Having problems with your Bosch 24 in. SHY66C02 / SHY66C06 Built-in Dishwasher ?

Tried to replace bosch soap dispenser model shu3036uc/u12

\015 Henry's appliance told us to just pry out the old one and pop the new one in. Once we did that the door does not open to release the soap and now the dishwasher leaks all over the floor. Is there a certian way the plug should be plugged in? Should the red or white wire be towards the top or does it matter?\015

Answers :

Repair Help & Product Troubleshooting for Bosch 24 in. SHY66C02 / SHY66C06 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Tried to replace bosch soap dispenser model shu3036uc/u12


... Bosch 24 in. SHY66C02 / SHY66C06 Built-in Dishwasher

After starting wash cycle the rotary dial advances to what appears to be the second phase and stops at about 1 oclock position. I replaced the timer/switch, same problem. Could I have a water temp sensing problem due to a poorly adhered sensor? I thought this may be the issue as the sensor at the water feed near the soap dispenser was loose on inspection. Model Bosch SHU4002UC/U06 Under counter Dishwasher


Check the thermostat sensor. If the sensor is faulty the amchine will not detect that the right temperature is reached and the cycle will not advance.The thermostat will read low ohms (about 1K) using a multimeter at Rx1 at ro ... Dishwashers

I have a KitchenAid but model # KUDI24SEWH1. Can not find it on your list although another model without the last letters 'WH1' is on it. Anyway, my nephew ordered the parts he said needed to be replaced. One was the top water feed tube and bearing which he had no problem replacing when the part came in. But, he is having a very difficult time opening up the front door to replace the soap dispenser. Removed the 6 screw (three on each side) and the two at the top of the door but that is as far


You don't Use the WH2 just the first 6 letters and numbers.\015\012Jim ... KitchenAid KUDI24SE Built-in Dishwasher

My new bosch dishwasher doesen't clean the top rack of glasses, ran it 3 times, no difference. also the soap dispenser opens up but the powdered detergent won't dissolve, the same soap has been in the dispenser for 3 cycles. i turned up the water heater temp to try to fix the problem it seems to have no effect. the dishwasher is 2 weeks old. could my water supply line be too small or are they a stndard size. thanks


... Bosch Dishwashers

Bosch SHU 3300. Soap dispenser not opening during cycle--and this is a brand new soap dispenser (old one would not stay closed in the beginning of cycle). Also had control panel replaced because old one started smoking.


... Bosch Dishwashers

My Kenmore model 665.16022401 has the problem w/ the clean light flashing. I tried the bottom combo of hi temp wash, heated dry, high temp wash, heated dry and it re-set my dishwasher but then after I tried to run a new load it doesn't seem like it finishes all the way through because there is still soap left in the soap dispenser and the dishes arn't all clean, plus the green clean light begins flashing again. Don't know what to do.


... Kenmore 24 in. 16022 Built-in Dishwasher

Bosch shx99a15uc - The soap dispenser was not working, I removed the door panel and noticed burnt circuits on the dispenser. I replaced the dispenser and have the same problem. What else could be causing the dispenser not to open?


... Bosch 24 in. SHX99A15UC Stainless Steel Dishwasher

Kenmore Tumble Action Washer, Model 417,44152400 LEAK! Leaky Door got progressively worse over a month. I replaced the boot and about 10 minutes into the first test wash there was a massive leak under the soap dispenser and down the hinge side of the door during a fill cycle that seemed to be going through the dispenser. This happened again during another fill through the dispenser. No leaks during subsequent fill through the boot hose, before the spin cycle and no leaks around the door


Any of those could be the problem. Theres no other way to diagnose and fix unless/until you open it back up. ... Dishwashers

Replace bosch shu 6800 soap dispenser


... Kenmore Dishwashers

Leaking dishwasher I have replaced the rubber grommet around the soap dispenser latch and have double checked it for leaks.It is not leaking and I suspect that was never my problem.The water is coming from the lower right hinge area.I do not qualify for the maytag recall.I have never used the rinse aid dispenser but find it peculiar that there is no rubber washer in sight.Could I have a bad door seal? Maytag Model #DWU7402AAB


Hi there, dishwasher leaking might be due to either of these causes, check these:Main tub sealNote… If the main motor of your dishwasher is mounted vertically, beneath the center bottom of the dishwasher, the foll ... Maytag 24 in. DWU7402 Built-in Dishwasher

On my bosch shu66 diswasher the error code indicates a number 1, aqua sensor I think. There is a screw missing in the soap dispensor and it's been letting water into the door interior. could this be repaired by replacement of the screw and drying out the interior insulation and wiring The solution I tried didn't clear the error code on the panel. Is there a reset or do I need to replace the aqua sensor or ? The machine still won't start and displays a #1 on display. There is no water in the whi


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a kenmore dishwasher model#665.17014400. the soap dispenser does not open in cycle. I replaced dispenser because of high ohm's reading ,but it still does not open. which is the next place to look?


