Having problems with your Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher ?

Its wont start a new cycle

\015 My dishwasher is stuck in draining mode i cancel it to start new cycle nothing happening even when i open the door its draining even if there is no water in it help PLEASE\015

Answers :

Repair Help & Product Troubleshooting for Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 4 year old Maytag MDBH945AWW and the panel lights come on and I can select cycles... but the dishwasher wont start. I tried holding the start cancel button, tried turning the breaker off for a couple of hours, took the inner panel off the door and checked the latch, but its still wont start. Any other suggestions? If it needs a new control panel its probably better to just get a new similar dishwasher for $300, correct?


What you need to do is read for continuity and power across the door latch switch. (2 white wires) AND 2 Black wires Both wires must read continuty at the control panel connectors to the power source terminals for the unit to start. Since the co ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

Telmann dishwasher We have just moved into a new house with a Telmann TEL12DWMS dishwasher. The dishwasher will light up but wont start. Power and Rinse cycle lights light up but when you turn the dial it wont start. Any suggestions? Thank you


... Dishwashers

Kenmore undercounter dishwasher model 66517019400 wont start..I want to purchase a new control board do you think this is the problem? normal cycle light comes on, cancel button works, heat on button works, just wont start ??


It might not start because the water solenoid is failed, or the water level sensor is failed.\015\012\015\012You have to use a meter to test these components first. Put your voltmeter on the two leads going to the water solenoid, and psuh ... Kenmore Dishwashers

We put in a new garbage disposal and now our dishwasher wont workit starts each cycle we suggest, but the water does not run and the cycle does not move forward


Hi, \015\012\015\012Does the drain hose for your dishwasher connect to the disposer ? If so, has the knock out for the drain tube in the disposer been "knocked out" ?\015\012\015\012Check that and reply. We'll move forward from there if need be.\015\ ... Bosch 24 in. SHU43 Built-in Dishwasher

Stuck in clean cycle....clean light blinking but wont start new cycle


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Hi I have a DS605SS Fisher & Paykel Single Drawer dishwasher, I rent the house and the landlord says that it is quite new can you please confirm the year? Also when we turn it on it runs for like 20 minutes then stops then when you try to start the cycle up again it stops after a minute and wont start again.


Heeeyyy - these have been around for ages no one can tell you the age unless you bought it and know where it was bought from to trace the serial numbers...\012\012I fail to understand why this is your problem when you are renting the hous ... Fisher and Paykel DS605SS Built-in Dishwasher

Bosch sgv53e13gb Integrated dishwasher - wont start a new cycle!?


Thanks for the input Dicky...I think my dad will be onto the place of purchase first thing tomorrow!! ... Bosch 24 in. SGV53E03 Built-In Dishwasher

Electrolux dishwasher says clean but wont start new cycle


... Electrolux 24 in. EDW5500DSS Stainless Steel Built-in Dishwasher

Brand new haier hdc1804tw wont start. i press the power button unit beeps once and power light comes on but i cannot select cycles. unit will then beep every five minutes. i have made sure there's water and unit is level. i have left it unplugged for over five minutes with same resulting issue.


... Haier HDC1804TW Dishwasher

Bosch SMS4012 - E-NRSmS4012AU/11 FD7309041276not sure of its age but this dishwasher wont commence its cycle when I turn the left dial (but If I hold the handle latch up, it starts) there is no error code facility on this unit. Would it be worthwhile getting a technician to fix it or should i just buy a new one !! Thank you - Rena.


... Bosch Dishwashers

My ge dishwasher gsd4610x00ww wont start a new cycle the green light flashes on wash any assistance would be appreciated


Hi\015\012\015\012\015\012\015\012\015\012\015\012Thanks for using FixYa. This issue can be either due to\015\012a faulty door latch or door lock switch which is not engaging itself. And, if\015\012the door latch will not engage the ... Indesit 18 in. D41 Slim-Line Free-standing Dishwasher

Beko dsfn1530b wont start cycle all lights up but nothing happens has been moved while new kitchen fittedand worked fine before this


... Beko Dishwashers

The pump gets ride of water but wont turn off or start a new cycle


You will have a leak in the sump of the d/washer. Pull it out and tilt it back about 50 degrees. water will form at the back on the floor. Place flat again then retry by starting a program. If it works, you know the leak is the problem. Mostly it ... Tecnik Dishwashers

I cannot get my dishwasher to cancel the old cycle and start a new one. I opened the door when the last cycle was drying, and let the dishes air dry. I tried to press the START button until CL appeared, but the timer will not progress beyond 0.01 and I cannot start a new cycle. Help!


