Having problems with your Bosch Dishwashers ?

Sanitized Light Fails to Light - Bosch Model # SHE55P02UC

\015 I have a new Bosch Dishwasher Model # SHE55P02UC. The Sanitized light does not light up at the end of the cycle. The problem occurs even after I have had a new control panel installed and set the house hot water to under 120 degrees as instructed in the manual (117 degrees actual tested temperature). The sanitized light fails to come on regardless of the cycle chosen, including Power Scrub. It also fails with the Extra Dry Heat Option set to ON or OFF.\015

Answers :

Being under warranty the Best solution is to make them do the repair however, it appears you are getting repairman that are not familiar with the machine. You had the control board replaced but did he check the light to make sure it has not gone faulty? Nothing more irritating than doing all sorts of repairs and finding out that bulb was burned out. I realize this is most likely a Diode but it can still fault out. If the heating element is actually heating up and your water temp is correct or within range as needed then the problem has to be in the circuit that actuates it. When the washer goes into Sanitize mode it actually uses the heating element to heat the water to 212+ degrees to sanitize your dishes. There should be 2 circuit boards and it is possible that the wrong board was replaced. If there is a fault on the secondary board it may cause a mis-diagnoses by the repairman. If the heating element is actually working the fault has to be in the temperature sensor or one of the circuit boards. Having replaced the one board already look at replacing the second board but first make sure the light is actually working.
When the wash cycles are complete, the “Sanitized” indicator on your dishwasher control panel will illuminate. However, if your household water supply is too hot your dishwasher’s heating time may be reduced, and the Sanitized message may not show. As your water input temp is 117 def F there should be no problem. This means that the input water temperature sensor may be defective. This can be proven if you reduced the water input temperature to 100 deg F to 110 deg F and see if the Sanitise light comes on as it should.
\015\012
\015\012As the machine is new you should go back to Bosch, or whoever you bought the unit from, and ask them to come back out and fix it for you under warranty as it obviously worked OK until they replaced the control panel. It may only be a case of loose wiring or a loose connector.
Repair Help & Product Troubleshooting for Bosch Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Sanitized Light Fails to Light - Bosch Model # SHE55P02UC


Being under warranty the Best solution is to make them do the repair however, it appears you are getting repairman that are not familiar with the machine. You had the control board replaced but did he check the light to make sure it has not gone fau ... Bosch Dishwashers

My bosch dishwasher model shu33a keeps running.At first the sanitized light would not light now it just keeps running and when i open the door its not real hot like before..the washer is only 3 years old.


Change the control module. check to see if there is a recall on this module. bosch will tell you if it is.give them model # and serial #. by the way if the modell is arecall you will get a free fix. let me know if this info helps, ... Bosch 23 in. SHU33A Built-In Dishwasher

My Bosch dishwasher stays running in the wash cycle, will not shut down or dry and sanitize the dishes.Checking the fault codes both the power scrub and the reg wash lights flash. Model SHU33A02UC


A solution to this problem would be to sell me your dishwasher. The law \012firm for which I work is looking to acquire an old unrepaired Bosch SHU \01233 dishwasher for some ongoing litigation. If you (or anyone else with \012this model Bosch) could ... Bosch 24 in. SHX33A02 / SHX33A06 Free-standing Dishwasher

Bosch Dishwasher model SHU33AO6UC/22 The sanitation light doesent come on


... Dishwashers

The sanitize light on my Bosch dishwasher no longer comes on and the dishes are not dry. Model # SHX33A05UC/43. I took apart everything and cleaned it well


... Bosch Evolution 300 SHE33M05UC Stainless Steel Built-in Dishwasher

BOSCH Dishwasher model: SHE44C (or 46C). I opened door in middle of cycle. Went back several hours later to unload and discovered it had not completed cycle and failed to drain. It would appear there is no electric to machine. Checked breaker, good, depressed the 2 buttons on front panel and nothing happens. Nothing lights up. We cannot locate a schematic.


... Dishwashers

Bosch dishwasher model she43p25uc/64 sanitize light not coming on and dishes are not dry


... Bosch Dishwashers

How to check the sanitized light on a bosch dish washer model SHE44C


... Bosch Dishwashers

Bosch dishwasher stuck on '1'/restarts & sanitize not lighting


It possibly could be a bad soldier joint on the heater relay of the circuit board. but if it is then let an authorized bsh tech replace the board since that is a 5 year warrenty part usually. it also could be problem with the NTC-HEAT ASSY- OR FLOW C ... Bosch Dishwashers

My Bosch dishwasher, model SHE58C did not completely drain. We were eventually able to use the cancel cycle/drain procedure to get the machine mostly drained, but now all the lights are lit on the panel, and the count down display is 11. I haven't figured out how to reset. I have tried to hit "Cancel drain" and turn on the machine to get into diagnostic mode, but I can't figure out what the codes & light combinations mean because my model is not in any of the online sources I've found


I have managed to pick up typical diagnostic error codes for a bosch dishwasher - these are\015\012\015\0120 = No faults detected 2 = Heating fault 8 = NTC (temperature sensor) fault\015\0121 = Aqua Se ... Bosch Evolution 800 SHE58C05UC Stainless Steel Built-in Dishwasher

Bosch Exxcel Auto Option, 2004. SGS56E02 GB/47 Stopped mid program all program lights flashing, on re-set several program lights illuminated, able to select rinse program but several lights illuminated and fails to pump out at end of rinse. What has gone wrong?