... Kenmore 24 in. 17032 Built-in Dishwasher

I have a bosch dishwasher model number SGS0902GB/05. I use tablets instead of detergent. I put the tablet in the Dispenser and close the lid, noproblem. I then set the programme and shut the door, I usually set the programme to delay start so that it washes dishes in the small hours when all are in bed, however, when I have set the programme and close the door within a minute the dispenser assembly opens and the tablet falls into the dishwasher, I then try and put the tablet back in the dispe


Hello Andrew,\015\012\015\012I'm more than happy to give step-by-step instructions for replacing the detergent dispenser, however it's not cheap (about \302\24350) and it probably doesn't need to be replaced. Some of the smaller component ... Bosch Dishwashers

I am trying to replace the soap dispenser but cannot seem to separate the out side and inside panel to get to the dispenser, any suggestions?


Sometimes there is a piece of foam that is stuck in the insulation. it is there to make the dishwasher more quiet, you may have to pull on the outer panel and stick a long screwdriver between the panels to seperate them if you break the foam dont wor ... KitchenAid 24 in. KUDP01DL Built-in Dishwasher

Model EB2404SS/WW, the soap dispenser does not open during the wash cycle, replaced the actuator, still does not work, which circuit board is at fault, can the switch for the dispensor be replaced on the circuit board?


... Samsung Dishwashers

LG model LDS5811WW/02 has never cleaned the dishes since first installation. Put clean dishes in and they will come out dirty too! Have tried all dishwasher soap types and brands and drying agents. Always scrape and rinse dishes prior to loading. Dishes loaded various ways but problem remains. Repairman says unit is working fine. Also never dries dishes completely. Often leaves soap dispenser completely or partially filled. We are on a farm and have hard water but we have a softener/iron remover


If the soap/detergent isn't completely rinsing out of dispenser, it sounds like water isn't directed the top spray-arm. possible a defective vario motor; as it directs water to the water channel that supplies water to the middle and upper spray arms. ... LG LDF8812 Stainless Steel Built-in Dishwasher

The soap dispenser on my ASKO Model 1805 Dishwasher broke, we got a replacement part from ASKO but can't figure out how to get the old one off to replace it?


Hello,\015\012\015\012Remove the outer door panel, the screws around the edge hold it on. The soap cup will depending on serial break be held down with metal flanges or small screws. Bend the flange or remove the screws and push the soap dispe ... Dishwashers

KITCHEN AID STAINLESS DISHWASHER MODEL #kuds02frssWe just replaced both springs in the door and the latch mechanism and the soap dispenser that still does not work. Our door will not stay shut. MY HUSBAND NEEDS HELP.. PLEASE HELP. HE IS VERY GOOD AT REPAIRS AND IS STUMPED!!


Hi.Your husband must check wiring harness from electronic control to door lock solenoid.The solenoid should also be tested reading Ohms with a multimeter.Here parts and diagrams: ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

I have a Whirlpool Model GU2700xtsq dishwasher. The soap dispenser latch and catch broke off. Now it just stays open and won't close. What is the replacement part#?


Dispenser, Assembly (DISPENSER)\015\012 Part Number: PS2363019 ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

We have a 16 month old Bosch SHE 4AM15UC/01 model dishwasher. The soap dispenser doesn't open most of the time. Does not seem to be dirty or clogged. Any thoughts?


Check the soap door for free opening. No friction in the hinge. Otherwise there may be little alignment problem. You may have to access that the rely latch area and adjust !! ... Bosch Dishwashers

I have a whirlpool dishwasher model adp 5550 condenser. The dishes do not get clean. I have had a repair man out twice and he replaced the soap dispenser on Friday but it still doesn't work. I went to the store today and bought every cleaning things I could find for dishwashers and also started to investigate online myself. I took the arms off and cleaned them, I took the filter out and cleaned it, and then I noticed that the plastic bar that runs from the top, along the back and into the bottom


... Dishwashers

The little plastic arm that holds the soap dispenser closed on my model DU1055XTSD2 dishwasher broke off. I can't find the part to replace it.


Must get new soup dispenser ... Whirlpool 24 in. DU1050SS Built-in Dishwasher

I'm trying to take apart a kitchenaid dishwasher door model KUDP01ILWH0 to replace the dispenser assembly. I removed all the torx screws holding the outer and inner door panels together, but they don't want to separate. Anyone know what the trick is here? Thanks


You can get assembly diagrams of your system. Go to;\015\012http://www.appliancepartspros.com/partsearch/model.aspx?model_id=503 ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

How to replace a soap dispenser in a kenmore dishwasher, model #587.16193400


... Kenmore Dishwashers

We purchased an Electrolux Dishwasher Model #EWDW6505GBO, installed on 8/3/10, and we are very dissatisfied with it, as it just does not wash the dishes clean. We have had G.E. Dishwashers, two, since 1961, and then a Bosch, and they have all worked well. It appears that the water is not getting to the top and/or properly rinsing them. We rinse everything prior to putting the dishes in, but coffee cups come out with the ring around the top. The soap doesn't fully disolve. We have tried doub


... Electrolux Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1580 seconds