Having problems with your Bosch Dishwashers ?

I have a Bosch SL1501B dishwasher. When we try to use it is it saying to check water. It is really cold just now and was -7 last night. Do you think it could vbe frozen?


Answers :

If there are problems with water supply elsewhere in the house, then it could be due to frozen pipes.

If the machine has just been installed, then check that the stop valve on the feed pipe has been opened.
Repair Help & Product Troubleshooting for Bosch Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Bosch SL1501B dishwasher. When we try to use it is it saying to check water. It is really cold just now and was -7 last night. Do you think it could vbe frozen?


If there are problems with water supply elsewhere in the house, then it could be due to frozen pipes.If the machine has just been installed, then check that the stop valve on the feed pipe has been opened. ... Bosch Dishwashers

Maytag mdb9150 dishwasher stopped at some point last night--found it this morning with flashing lights--I think "clean" and "heated dry", not sure.  I used "drain/off" to make sure there was mechanical noise--there was, so I don't think the machine is dead.  Purchased on 2001 with 5 year warranty, so out of luck there.  I tried turning off the electricity to the unit for a few hours; nothing improved.  When you start it (or think you have!) it makes noises for about a minute that sound promising


Check pump and solonoids click/work, if no mechanical noise, could be the circuit board, but they can be expensive. :(\015\012if the solenoids click, and allows water in, then the pump might be jammed, with grit, clean and reinstall... good luc ... Maytag 24 in. MDB9150A Built-in Dishwasher

Ultra Wash Hi, When I got up this morning, I noticed the dishes were still dirty and dry??  The soap dispenser had popped open but that was about it.  I had some work done on it because it wasn't cleaning the dishes properly about a year ago and they replaced the motor.  While cleaning the kitchen last night, I heard it come on, but now that I think about it, I never actually heard the water start sloshing around. I don't have the owner's manual - I bought this house 3 years ago and I think the


Sounds like your not getting water to it. Turn on and let run for a few minutes then open door and check to see if you have water in it. If not check to be sure water to it is turned on. Check float in front corner of dishwasher to see if mo ... Kenmore 24 in. 15689 Built-in Dishwasher

My Kenmore Elite dishwasher did not drain the water out of the bottom after the dishes were washed last night. Could I possibly have pushed a wrong button to keep it from draining, or do I have a problem? All the dishes were clean. Should I run it through another wash cycle? I've got water standing in the bottom of my dishwasher.


Yes , If the program controller has hung it would have skipped the drain cycle. So try to redo the cycle and see if the drain works, is not check the program controller and the drain valve/pump.- if there is food particles that have clogged and block ... Kenmore Dishwashers

Have spent $300 in the last week on Haier HDW101ss repairs. It still isnt fixed. The repair guy 'thinks' it is now a faulty timer. The unit hangs at certain points in the cycle. At these points the timer (ticking) noise stops but the machine carries on washing. It will hang at this point indefinately. I have taken the timer out, and it looks brand new (the unit is only 4yr old). Any advise, does this sound like a timer issue, or could it be something else? Where can i source a cheap (2nd hand)


... Haier Dishwashers

We recently purchased a Whirlpool ADP 4736 dishwasher, and just last night while it was working the fuse just blew, and we heard a popping sound at the back of the washer. We tried to replace the fuse, but the same problem. rnAlso, there a lot of water has collected at the bottom of the washer, although the dishes have been cleaned and dry. What could be the problem and the solution for this. All the instructions are in Polish and made in Poland. Please advise?? Many thanks Percy'


... Whirlpool 33 in. ADP6830 Free-Standing Dishwasher

I have a KitchenAid KDS-17E dishwasher, which has worked well since I acquired it second-hand in 1984. Last night it ran continuously, stuck in the prewash part of fullcycle, with water being pumped through the system, and was fairly warm in the morning. It drained normally when I pressed the Cancel/drain button. I tried the machine again in full cycle. After 20 minutes it was still stuck in prewash, with the water temperature about 42 C, so I stopped it. Machine is connected to cold wate


Your problem is a bad timer.and you really got your moneys worth on this dishwasher.The timers useally go much soon than this one 7-8 years is the norm.The timer gets stuck in one position is a good sign its loseing its ability to fuction normally, ... Dishwashers

Kenmore we have a kenmore 665.1376 that is just over a year old. last night after about 15-30 min it shut down. there is water standing in the bottom but i don't think the float shut it off. checked the power breaker and everything seems fine there.


