Having problems with your Bosch 24 in. SHV66A03 Built-in Dishwasher ?

Unable to turn off the delay start and the latch is in the wrong position so that the door will not close properly. Also, there is no digital display--it remains dark. I tried the cancel/drain, which didn't help. The machine seems to be running through all cycles fine.


Answers :

Pull the open handle to open the latch up and try to get it to close. Disconnect the power to the machine for a few minutes. Run a cycle that you don't usually run. See if that helps.
Repair Help & Product Troubleshooting for Bosch 24 in. SHV66A03 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Unable to turn off the delay start and the latch is in the wrong position so that the door will not close properly. Also, there is no digital display--it remains dark. I tried the cancel/drain, which didn't help. The machine seems to be running through all cycles fine.


Pull the open handle to open the latch up and try to get it to close. Disconnect the power to the machine for a few minutes. Run a cycle that you don't usually run. See if that helps. ... Bosch 24 in. SHV66A03 Built-in Dishwasher

We have a whirlpool quiet partner iii. It was working fine and was opened mid cycle. Then it wouldnt drain. Then all the lights started blinking. At some point it drained the water out. We flipped the breaker and now just the normal cycle light is flashing. Flipped breaker again that didnt work. Tried the reset code hi temp wash and heated dry. Normal light still blinking. Help please?


See this causes and fix it. God bles you\012 \012 \012 \012 \012 Check Fault Codes\012 \012 \012 \012 \012 \012 \012 \012 \012 ... Dishwashers

Help! My Whirlpool Quiet Partner II isn't working at all. Water was standing in bottom at end of last 2 cycles, but on the last cycle, I came home to clean looking dishes, standing water, and a machine that won't turn on at all- no lights on any buttons- nothing works. I've tried the reset codes published here and elsewhere, but there are no lights on any buttons at all. The circuit breaker is fine. I have 3 young kids and can't function long without my dishwasher!


There is a fuse in the control panel what your model# i can get you the part number its easy to replace it. ... Dishwashers

The dishwasher was not draining, I tried the baking soda & vinegar trick and it seemed to release the clog..now, it seems no water is being supplied to the machine during a wash cycle...it drains fine, no water and the rotating arms for the sprayer on the bottom of the tub don't seem to be moving..any help??


... Magic Chef 24 in. DU6550 Built-in Dishwasher

Bosch Dishwasher model : SHV4313GB/17 The machine won't switch off and the pump is still trying to drain water ( there is no water left in machine ) The cycle seems to have finished as it has made the beep sound as if it has finished. The dishwasher is still working even when you open the main door. Have tried to reset it but to no avail. Even after turning it off at the mains it still starts up again as if in mid cycle ! HELP PLEASE


I have a SHV. My sink drain backed up, and the water accumulating in the sink then migrated to the dishwasher, through the drain pipe, causing the dishwasher to fill up and, it turned out, overflow a little. When I turned on the dishwasher, the wat ... Dishwashers

I have an equator PLS600 and I can't seem to get it to work. I have tried the WikiFix to help a stalled dishwasher, by adding water and vinegar. When I put on the wash cycle it does not run. Even with the short rinse cycle, the sprayer will not move, and the machine will just run through the cycle until it starts to drain. Please help!!! Thanks =)


Give the spray arm a spin to make sure it rotates. It should spin freely. If not, remove plastic spray arm clip, flip it over, replace it, and try again. Make sure holes in the spray arm are clear of debris. Spray arm must be clean for it to spin ... Equator 20 in. PLS600 Free-Standing Dishwasher

My ariston lsv 66 dishwasher will not start washing cycle. It makes the pumping noise as it normally does at the start of the cycle and some water enters the bottom of the machine but then it stops. I have checked to make sure that there are no leaks so the problem is with the filling up of the machine. I live in a hard water area and haven't used anything to help reduce the limescale so expect this to be playing a part. I have tried all the washing cycles but the same thing happens. Any advic


