Having problems with your Bosch Dishwashers ?

Dishwasher cycles lasting too long

\015 My Bosch dishwasher runs, and cleans the dishes, but the cycles are too long. It will go through the cycles, it just runs 2-3-4 times longer than normal.\015\012\015\012I have figured out it has an instant water heater on it and I am suspecting that, but it is an expensive part and I hate to buy that only to learn it is something else.\015\012\015\012Any ideas appreciated.\015

Answers :

Good idea to look at the drainage system. If the system isn't draining, the system isn't going to proceed because the washer would flood. Look here for my guide on the drainage system and what to do to clear it. If it helps you, there is a guestbook I'd like to ask you to sign at the bottom.

Good Luck!
Repair Help & Product Troubleshooting for Bosch Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I used the "rinse only" cycle on the dishwasher a little while ago. I've never used this cycle before. After dinner I tried to start the dishwasher, but no other buttons on the panel respond except the last one I used, which is the rinse only cycle. I push and push, I tried pushing and holding, nothing works, I get no lights no anything. I've been using the "light wash" cycle for a long time and I normally just push the start button and the last cycle used starts automatically, so I wasn't a


Try un-plugging the dishwasher (check for cord under the sink) or turn off the breaker to it to re-set the control board. If this does not resolve your issue you may have a defective key panel. ... Dishwashers

During power scrub cycle which is the one we use most of the time the dishwasher stays at one minute fot a long time. the dishes come out clean and it finally does finish cycle just dont know why it takes so long on last minute of cycle for so long


It's just heating the water more ... Bosch 24 in. SHU43 Built-in Dishwasher

Help! My Whirlpool Quiet Partner II isn't working at all. Water was standing in bottom at end of last 2 cycles, but on the last cycle, I came home to clean looking dishes, standing water, and a machine that won't turn on at all- no lights on any buttons- nothing works. I've tried the reset codes published here and elsewhere, but there are no lights on any buttons at all. The circuit breaker is fine. I have 3 young kids and can't function long without my dishwasher!


There is a fuse in the control panel what your model# i can get you the part number its easy to replace it. ... Dishwashers

I have a smeg si 112 eco dishwasher cycle takes too long and last cycle water is not heating


... Smeg Dishwashers

I have a kitchenaid dishwasher model kuds24se with a problem. I MUST hit cancel before I hit start. Note that it doesn't matter how long it's been since the last cycle. It could be a few minutes or a day or more. I have to hit start to get a complete wash cycle. If I don't hit cancel, the washer goes through some sort of cycle and stops. It seems like a normal cycle but of course it is not because I don't hear any water and, upon completion, when I open the door there is heat but the soap dispen


... KitchenAid KUDS24SE Built-in Dishwasher

Our Miele Incognito dishwasher was installed in our new home in August, 2005. The wash/dry cycle has always taken a very long time - 5-6 hours is now the standard. So we have gotten accustomed to only running the dishwasher at over night. However, for the last few months, we've noticed the dishwasher is no longer drying well - we also need to finish drying the plates, glasses and silverware. Do you recommend we have a service call?


Yes, absolutely. The timer motor is not functioning right for it to stay on like that. Could be other control issues too. ... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

Dishwasher cycles lasting too long


Good idea to look at the drainage system. If the system isn't draining, the system isn't going to proceed because the washer would flood. Look ... Bosch Dishwashers

How long should the "normal" wash cycle last from start to finish on my Frigidaire FDB510LCS5 dishwasher?


... Dishwashers

Cycles last too long--Bosch dishwasher


... Dishwashers

I've had an ASKO 1996 dishwasher for about 9 years and in the last few days it has stopped cleaning effectively. The cycle seems to run normally but when finished, the dishes and glasses have a new film on them and generally feel and appear unclean. Is this just a filter problem? If so, how do I clean/replace it and why has it worked ok for so long? Thanks!


Hi, you may want to visit this link, but i will suggest to have a technician to check up on this . hope this helps ... Dishwashers

Our bosch dishwasher gets stuck on the last minute of the cycle ....says "1" for as long as we let it and we hear water swishing around and the dishes come out wet- we have to just stop it.


Hello,Welcome to FixYa.Based on your description "bosch dishwasher gets stuck on the last minute of the cycle ....says "1" for as l ... Bosch Dishwashers

Kitchaid superba dishwasher runs far too long. the 92 minute cycle can last 2.5 hours.


... KitchenAid 24 in. KUDS01DLSS Built-in Dishwasher

I have a Beko DWD5410W dishwasher. It has been working well for a couple of years now. Last week is stopped during a wash cycle and now when you switch it on, it fills with water to the top of the filters (as normal?) and stops. Nothing further happens no matter how long I wait unless I switch the machine to drain mode. Do you have any idea what the problem could be or how I can go about investigating further? Many thanks in anticipation


Hi, this is a control fault that is localized in the logic sector of the control board. the logic chip which holds all wash programing is damaged. you will need to replace the control asap if possible...thank u rate me ... Dishwashers

Drainage problem My dishwasher drains on every cycle except for the last rinse cycle, so I know it isn't clogged. I always have about an inch of water in the bottom of the dishwasher when it completes the last cycle.