... Kenmore 15073 Stainless Steel Built-in Dishwasher

Hi, I have an AEG Favorit 525 dishwasher. It's over 20 years old, but has a panel on the front which matches the kitchen and it has done stirling service over the years. Lately, the knob has been sticking a bit mid cycle, but it has been intermittent. Last night, although the dishwasher sounds like it is working properly, it is not filling with water. Motor sounds like it is trying, but to no avail. If it was human, I would say prostate issues, but I don't think dishwashers have those. A


... AEG Dishwashers

I have been negligent in not cleaning out the filters and after the unit more or less stopped, I pulled the two filters finding them full of what looked like soap scum. I cleaned them best I could (but noticed the inner filter still had most of the small holes blocked) Started the unit and it cleaned alright for a couple of days. Last night after running a load all the water did not empty from the bottom of the tub? Any suggestion on what wrong? Bought the unit on 1/19/05. Thanks


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

Hi, I Have a whirlpool dishwasher ADP 6515 and working fine for the past three years. Just last night, the dishwasher started initially but then stopped as water not draining. Flashing green light. Not sure what it means. Could you please help and tell me how to fix it.


... Dishwashers

Hi I have a brand new Honda Power washer GC 160,2600 psi 2.3 GPM my husband taught me how to use it last night and I think I have followed all of steps: 1. hose free of kinks 2. connected to machine 3. purged pw handle of air and made sure water from house coming through 4. pulled out choke 5. turned red button to "ON" position 5. pulled T handle enging starter and it sounds like it will start but doesnt what am I doing wrong??? yes it does have gas in the fuel tank.


... Karcher 2500 PSI Pressure Washer

Hello, We need some assistance with our Kenmore dishwasher. Last night after I started a load, the dishwasher just stopped and then the washing and drying lights started flashing red, sanitized and green are flashing green and the 6 hour delay button is flashing red. I have pushed the start/cancel button but to no avail. My husband shut the power from it to see if it would reboot, it does not help either. It runs a little bit then quits and does not clean the dishes. Could you give us sugg


Hold the start button for 3-4 seconds and see what that does ... Dishwashers

Kenmore elite mod 665/17059 diswasher. unit was runing last night sometime during this time unit shut off. now it has no power at all. checked breakers and unit has power to it. could this be control unit?


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

I also have a dishwasher (AEG Favorit), and it does not heat the water anymore. It worked fine for last 3 years, and all sudden, it only washes dishes with cold water. Could you please help to solve this problem? The hot water line is fine and I do have the hot water to the sink next to the dishwasher. Thank you in advance for your help.


... AEG 23 in. Favorit 44070IW Built-in Dishwasher

Our dishwasher had to be removed. In reconnecting it to the water supply under the sink, the plumber could not keep it from leaking. I think there was a rubber washer that got lost during the disconnect/connect procedure. He then proceeded to gut off the end of the PEX hose which has a ridge and the last 1/2 inch is a little smaller than the hose. Now he says we need to order a new PEX hose from the factory. The PEX hose is too big to fit into the fitting. Cannot a normnal flex hose for thi


... Dishwashers

No pressure The washer is leaking from underneath - only used it twice last summer - was in the garage in the winter - could it have frozen?