HERE I AM I LIKE THIS JOBE\015\012 PLEASE CHECK THE WATER INLET FILTER I FEEL FROM YOUR DESCRIBE IS IT\015\012 YOU NEED TO CLEAN IT BY ASMALL BRUSH >\015\012 THANKS ... Dishwashers

Bosch dishwasher model SHV66A. New in 2004. Has worked well since then, but for last couple weeks something's up. Dishes aren't clean. Residue remains on everything. Food looks caked on & dried to plates. Silverware a little better but not much. Tried running a couple cycles with vinegar, no help. Took out strainers, etc. on bottom of washer & cleaned out; no help. Just ran a cycle now - - opened midway and it appeared the arms were both spinning. Also, water seemed warm (maybe not super


Hi\015\012\015\012If you are observing that the dishes are\015\012not clean, then you'll need to follow certain steps to be sure where exactly\015\012the issue. First thing to check for is\015\012the deter ... Bosch Dishwashers

Bosch Dishwasher SHV4313GB/17 Wont switch off ! The machine keeps running even when you open the door The pump is trying to drain water away (even though there is no water left in machine ) Have tried to reset it as instructed but to no avail. It has beeped like it has finished cycle but the pump wont switch off HELP PLEASE !


Introduction: This may work for your problem, but only if you're finding that you cannot get further water to flow into your machine. If your machine fills OK, then this ISN'T a solution to your problem. If your machine doesn't fill but your drain m ... Dishwashers

Viking dishwasher M# DFUD142-PSS drains a little bit only then starts refilling, start button is blinking. When pressing the 2 buttons to drain have to press several times until responding then it drains just fine, also no push button light is on when pressing for drain. After doing all this machine worked fine for one wash only, then the same problem again after the wash cycle the water stays in the machine. Please help, thank you


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers

Machine leaves a layer of suds after any programmed cycles. Tech tried changing the combi unit; tried adj rinse cycles. But still get suds when washing is finished. Need help.


... Miele CVA2660 Dishwasher

Ran the dishwasher and the water didn't drain completely. Checked the drain line for clog - it was clear. Scooped out the remaining water (barely covered the flat wire mesh filter in bottonm of the machine) and cleaned off the canister mesh filter and carefully relocked the filtyer in place. Tried to run the machine last night. Soap tray opened but apparently no water cycled through the machine as all the soap was in the bottom of the machine. The heat never turned on to dry the dishes and


Hello Ramona Doug,\015\012 Try disconnecting power from your dishwasher for a few minutes to clear the memory and then reapply power again. Start a wash cycle without dishes on the hottest water setting and after a few minutes.. pause the wash ... Bosch Dishwashers

Dishwasher flooding Hi my Asko D1716 Super Cleaning System Dishwasher has started to have a flooding problem. When the cycle finished last night it seemed fine then in the morning the machine was full of water, I scooped out the water and by this evening the machine had flooded onto the kitchen floor. I tried other solutions I found on this website but they didn't suit my dishwasher as it doesn't have the appropriate buttons. Any suggestions would be appreciated!


When you say that you tried other solutions.. it's hard to know which you've tried and which you haven't so I will suggest some basics first.. ( if you've tried them, then disregard)...\015\012Have you checked or addressed the following:\ ... Asko D1716 Built-in Dishwasher

I have a new FDB520RHS2A Frigidaire dishwasher which remains in the wash cycle after I've started it. It sounds as if it is changing cycles but the wash light stays lit and never switches to rinse. The machine continues to run for hours if I don't stop it. We've checked the drain to the garbage disposal and it is clear. the water temp seems to be hot enough but how do I check that? Any ideas on what we should check before we bring it back to the store? Your help is much appreciated. Thanks!


... Dishwashers

Frigidair model FDB520rHB2 Bought this brand new dishwasher and had it professionally installed. The unit seems to cycle fine, but after it's done, there is always a pile of detergent on the machine floor from where it dropped out of the dispenser. Plus the dishes are somewhat clean, but not all the way. I've tried all the trouble shooting that I could come across, but nothing seems to work. We have tried liquid, tablet and powder detergent with all the same results. Any ideas? Thanks


... Dishwashers

Have whirlpool gold dishwasher made in Mexico, the control lock light stays on, when i push it and hold it just blinks three times and then stays on steady and then does the same over and over, before it did this I noticed the lights for different cycles flashing randomly, and even pushing cancel button once in a while would start the machine up....I have tried to unplug the machine and then plug back in, but nothing is helping....any ideas??


