Having problems with your Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher ?

Water remains in the tub after the cycle is complete.

\015 The drain is not plugged. What is wrong and how can it be fixed?\015

Answers :

If you are sure that the soft disposal and drain are clear, then check the discharge hose to the sink and be sure it isn't kinked or otherwise obstructed. Also check the drain for the sink and be sure it isnn't partially plugged. If all ok, then look for an issue with the control board or pump.
Where pump located
Repair Help & Product Troubleshooting for Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Large amount of water remains in tub after completion of wash, water is draining out during cycle, dishes are cleaned, I can hear water being pumped out into sink drain as dishwater is going thru its cycle. The depth of the water is over one inch at the lowest part of tub. Water is not clean and has soap in it.


Hi.To start check the drain well, and also have a look at the drain hose at the back of the appliance.If the drain lines are OK, then you will need to replace the pressure switch, that determines when to stop pump from drainin ... GE Dishwashers

GE GSD4920Z dishwasher. Problem is that it does not drain completely at the end of the cycle--about an inch of water remains. After checking for clogs, etc, we followed a troubleshooting procedure which involves a hard reset (power off, then reset twice at beginning of cycle) and this procedure successfully drains the tub. However the next time that it's used on a normal cycle, water remains again. Suggestions?


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa.\015\012Dishwasher not draining properly or not draining at all issues can arise due\015\012to different reasons. Usually, these issues are related to kinked hoses,\015\012knocked o ... GE 24 in. GSD4920Z Built-in Dishwasher

Water remains in bottom of tub after cycle is complete.


... Dishwashers

MDB5600AWB dishwasher after the cycle has completed some water remains in the bottom of the tub.


Either the check valve located in the lower sump is plugged or not closing fully and letting waste water back in,or the sump is plugged with waste food,or the drain line to the sink is partially plugged ... Dishwashers

Dishwasher is not completing the cycle, and water remains in the tub. I've cleaned the filter and that doesn't seem to solve the problem.


The float ts on the bottom in the back of dishwasher pull racks out and look for it.There is a relay inside float that activates water flow re filling and emptying machine ... Dishwashers

Water remains in the tub after the cycle is complete.


If you are sure that the soft disposal and drain are clear, then check the discharge hose to the sink and be sure it isn't kinked or otherwise obstructed. Also check the drain for the sink and be sure it isnn't partially plugged. If all ok, then ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

I have a Bosch dishwasher that is about 4-6 years old (model SHU8805UC/U12). A few days ago I found clear water in the tub hours after the wash cycle had completed. I drained the tub by resetting the cycle as instructed in the user manual, but the tub gradually filled up with water again after several hours.. will replacing the inlet valve solve this issue?according to what I can tell for my model the water valve assembly (part No. AP3783031) is the part I need. How difficult and expensive


Just pulled mine out last night. You have a different model but it should be the same. Remove the bottom dress panel and detach your inlet hose from the water valve assembly (have a rag handy to catch a little water). Two torx screws on the front ... Dishwashers

Subject is Bosch dishwasher SHU6800. There is a soap residue left on dishes. Residue is not visible. Using two glasses taken from a recently completed wash cycle I rinsed one under tap water and then filled glass with tap water. The second was just filled with tap water. There is noticeable soap bubbling and foam in the second glass. Starting the 10 min rinse/hold cycle following completion of a full 60 min wash cycle results in considerble soap foam in the bottom of the tub. Have tried thr


WHAT IS WRONG WITH YOUR DISHWASHER? \015\012\015\012\015\012\015\012 \015\012For a detailed Dishwasher ill ... Dishwashers

Once cycle is complete, water remains at the bottom of the dishwasher (inside the dishwasher - level of water remaining up to the element/heater). Dishwasher GE Profile Model PDW7712J00BB Ser. TF615328A My question: How to eliminate all the water once cycle is over? Thank you, Nicole


... GE Dishwashers

EDW5500DSS wont completely drain water Okay so now that my dishwasher runs, when it finishes a cycle it has a nice puddle of water at the bottom that never drains completely out. I am assuming its a relay or something because I looked for a floating switch (did not find), I can hear a pump sound as if it wants to pump the remaining water out, but, it doesn't. I really want to solve this problem soon so I can order the new door seal and needed part together. Checked the line out and of course i


The srainer over the pump could be clogged not letting the water drain quick enough. Be sure the screen is cleane out. I believe you would have already checked and cleaned this. I believe it is the impeller on the pump that pumps the water that is ei ... Dishwashers

I have a kitchenaid dishwasher model number kudso2sr and there is standing water in the bottom of the unit after the cycle is complete. The water will not drain. I ran another cycle and the water still remained. Please help


You may have a vacume issuealong side of the dishwasher itself there is a loop of drain hose to create a trap - inspect. also inspect where it is hooked up & follow where the drain hose goes to it's final connection to be sure there are ... KitchenAid 24 in. KUDS02SR Built-in Dishwasher

It does not complete the cycle. It stops working after 90 minutes without completing the cycle. Cycle should be 115 min. according to manual. Washing light is flashing but it does not continue washing. A huge amount of water remains in bottom.


