Having problems with your Bosch Dishwashers ?

Dishwasher without power

\015 I have a Bosch s10r1b dishwasher. Suddenly during its cycle it shut down. It appears to have no power at all now. What could be the problem?Sincerely\015

Answers :

Check the electrical source. Possibly the breaker blew or he plug went bad.
\015\012
\015\012The electrical load varies drastically during a cycle due to heater, motor, etc. If the breaker blew, ONLY reset it ONCE to try as there may have been a serious problem within the dishwasher. ALSO if the unit shares the power with another device that could cause the problem.
Repair Help & Product Troubleshooting for Bosch Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher confused Dishwasher was switched off just after cycle commenced (tablet had been released). On restarting dishwasher, it wouldn't take in water and has just been going through the motions of the cycle without anything happening. Even when the power button on the machine is switched off or the door is opened, the motor continues to run but without water. Water is definitely switched on under sink. I think the computer is confused - can you please help?


I suspect this is nothing to do with switching off during the cycle.take the bottom plate off and check if there is water leaked into the bottom pan. alternatively, if you can, tilt the machine back to 45deg and see if water runs out.most ... Dishwashers

We have just moved into this unit fitted with a MIDEA WQP12 - 9011B dishwasher with NO MANUAL. What can we do ? We have been using the dishwasher by turning the operating KNOB to a position and pushing in the POWER KNOB. The machine then goes through a cycle of 80 to 100 minutes but without an USER OPERATING MANUAL, we have no idea of whether the dishwasher is being operated correctly.


... Dishwashers

I have an Asko 1585 dishwasher. It drops the inlet valve on step (step 12), and the recirculation pump (next step) tries to pump with no water. Later at about step 47, the inlet valve begins to work again and the dishwasher finishes the cycle without a problem. I have had the board checked, and all of the power supply and transfer circuits are good. That leaves the processor. Is there any combination of buttons to press which can completely reset the controller board?


... Asko 24 in. 1585 Built-in Dishwasher

My dishwasher, Whirlpool IKEA DWH B10, has jammed on a setting. It is continually going and I can't stop it without turning the power off, but it starts up again if I turn the power back on.


... Whirlpool Dishwashers

Own a Frigidaire Dishwasher Model Number FDB4315LFSO and now after about 2 years suddenly the display will not light and function anything. Without pulling the power panel off the whole line circuit seems to have power as they have my disposal unit tied into same electric line and that runs and so does everything else and no breaker is tripped. Is their a reset somewhere to check or any ideas what can casue the display panel not to function any commands at all. Nick


... Dishwashers

FDB520RHS2 Dishwasher Same problem as posted. Dishwasher has power & water - control panel lights are on, when start is pressed the sound of a relay can be heard but nothing else happens - no water fill no cycle. Unit stays in this condition without running.


... Frigidaire FDB520RHS Full Console Dishwasher with 4 Wash Cycles 4 Wash Lev

Kenmore Ultra Wash Quiet Guard 4 Dishwasher model 665160344000 normal wash light keeps flashing. I have done all of the push this button and that button combinations I can find on the internet. I unplugged and repluged the 14 pin ribbon with power and without power --no joy. Looks like I need a new part - which part?


Hi\015\012\015\012Open the door. Within 3 seconds press the following sequence\015\012--Try pressing normal wash, heated dry, normal wash, heated dry, normal wash,\015\012heated dry three times within 6 seconds and then press cancel to re ... Dishwashers

Dishwasher without power


Check the electrical source. Possibly the breaker blew or he plug went bad. \015\012\015\012The electrical load varies drastically during a cycle due to heater, motor, etc. If the breaker blew, ONLY reset it ONCE to try as there may ha ... Bosch Dishwashers

I have a kitchen aid dishwasher that is not dispursing the water enough to clean. I have cleaned the entire unit with commercial cleaners and have added vinegar to the washer without dishes. And still it seems to not clean. It fills properly but the washer arms do not spin with any power.


You need to remove the wash arms by turning the nut in the centre of the arm and remove,then unblock the holes that are in the arms and replace them,test if the arms now turn and you can see a differance then also check there is salt in the salt disp ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

My Neff fully integrated S5409 dishwasher is not getting any inlet water. It has power and is trying to run any programme I try without water. I have checked the filters including the one where the aq


... Neff Dishwashers

Zanussi zsf6126 dishwasher showing fault 3, water inlet not opening, not receiving power to valve. tracing circuit without diagram have tested both level switches and valve but no fault found there. can you help please?


... Zanussi Dishwashers

Dishwasher stopped without fully draining water after all cleaning seems to have completed, probably in rinse cycle. There is no power to the appliance, although breaker on panel is on. Any thoughts?


If it is pluged into gfa plug it might be triped ... Whirlpool 24 in. GU940SCG Built-in Dishwasher

The fuse in the plug keeps blowing. Initially it would run for a while - sometimes 3 or 4 cycles - before blowing. It now blows the fuse the second that I plug in to the socket, even with the on/off button on the front of the dishwasher set to off.I'm keen to take it apart, but it's full of water as it blew mid-cycle. Is there a clever way to empty the machine without the power being on, or do I need bits of hose and sponges?A schematic blow up would also be extremely helpful.