... Bosch SHE6AP05UC 24 in Builtin Dishwasher

I have a Whirlpool GU2275XTVY0 when I start the cycle on normal it will run for about 5 minutes then the power button starts flashing and wont run. It drains fine and starts fine just wont finish the cycle.


It might help if the wash arm had started moving when it shut off.\015\012\015\012Unless it is always exactly 5 minutes I would say perhaps the door switch is out of alignment. It might start ok when you engaged at time of closing door bu ... Whirlpool Gold GU2275XTV Builtin Dishwasher

Our GE dishwasher (5 yrs old, Model GLD4250L00CS) only fills with water half way when the unit is started. The inlet valve was replaced with a new one, but that did not solve the problem. When started, the dishwasher fill cycle runs for 41 seconds before the wash cycle begins. Repair workers told us we probably need a new ECU (Electronic Computer Unit). My questions are: Is 41 seconds the correct time for the fill cycle for our model? What else could be the reason for the unit not filling pr


Hello &\015\012Welcome to FixYa\015\012\015\012Check this\015\012 ... Dishwashers

I have a Kenmore Elite Dishwasher Model 665.172824000. We think it stopped part way throught the dry cycle. The green "Clean" light has been flashing since in 7 flash cycles non stop. I tried pushing the Cancel button, it starts the drain pump then stops and we are back to where we started. I tried to start a new wash cycle but when I close the door and push the start button it just give 3 quick red flashes and then nothing but the green clean light flashing again. I shut the breaker off fo


So sorry but the partsdirect site for sears locked down my computer. Check where the drain hose connects to your pump and see if there is a small device the hose connects to that has 2 wires going to it. If it does unplug the wires, turn power off, w ... Dishwashers

My built in Whirlpool adg 9340 washer won't start a cycle at all. It seems to start a cycle and after 1 minute it stops and it starts beeping. Also water remains on the bottom. As soon as the cycle starts it drains that water and brings new water in which stays there. It won't work for more than 1 minute....


... Dishwashers

New SHE4AM16UC, professionally installed eight months ago. Worked fine with very light usage until now. Dishwasher starts normally but stops and signals "clean" after less than five minutes on any cycle. One inch of water in bottom that (I think) drains when a new cycle starts. Soap tablets are not ejected from compartment. Bosch authorized repairman says he now has two client dishwashers with identical symptoms and is asking Bosch support for ideas (he's changed pump, control unit, and float sw


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the clean light flashes, pauses, and then repeats.\015\012When the dishwasher doesn't sense a water t ... Bosch SHE4AM16UC 24 in. Built-in Dishwasher

Cant start the wash cycle on my kenmore precision quiet standard dishwasher my wash cycle blinks and wont start the wash cycle


... Dishwashers

Whirlpool DWF417W, Type 12155 A couple of weeks ago the machine failed to empty, leaving dirty water in the machine at the end of the cycle. Start a new program it emptied & all was then well. A couple of days ago we started a wash cycle as normal, shut the door, the pump normally runs for about 10 seconds then the cycle starts. However the pump just runs continuously?? After looking here there seemed to be a few links to the subject of water being in the base & the anti flood switch being ac


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

Hi. I have a GE dishwasher and it is stuck at the rinse cycle, meaning when i try to start a new cycle, it starts at the rinse cycle rather from the prewash. i've tried to reset/clear the cycle many times but to no avail. thank you. it is a GE MONOGRAM ZBD 5900/5700.


Http://kitchen.manualsonline.com/mdownloads/35dcc834-139e-445e-95d0-d4cfc78d7bd5.pdf\015\012\015\012\015\012\015\ ... GE Dishwashers

4 cycle snowblower wont start


Clean the carb's insides. It's probably gooped up with gummy gas. I like B-12 Chem Tool. Its a spray cleaner from Auto Zone about $4. Others kinds are ok but this is good stuff. ... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1373 seconds