More than likely it has frozen , if you did not disconnect the hose and drain residual water from unit ... Karcher PSI Electric Pressure Washer

Last night when the dishwasher reached 6 in the cycle (plate warming) there was a loud pop that caused as to loose all electricity in our home. When the electrician took the dishwasher out of the powerpoint the electricity came back on. The power point still works so the electrician has said that the dishwasher has blown. Does this sound like something that could be fixed? And if so who would I contact to do this? Thanks


The heating element in a dishwasher ( 120 volts only on a residential dishwasher ) draws a lot of current like an oven element (240 volts ) & probably has shorted or split open to let water into the internal element(from the outer shell/cover) of the ... Dishwashers

I HAVE A BAUMATIC D/WASHER BHD5 TYPE DW-24E1,(ABOUT 8 YEARS OLD) IT IS A WHILE SINCE LAST USED THEN 1 NIGHT AS IF IT HAD STARTED BY IT'SELF IT STARTED MAKING A BEEPING NOISE ALL 4 INDICATING LIGHTS AS WELL AS SALT AND RINSE AID WERE FLASHING HAVE SINCE TOPPED UP SALT AND RINSE AID BUT ROUGHLY 1 MINUTE AFTER STARTING IT BEGINS TO BEEP AND ALL LIGHTS FLASH. COULD YOU TELL ME THE PROBLEM. MANY THANKS


... Baumatic Dishwashers

Hello there from New Orleans!! I really could use some help. I have a Maytag mdb8951aws dishwasher that I purchased in 06 for 795 bucks, plus 180 for a 3 year warranty!! They came out maybe in 07 becaise of some recall, I don't remember what for. I called them because my heater stayed on all day yesterday and melted some dishes. Good thing we caught it last night and shut off the breaker. They said it was not recalled and out of warranty. Go figure! Do you know what this might be and how


It sounds like your heating element shorted out, causing the heater to stay on. You can replace this yourself, very easy to do. You should be able to buy this part on line. ... Dishwashers

Leaky Dishwasher I recently moved into a new house that has a brand new Magic Chef dishwasher. We haven't even had a chance to use it, but last night discovered water leaking from the bottom onto the floor. When I opened the door, there was about 3-4 inches of water inside. I baled as much of the (slimey) water out as I could, and that stopped the leak. Now afraid to run the dishwasher for fear that it might leak even worse. E71195 Type 777-0


... Magic Chef 24 in. DC4000 Free-standing Dishwasher

Bosch SHY66C My Bosch dishwasher won't fill with water.  All electrical connections are fine and I can hear it make a sound as if it is trying to start about every 2 minutes.  There was water in the bottom so I used a shop vac and pulled it all out but it still won't start and is doing the same thing.  I checked the solenoid with a multi-meter and it appears to be working.  My power went out last night for about two hours and that's all I can think of that might have affected it.  The dishwasher


I'm a novice on this question, but i agree with the above statement about check the stuck float switch or check for a bad safety switch or lockout switch of some sort. I would suspect something is definately faulty in that area. Will the dishwasher r ... Dishwashers

DISHWASHER PROBLEM HI, Last night I ran the dishwasher down in our kitchen down stairs. Four hour later I heard a humming sound coming from down there. I noticed the dishwasher went through the cycle perfectly , except on the hot drying cycle the timer knob was stuck and won't budge. I cannot move it either way. So I just unlatched it. Want do you think happened?


Do you see any error message on the display? ... GE Nautilus 24" Built-in Dishwasher

I have a neff s9151f dishwasher (integrated) last night it was working this morning it will not turn on. I have checked socket, plug and fuse all working? Is there a reset button or can you suggest what could be wrong?


... Neff Dishwashers

My kitchenaid dishwasher model # kuds02frss2 stopped working after I ran a cycle of dishes last night. When I looked at it this morning 3 lights were flashing: normal, china and cancel. When I turn off the breaker and turn it back on the same lights resume flashing. Any ideas on what this could be?


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0791 seconds