My hotpoint dishwasher hda487a-01 is not pumping out the water ... Hotpoint 24 in. HDA3740G Built-in Dishwasher

We have a Bosch dishwasher model SHV46C03UC (4-5 years old). has always run well. It now appears to be stuck on last cycle (humms). When I went to unload the dishwasher, water had not drained out of last cycle. I turned it off and on, then ran it again - same thing happened. I checked filter in bottom of dishwasher and it was clean. Any ideas?


... Dishwashers

My dishwasher Siemens work corectly only on 30min cycle.When i use the other long cycles (cycle is very long ,more than normal for cycle)and their is water at the bottom of dishwasher at the end.Model : SL65560EU/21


... Siemens Dishwashers

The dishwasher cycle starts and gets 20-30 minutes in and then stops giving me the - - - like the door was opened, but it was not. If I use extra heated wash, the cycle stops at 63 minutes left. If I use the regular wash cycle, it stops at 43 minutes left. I have to click the resume button to get the dishwasher to complete the wash cycle. This has been happening evey time I use the dishwasher the last 2 weeks. It is Whirlpool dishwasher model GU2700XTSS! and is only 3.5 years old.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I suspect based on your description...\015\012\015\012"stops giving me the - - - like the door was opened, but it was not, I have to click the res ... Whirlpool Dishwashers

Frigidaire dishwasher won't end cycle - will run on and on for hours. Sometimes it cycles through, usually it just endlessly washes and rinses. I have to CANCEL the cycle, which causes the dishwasher to empty and run a few RINSE ONLY cycles (which are consistent, cycle time wise) to rinse the soap off of the dishes. Also, the door for the soap seems to stick - how long into the cycle before the soap door should open? Also, does opening the washer during it's cycle (to add more dishes) change or


I would say the resettable thermostat has failed. There is a thermostat which senses the water temperature, and when it fails, it causes the dishwasher to run constant. Replace the thermostat underneath the dishwasher and that should cure problem. P ... Frigidaire 24 in. FDBB540 Built-in Dishwasher

I have a kenmore ultra wash mod# 665.13492k600 dishwasher that in the last couple of days will not drain the last cycle . If you push the cancel /Drain button after the cycle is finished it will then drain but all the dishes have soap spots on them and are very wet .I have checked for clogs but cant find any I have also run a lot of water throug our waste disposla because the dishwasher drains into it help ??


... Kenmore Dishwashers

We have a Bosch SHE44C02UC/46 that suddenly won't start. I pushed the on/off button to start the dishes cleaning on the 'Power Scrub Plus' cycle and the display lights up with a 125 min. indication for the cleaning time, but the dishwasher never starts. It just sits there completely silent and never begins the cleaning. The dishwasher has worked perfectly up to, and including, the last cleaning cycle (3 days ago) for the last 4 years. Suddenly, today, nothing. Zip. Zilch. Nada. I don't get i


Hi.Re:" I\\'m sure it has to be something simple." A: yes, probably a fault, simple as that.To start there is a recall concerning this model. ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Kenmore dishwasher will not drain unless repeat the drain action of the last part of the cycle several times.


... Kenmore 24 in. 16994 Built-in Dishwasher

When dishwasher is set to begin, sensor takes very long period of time. Cycles are longer than minutes indicated. Dishwasher fills with water but does not wash. Water then drains as though cycle is complete and moves to next cycle. Then the process continues. When cycle for drying is reached, much heat is given and occasionally it smells as though there is burning. A 82 minute procedure turns into hours.


... Kenmore 24 in. 16532 - Multiple Color Built-in Dishwasher

My dishwasher runs 2 hours as a complete cycle. I think it is never going to finish but I have not stopped it in mid cycle. Dishes are very clean but they should when it runs this long. I hear it change cycles so I know it is not stuck on 1 cycle. It also makes a lot of noise. 2 hours of noise. HELP!!! How long it it suppose to run?


That means that the machine does not detect that one condition to continue the cycle is met.Sometimes\015\012 when this happen unesperience repairers replace the timer board , an \015\012expensive part that rarely fails. The timer b ... Whirlpool DU1055XTS Built-in Dishwasher

Hi - i have a Turbo dishwasher (made in Italy). It has a foul smell when you open the door, i ran an dishwasher cleaner through it on an emply cycle last week, was good after that, now stinks again. also the dishes are not drying properly, and when the cycle is finished, the dishwasher has lots of condensation inside. Thanks in advance.


Your heater system has stopped functioning.If you have a heated dry setting use it.If it does not work you will have to repair the heat system. ... Dishwashers

Kenmore Dishwasher Model 665.11643300 Cycle will not run. Normal Wash light blinking Cancel light will also blink (but can be cancelled by holding button down) I tried shutting down the power and resetting at the breaker. I tried other buttons like Air Dry, etc to see if there was some sort of sequence Note* last cycle ran was rinse cycle many months ago - house has been vacant and dishwasher has not been in use.


I will look a bit further in detail about your dishwasher problem. I am assuming you have checked the inlet water tap to the dishwasher is turned on. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1411 seconds