... Bosch 24 in. SGS57E02 / SGS57E08 Exxcel Free-standing Dishwasher

We have a Bosch dishwasher SHX46A06 UC/21. It continually runs. We couldn't find a diagnostic test for our model, but we did for another model. We held down the power scrub and regular wash cycles then turned it on and pressed them again. The delicate/econo light started blinking. Looking at some of the blogs, most often it seems to be the heater or the control panel - does this diagnostic test help to pinpoint what could be wrong? Also, where can we find a good manual for our model - we're havi


Here is a link to the service manual http://cgi.ebay.com/Bosch-Dishwasher-Service-Repair-Manual-/250480379703. \015\012 ... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

Water does not drain from Bosch Model SHX33A05 dishwasher. When trying to initiate Cancel/Drain (pushing simultaneously the 2 outer buttons) the 2 lights do not light up simultaneously - instead, Rinse&Hold and Clean lights come up.


I pulled the unit out and it turned out that the contractor pinched the drain hose between the back of the unit and the wall. Before, I was erroneously informed that the unit went through a complete washing cycle OK after the installation, so I did n ... Bosch Dishwashers

Bosch Exxcel model number SGS46E12GB had the check water light on a week ago, checked supply and cleaned filters, all good. light still on, got upset and slammed the door, light off. since then the unit will either wash stuff, or not. didn't seem the arms were spraying very well when I opened the door, so I bypassed the door switch tonight and put it through a pre rinse cycle. (I ran it with the bottom filters removed) upshot is the pressure of water was really poor. also, when I first turned


... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Bosch Dishwasher I have just moved into my flat where there is a Bosch dishwaher installed in the kitchen. I have tried on a number of times to get the dishwasher to start a programme but for some reason it fails to start. It does switch on but I dont know how to operate it. I dont have a manual for it so have not a clue what to press to get the programmes running. I would be grateful if you could help. Bosch Dishwasher logixx Model Number SGS6952GB/13 Installed 2001


Dear Saps,\015\012Go to https://portal.bsh-partner.com/portal(bD1kZSZjPTAwOQ==)/PORTALFRAME.HTM for a pdf download for an Intr ... Dishwashers

Here again is my model and serial it stops in the middle of the cleaning cycle Kenmore 665.16773402 serial # ft0302854 Here is how I have been resetting the dishwasher. I hit the following sequence of buttons: Normal Wash Heated Dry Normal Wash Heated Dry Normal Wash After that ? all the lights are lit up as follows: Smart Wash, Pots Pans, Normal Wash, China Gentle, Turbo Zone, Hi Temp Wash, Sani Rinse, Heated Dry, Sanitized (Green light ? not a button), Lock on (Red Light ? no


Door latch.Open and close the door to make sure the door latch is securely fastened\015\012 \015\012Hi-Temp Wash, Hi-Temp Rinse, or Sanitize options.Some models have options that may requi ... Dishwashers

Bosch Dishwasher SHU33-Long Cycle, no Sanitize Light


... Bosch SHU3306UC Built-in Dishwasher

Maytag MDBH965AWQ I have a Maytag dishwasher model number MDBH965AWQ. A few weeks ago the clean and sanitized lights would not go off after the door had been left open for over 30 seconds. Then last week, the diswasher would shut off in mid cycle and all lights would turn off with water still in the dishwasher. Today, I noticed that I am able to open the dishwasher door while the dishwasher is running and it will continue to run like the door was never opened. Now it is starting to trip the brea


2 items in need of testing are the door switch - and the main controller board/timer unit.CLIC ... Maytag 24 in. MDBH965AW Built-in Dishwasher

Bosch diswasher Turn dishwasher on lights that are showing are heavy duty wash, sanitize and clean lights. Just beeps like a load is completed - tried reset by holding down start button, etc.. Not able to even change cycles - only button that works is the on/off button


... Bosch SHX3AR75UC Ascenta Series 24 In. Stainless Steel Bar Handle Built-In Dishwasher

Bosch SHX45P05UC: i see from other forums this model often overflows within a year of being installed. Customers must make modifications to the drain system to accommodate the company's failed design. Is there a fix for an overflowing bosch dishwasher in the filter system, to eliminate the larger particles of food from lodging in the machine's drain/pump system?


... Bosch SHX45P05UC Dishwasher

My maytag dishwasher model MDBH979AWB3 is new. the sanitize light flickers when pushed then does not stay on. the sanitize cycle does not run.


... Maytag Dishwashers

Bosch dishwasher model # SHX43C05UC/46. How do the lights on the front supose to work. I only get red lights when I open door during use.


... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Bosch SD1306B dishwasher and cannot see the "normal" salt compartment. Does this model not need salt? Is the logo that looks like an eyelash the symbol for the descaler fluid for keeping the glasses shiny? The light is on there. Sorry for the simple questions but I have no manual for the dishwasher and its my first Bosch. Many Thanks Neil Fraser


... Bosch Dishwashers

Bosch SHX43P1 doesn't dry and I have increased the setting on rinse agent. It has a sanitize light but not sure how to make it sanitize. Dishes are clean but not dry.


Check heater & blower inside. contact service center for help. ... Bosch SHX43P1 Builtin Dishwasher

I have a model FDB2310LCC2 dishwasher and it won't turn on. The column cycle lights washing cleaning drying and sanitizing are all blinking simultaneously along with the "high temp wash" light. I de-energized the circuit breaker for approx. 1 minute then re-energized and no difference is noted. Any ideas?


This may be a problem with the door interlock switches. You will need to shut off power to the dishwasher, unscrew the control panel and remove the wires to the door switch ( make note of where the wires go on the switches) and check the switches wit ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1430 seconds