... Whirlpool Dishwashers

Smeg df612 dishwasher problem, lights up as a e2 fault ,i have tried draining the dishwasher but still the same problem . the salt container is full of water is this normal?. and how do i reset the machine . ive tried pressing the programme button 4 times but it just shifts through the different cycles . can you help please/.


... Smeg Dishwashers

Whirlpool adp8540 - goes throught the wash cycle without the soap door opening, the water gets into the soap box, and the powder or tablet (I've tried all the brands) are wet but remain in the soap box. When I flick the level on the soap box, works just fine, just doesn't happen during the wash cycle.


Normally, the dispenser is waterproof when closed, so the detergent should not get wet. Most likely the actuator of the dispenser works and does open the door, but something is blocking it from opening all the way. Look for stuff not it its place, ie ... Whirlpool Dishwashers

Kenmore Elite: - Stale smell from dishwasher, won't go away, lingers on dishes, glasses. I tried a vinegar remedy suggested by a diy site - it helps for a cycle or two, but the smell comes right back. Diy site suggested taking apart the dishwasher to see if there is food trapped: there always remains a little water at the end of each cycle - but I'm concerned about taking apart my dishwasher if there is another solution. Smell doesn't smell of food to me. What do you think? Hollie Smith


Try useing your heat to dry at the end of wash,or mabey take and blow your unit out with a compressor and attatchment especially the drain outlet. also run a cycle with just a little lime away then flush with a second rinse. ... Kenmore Dishwashers

I have a Kenmore model 587.1610 dishwasher that doesn't fill all the way when starting a load. I checked the float switch and it is working fine. The fill soleniod is also working fine and is clean. It just seems to time out before it fills all the way.also to compound the problem it doesn't seem to want to start all the wash cycle even after I have re-started the machine and it has filled to capacity. please help thanks Danny


... Dishwashers

Our 8 year old integrated 2 draw dishwasher (top draw) has a problem on the rinse cycle and constantly beeps and water at the bottom of the draw remains. I have cleaned out all the grit and stuff residual water and tried to use again. But alas there appears to be a blockage still on the rinse cycle. Can you help or do I need to get a plumber? Thanks...Louise


Sorry i lost you my breaker tripped ... Dishwashers

I have a Diplomat ADP8242 Dishwasher that continues to run during its wash cycle. The machine starts and heats up correctly but will not switch to its rinse cycle and just keeps running with 2 intermitent beeps. I have tried to reset the programe which does pump the water out and resets the control panel, but unfortunatly does not clear the fault. Can you help?


... Dishwashers

Westinghouse SB915WJ is leaking cold water underneath machine. Working fine, just leaking water. Have changed door seal but it is still leaking. Also tried leveling it but this has not helped. Would like to access underneath and see if clamps are on tight but don't know how to access this part of machine.


... Westinghouse Dishwashers

So i have a maytag jetclean eq plus MDB7100AWW not sure how old it is as it was in my condo when i moved in 6yrs ago and there was no paperwork with it. The dishwasher worked fine until a couple days ago. The last load that i washed came out with a white film on everything, i checked the jetdry it was empty so i filled that and ran another load, everything was still covered in the white soapy film. So I tried running a dishwasher cleaning product through it, that didnt help, i tried running it w


... Maytag Dishwashers

My dishwasher is a swan sdw7030w, water is going in and out the machine but no water is getting through to man part wher dishes are, am putting it on and it's jumping from my choosen cycle to economy while beeping, the salt light and starish looking 1 are both on as well, can anyone help me? It was working fine n old house, could it possibly be my water pressure as I can't think of anything else as a woman. Please help me.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1738 seconds