... Haier HDC1804TW Dishwasher

Water remains at bottom after dish cycle is complete . Dishes come out clean and everything seems normal except for the water that remains at the bottom of the dish washer. I realize that a small amount of water is usually there but this is too much.


Set the controls to off then power off at the mains for 30 mins and then power mains back on and run a drain program or a full wash program. If the water won’t drain away then the most likely problems are the door interlock switch is faul ... Whirlpool Dishwashers

My Frigidaire Model FDB2810LDC1 dishwasher will not stop running. Seems to complete a normal cycle and different cycles can be selected with normal time countdown but at end only rinse agent low light remains lit and sounds as if pump is still running. If opened, water appears to be streaming from rotator arms. Have cycled power but symptoms remain.


... Frigidaire Dishwashers

Water remains in drain after cycle is completed. Odor remains in unit before loading is complete (a day or two) before another wash...Normal?


Hi\015\012\015\012Thanks for using FixYa. Dishwasher not draining properly or not draining at all issues can arise due to some different reasons. Usually, these issues are related to kinked hoses, knocked out disposer unit (if connected w ... Bosch Dishwashers

My Brandt VF300 dishwasher is not draining properly. If I empty the residual water (by hand) I can still use it but the water still remains in the bottom at the end of each cycle. How can I fix this? It's driving me nuts! Also the door is not functioning properly something has broken that supports the weight of the door. It can only be shut completely or open completely! Is there a part that can be bought to fix this?


... Dishwashers

Having trouble with my 2 year old Kenmore Elite dishwasher, the water from the last cycle will not all drain out, inside of door is wet and water remains in bottom of dishwasher after cycle is complete


Check drain hose and air gap in sink. check filtes in unit inside ... Dishwashers

Water is not draining completely from the dishwasher. About 1-2 inches remain in the bottom. Seems to drain most of the water during the wash cycle, but a bit remains. Thoughts on how to fix this?


Either the check valve on the end of the drain hose that connects to the drainpump motor is closed shut or sometin is clogged inside the drain hose..... also maybe you pump motor assmbly is faulty... u prob need wet/dryshop vac and drain it out from ... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

Maytag Model MDB7160AWW S/N 10337613WQ Symptons: Fills with water OK, shuts off water OK, does not start any cycle, or drain. After a power off/power on reset, problem remains. Flashes CLEAN & LIGHT WASH. My understanding is this is an error condition for low motor current, which makes sense as the motor never starts. I know both door switches are good (I checked them with a DVM) and both engage when the door is closed. Tripping the water float switch opens the valve and water fills the tub


... Dishwashers

I have a Kenmore dishwasher, model 665.17019401 (serial number FS1002610). It goes through all cycles, drains out water, periodically, and dries the dishesat the end. But, when it ends, there is water at the bottom of the tub, at least 1 quart of water. I have to drain out the remaining water in the dishwasher. What is wrong?


Either the drain or screen is somewhat plugged, or a clog or jam in water pump. Many machines do leave just a little bit of water just so the sewer fumes don't come up. ... Kenmore Dishwashers

Water level What should the correct and/or optimum water level be in the tub of this dishwasher for proper operation? There is water in the bottom of the dishwasher after the cycle completes. 1)checked the hose, it is not kinked 2) not hooked up to a waste disposal. What else could it be??


Some water in the tub after the cycle is complete is normal. most dishwashers are time filled with a float switch as a safety device. the actual level depends on the fill time and the water pressure. what exactly is the d/w doing (or not doing) to ma ... Moyer Diebel 24 in. 501HT Built-in Dishwasher

Electrolux esl 6115 integrated dishwasher.Water not being pumped/ draining away. Have tried laying drain hose flat on the floor water drains away fine and water runs clear but with hose connected cycle does not complete and water remains in bottom of dishwasher. Is there a drain pump in this model


... Dishwashers

When I start the top drawer it defaults to 5 minutes (with the lights Heavy, Fast, Rinse highlighted) runs for a couple minutes, then stops and the LED starts randomly cycling through all kinds of codes very quickly. There is water in the tub that has not drained after completing the couple minutes of operation. This cycle repeats itself if I hit the power button again after the LED starts freaking out. The 5 min cycle shows in the LED, sometimes with the no circulation error, sometimes with the


Here is the solution: \015\012http://applianceguru.com/forum1/24814.html ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Ran the dishwasher and the water didn't drain completely. Checked the drain line for clog - it was clear. Scooped out the remaining water (barely covered the flat wire mesh filter in bottonm of the machine) and cleaned off the canister mesh filter and carefully relocked the filtyer in place. Tried to run the machine last night. Soap tray opened but apparently no water cycled through the machine as all the soap was in the bottom of the machine. The heat never turned on to dry the dishes and


Hello Ramona Doug,\015\012 Try disconnecting power from your dishwasher for a few minutes to clear the memory and then reapply power again. Start a wash cycle without dishes on the hottest water setting and after a few minutes.. pause the wash ... Bosch Dishwashers

My GE dishwasher after complete washed look like water not out drain (water remain in the tub)


Normally, there is a filter that precedes the pump and that's probably clogged with food by products. Look for the filter screen near the bottom of your dishwasher and remove any debris there. \015\012Another consideration is if your dishwasher ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1050 seconds