\012level. Dishwashers have a glass ... Frigidaire Dishwashers

The motor makes a weird whirring loud noise but the gears seem to be turning still the arms are still turning and the water is going in fine it seems to be any time the dishwasher is on and in any cycle. please help!!!!


So it turns out that it was the disposer blades right behind the motor that were causing the problem. I took the filter off of the drain and found I had a piece of glass and a plastic army man gun trapped in the filter to the drain that the blades we ... GE GSC3400G Built-in Dishwasher

Hi, my LG LD2120WH dishwasher stopped working recently because of the detergent container being empty and the salt level too low. After replacing these the machine still doesnt want to start washing. The timer displays fine but doesnt count down either and the machine turns off after a couple of minutes. Please help.


... Dishwashers

Whirlpool dishwasher my dishwasher turns on and i can hear the motor but there doesnt seem to be any water going in


Hi jamesward,\015\012\015\012I'm Harvey the Master Plumber.\015\012\015\012Your problem is: Your dishwasher turns on and you can hear the motor but there doesnt seem to be any water going in \015\012\015\012This m ... Dishwashers

Dishwasher won't drain nor will the lower arm rotate and spray. When turned to the ON position it just makes a clank noise (like a motor is trying to turn on) and hum for a short bit. Nothing afterwards. There is water standing in the basin.


I don't know if this is unusual or not. But, I found A solution. Thinking about what I said in the problem descriptor, I disconnected the power to the dishwasher. Got to messing around with the electric motor and found it was seized up...don't kno ... Hotpoint 24 in. HDA1000G Built-in Dishwasher

I turn on the dishwasher and it just hums with no water spraying the dishes. I tried the sani wash cycle and it worked but just one time. Now every cycle is the same - turn it on and just the mild motor noise


... Miele 24 in. Novotronic G851SC Plus Built-In Dishwasher

I have a Kenmore Elite dishwasher (model 630.17303406) and it just stopped working. Doesn't drain what's left in the bottom and just makes a humming sound when turned on. Power is good, sounds like the motor is working. Doesn't seem like it is drawing water in. I want to check the pump and motor, anybody have any advice?


If nothing obvious like blocked / obstructed outlet pipe\015\012You need to check if the outlet pump motor in line with the outlet hose is spinning when in the outlet mode. First check if it is spinning by looking at it and see if the small fan ... Dishwashers

My Asko Dishwasher (5 year old) motor won't stop, only if I turn the power off from the wall. The motor continues to run even if I open the door. Any suggestions on what i need to do to get it working again please?


... Asko 24 in. D3121XL Free-standing Dishwasher

Hi there I have a LD-1204 Dishwasher and most of the time it works fine but every now and then it wont turn on or it will turn on but when I got to press start to start a wash it doesnt do anything. Can you help me please


... LG Dishwashers

Bosch SHU43 My Bosch SHU43C dishwasher stopped washing, turns out the impella came free from the motor, I repairded impella and put it back together and now the dishwasher washes great however now it is stuck in a wash rinse drain cycle. Display counts down but the unit never stops running when it reaches 0. Also, the water level is higher than normal and I there is a kind of thumping sound repeatedly every 15 seconds " use to make that sound only once at the start of a cycle before the impella


Sounds like the control module is out -- cost about $100 (I am on my third). I got a "lifetime" warranty when buying my second one. If you are handy, you can replace it yourself. You can call Bosch to confirm this (I did). It mounts inside the door. ... Bosch 24 in. SHU53 Built-in Dishwasher

My bellissimo dishwasher Model - VDW6SS-4 .. doesnt let me press start i turn it on and it just starts beeping then u hear the motor running but nothing happens, then it just stops :( what is the iss


... Dishwashers

Main motor does not turn it just hums - Dishwashers


Could be something has the motor in a bind like something lodged in between the impellers or could be the motor is bad ... Dishwashers

My avanti 18 dishwasher starts to work but then just before it reaches the next drawing on the wheel or knob thing it just stops, it sounds like its humming bu it freezes there and to actually wrk we have to manually turn it a bit to the next cycle so it continues to work. please help!


... Avanti Dishwashers

My GE dishwasher, model # gsd2230f00ww won't drain. The spray arm is working and i hear the motor. Checked both ends of drain hoses, very clean. took sum cover off, clean. checked float, fine. What could be the problem? solenoid? I turn the dial on the washer and the solenoid does nothing, should it make a noise to actuate the drainage? please help! Thank you


... GE Nautilus 24" Built-in Dishwasher

Kenmore model 16309. The dishwasher has power and water but the motor does not seem to be working. It hums for a second, but quits. The timer is working and the water seems to be coming in fine. but the arms are not turning. Any thoughts?


Hi\015\012\015\012 \015\012\015\012The timer is working, unit has power and it also fills\015\012water, all this indicate that it is the motor that is bad and should be replaced\015\012to solve this issue. Moreover, the hum sound ... Kenmore 24 in. 16309 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2425 seconds