Lower the outlet hose into a washing up bowl, it should then Drain. Check the heater to see if it is earthing you get to it by removing the right hand side panel. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I am renting a house with an old dishwasher in it. It powers up and sounds like the pump comes on but I need a manual to figure it out. I don't wantt to pull it out from under the counter without a manual or something. It is a Kenmore model # 587.1430590. Can you help me?


... Kenmore Dishwashers

Have a frigidaire dishwasher (model- PLD4375RFC0)about 2 years old. Set to run as we left to go out of town- when we came back all lights flashing including error- found a child's plastic bowl that had fallen to the bottom and had a melted spot as it was next to the heating element. Called support and were told to master restart- shut the power off for 15 minutes. Did and now flashing "27". Cannot find a code for that and neither could support without sending out a repairman. Any advice before


... Frigidaire Dishwashers

Bosch Dishwasher SHX56B05UC won't turn on after working fine everyday for almost 5 years. Checked circuit is fine. Disposal is running which is in same line. It won't turn on with power button today. It worked until now without any problem. What should I look for. Called a repair person but it will cost me $105/half-hour for the repair visit.


... Bosch 24 in. SHX46B05 Stainless Steel Built-in Dishwasher

Both spray arms of my DU943PWKQ0 do not turn or spray. The motor is moving and the it drains without problem. During the wash and rinse cycle I can hear the sound of water, however it doesn't clean at all and the sprays arms stay where they were. It seems the motor only creates no spray, but wave. I powered cycled the dishwasher, the problem remains the same. Anyone know what's wrong with it? Thanks James


Try rotating the spray arms by hand. It should rotate freely. If possible clean the arm rotating place by removing them.Arms rotate by by pump pressure only. finally check the water pump also. ... Whirlpool DU943PWK - Multiple Color Built-in Dishwasher

Got a Indesit Di620 Dishwasher that trips RCD after power up & immediateley as you shut door.Fault is definately related to pressure switch, disconnected pipe to switch and then able to start cycle, without tripping, small amount of water out of pipe,but cycle only lasts for a few minutes, then stops. ( blowing into pressure switch trips rcd )How can i test switch, or is it a water level problem ??Any help would be good, thanks S.C


... Dishwashers

Indesit dishwasher will not start a cycle and the first (pre-wash) light keeps flashing. I have tried different cycles and switching the power off and restarting without success. Any suggestions?


... Indesit Dishwashers

I have the "rinse" error code on my kitchenaid double drawer dishwasher kudd01dppa1. I've turned off the power, then it worked for one load and the code reappeared on both drawers again. What should be a next step? it says in the manual that the "rinse" error code means that something happened to the flood switch...? Can this be fixed without calling out the kitchenaid technicians? thanks


... KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher

Dishwasher I have had above integrated dishwasher which is intermittently tripping the mains fuse. Power is getting to dishwasher and the washing cycles work until a certain point (not the same time) where a loud bang can be heard and the main fuse is tripped. Reset the main fuse and power still gets to the dishwasher and it works again. It has just started to trip the fuse when its not running any cycle (just when power is getting to it). I've checked the fuse on the spur and it looks ok. I hav


Its quite common for the interferance filter to fail on these models its situated in the base of the dishwasher connected to the mains block usually when they fail you can see black dust around it, ... Neff 24 in. S5456 Built-in Dishwasher

Opened door and unit did not have electrical power (lights did not come on either unit). Called serviceman. He stated there was no electricity to unit(s). Called electrican. He stated wiring to the dishwasher had power. Called serviceman again. He came out and dishwasher worked. He did nothing to it. I opened the door and the lights(buttons) came on. Unit worked for a few days and this morning, there was again, no power to the unit. What is likely wrong with this dishwasher?


... Fisher DD603B / DD603W / DD603H Dishwasher

My dishwasher stop working in the middle of washing cycle. The water has not drained out completely. I attempted to restart the dishwasher but it appears there is no power. I checked the power auto swithch/fuze on the master fuze board. There is still no power going through the dishwasher.


... Dishwashers

I have no power to the dishwasher. I tried the circuit breaker, flipped it. No lights on, nothing. It must have been running when the power might have gone off, may be the power surged or something and it wasn't able to finish running the cycle. I have taken out all my dishes and washed them by hand but I still have water standing in the bottom of the dishwasher. I am a mechanically challenged mom and my husband won't be getting home for two more weeks. The dishwasher is a WhirlPool Gold Quiet


First check and make sure that the units not on a switched receptacle(and is wired into this circuit(i know the dishwasher is "hard-wired",as in the unit doesn't have a plug on it,but it could have been wired into this switched circuit by mistake) un ... Whirlpool Dishwashers

Frigidaire dishwasher model-GLD2445RFC0- PF code came on and then lost power to dishwasher. No power to dishwasher for 3 days now. Outlet is good and has power and circuit breaker is also OK.


PF flashes \015\012 if the washer loses power during a running cycle. If you have PF code and machine has power, \015\012 just press START to continue the cycle from the moment that power \0 ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1648 seconds